• Journal of IKEEE
• /
• v.5 no.1 s.8
• /
• pp.16-23
• /
• 2001

Passive noise reduction is a classical approach to attenuate industrial noise, and an active noise cancellation has several advantages over the passive noise cancellation. The active noise reduction system offers a better low frequency performance with a smaller and lighter system. This paper presents a simple active closed loop control system which consists of an controller for inverting and compensating the phase delay, a microphone for picking up the external noise, and a loudspeaker for radiating the acoustic out of phase signal to reduce the external noise, and external noise can be reduced after compensating the phase difference to be $180^{\circ}$ in the frequency of maximum value in the amplitude response. The noise of the phase delay covered from $50^{\circ}\;to\;310^{\circ}$ tends to be reduced in the active noise control system and it is possible to obtain a noise cancelling of up to approximately 20[dB] at the ears in the enclosurer.

• Journal of Power Electronics
• /
• v.16 no.3
• /
• pp.1226-1235
• /
• 2016

For wearable health monitoring systems, a fundamental problem is the limited space for storing energy, which can be translated into a short operational life. In this paper, a highly efficient active voltage doubling rectifier with a wide input range for micro-piezoelectric energy harvesting systems is proposed. To obtain a higher output voltage, the Dickson charge pump topology is chosen in this design. By replacing the passive diodes with unbalanced-biased comparator-controlled active counterparts, the proposed rectifier minimizes the voltage losses along the conduction path and solves the reverse leakage problem caused by conventional comparator-controlled active diodes. To improve the rectifier input voltage sensitivity and decrease the minimum operational input voltage, two low power common-gate comparators are introduced in the proposed design. To keep the comparator from oscillating, a positive feedback loop formed by the capacitor C is added to it. Based on the SMIC 0.18-μm standard CMOS process, the proposed rectifier is simulated and implemented. The area of the whole chip is 0.91×0.97 mm², while the rectifier core occupies only 13% of this area. The measured results show that the proposed rectifier can operate properly with input amplitudes ranging from 0.2 to 1.0V and with frequencies ranging from 20 to 3000 Hz. The proposed rectifier can achieve a 92.5% power conversion efficiency (PCE) with input amplitudes equal to 0.6 V at 200 Hz. The voltage conversion efficiency (VCE) is around 93% for input amplitudes greater than 0.3 V and load resistances larger than 20kΩ.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.12C
• /
• pp.1239-1247
• /
• 2005

It is important to improve TCP performance in Self-similar TCP network where signalling between the same end nodes through bidirectional traffic routes. In wireless link, the traffic limitation pattern occurred in two or more TCP connections is applied into MPEC video control as multi time-interval congestion control. For TCP update variable, we extend TCP and perform as function call, and we study a method of relating TCP with LTS module controlling with the information type that is overcoming the limit of feedback loop determined by RTT. For comparison, we measure the TCP throughput without LTS and verify the fairness by means of meta control. The improved TCP performance is shown by that the number of connections of traffic congestion control increases when RTT increases.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.26 no.7A
• /
• pp.1152-1161
• /
• 2001

