• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2013년도 춘계학술대회 논문집
• /
• pp.425-431
• /
• 2013

Nowadays, high speed train has settled down as a fast and convenient environment-friendly transportation and it's need is gradually increasing. However increased train speed leads to increased aerodynamic noise, which causes critically affects comfortability of passengers. Especially, the pantograph of high speed train is protruded out of train body, which is the main factor for increased aerodynamic noise. Since aerodynamic noise caused pantograph should be measured in high speed, it is difficult to measure it and to analysis aerodynamic noise characteristics due to the various types of pantograph. In this research, aerodynamic noise of pantograph is predicted by CFD (Computational Fluid Dynamic) and FW-H (Ffowcs Williams-Hawkings) equation. Also, Wind tunnel test results and numerical simulation results were compared. As a result, Simulation results predicting sound pressure level is very similar with wind tunnel test result. To analyze contribution of the pantograph to the noise of high-speed train, simulation results compared with measurement results of exterior noise. The simulation reuslts found that pantograph is a dominant noise source of high-speed trains's exterior noise in low frequency section. This dominant noise was come out from vortex shedding of the panhead in the pantograph. This research will be utilized for reduce sound pressure level of pantograph.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2002년도 추계학술대회논문초록집
• /
• pp.335.2-335
• /
• 2002

Non-singular boundary element method (BEM) codes are developed in acoustics application. The BEM code is then used to calculate unknown boundary surface normal displacements and surface pressures from known exterior near field pressures. And then the calculated surface normal displacements and surface pressures are again applied to the BEM in forward in order to calculate reconstructed field pressures. (omitted)

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2007년도 추계학술대회논문집
• /
• pp.303-310
• /
• 2007

The vehicle noise is classified into interior and radiated exterior noise. And it influences on consumer‘s vehicle decision and traffic noise environment very much. In case of the vehicle exterior noise, it is related with traffic noise and in case of the interior noise, it is related with driver’s and passenger‘s sensitivity quality. Because these influenced on drivers and traffic environment, so standards are restricted by the laws and regulated for the measurement. But, the existence standards measuring the only sound pressure level are limit to reflect consumer’s sensitive aspects. Therefore in this study, the recent standards and laws were searched about domestic and abroad papers and the testing mode for the sound quality (SQ) evaluation was constructed about the vehicle interior noise. Finally, we aimed at the standard establishment to evaluate the vehicle interior SQ using statistics method.

• 한국소음진동공학회논문집
• /
• 제17권12호
• /
• pp.1230-1237
• /
• 2007

The vehicle noise is classified into interior and radiated exterior noise. And it influences on consumer's vehicle decision and traffic noise environment very much. In case of the vehicle exterior noise, it is related with traffic noise and in case of the interior noise, it is related with driver's and passenger's sensitivity quality. Because these influenced on drivers and traffic environment, so standards are restricted by the laws and regulated for the measurement. But, the existence standards measuring the only sound pressure level are limit to reflect consumer's sensitive aspects. Therefore in this study, the recent standards and laws were searched about domestic and abroad papers and the testing mode for the sound quality(SQ) evaluation was constructed about the vehicle interior noise. Finally, we aimed at the standard establishment to evaluate the vehicle interior SQ using statistics method.

• 한국철도학회논문집
• /
• 제10권6호
• /
• pp.786-791
• /
• 2007

고속열차의 속도가 300km/h 이상이 되면 난류의 박리나 와류발산 등에 의한 공력소음의 영향이 지배적이 된다. 본 연구에서는 KTX와 한국형고속열차의 외부에서 발생하는 공력소음, 특히 차간 공간에서 발생하는 소음의 특성을 시험을 통해 규명한다. 차량 실내외의 소음 측정을 통해 이 소음의 특성을 분석하였고, 풍동시험을 통해 머드플랩 사이의 틈의 크기가 저주파 소음 발생에 직접적인 영향을 준다는 것을 규명하였다. 또한 마이크로폰어에이 시험으로 고속열차의 외부에서 발생하는 소음의 주파수 특성을 분석하였다.

• 한국자동차공학회논문집
• /
• 제8권5호
• /
• pp.129-137
• /
• 2000

The powertrain is an important factor for the interior and exterior noise behavior of the vehicle Thus, the noise vibration and harshness(NVH) behavior of an engine is becoming a major target of the powertrain development. This paper describes the analyses with the aim to reduce the vibration and noise of an advanced inline 4-cylinder diesel engine block by use of CAE methods. The characteristics of an engine block as a main excitation source of car interior noise is studied. Particularly, The effect of balance shaft to reduce the 2nd order engine excitation force is calculated by forced vibration and radiated noise analysis. The engine exitation forces are obtained under real operating conditions. It is shown that the reduction of vibration and noise level by adapting blancing shaft is well predicted and rediated noise is directly related to the surface velocity of engine block.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2013년도 추계학술대회 논문집
• /
• pp.430-431
• /
• 2013

• 한국소음진동공학회논문집
• /
• 제26권7호
• /
• pp.765-773
• /
• 2016

The vehicle interior noise caused by exterior fluid flow field is one of critical issues for product developers in a design stage. Especially, turbulence and vortex flow around A-pillar and side mirror affect vehicle interior noise through a side window. The reliable numerical prediction of the noise in a vehicle cabin due to exterior flow requires distinguishing between the aerodynamic (incompressible) and the acoustic (compressible) surface pressures as well as accurate computation of surface pressure due to this flow, since the transmission characteristics of incompressible and compressible pressure waves are quite different from each other. In this paper, effective signal processing technique is proposed to separate them. First, the exterior flow field is computed by applying computational aeroacoustics techniques based on the Lattice Boltzmann method. Then, the wavenumber-frequency analysis is performed for the time-space pressure signals in order to characterize pressure fluctuations on the surface of a vehicle side window. The wavenumber-frequency diagrams of the power spectral density shows clearly two distinct regions corresponding to the hydrodynamic and the acoustic components of the surface pressure fluctuations. Lastly, decomposition of surface pressure fluctuation into incompressible and compressible ones is successfully accomplished by taking the inverse Fourier transform on the wavenumber-frequency diagrams.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2008년도 추계학술대회논문집
• /
• pp.535-536
• /
• 2008

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 1999년도 추계학술대회 논문집
• /
• pp.487-494
• /
• 1999

The object of this study is to reduce the subway noise by the low noise wheel. The vibro-acoustic reduction was predicted from the FRF difference between low noise wheel and solid wheel by experimental modal analysis. The low noise wheel and solid wheel were compared in viewpoint of car interior/exterior noise. The effect of low noise wheel on the noise of subway train of 6 vehicles was obtained. But, the application of low noise wheel must be reviewed in some aspect.