• 대한환경공학회지
• /
• 제27권8호
• /
• pp.787-798
• /
• 2005

본 연구에서는 폐광산지역에서 발생되는 폐기물인 광미를 대상으로 토양세척공정을 이용하여 다양한 세척용매와 농도, 그리고 추출시간에 따른 중금속의 추출특성을 파악하였다. 세척용매로는 물, HCl(0.1, 0.3, 1.0 N), EDTA(0.01, 0.05, 0.1 M), SDS(0.1, 0.5, 1.0%)를 이용하였다. 그 결과, 물과 SDS 용매에서 Zn과 Cd이 Pb과 Cu보다 높은 추출효율을 보였지만, 전체적으로는 1%이하로 중금속의 추출에 효과적이지 못하였다. 그러나, SDS에서 Pb과 Cu의 추출효율은 추출시간이 길어질수록 증가하였다. HCl과 EDTA를 이용한 중금속의 추출은 물과 SDS보다 빠른 추출경향을 보였고, 대부분의 중금속이 6시간 이내에 추출되었으며 용매의 농도와 무관하였다. 6시간 이후에는 느린 추출경향을 보였지만 세척용매의 농도에 따라 좌우되었다. 또한, 용매의 농도가 증가할수록 추출경향은 빨라졌고, 추출 효율도 증가하였다. 추출효율은 1.0 N HCl에서 Cd>Pb>Zn>Cu로, 0.1M EDTA에서 Pb>Cd>Zn>Cu 순으로 높았다. 농도증가에 따른 추출효과는 HCl에서 Pb이, EDTA에서 Pb과 Cd이 가장 컸으며, 중금속제거를 위한 6시간이상의 추출은 비효과적이었다.

• Korean Chemical Engineering Research
• /
• 제55권4호
• /
• pp.574-577
• /
• 2017

In Indonesia, vetiver oil is one commodity that plays an important role in the country's foreign exchange earnings. Currently, the extraction of essential oil from vetiver still uses conventional methods. Therefore, the aim of this study was to know and verify the kinetics and mechanism of microwave hydrodistillation of vetiver based on two models. In this study, microwave hydrodistillation was used to extract essential oils from vetiver. The extraction was carried out in nine extraction cycles of 20 min to 3 hours. The rate constant, the equilibrium extraction capacity, and the initial extraction rate were calculated using the two models. Kinetics of oil extraction from vetiver by microwave hydrodistillation proved that the extraction process was based on the second-order extraction model. The second-order model was satisfactorily applied, with high coefficients of correlation ($R^2=0.9427$), showing that it well described the process.

• 공업화학
• /
• 제5권1호
• /
• pp.149-159
• /
• 1994

금속의 용매 추출에 amidoxime의 추출제로서의 특성을 검토하기 위하여 benzamidoxime 및 phenylacetamidoxime에 의한 금속 추출평형 및 추출속도에 관한 실험 및 이론적 고찰을 하였다 Cu, Pb, Zn 및 Cd 등 단독 금속계와 혼합 금속계에 대한 amidoxime-클로로포름에 의한 추출에서 추출비와 수소이온 농도 및 추출제 농도간의 상관관계로부터 추출기구와 추출성을 검토하고, 수상측 경막 내 확산 방정식으로부터 도출된 이론적 속도식과 실험적 속도식을 비교함으로써 초기 추출 속도식은 $R_o=k{\overline{C}}_{HRO}(C_{Mo}/C_{Ho})^{1/2}$로 표시할 수 있었으며, 추출과정의 율속 단계를 고찰하였다. amidoxime에 의한 Cu의 추출 화학종은 ${\overline{CuR_2}}$의 형이었다.

• 한국정밀공학회지
• /
• 제22권12호
• /
• pp.170-174
• /
• 2005

A numerical system to extract effective elastic properties of polycrystalline thin-films for MEMS devices is developed. In this system, the statistical model based on lattice system is used for modeling the microstructure evolution simulation and the key kinetics parameters of given micrograph, grain distributions and deposition process can be extracted by inverse method proposed in the system. In this work, effects of kinetics parameters on the extraction of effective elastic properties of polycrystalline thin-films are studied by using statistical method. Effects of the fraction of the potential site($f_p$) among the parameters for deposition process of microstructure on the extraction of effective elastic properties of polycrystalline thin-films are investigated. For this research, polysilicon is applied to this system as the polycrystalline thin-films.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2004년도 추계학술대회 논문집
• /
• pp.50-54
• /
• 2004

A numerical system to extract effective elastic properties of polycrystalline thin-films for MEMS devices is already developed. In this system, the statistical model based on lattice system is used for modeling the microstructure evolution simulation and the key kinetics parameters of given micrograph, grain distributions and deposition process can be extracted by inverse method proposed in the system. In this work, the effects of kinetics parameters on the extraction of effective elastic properties of polycrystalline thin-films are studied by using statistical method. The effects of the fraction of the potential site( $f_{P}$ ) and the nucleation probability( $P_{N}$ ) among the parameters for deposition process of microstructure on the extraction of effective elastic properties of polycrystalline thin-films are studied.d.d.

