• Polymer(Korea)
• /
• v.33 no.3
• /
• pp.191-197
• /
• 2009

We have investigated the effect of strong p-type organic semiconductor $F_4$-TCNQ-doped CuPc hole transport layer on the performance of p-i-n type bulk heterojunction photovoltaic device with ITO/PEDOT:PSS/CuPc: $F_4$-TCNQ(5 wt%)/CuPc:C60(blending ratio l:l)/C60/BCP/LiF/Al, architecture fabricated via vacuum deposition process, and have evaluated the J-V characteristics, short-circuit current ($J_{sc}$), open-circuit voltage($V_{oc}$), fill factor(FF), and power conversion efficiency(${\eta}_e$) of the device. By doping $F_4$-TCNQ into CuPc hole transport layer, increased absorption intensity in absorption spectra, uniform dispersion of organic molecules in the layer, surface uniformity of the layer, and enhanced injection currents improved the current photovoltaic device with power conversion efficiency(${\eta}_e$) of 0.16%, which is still low value compared to silicone solar cell indicating that many efforts should be made to improve organic photovoltaic devices.

• Journal of the Korean Ceramic Society
• /
• v.37 no.6
• /
• pp.552-558
• /
• 2000

LiMn2O4 thin fiolm cathodes for Li-ion secondary battery were fabricated by r.f. magnetron sputtering technique. As-deposited films were amorphous. A spinel structure could not be obtained LiMn2O4 films by in-situ thermal annealing. After post thermal annealing over $700^{\circ}C$ in oxygen atmosphere, LiMn2O4 films prepared above 100 W r.f. power could be crystallized into a spinel structure. The electrochemical property of the LiMn2O4 film cathodes was tested in a Li/1 M LiClO4 in PC/LiMn2O4 cell. From cyclic voltammetry at scan rate of 2mV/sec of 2.5~4.5V, LiMn2O4 electrode prepared by post annealing at 75$0^{\circ}C$ showed good initial capacity. LiMn2O4 electrode prepared by post annealing at 80$0^{\circ}C$ showed the best crycling performance.

• Proceedings of the KSPS conference
• /
• 2007.05a
• /
• pp.64-66
• /
• 2007

The purpose of this study was to compare and analyze some acoustic parameters of the cochlear implanted children(N=20, aged 3-10) and to suggest a basic data on speech rehabilitaion for the cochlear implanted children. Acoustic analyses of seven Korean monophthongs produced by 4 contexts(V, CV, VC, CVC) were conducted for the cochler implanted children and normal hearing children(N=20, aged 3-10). Subjects were asked to pronounce a list of vowel repeating three times. The results of this study are the same as follows: First, in the case of the cochlear implanted group, there were no significant differences in F1 and F2. Second, in the case of the normal hearing group, there were significant differences in F2 /ㅜ/ between V and CVC, between VC and CVC. Third, there were significant differences in F1, F2 between CI group and normal hearing group.

• Electrical & Electronic Materials
• /
• v.3 no.1
• /
• pp.29-35
• /
• 1990

원통형 및 평판형 유전체에 임펄스전압을 인가하는 경우 나타나는 50%의 Flash over전압 (F.O.V)특성 및 Lichtenberg 도형에 미치는 배후전극의 영향을 관측하였다. F.O.V는 배후전극이 있는 경우가 없을 때보다 인가전압을 저하시킬 수 있었고 Lichtenberg도형에서 방전로의 진전상태는 배후전극의 존재로 인하여 크게 신장함을 알았다.

• Proceedings of the KIEE Conference
• /
• 1991.07a
• /
• pp.131-134
• /
• 1991

In order to determine an operating pattern of SLIM in an experimental MAGLEV vehicle, operating characteristics of SLIM are obtained using a disk type test facility. The test results are compared with the pre-estimated values. It is found that a closed loop control is required for operating at a constant slip-frequency condition which makes the normal force minimum.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.6
• /
• pp.1407-1412
• /
• 2014

In order to improve spectrum sensitivity of photodiode for detection of the laser at 850 nm ~ 1000 nm of near-infrared wavelength band, this study has produced silicon-based fast film PIN photodiode and analyzed electrical and optical properties. The manufactured device is packaged in TO-18 type. The electrical properties of the dark currents both Anode 1 and Anode 2 have valued of approximately 0.055 nA for 5 V reverse bias, while the capacitance showed 19.5 pF at frequency range of 1 kHz and about 19.8 pF at the range of 200 kHz for 0 V. In addition, the rising time of output signal was verified to have fast response time of about 30 ns for 10 V. For the optical properties, the best spectrum sensitivity was 0.66 A/W for 880 nm, while it was relatively excellent value of 0.45 A/W for 1,000 nm.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.48 no.6
• /
• pp.442-450
• /
• 1999

In this paper, we have fabricated Langmuir-Blodgett(LB) films by LB technique and evaluated the deposited status of LB films by UV-vis absorbance. It was found thatthe thickness of LB films per a layer are $27~30[{\AA}]$ by ellipsometry. The responeses between LB films and organic gases were investigated using by I-V characteristics of LB films and F-R diagram of quartz crystal. The response orders between LB films and organic gases observed by I-V characteristics were as following ; chloroform, methanol, acetone and ethanol in the order of their short chain length. The response mechanism between LB films and organic gases observed by F-R diagram of quartz crystal could be modeled on adsorption at surface, penetration, desorption at surface and inside.

• Proceedings of the KIEE Conference
• /
• 2001.07c
• /
• pp.1619-1622
• /
• 2001

Recently many researches on the diagnosis of stator winding insulation for large rotating machines have been developed sine the 1970s. Capacitive coupler has been the most widely used sensor for on-line partial discharge(PD) in rotating machines. The 105 [pF] ceramic coupler(CC) has been developed to continuously measure the PD activity in operating motor stator windings. This paper presents frequency characteristics and laboratory test to compare traditional 80 [pF] epoxy-mica coupler(EMC) and 105 [pF] CC for PD measurement in 6.6 [kV] stator windings.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.11b
• /
• pp.374-377
• /
• 2001

We have synthesized poly(3-hexylthiophene)(P3HT), which is the most famous conducting polymer and studied the optical properties of P3HT. And then fabricated the device using P3HT as an emitting layer. For the improve of hole injection from ITO electrode to P3HT emitting layer, we use transparent polyaniline(PANI) electrode. In the voltage-current-luminance characteristics of ITO/PANI/P3HT/LiF/Al device which use the PANI film synthesised during 5 cycle, the device turn on at the 2V and the luminance of $218nW/cm^{2}$ obtained at 12V. External quantum efficiency of ITO/PANI/P3HT/LiF/Al increased at 8V than that of ITO/P3HT/LiF/Al device.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.11a
• /
• pp.374-377
• /
• 2001

We have synthesized poly(3-hexylthiophene)(P3HT), which is the most famous conducting polymer and studied the optical properties of P3HT. And then fabricated the device using P3HT as an emitting layer. For the improve of hole injection from ITO electrode to P3HT emitting layer, we use transparent polyaniline(PANI) electrode. In the voltage-current-luminance characteristics of ITO/PANI/P3HT/LiF/Al device which use the PANI film synthesised during 5 cycle, the device turn on at the 2V and the luminance of 218 nW/$\textrm{cm}^2$ obtained at 12V. External quantum efficiency of ITO/PANI/P3HT/LiF/Al increased at 8V than that of ITO/P3HT/LiF/Al device.