• ALGAE
• /
• v.35 no.1
• /
• pp.91-106
• /
• 2020

Incorporating renewable fuel into practice, especially from algae, is a promising approach in reducing fossil fuel dependency. Algae are an exceptional feedstock since they produce abundant biomass and oils in short timeframes. Algae also produce high-valued lipid products suitable for human nutrition and supplement. Achieving goals of producing algae fuels and high-valued lipids at competitive prices involves further improvement of technology, especially better control over cultivation. Manipulating microalgae cultivation conditions to prevent contamination is essential in addition to promoting optimal growth and lipid yields. Contamination of algal cultures is a major impediment to algae cultivation that can however be mitigated by choosing extremophile microalgae. This work describes the isolation of alkali-tolerant / alkaliphilic microalgae native to South Florida with ideal characteristics for cultivation. For that purpose, water samples from Lake Okeechobee were inoculated into Zarrouk's medium (pH 9-12) and incubated for 35 days. Selection resulted in isolation of three strains that were screened for biomass and lipid accumulation. Two alkali-tolerant algae Chloroidium sp. 154-1 and Chlorella sp. 154-2 were poor lipid accumulators. One of the isolates, the diatom Fistulifera sp. 154-3, was identified as a lipid accumulating, alkaliphilic organism capable of producing 0.233 g L^-1 d^-1 dry biomass and a lipid content of 20-30% dry weight. Lipid analysis indicated the most abundant fatty acid within Fistulifera sp. was palmitoleic acid (52%), or omega-7, followed by palmitic acid (17%), and then eicosapentanoic acid (15%). 18S rRNA phylogenetic analysis formed a well-supported clade with Fistulifera species.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.15 no.5
• /
• pp.3327-3335
• /
• 2014

In this study, comparison works have been performed for single-stage and multi-stage refrigeration cycle using propane as a refrigerant in order to cool down the natural gas stream. A comparative analysis has been performed for a single, two, three and four stage refrigeration cycle using propane as a refrigerant for cooling the natural gas stream. For the simulation, natural gas feedstock properties supplied by KOGAS were utilized and Peng-Robinson equation of state model was used. As the number of compression stages increase, the condenser heat duty is decreased. The refrigeration heat duty for a four-stage refrigeration cycle is decreased by 20.36% compared to that for a single-stage refrigeration cycle. Moreover, the total refrigerant circulation rate for a four-stage refrigeration system is was reduced by 14.53% compared to the single stage refrigeration cycle. The total compression power for a four-stage compression was reduced by 41.61% compared to the single stage compression.

• Journal of the Korean Applied Science and Technology
• /
• v.18 no.2
• /
• pp.103-110
• /
• 2001

Resource recovery and recycling of materials and products, including polyurethanes is viewed as a necessity in today's society. Most urethane polymers are made from a polyol and a diisocyanate. these and be chemicals such as water, diamines or diols that react with isocyanate groups and add to the polymer backbone. The problems of recycling polyurethane wastes has major technological, economic and ecological significance because polyurethane itself is relatively expensive and its disposal whether by burning is also costly. In general, the recycling methods for polyurethane could be classified as mechanical, chemical and feedstock. In the chemical recycling method, there are hydrolysis, glycolysis, pyrolysis and aminolysis. This study, the work was carried out glycolysis using sonication ant catalyzed reaction. Different kinds of recycled polyols were produced by current method(glycolysis), catalyzed reaction and sonication as decomposers and the chemical properties were analyzed. The reaction results in the formation of polyester urethane diols, the OH value which is determined by the quantity of diol used for the glycolysis conditions. The glycolysis rates by sonication for the various glycols, increased as fallows: PPG

• Journal of the Korean Applied Science and Technology
• /
• v.31 no.3
• /
• pp.453-465
• /
• 2014

The paper provides a review on bio-oil production technology from biomass by using fast pyrolysis to use heating fuel, power fuel and transport fuel. One of the most promising methods for a small scale conversion of biomass into liquid fuels is fast pyrolysis. In fast pyrolysis, bio-oil is produced by rapidly heating biomass to intermediate temperature ($450{\sim}600^{\circ}C$) in the absence of any external oxygen followed by rapid quenching of the resulting vapor. Bio-oil can be produced in weight yield maximum 75 wt% of the original dry biomass and bio-oils typically contain 60-75% of the initial energy of the biomass. In this study, it is described focusing on the characterization of feedstock, production principle of bio-oil, bio-oil's property and it's application sector.

• Journal of Forest and Environmental Science
• /
• v.27 no.3
• /
• pp.143-149
• /
• 2011

The possibility of employing biomass of Salix viminalis cv. Q683 as a resource of bio-energy was evaluated. The chemical analysis of S. viminalis cv. Q683 leaf biomass showed components such as, extractives (2.57%), lignin (39.06%), hemicellulose (21.61%), and cellulose (37.83%), whereas, its stem was composed of extractives (1.67%), lignin (23.54%), hemicellulose (33.64%), and cellulose (42.03%). The biomass of S. viminalis cv. Q683 was saccharified using two enzymes celluclast and viscozyme. The saccharification of S. viminalis cv. Q683 biomass was influenced by enzymes and their strengths. The optimal enzyme combination was found to be celluclast (59 FPU/g substrate) and viscozyme (24 FBG/g substrate). On saccharification the glucose from leaf and stem biomass was 7.5g/L and 11.7g/L, respectively after 72 hr of enzyme treatment. The biomass and enzyme-treated biomass served as the feedstock for ethanol production by fermentation. The ethanol production from stem and leaf biomass was 5.8 g/L and 2.2 g/L respectively, while the fermentation of the enzymatic hydrolysates yielded 5 g/L to 8 g/L bioethanol in 72 hours.

