• Journal of the Korean Ceramic Society
• /
• v.43 no.1 s.284
• /
• pp.48-54
• /
• 2006

Hydroxyapatite $(HAp,\;Ca_{10}(PO_4)_6(OH)_2)$/alumina composites were fabricated with the addition of fluorides, such as $MgF_2$ and $CaF_2$. In this study, the effect of fluorides on the inhibition of phase decomposition and the mechanical properties of HAp was investigated. Due to the higher solubility of F ion in HAp structure, $MgF_2$ additive was more effective compared to $CaF_2$ additive in the lowering decomposition temperature of HAp. Therefore, the dissociation tendency of HAp was fully inhibited below $1400^{\circ}C$. The mechanical properties of HAp composites with $MgF_2$ additive showed higher value (flexural strength: $\~170MPa$, Vickers hardness: $\~7\;GPa$, fracture toughness: $\~1.5\;MPam^{1/2}$) compared to $MgF_2-free$ composites. The linear thermal expansion coefficient of HAp composites with $MgF_2$ showed the value of $16.4\times10^{-6}/^{\circ}C\;at\;20\~400^{\circ}C $.

• Journal of the Korean Ceramic Society
• /
• v.37 no.6
• /
• pp.552-558
• /
• 2000

LiMn2O4 thin fiolm cathodes for Li-ion secondary battery were fabricated by r.f. magnetron sputtering technique. As-deposited films were amorphous. A spinel structure could not be obtained LiMn2O4 films by in-situ thermal annealing. After post thermal annealing over $700^{\circ}C$ in oxygen atmosphere, LiMn2O4 films prepared above 100 W r.f. power could be crystallized into a spinel structure. The electrochemical property of the LiMn2O4 film cathodes was tested in a Li/1 M LiClO4 in PC/LiMn2O4 cell. From cyclic voltammetry at scan rate of 2mV/sec of 2.5~4.5V, LiMn2O4 electrode prepared by post annealing at 75$0^{\circ}C$ showed good initial capacity. LiMn2O4 electrode prepared by post annealing at 80$0^{\circ}C$ showed the best crycling performance.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.17 no.3
• /
• pp.227-235
• /
• 2015

Using eddy covariance method, net ecosystem exchange (NEE) of $CO_2$ ($F_{CO_2}$), $H_2O$ (LE), and sensible heat (H) can be approximated as the sum of eddy flux ($F_c$) and storage flux term ($F_s$). Depending on strength and distribution of sink/source of scalars and magnitude of vertical turbulence mixing, the rates of changes in scalars are different with height. In order to calculate $F_s$ accurately, the differences should be considered using scalar profile measurement. However, most of flux sites for agricultural lands in Asia do not operate profile system and estimate $F_s$ using single-level scalars from eddy covariance system under the assumption that the rates of changes in scalars are constant regardless of the height. In this study, we measured $F_c$ and $F_s$ of $CO_2$, $H_2O$, and air temperature ($T_a$) using eddy covariance and profile system (i.e., the multi-level measurement system in scalars from eddy covariance measurement height to the land surface) at the Chengmicheon farmland site in Korea (CFK) in order to quantify the differences between $F_s$ calculated by single-level measurements ($F_s_{-single}$ i.e., $F_s$ from scalars measured by profile system only at eddy covariance system measurement height) and $F_s$ calculated by profile measurements and verify the errors of NEE caused by $F_s_{-single}$. The rate of change in $CO_2$, $H_2O$, and Ta were varied with height depending on the magnitudes and distribution of sink and source and the stability in the atmospheric boundary layer. Thus, $F_s_{-single}$ underestimated or overestimated $F_s$ (especially 21% underestimation in $F_s$ of $CO_2$ around sunrise and sunset (0430-0800 h and 1630-2000 h)). For $F_{CO_2}$, the errors in $F_s_{-single}$ generated 3% and 2% underestimation of $F_{CO_2}$ during nighttime (2030-0400 h) and around sunrise and sunset, respectively. In the process of nighttime correction and partitioning of $F_{CO_2}$, these differences would cause an underestimation in carbon balance at the rice paddy. In contrast, there were little differences at the errors in LE and H caused by the error in $F_s_{-single}$, irrespective of time.

