• Journal of the Korean Vacuum Society
• /
• v.21 no.5
• /
• pp.258-263
• /
• 2012

Fe-diluted Si alloys grown on p-type Si (100) substrates by pulsed-laser deposition method were studied for structural, electrical, and magnetic properties. The X-ray diffraction patterns for these alloy samples showed a few of peaks with cubic structures such as FeSi, $Fe_3Si$, and $Fe_4Si$. The Fe-composition in alloys are confirmed as Fe atomic percent about 1.25~6.49 % from energy dispersive spectroscopy measurement. The resistivity as a function of the reciprocal temperature was indicated an exponential increase with two activation energies of 5.21 and 7.79 meV. The maximum value of the magnetization at 10 K was about 100 emu/cc, and the ferromagnetism was also observed until 350 K from total magnetization as a function of temperature with applied magnetic field of 3,000 Oe.

• Journal of the Korean Chemical Society
• /
• v.27 no.6
• /
• pp.424-482
• /
• 1983

Determination for $Ta_2O_5$,$Nb_2O_5$ and $SnO_2$ in tin slags was investigated by X-ray spectrometric method. Standard addition-dilution method was attempted and showed a comparable accuracy with standard calibration curve method. Pure chemicals($Ta_2O_5$,$Nb_2O_5$ and $SnO_2$) were added to the samples and diluted with silica or ferric oxide. For the determination of $Ta_2O_5$and$SnO_2$ , silica was more suitable than ferric oxide while the latter was more preferable than the former for $Nb_2O_5$.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.25 no.7
• /
• pp.1073-1081
• /
• 2001

Many researches have published numerous papers about the high-strain-rate obtained from Split Hopkinson Pressure Bar(SHPB) tests. And 6.5wt%Si steel is widely known as an excellent magnetic material because its magnetostriction is nearly zero. Single crystals are prepared by the Floating Zone(FZ) method, which melts the alloy by the use of a high temperature electron beam in a pure argon gas condition. In this paper, the fracture behavior of the poly crystals and single crystals (DO$_3$phase) of Fe-6.5wt%Si alloy by SHPB test is observed. The comparison of high-strain-rate results with static results was done. Obtained main results are as follows: (1) Fe-6.5wt%Si alloy has higher strength at high-strain-rate tensile. SHPB results of polycrystal are twice as high as static results. (2) From the fractography, the cleavage steps are remarkably reduced in the SHPB test compared with the static test.

• Applied Chemistry for Engineering
• /
• v.10 no.3
• /
• pp.343-348
• /
• 1999

The iron silicide films were prepared by chemical vapor deposition method using rf-plasma in variations of substrate temperature. rf-power, and ratio of $SiH_4$ and Fe-precursor. While iron silicide films are generally grown by ion beam synthesis (IBS) method of multi-step process, it is confirmed that iron silicide or $\beta$-phase consolidated $Fe_aSi_bC_cH_d$ was formed by one-step process in this study. The characteristics of films is variable because the different amounts of carbon and hydrogen was involved in the films as a function of dilute ratio of Fe-precursors and silane. It was shown that the different characteristics of films in carbon and hydrogen following the ratio of Fe-precursor and silane. The optical gap energy of films fabricated according to substrate temperature was invariant because active site brought in desorption of hydrogen was limiled. When rf-power was above 240 watt, the optical gap energy turned out to have high values because of dangling bonds increased by etching.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.24 no.12
• /
• pp.2909-2916
• /
• 2000

6.5wt% Si steel is widely known as an excellent magnetic material because its magnetostriction is nearly zero. The AX magnetic properties as magnetostriction of 6.5% Si steel were evaluated and compared with those of conventional 3% Si steel sheet. In this paper, the fracture behavior of the poly crystals and single crystals of Fe-6.5wt%Si alloy has been observed. Single crystals were prepared by Floating Zone(FZ) method, which melts the alloy by the use of high temperature electron beam in pure argon gas condition. And the single crystals were annealed at 500$^{\circ}C$ and 700$^{\circ}C$ respectively and tensile tested at room temperature. According to the result, B2 phase has more good elongation than DO$_3$ phase. It was also found that the fracture surfaces of the single crystals have hairline facets in same direction, and the facets change the direction according to the single crystal phase.

• Korean Journal of Materials Research
• /
• v.5 no.7
• /
• pp.808-815
• /
• 1995

The magnetic states of nonstoichiometric substituted ferrite Fe$_{}1.429$(Al$_{4-x}$ Ga$_{x}$)$_{0.286}$ Si$_{0.143}$ /O$_4$ system have been investigated using Mossbauer spectroscopy and SQUID. The Mossbauer spectra at room temperature show well-defined two Zeeman patterns for x=0.2, superpositions of two Zeeman patterns and a doublet for x=0.4. The doublet peak seems to be originated from the superparamagnetic clusters. The system shows significant departures from the Neel's collinear model and seems to be the diluted ferrites. The Mossbauer spectra below R.T show various and complicated patterns, which can be explained by freezing of the superparamagnetic clusters. On cooling, magnetic states of the system may be various and multicritical, Resulting from SQUID measurements, there was an unexpected dip in magnetization curves below 50K. It was interpreted as an effect of spin canting including spin freezing or collective spin behavior.