• Membrane Journal
• /
• v.29 no.2
• /
• pp.67-79
• /
• 2019

High purity propylene (propene) is an octane-enhancing chemical and also feedstock to industrially important chemicals. Purification of propylene from propane mixture is technologically and financially challenging because of their close boiling points. ZIF-8 membrane has been increasingly researched due to its great potential to separate propylene from propane effectively by molecular sieving. The increasing interest in ZIF-8 membranes lies in the so called "gate opening" effect. The gate opening effect enlarges the membrane pores and preferentially allows propylene to permeate through the membrane pores, while retaining the larger and heavier propane molecules in the feed stream in order to effect high propylene separation from propylene/propane mixture. In this paper, the widely accepted methods of ZIF-8 membrane preparation and parameters affecting propylene permeation and selectivity in ZIF-8 membrane are identified and reviewed.

• Journal of the Korean Wood Science and Technology
• /
• v.47 no.2
• /
• pp.189-199
• /
• 2019

This study addresses the biorefinery feedstock from Pinus densiflora. This raw material is a major tree species in the Republic of Korea; it is renewable, has cost-effective, and is readily available. In this study, steam explosion of P. densiflora was performed in a reactor at $225^{\circ}C$ and with 1 to 13 min reaction times with or without previous water impregnation. The combined severity factor (Ro), which is an expression relating the reaction temperature and reaction time used in the steam explosion treatment, ranged from 3.68 to 4.79. The influence of both impregnation and steam explosion conditions were investigated by examining color variations, chemical composition, and mass balance on the pretreated solids. The results showed that steam-exploded P. densiflora that was not impregnated with water exhibited significantly darker color (chroma 28.8-41.4) than water-impregnated and steam-exploded P. densiflora (chroma 18.8-37.3). The increased ${\alpha}$-cellulose and lignin contents were detected as the severity factor increased. Furthermore, the ${\alpha}$-cellulose and lignin contents in the non-impregnated/steam-exploded P. densiflora were higher than those in the water-impregnated/steam-exploded P. densiflora. However, the decreased holocellulose content was detected as the severity factor increased. In mass balance, the holocellulose yield from water-impregnated/steam-exploded P. densiflora was higher than that from the non-impregnated P. densiflora.

• Journal of Microbiology and Biotechnology
• /
• v.29 no.3
• /
• pp.382-391
• /
• 2019

Many poultry eggs are discarded worldwide because of infection (i.e., avian flu) or presence of high levels of pesticides. The possibility of adopting egg yolk as a source material to produce polyhydroxyalkanoate (PHA) biopolymer was examined in this study. Cupriavidus necator Re2133/pCB81 was used for the production of poly(3-hydroxybutyrate-co-3-hydroxyhexanoate) or poly(3HHx), a polymer that would normally require long-chain fatty acids as carbon feedstocks for the incorporation of 3HHx monomers. The optimal medium contained 5% egg yolk oil and ammonium nitrate as a nitrogen source, with a carbon/nitrogen (C/N) ratio of 20. Time course monitoring using the optimized medium was conducted for 5 days. Biomass production was 13.1 g/l, with 43.7% co-polymer content. Comparison with other studies using plant oils and the current study using egg yolk oil revealed similar polymer yields. Thus, discarded egg yolks could be a potential source of PHA.

• Journal of the Korean Wood Science and Technology
• /
• v.47 no.3
• /
• pp.360-370
• /
• 2019

Woody crops cultivated in short-rotation coppices are attractive sources of lignocellulosic materials for bioethanol production, since they are some of the most abundant renewable resources. In this study, we evaluated the effects of the growth period on bioethanol production using short-rotation woody crops (Populus nigra ${\times}$ Populus maxiwiczii, Populus euramericana, Populus alba ${\times}$ Populus glandulosa, and Salix alba). The carbohydrate contents of 3-year-old and 12-year-old short-rotation woody crop branches were 62.1-68.5% and 64.0-67.1%, respectively. The chemical compositions of 3-year-old and 12-year-old short-rotation woody crop branches did not vary significantly depending upon the growth period. However, the 3-year-old short-rotation woody crop branches (glucose conversion: 26-40%) were hydrolyzed more easily than their 12-year-old counterparts (glucose conversion: 19-24%). Furthermore, following the fermentation of enzymatic hydrolysates from the crop branch samples (by Saccharomyces cerevisiae KCTC 7296) to ethanol, the ethanol concentration of short rotation coppice woody crops was found to be higher in the 3-year-old branch samples (~ 0.18 g/g dry matter) than in the 12-year-old branch samples (~ 0.14 g/g dry matter). These results suggest that immature wood (3-year-old branches) from short-rotation woody crops could be a promising feedstock for bioethanol production.

• Journal of Korea Society of Waste Management
• /
• v.35 no.7
• /
• pp.587-599
• /
• 2018

The coffee grounds generated during the coffee extraction process contain several resources, but the technology for their recycling has not been commercialized yet, causing various environmental problems. Due to the recent increase in coffee consumption worldwide, the amount of coffee grounds produced has been continuously increasing, reaching more than 750 million tons. In Korea, about 120,000 tons of coffee waste are annually generated; however, most of them are landfilled or incinerated. Although there is still a shortage of coffee waste recycling technologies compared to the amount of coffee grounds produced, various recycling approaches are being actuated in many countries including Korea. In this study, the generation of coffee grounds at home and abroad, the status of coffee grounds recycling, and the associated technology development trends were investigated. The coffee grounds recycling has been studied in the fields of energy, adsorbent, construction, agriculture, and bio-foods. Research is most active in the energy and biotechnology areas; in particular, since the oil in the coffee grounds is valuable as a feedstock for biomass energy, the technology related to energy recovery is currently under development worldwide. Removed because confusing and unnecessary.