• Bulletin of the Korean Chemical Society
• /
• v.4 no.1
• /
• pp.10-14
• /
• 1983

Anisotropic rotation of C$_{6}$F$_{6}$ in neat liquid is investigated by the analysis of the ν$_{1}$ and ν$_{15}$ (both C-F stretching) bands of Raman spectrum and diffusion constants for the spinning (D$_{II}$) and tumbling (D$_{⊥}$) motions are obtained by the rotational dffusion theory. The same analysis is also carried out for the ν$_{2}$ and ν$_{16}$ (both C-C stretching) bands and both results are compared with the results obtained for benzene in neat liquid. The results show that the reorientation of C$_{6}$F$_{6}$ is highly anisotropic and the anisotropy is greater for C$_{6}$F$_{6}$ than benzene. This is due to the fact that the spinning rate is about the same but the tumbling rate is sharply reduced for C$_{6}$F$_{6}$.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1998.10a
• /
• pp.507-512
• /
• 1998

An experimental investigation was conducted to examine the behavior of high strength R/C columns subjected to reversed cyclic and axial loads and to find the relationship between amounts of lateral reinforcement and axial loads ratios. The test parameters of column specimens were the compressive strength of concrete($f`_c$=250, 320, 460, $517kg/\textrm{cm}^2), $ the yield strength of longitudinal steel($f_y$=3700, $5254kg/\textrm{cm}^2), $ axial load ratio(0.3, 0.5, 0.6$f`_cA_g$). The results indicated that axial load can significantly affect and alter the behavior of HS R/C column under inelastic cyclic loadings. Also we found that the relationship between amounts of lateral reinforcement and axial load ratios was $\rho$ =(0.37η+0.15)f`/f.

• Smart Media Journal
• /
• v.12 no.7
• /
• pp.27-42
• /
• 2023

The development of cloud services and IoT technology has radically changed the cloud environment, and has evolved into a new concept called fog computing and F2C (fog-to-cloud). However, as heterogeneous cloud/fog layers are integrated, problems of access control and security management for end users and edge devices may occur. In this paper, an F2C-based IoT smart health monitoring system architecture was designed to operate a medical information service that can quickly respond to medical emergencies. In addition, a role-based service access control technology was proposed to enhance the security of user's personal health information and sensor information during service interoperability. Through simulation, it was shown that role-based access control is achieved by sharing role registration and user role token issuance information through blockchain. End users can receive services from the device with the fastest response time, and by performing service access control according to roles, direct access to data can be minimized and security for personal information can be enhanced.

• Journal of the Korean Vacuum Society
• /
• v.7 no.4
• /
• pp.403-409
• /
• 1998

In this study, the effects of multi-dipole type of magnets on the characteristics of the inductively coupled plasmas and $SiO_2$ etch properties were investigated. As the magnets, 4 pairs of permanent magnets were used and, to etch $SiO_2, C_2F_6, CHF_3, C_4F_8, H_2$, and their combinations were used. The characteristics of the magnetized inductively coupled plasmas were investigated using a Langmuir probe and an optical emission spectrometer, and $SiO_2$ etch rates and the etch selectivity over photoresist were measured using a stylus profilometer. The use of multi-dipole magnets increased the uniformity of the ion density over the substrate location even though no significant increase of ion density was observed with the magnets. The use of the magnets also increased the electron temperature and radical densities while reducing the plasma potential. When $SiO_2$ was etched using the fluorocarbon gases, the significant increase of $SiO_2$ etch rates and also the increase of etch uniformity over the substrate were obtained using the magnets. In case of gas combinations with hydrogen, $C_4F_8/H_2$ showed the highest etch rates and etch selectivities over photoresist among the gas combinations with hydrogen used in the experiment. By optimizing process parameters at 1000 Watts of inductive power with the magnets, the highest $SiO_2$ etch rate of 8000 $\AA$/min could be obtained for 50% $C_4F_8/50% H_2$.

