• Journal of Digital Convergence
• /
• v.11 no.7
• /
• pp.201-207
• /
• 2013

The chirp signaling has been mainly used in radar systems due to its good correlation characteristics, and nowadays it is applied to real time locating system(RTLS). The RTLS with chirp signaling was chosen as a standard such as ISO/IEC 24730-5 and IEEE 802.15.4a. In this paper, the performance of a real time locating system with chirp signaling was evaluated and simulated with relative distance error rates. We considered three cases of S/I = -30[dB], -20[dB], and -10[dB] with Rician factor K=10 and K=20. The performance was enhanced with K factor improvement by 25%, 27% and 50% for respective three cases of S/I. As results, in case of S/I < -20[dB], the minimum signal power is required for performance improvement even though the line of sight component is helpful. And also, in case of S/I ${\geq}$ -20[dB], as the line of sight component is stronger the better performance is obtained.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.12 s.354
• /
• pp.61-67
• /
• 2006

This paper proposes the algorithm for tracking of the residual phase errors incurred by carrier frequency offset and sampling frequency offset in the orthogonal frequency division multiplexing (OFDM) systems which are suitable for high data rate wireless communications. In the OFDM systems the subcarriers which are orthogonal to each other are modulated by digital data and transmitted simultaneously. The carrier frequency offset causes degradation of signal to noise ratio(SNR) performance and interference between the adjacent subcarriers. The errors in the sampling timing caused by the sampling frequency difference between the transmitter and the receiver sides also cause a major performance degradation in the OFDM systems. The residual error tracking and compensation mechanism is essential in the OFDM system since the carrier and the sampling frequency offset cause the loss of orthogonality resulting in the system performance loss. This paper proposes the scheme where the channel gain and the payload data information are reflected in the residual error tracking process which results in the reduction of the estimation error and the tracking performance improvements under the frequency selective fading wireless channels.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.7A
• /
• pp.640-648
• /
• 2011

We propose relay selection schemes using STBC (Space Time Block Coding) technique in OFDM (Orthogonal Frequency Division Multiplexing)-based wireless systems. The proposed schemes select the optimum relay having the maximum instantaneous equivalent channel gain among multiple candidate relays. Also, in order to reduce the system overhead, a symbol grouping method which groups some amount of symbols before selecting the optimum relay is proposed. The simulation results show that the proposed relay selection schemes can obtain more selection diversity gain as the number of selectable relay candidates increases. Furthermore, the proposed scheme with the symbol grouping can reduce system overhead without any degradation of the performance in fading channels with low frequency selectivity.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.10A
• /
• pp.839-846
• /
• 2011

Link Adaptation should select the best modulation and coding scheme (MCS) which gives the highest throughput as channel conditions vary. Several link adaptation algorithms for wireless local area network (WLAN) have been proposed but for the future WLAN systems such as 802.11n system, these algorithms do not guarantee the best performance. In this paper, we propose a new link adaptation algorithm in which an MCS level is chosen by the received SNR plus the offset value obtained from the transmission results. The performance of proposed algorithm is simulated by an IEEE 802.11n system. From the analysis, we conclude the proposed algorithm performs better than the well-known link adaptation algorithms such as auto rate fallback and general SNR-based techniques. Particularly, the proposed algorithm improves throughput when the packet error ratio (PER) is constrained for fast fading channels.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.1C
• /
• pp.1-7
• /
• 2010

In this paper, the performance of the soft-decision-and-forward (SDF) protocol in the cooperative communication network with one source, one relay, and one destination, where each node has two transmit and receive antennas, is analyzed in terms of the bit error rate (BER) obtained from the pairwise error probability (PEP). For the slow-varying Rayleigh fading channel, the optimal and suboptimal power allocation ratios are determined without feedback. The optimal power allocation can be obtained by minimizing the average PEP. For the tractability, an alternative strategy of maximizing the product SNR of direct and relay links, which we call the suboptimal power allocation, is considered. Through the numerical analysis, we show that the performance gap between the suboptimal and the optimal power allocation is negligible in the high SNR region.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.10A
• /
• pp.752-759
• /
• 2009

