• Journal of the Institute of Convergence Signal Processing
• /
• 제8권1호
• /
• pp.44-50
• /
• 2007

In this paper generating algorithms of the conventional chaos code sequences and a new chaos code sequence derived from the real and imaginary parts of FFT of one chaos code sequence, and the time-frequency function characteristics of generated code sequences to measure the signal resolution, are considered. And two chaos based QCSK digital communication systems-one with two different chaos code sequences, the other with FFT of one chaos code sequence-are analyzed in AWGN and fading communication channels. After analyzing the correlation functions of such sequences, the delta-like autocorrelation and near zero crosscorrelation functions of them are very suitable for chaos based spread spectrum communication systems, is verified. Through evaluating the performance of two chaos based QCSK systems above using Monte-Carlo simulation, the improvement of performance in the latter QCSK system compare favorably with that of the former system, is shown.

• The Transactions of the Korean Institute of Electrical Engineers
• /
• 제39권4호
• /
• pp.341-348
• /
• 1990

This paper describes an algorithm for evaluating the Loss of Load Probability (LOLP) and calculating the production cost for all the generators in the system using Fast Hartley Transform (FHT). It also suggests the deconvolution procedure which is necessary for the generation expansion planning. The FHT is as fast as or faster than the Fast Fourier Transform (FFT) and serves for all the uses such as spectral, digital processing, and convolution to which the FFT is normally applied. The transformed function using FFT has complex numbers. However, the transformed function using FHT has real numbers and the convolution become quite simple. This method has been applied for the IEEE reliability test system and practical size model system. The test results show the effectiveness of the proposed method.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 한국소음진동공학회 2003년도 춘계학술대회논문집
• /
• pp.408-413
• /
• 2003

The frequency response function(FRF) of each substructure is used for the transfer function synthesis method(TFS). The dynamic characteristics of the full system are obtained by synthesizing FRFs of each substructure. The validation of TFS depends on accuracy for FRF of each substructure. Impact hammer testing Is widely used to obtain the modal characteristics of structures However. the FRF obtained from impact hammer testing contains bias errors, such as finite record length error and leakage error of which characteristic depends on data acquisition time which we call record length. In this paper, a method to remove hose errors is proposed so as to enhance results of TFS. Numerical and experimental examples show that the FRF of full structure can be predicted nearly exactly by the method proposed in this paper.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• 제8권4호
• /
• pp.89-95
• /
• 2008

In the maritime communication, Orthogonal Frequency Division Multiplexing (OFDM) communication terminal should be operated with low power consumption, because the communication should be accomplished in the circumstance of disaster. Therefore, Low power FFT processor is required to be designed with current mode signal processing technique than digital signal processing. Current- to-Voltage Converter (IVC) is a device that converts the output current signal of FFT processor into the voltage signal. In order to lessen the power consumption of OFDM terminal, IVC should be designed with low power design technique and IVC should have wide linear region for avoiding distortion of signal voltage. To design of one-chip of the FFT LSI and IVC, IVC should have a small chip size. In this paper, we proposed the new IVC with wide linear region. We confirmed that the proposed IVC operates linearly within 0.85V to 1.4V as a function of current-mode FFT output range of -100~100[uA]. Designed IVC will contribute to realization of low-power maritime data communication using OFDM system.

• Journal of the Korean Society of Combustion
• /
• 제22권2호
• /
• pp.1-8
• /
• 2017

To evaluate the combustion instability of a gas turbine combustor, the DMD technique was applied. The mode frequency results for each fuel composition were compared with FFT(Fast Fourier Transform) results. The damping coefficient, which is a quantitative parameter for combustion instability, was evaluated for 5 experimental cases. The flame transfer function (FTF) was calculated in the most unstable test case. In deriving the FTF, gain and phase were calculated using DMD technique. As a result of the analysis of the OH radical perturbation of the DMD, the heat release fluctuation was the highest at 100 Hz, at which the highest value of gain is observed. The frequency of FFT and FTF were different. In order to clarify the reason for this, FTF for various resonance frequencies was performed and it shows that the pattern of gain was similar to FFT.

• Journal of Korean Vacuum Science & Technology
• /
• 제3권2호
• /
• pp.107-111
• /
• 1999

We developed the experimental function (ERF) which can be used for the numerical curve fitting analysis in photoelectron spectroscopy (PES). We selected the core-levels of Ag 3d5/2 and Au 4f7/2 to obtain the ERF from the measured core-level spectra. For the numerical fourier transformation we applied the fast transform (FFT) algorithm. we considered optical (Wiener) filtering with the FFT due to noise and used Hann window function to remedy the information leakage in frequency domain due to discrete and finite sampling of measurement. The comparison of the curve fitting results using the ERF obtained in this work and the mathematical response function with a gaussian in the conventional approach shows clearly the improvement of the curve fitting analysis.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 한국추진공학회 2017년도 제48회 춘계학술대회논문집
• /
• pp.59-60
• /
• 2017

Combustion instability of gas turbine is performed by adopting dynamic mode decomposition (DMD). The unstable frequencies are calculated and compared with FFT results. The damping coefficient derived from the DMD technique and FFT results were compared and analyzed. OH radical is measured by experimental work and fluctuation field is extracted and FTF was calculated at various points with DMD. The gains of FTF are changed depending on the extraction position of the heat release fluctuation field.

• Proceedings of the KIEE Conference
• /
• 대한전기학회 1987년도 전기.전자공학 학술대회 논문집(II)
• /
• pp.1485-1487
• /
• 1987

To improve time delay produced in computation of trigonometric function by software method, the function generator was designed to compute the sine function with ROMs. Since the computation speed of trigonometric function can be improved by this ROM, it will be used in various parts required to scientific calculation-radar, FFT and signal processing etc.

• Proceedings of the IEEK Conference
• /
• 대한전자공학회 2000년도 하계종합학술대회 논문집(3)
• /
• pp.161-164
• /
• 2000

We propose the genetic algorithm to apply three kinds of FFT data flows to be considered the overhead for the data exchange between processors that have the multi-scheduling problem on parallel computer In the design of genetic algorithm, we propose the chromosome representation which can simply encode and decode a solution without any heuristic information, the evaluation function to be considered an efficiency of processor, and the genetic operator to inherit a superior gene from their parents. And we saw that the simulation result can verify better performance than the existing algorithm(BEA : binary exchange algorithm)in the face of execution time.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 한국정보통신학회 2022년도 추계학술대회
• /
• pp.526-528
• /
• 2022

In this study, through the capstone design project, an IoT based piano training system was developed after identifying problems in piano learning. The piano training system recognizes sheet music through image processing technology and checks whether the correct keyboard is struck through FFT transformation during piano practicing. By providing a visual effect and score display function using a rhythm game, it was possible to arouse interest in boring piano practice and increase the effect of piano learning.