• The Korean Journal of Rheology
• /
• v.5 no.2
• /
• pp.161-169
• /
• 1993

Glucomannan(G.M.)은 Amorphophallus Konjac C. Koch의 tuber로부터 분리되었고. 이 G.M.은 다시 침전제로 메탄올을 사용하여 4단계로 분별되었다.(F.1, F.2, F.3, F.4,). 각분 별물에 비하여 직선으로부터 벗어남을 보였다. Low shear viscometer로 G.M. 용액의 viscosity를 측정하였고 농도와 zero shear specific viscosity의 logarithm을 도시한 결과 inflection point를 나타내었다. 이것은 G.M. 분자들의 coil overlap의 시작에서 기인한 것이 고 묽은 용액에서 진한 용액으로의 전이행동은 임계농도. C＊=4/[η]에서 일어났고 이때의 zero shear specific viscosity는 10을 나타내었다. 또한 specific viscosity는 묽은 용액에대해 서는 C14로써 변화하였고 진한 요액에서는 C3.0으로변화하였다. G.M.의 고체상태에 대한 유 전성($\varepsilon$＇,$\varepsilon$＂)과 점탄성(C＇,C＂)계수들을 액체질소 온도에서부터 15$0^{\circ}C$ 온도범위에 걸쳐 4단계로 film을 건조시키면서 10Hz에서 측정하였다. G.M. film의 유전성과 점탄성의 허수부 분은 ($\varepsilon$＂, C＂), -10$0^{\circ}C$에서 peak를 나타내었고 이 peak는 hydroxy methyl 기들의 회전 운동에서 생겨난 것이다. 건조시키지 않은 상태의 G.M. film의 유전성과 점탄성의 허수부분 의 값들은 -5$0^{\circ}C$에서 물 분자의 운동에 의하여 생긴 peak를 보였다.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.16 no.5
• /
• pp.397-403
• /
• 2003

Microwave dielectric properties of (1-x)ZnW $O_4$-xTi $O_2$ ceramic systems were investigated with calcination temperatures and Ti $O_2$ contents. The ZnW $O_4$ ceramic could be suitably sintered at 1075$^{\circ}C$ and showed the dielectric constant of 13.6, quality factor(Q$\times$ $f_{O}$value) of 22,000 and temperature coefficient of resonant frequency($\tau$$_{f}$) of -65$\pm$2ppm/$^{\circ}C$. Increasing the amount of Ti $O_2$ in the range of 0.25 to 0.45 mol, the dielectric constant and $\tau$$_{f}$ increased due to the role of Ti $O_2$ but the quality factor decreased due to the increase of phase boundaries. The 0.7ZnW $O_4$-0.3Ti $O_2$ ceramic showed the dielectric constant of 19.8, qualify factor(Q$\times$ $f_{0}$) of 20,000 and $\tau$$_{f}$ of -3$\pm$1ppm/$^{\circ}C$.>.EX>.>.>.

• Korean Journal of Microbiology
• /
• v.32 no.2
• /
• pp.120-125
• /
• 1994

The genes, trpB, trpA and 3’ trpC(F) of Vibrio metschnikovii strain RH530 were cloned and sequenced. The trpB and trpA genes had open reading frames of 1,173 bp and 804 bp encoding 391 and 268 amino acids, respectively. The trpB and trpA genes had conventional ribosome-binding sequences and overlapped with each other by one nucleotide, suggesting that these two genes are translationally coupled. 115 nucleotide upstream the trpB start codon, tjere was an incomplete open reading frame of the 3’-end of the trpC(F). The amino acid sequences of trpB, trpA and trpC(F) of V. metschnikovii RH530 had identities of 64.2%, 82.4% and 73.7% respectively, for those of V. parahaemolyticus; 58.7%, 72.3% and 54.9%, respectively, for Salmonella typhimurium; and 42.6%. 54.1% and 12.5%, respectively, for brevibacterium lactofermentum. The genetic organization of these genes, especially in the noncoding region between trpC(F) and trpB, was distinct from that of Enterobacteriaceae.