• Membrane and Water Treatment
• /
• 제7권6호
• /
• pp.521-537
• /
• 2016

Laboratory-scale experiments were carried out to investigate the adsorption equilibrium, the adsorption kinetics and facilitated transport of two cationic dyes (Methylene Blue (MB) and Rhodamine B (RB)) on Polymer Inclusion Membrane (D2EHPA-PIM). Different adsorption isotherms (Freundlich, Langmuir and Temkin models) as well as kinetics models indicated that the adsorption process is spontaneous and exothermic. Under the optimal conditions, the adsorption removal efficiencies reach about 93% and 97% for MB and RB respectively. Different extraction values by D2EHPA-PIM were obtained for the two cationic dyes: MB is weakly extracted at pH 2.0 (E% = 18.7%) whilst E% = 82.4% was observed for RB at the same pH. This difference was exploited in a mixture containg both the 2 cationic dyes for the selective extraction of RB at pH 2. Desorption of both dyes was achieved from the membrane by using acidic aqueous solutions and desorption ratio up to 90% was obtained. The formulas of the extracted complexes by the PIMs were, determined by the method of slopes. The dyes transport was elucidated using mass transfer analysis where in it found relatively high values of the initial flux ($J_0$) as 41.57 and $18.74{\mu}mol.m^2.s^{-1}$ for MB and RB respectively.

• 한국환경과학회지
• /
• 제20권10호
• /
• pp.1265-1272
• /
• 2011

In this study, the extraction characteristics of soluble solid from Rumex crispus(Curled dock) was studied from the investigation of the effects of experimental conditions on extraction rate; extraction ratio, composition of extractants, extraction time and pH of extractant, etc. The proximate composition of Rumex crispus was 2.58% crude lipid, 5.59% crude protein, 7.39% crude ash, 6.13% moisture and 78.31% carbohydrate, respectively. Turbidity of extract by distilled water was higher and increased with extraction time and extraction temperature, where as the turbidity didn't increase by ethanol and methanol in 20 folds of extraction ratio. Turbidity was inversely proportional to the extraction ratio for the three extractants at 25$^{\circ}C$ and 1 hour extraction. But turbidity of extract was highest by composition of 50% methanol-water extractant than any other compositions of extractants. Eighteen and fifteen free aminoacids were detected in extracts with distilled water, methanol and ethanol extractant, respectively, and it's contents were order of glutamic acid>proline>aminobutyric acid>alanine. The extraction rate of soluble solid from Rumex crispus was order of distilled water>methanol>ethanol within experimental extraction ratio. In extraction with distilled water, the contents of soluble solid was inversely proportional to the pH of extractant.

• Journal of Industrial and Engineering Chemistry
• /
• 제67권
• /
• pp.109-122
• /
• 2018

This work highlights extraction and removal of Lignosulfonate using sunflower oil-Tri-n-octylamine (TOA) system in bulk liquid membrane transport. Maximum extraction and recovery percentages of 92.4% and 75.2% were achieved. Optimum manifold operating conditions were: 4 vol.% TOA, $2{\pm}0.1$ feed phase pH, 300 rpm stirring speed, at $40^{\circ}C$ with 0.2 (M) $Na_2SO_4$ solution. 1:2 (organic/aqueous) and 1:1 (aqueous/aqueous) phase ratios produced best results. Extraction (36.85 kJ/mol) was found to be intermediate controlled and stripping (54.79 kJ/mol) was chemical reaction controlled. Kinetic estimation of data with higher rate constants for stripping vis-${\grave{a}}$-vis extraction showed latter to be rate determining.

• Preventive Nutrition and Food Science
• /
• 제12권3호
• /
• pp.131-134
• /
• 2007

The kinetic analyses for thermal products of alpha-, gamma- and delta-tocopherols during heating as functions of temperature and time were studied. Alpha-, gamma- and delta-tocopherols dissolved in glycerol were heated at $100{\sim}200^{\circ}C$ for $5{\sim}60$ min. The thermal products were separated by hexane extraction and analyzed by HPLC using a reversed phase ${\mu}-Bondapak$ $C_{18}-column$ with two kinds of elution solvents in a gradient mode. The formation kinetics of thermal products of tocopherols followed a first-order kinetic model. The formation rate of thermal products of tocopherols was dependent on heating temperatures and heating times. The activation energy and enthalpy for the thermal products of ${\gamma}-and$ ${\delta}-tocopherols$ were higher than those for ${\alpha}-tocopherol$ as in the case of the oxidative degradation kinetics of tocopherol. The magnitude order of the activation energy was ${\gamma}->{\delta}->{\alpha}-tocopherol$.

• Nuclear Engineering and Technology
• /
• 제53권4호
• /
• pp.1218-1223
• /
• 2021

A hydrophobic ionic liquid including an amino moiety ([DiOcAPmim][NTf₂]) was synthesized. Its extraction behaviors towards Pd(II), Ru(III), Rh(III) were investigated in nitric acid aqueous solution as a function of contact time, effect of concentration of nitric acid, effect of temperature, and effect of co-existing metal ions. The extraction kinetics of Pd(II) was fairly fast and extraction equilibrium can be attained within only 5 min under the [HNO₃] = 2.05 M. When [HNO₃]< 1 M, the extraction percentage of Pd(II), Ru(III), Rh(III) were all above 80%. When [HNO₃] reached 2 M, all of the extraction percentage decreased and in an order of Pd(II)>Ru(III)>Rh(III). When [HNO₃]> 2 M, the extraction performance gradually recovered. The effect of temperature can slightly affect the extraction performance of Pd(II). Furthermore, in simulated high-level liquid waste, [DiOcAPmim][NTf₂] showed a better preference towards Pd(II) under the interference of various other co-existing metal ions.