본 논문에서는 이동국 수신 신호의 SINR을 최대화하는 빔 성형 알고리듬을 이용하여, 폐쇄 루프 송신 빔 성형기술을 적용한 순방향 링크 CDMA 시스템에서의 안테나 수, 귀환 채널의 구조, 귀환 지연 등과 시스템 성능과의 상관관계를 연구하였다. 폐쇄 루프 전송 빔 성형에서는 이동국이 각 안테나가 겪는 채널을 추정하여 수신 SINR을 최대화시키는 가중치 벡터를 계산하고, 귀환채널을 통해 가중치 벡터의 양자화된 진폭과 위상정보를 전송한다. 컴퓨터 모의 실험 결과는 송신 안테나가 2개, 3개, 4개로 늘어남에 따라 빔 성형 이득은 단일 송신 안테나와 비교해 $10^{-5}$ BER 근방에서 4.2dB, 5.8dB, 7dB로 증가하지만 양자화 오류에 의한 성능 저하 또한 0.1dB, 0.6dB, 1.3dB로 커지는 것을 보여준다. 또한 순방향 채널의 최대 도플러 주파수가 100Hz일 때에는 귀환 채널을 통한 소신 가중치 벡터를 보다 빠르게 갱신하는 것이 가중치 벡터의 양자화 레벨의 수를 늘여주는 것보다 $10^{-5}$ BER 근방에서 0.6dB 더 좋은 성능을 보이며, 최대 도플러 주파수가 10Hz일 때에는 가중치 벡터의 갱신 속도를 늘이기 보다 양자화 레벨의 수를 늘여주어 정확한 가중치 벡터를 전송하는 편이 0.9dB의 성능 향상을 보인다. 두 전력제어 그룹 길이의 귀환지연으로 인한 성능저하는 채널의 최대 도플러 주파수가 50Hz인 경우가 채널의 최대 도플러 주파수가 100Hz인 경우보다 $10^{-5}$ BER 근방에서 0.3dB 정도 더 작다. 또한 AOS가 3$^{\circ}$인 경우가 AOS가 $10^{\circ}$인 경우보다 $10^{-5}$ BER 근방에서 1.9dB 정도, 주파수 선택적 페이딩 채널이 주파수 비선택적 페이딩 채널보다 $10^{-5}$ BER 근방에서 1dB 정도 귀환 지연으로 인한 성능의 저하가 작다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.6C
• /
• pp.560-569
• /
• 2005

This paper proposes an algorithm for transmit antenna selection in a multi-input multi-output(MIMO) spatial multiplexing system with per antenna rate control(PARC) and an ordered successive interference cancellation (OSIC) receiver. The active antenna subset is determined at the receiver and conveyed to the transmitter using feedback information on transmission rate per antenna. We propose a serial decision procedure consisting of a successive process that tests whether antenna selection gain exists when the antenna with the lowest pre-processing signal to interference and noise ratio(SINR) is discarded at each stage. Furthermore, we show that 'reverse detection ordering', whereby the signal with the lowest SINR is decoded at each stage of successive decoding, widens the disparities among fractions of the whole capacity allocated to each individual antenna and thus maximizes a gain of antenna selection. Numerical results show that the proposed reverse detection ordering based serial antenna selection approaches the closed-loop MIMO capacity and that it induces a negligible capacity loss compared with the heuristic selection strategy even with considerably reduced complexity.

• Journal of the Korea Society of Computer and Information
• /
• v.19 no.6
• /
• pp.19-26
• /
• 2014

An ensemble classifier system is a widely-used multi-classifier system, which combines the results from each classifier and, as a result, achieves better classification result than any single classifier used. Several methods have been used to build an ensemble classifier including boosting, which is a cascade method where misclassified examples in previous stage are used to boost the performance in current stage. Boosting is, however, a serial method which does not form a complete feedback loop. In this paper, proposed is context sensitive SVM ensemble (CASE) which adopts SVM, one of the best classifiers in term of classification rate, as a basic classifier and clustering method to divide feature space into contexts. As CASE divides feature space and trains SVMs simultaneously, the result from one component can be applied to the other and CASE achieves better result than boosting. Experimental results prove the usefulness of the proposed method.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.38 no.1
• /
• pp.44-54
• /
• 2001

In this paper, a novel test method is proposed to detect the hard and soft fault in analog circuits. The proposed test method makes use of the offset voltage, which is one of the op-amps characteristics. During the test mode, CUT is modified to unit gain op-amps with feedback loop. When the input of the op-amp is grounded, a good circuit has a small offset voltage, but a faulty circuit has a large offset voltage. Faults in the op-amp which cause the offset voltage exceeding predefined range of tolerance can be detected. In the proposed method, no test vector is required to be applied. Therefore the test vector generation problem is eliminated and the test time and cost is reduced. In this note, the validity of the proposed test method has been verified through the example of the dual slope A/D converter. The HSPICE simulations results affirm that the presented method assures a high fault coverage.