Cooperative diversity is an effective technique to combat multi-path fading. When this technique is applied to energy-constrained wireless sensor networks, it is a key issue to design appropriate relay selection and power allocation strategies. In this paper, we proposed a new multi-relay selection and power allocation algorithm to maximize network lifetime. The algorithm are composed of two relay selection stages, where the channel condition and residual power of each node were considered in multi-relay selection and the power is fairly allocated proportional to the residual power, satisfies the required SNR at destination and minimizes the total transmit power. In this paper, proposed algorithm is based on AF (amplify and forward) model. We evaluated the proposed algorithm by using extensive simulation and simulation results show that proposed algorithm obtains much longer network lifetime than the conventional algorithm.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39C no.11
• /
• pp.1042-1049
• /
• 2014

In Military MicroWave communication, the distance of link, availability, transmission capacity is the important point in order to design the circuit. Currently, operated by fixed modulation, in the future it will be evolved to the modulation techniques enabled to increase the transmission capacity. It would be hard to consistently guarantee the transmission quality of the high-availability because the occurrence probability of fading increase in terms of the link distance for the case of the long distance. In the case of the modulation techniques for the transmission of high-capacity, as the distance is long, a falling-off in the fade margin from the link budget analysis cause the decrease in the availability. It is difficult to provide QoS guaranteed connection. In this paper, we propose the performance improvement technique of transmission by the variable allocation of the bandwidth and the higher priority transmission technique using setting the ratio of the higher priority capacity in association with the distance of link. Also we suggest the alternative of the calculation for channel transmission capacity to design the circuit.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.1
• /
• pp.788-791
• /
• 2005

In this paper, We propose performance of improvement method for eHDR-WPAN system using Interleaver. Burst error pattern caused by fading in indoor wireless channel. for the reason, using of Interleave method (make burst error to random error) can be enhance to error-rate in system. This paper is used Convolutional, Block, Random Interleaver. We make use of 9 and 27 for symbol spacing. Block-Interleaver is show that performance about 0.6dB of E$_b$/N$_o$ at $10^{-4}$. In result, the suitable Interleaver for eHDR-WPAN system is Block Interleaver of 9 symbol spacing.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.9A
• /
• pp.859-867
• /
• 2010

In this paper, we consider a novel spectrum sensing system in which firstly, the fusion center (FC) senses and makes the own decision then if its sensing result is not useful for achieving the final decision, the local observations from the cognitive users (CUs) will be required. Moreover, in case that FC needs the results from CUs, we will choose only CU having the highest collected energy to send its local decision to FC. Based on this selecting method, the number of sensing bits can be reduced; hence, we can save the power and the bandwidth for reporting stage in the cognitive radio network (CRN). The mathematical analysis of the key metrics of the sensing schemes (probability of detection, false alarm, e.g.) will be investigated and confirmed by the Monte-Carlo simulation results to show the performance enhancement of the proposed schemes.

• The Journal of Information Technology
• /
• v.6 no.2
• /
• pp.1-8
• /
• 2003

This paper is about power line communication(PLC) over the low power voltage grid. The main advantage with power line communication is the use of an existing infrastructure. The PLC channel can be modeled as having multi-path propagation with frequency-selective fading, typical power lines exhibit signal attenuation increasing with length and frequency. OFDM(Orthogonal Frequency Division Multiplexing) is a modulation technique where multiple low data rate carriers are combined by a transmitter to form a composite high data rate transmission. To implement the multiple carrier scheme using a bank of parallel modulators would not be very efficient in analog hardware. Each carrier in an OFDM is a sinusoid with a frequency that is an integer multiple of a base or fundamental sinusoid frequency. Therefore, each carrier is a like a Fourier series component of the composite signal. In fact, it will be shown later that an OFDM signal is created in the frequency domain, and then transformed into the time domain via the Discrete Fourier Transform(DFT).