• Proceedings of the Korean Society of Postharvest Science and Technology of Agricultural Products Conference
• /
• 2003.04a
• /
• pp.121.1-121
• /
• 2003

증류수, 수도수, 온천수(경산 사이판 온천) 희석액 (55배 희석; I, 4배 희석; II, 2배희석; III을 사용한 반죽의 발효와 빵의 품질에 미치는 영향을 조사하였다. 경산사이판 온천수는 총고형물이 8,765 ppm 이였으며 주요 무기질로는 Na가 2296 ppm, Ca가 287 ppm, Mg와 K가 각각 65 및 8 ppm을 함유하였다. Fe, Cu, Co, F. Zn Al, S, Mo, Se 및 Si 등이 0.002~5.2 ppm을 함유하였다. 온천수를 사용한 반죽의 pH는 6.95~7.68로 증류수의 6.40보다 높았다. 반죽부피는 온천수의 농도가 높아짐에 따라 감소하였다. pH를 5.5로 조정한 온천수를 사용한 반죽의 부피는 대조구 보다 오히려 높았다. 온천수를 사용한 빵의 경도 (hardness)와 신장성(strength)는 대조구 보다 높았으나 pH를 조정한 온천수의 경우는 낮았다. 점착성은 경도 및 신장성과는 역으로 희석 온천수에서 낮았다. pH 조정 없이 구운 빵의 부드러운 정도는 4배로 희석한 온천수가 증류수 및 55배, 2배 희석 온천수보다 높았다. 쫄깃한 맛도 온천수가 대조구에 비하여 높았으며 종합적인 기호도는 4배 희석 온천수가 가장 좋았다.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.102-102
• /
• 2011

ZnO는 우수한 전기적, 광학적 특성으로 LED, solar cell 등과 같은 광전자소자의 응용을 목적으로 많은 연구가 진행되고 있다. 최근에는 ZnO 동종접합을 만들고자 많은 연구가 진행되고 있으나 p형 ZnO의 낮은 용해성과 높은 불순물에 따른 제조의 어려움으로 현재까지는 n형 ZnO만이 전도성 기판 위에 성장되어 응용되고 있다. 전도성 기판으로서 Si의 경우 낮은 가격, 공정의 용이함 등으로 GaN, SiC 등의 기판에 비하여 많은 응용이 가능하다. 따라서 본 연구에서는 전기화학증착법을 이용하여 p-n 접합을 형성하기 위하여 p형 Si 기판 위에 n형 ZnO 나노구조를 성장하고 그 특성을 분석하였다. 전기화학증착법은 낮은 온도 및 간단한 공정과정으로 빠른 성장 속도를 가지고 나노구조를 효과적으로 성장할 수 있는 방식이다. Seed 층 및 열처리에 따른 n형 ZnO 나노구조의 성장 특성 분석을 위하여 radio frequency (RF) magnetron 스퍼터를 사용하여 ZnO 및 Al doped ZnO (AZO) seed 층을 p형 Si 기판 위에 증착 후 다양한 온도로 열처리를 수행하였다. 질산아연(zinc nitrate)과 HMT가 희석된 용액에 KCl 촉매를 일정량 첨가한 후 다양한 공정 온도, 공정시간 및 질산아연의 몰농도를 변화시켜 n형 ZnO 나노구조를 성장하였다. 성장된 나노구조의 특성은 field emission scanning microscopy (FE-SEM), energy dispersive X-ray (EDX), photoluminescence (PL) 등의 장비를 사용하여 구조적, 광학적 특성을 분석하였다.

• Journal of the East Asian Society of Dietary Life
• /
• v.13 no.1
• /
• pp.56-63
• /
• 2003

The dough fermentation and the quality of bread prepared with different kinds of water such as distilled water, tap water and diluted hot spring water(SW) from Gyungsan Sipan hot spring were investigated. Content of total soluble solid in the hot spring water was 8,765 ppm and contents of Na, Ca, Mg and K as major elements was 2,296, 287, 65 and 8 ppm, respectively. Content of Fe, Cu, Co, F, Zn, Al, S, Mo, Se and Si as minor elements was in the range of 0.002~5.2 ppm. The pH(6.95~7.68) of the dough prepared with diluted hot spring water(I, 55 times; II, 4 times; III, 2 times) was higher than that of distilled water. The dough volume after the 1st fermentation was expecially lower in the III, but the volume of the dough prepared with III adjusted pH to 5.5 was higher than that of the control. The hardness and the strength were higher than those of the control, but the scores were love. than those of the control in case of pH adjustment(pH 5.5). The cohesiveness was also lower than that of the control in the bread with diluted hot spring water. Softness and stickiness of the bread(III) were hisher than those of the control. But overall acceptability was the highest in the II.

• Economic and Environmental Geology
• /
• v.35 no.1
• /
• pp.55-66
• /
• 2002

There are several abandoned coal mines around Donghae mine area in the Taebaek coal field. Two major creeks, Soro and Sanae, are contaminated with the colored precipitates formed from the coal mine drainages. Bed rocks of the study area consist of limestone, shale, and sandstone. Limestone consisted mainly of calcite and dolomite, and shale of quartz, pyropyllite and chlorite, and sandstone of quatz and illite. Coal coal spoil dumps composed mainly of pyrite and chlorite. The oxidative dissolution of sulfide minerals leads to acid mine drainage and adds the metal ions in the stream water. The ion concentrations of Fe, Ca, Mg, Al, Si, SO$_{4}$in the stream polluted by AMD are generally higher than those in the unpolluted stream water. High concentrations of Ca and Mg, Al and Si can be resulted from dissolution of carbonate minerals such as calcite, dolomite and aluminosilicates such as chlorite, pyrophyllite. Although the Fe, Al, Si, SO$_{4}$ contents are considerbly high in the acid water released from the mine adits, they become decreased downstream due to dilution of unpolluted water and precipitation of oxide/hydroxide and sulfate minerals on the bottom of stream.