• Aerospace Engineering and Technology
• /
• v.1 no.2
• /
• pp.105-112
• /
• 2002

In this paper, a servo filter design for the gimbal engine actuator system of KSR-III(Korea Sounding Rocket-III) is considered. A reasonable filter structure is determined based on the actuator analytic models. The servo filter consists of a 2-nd order lowpass filter and a 1-st order compensator. The lowpass filter is required to protect the actuator from high frequency vibration, and the compensator to enhance the resulting stability. A Butterworth type servo filter is considered as the simplest one. The final servo filter type is determined by evaluating simultaneously both high frequency gain reduction performance and the corresponding KSR-III stability margin. Consequently it is revealed that a notch type servo filter located on the error between command signal and feedback signal in the control loop is very effective. Later, based on the proposed servo filter type, an onboard servo filter hardware of KSR-III will be designed and tested.

• 한국균학회소식:학술대회논문집
• /
• 2016.05a
• /
• pp.27-27
• /
• 2016

The ascomycete fungus Fusarium graminearum is the most common pathogen of Fusarium head blight (FHB), a devastating disease for major cereal crops worldwide. FHB causes significant crop losses by reducing grain yield and quality as well as contaminating cereals with trichothecenes and zearalenone (ZEA) that pose a serious threat to animal health and food safety. ZEA is a causative agent of hyperestrogenic syndrome in mammals and can result in reproductive disorders in farm animals. In F. graminearum, the ZEA biosynthetic cluster is composed of four genes, PKS4, PKS13, ZEB1, and ZEB2, which encode a reducing polyketide synthase, a nonreducing polyketide synthase, an isoamyl alcohol oxidase, and a transcription factor, respectively. Although it is known that ZEB2 primarily acts as a regulator of ZEA biosynthetic cluster genes, the mechanism underlying this regulation remains undetermined. In this study, two isoforms (ZEB2L and ZEB2S) from the ZEB2 gene in F. graminearum were characterized. It was revealed that ZEB2L contains a basic leucine zipper (bZIP) DNA-binding domain at the N-terminus, whereas ZEB2S is an N-terminally truncated form of ZEB2L that lacks the bZIP domain. Interestingly, ZEA triggered the induction of both ZEB2L and ZEB2S transcription. In ZEA producing condition, the expression of ZEB2S transcripts via alternative promoter usage was directly or indirectly initiated by ZEA. Physical interaction between ZEB2L and ZEB2L as well as between ZEB2L and ZEB2S was observed in the nucleus. The ZEB2S-ZEB2S interaction was detected in both the cytosol and the nucleus. ZEB2L-ZEB2L oligomers activated ZEA biosynthetic cluster genes, including ZEB2L. ZEB2S inhibited ZEB2L transcription by forming ZEB2L-ZEB2S heterodimers, which reduced the DNA-binding activity of ZEB2L. This study provides insight into the autoregulation of ZEB2 expression by alternative promoter usage and a feedback loop during ZEA production.

• Journal of the Korea Society of Computer and Information
• /
• v.8 no.3
• /
• pp.179-187
• /
• 2003

This study investigate the reasons of organizational failure in detection and appropriate response to risk signal. The Crisis does not come true suddenly, there is some risk signals in crisis. If Organization detect the risk signals the crisis is come true opportunities, if not the crisis is come true disastrous outcome. This is use the system dynamics approach. System Dynamics assume the system as a collection of causal feedback loop, so we understand the dynamics around the problems. This investigate suggest that, the focus on growth is the a kind of promotional pressure and the pressure drive the organization to less attention the risk signal, so the risk is underestimate In proportion to real risk. Ultimate, the organization entrap the promotional climate and insensible to security. This study is a kind of hypothesis-discovering research, in the further study, the discovered hypothesis will be empirically tested.