• 한국터널지하공간학회 논문집
• /
• 제11권1호
• /
• pp.1-9
• /
• 2009

절리암반에시 기존 터널에 근접하여 사면굴착시 터널의 거동은 절기와 굴착사면상태의 영향을 받는다. 본 논문에서는 기존터널에 근접하여 지반을 굴착시, 절리각도와 굴착사면 경사의 영향을 파악하기 위하여 2축 실대형 모형시험장치(3.1 m*3.1 m*0.50 m(폭*높이*길이))를 이용한 시험을 수행하였다. 절리암반은 콘크리트 블록을 사용하여 모사하였으며 터널은 1/10축척(직경 0.6 m)으로 제작하였다. 절리각도는 $0^{\circ}$부터 $90^{\circ}$까지 변경이 가능하며, 굴착사면 경사는 $30^{\circ}$에서부처 $90^{\circ}$까지 가능하도록 되어 있다. 실대형 시험을 통하여 절리각도와 사면경사에 따른 터널거동과 수평지중변위를 계측, 분석하였다. 분석결과 절기각도와 사면경사가 크면 클수록, 터널 내공변위와 터널 라이닝 모멘트가 커지는 경향이 있었으며 수평지중변위 또한 절리각도와 사면경사에 많은 영향을 받고 있어 향후 사면보강에 있어 효율적 방안제시를 위한 기초자료로 활용이 가능할 것이다.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 1994년도 가을 학술발표회 논문집
• /
• pp.225-230
• /
• 1994

This paper concerns a case study on the design concept, analysis, construction methodology of a subway tunnel excavated in the soft ground beneath an existing building where the distance between the bottom of the building and the crown of the tunnel is separated by about 3 meters only. The silot tunnels are excavated in advance, and side reinforced-concrete walls are installed. Then, main tunnels are excavated with ring cut method. The steel ribs are installed and supported by the side walls made in advance. Between the steel ribs and the side walls, the screw jack is installed to apply prestressing so that settlement can be controlled at minimum. Various in-situ seasurements are made and compared with computed values obtained by numerical methods. By choosing this underpinning method with very caraful construction control, tunnelling projects could be finished successfully without having any damage to the building located very closely to the tunnel crown.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2011년도 정기총회 및 추계학술대회 논문집
• /
• pp.2389-2392
• /
• 2011

To construct a tunnel to the bottom of the existing tunnels by the behavior of the tunnel to examine the scope and effect, Schubert (1995) Influence Line and Trend Line to the proposed concept was introduced. Crossing angle of the existing tunnels and new tunnels 15, 30, 60, and 90 were set, the lower ground after 3-grade fixed above the ground was graded a 3-grade and 5-grade. Interpreted as a result of these conditions, the tunnel diameter 10m (D) If the crossing angle of around 90 degrees, 60 degrees, 30 degrees or less, each 3.0D, 3.5D, 4.0D, respectively, in the range of the effect could be estimated.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2000년도 가을 학술발표회 논문집
• /
• pp.485-492
• /
• 2000

Current design practice for the prediction of tunnelling-induced ground movements depends on empirical methods, which are based on many assumptions and simplification of the modeling. Some discrepancies between the predictions and the measurements of ground movements regarding adjacent structures are inevitable. In order to investigate tunnel-induced ground movements affect on the settlement of existing structures as well as existing structures affect tunnel-induced ground movement, 2-D elasto-plastic finite element analysis are performed. The following influencing factors such as load of the structures, the width of structures, its bending and axial stiffness, its position relative to the tunnel are considered in the numerical analysis.

• 한국터널지하공간학회 논문집
• /
• 제7권2호
• /
• pp.133-141
• /
• 2005

저토피 구간에서 기존터널 하부에 새로운 터널을 교차하여 신설할 때에 하부 터널굴착으로 인하여 발생하는 교차부 주변지반의 거동을 대형모형실험과 수치해석을 통하여 연구하였다. 모형실험결과 교차 전 후의 하부터널 굴착에 따른 종방향 응력전이가 상부터널에 의하여 차단됨을 알 수 있었다. 수치해석결과에 의하면 측압계수 K = 0.38인 경우에 응력그림자 현상으로 단일터널 천단부에서의 최소주응력 감소는 상하교차터널의 천단에서보다 크게 발생한다. 직각교차터널에서는 기존상부터널의 영향으로 응력그림자 현상이 나타나 단일터널에 비하여 작은 응력감소를 보인다.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2004년도 춘계학술대회 논문집
• /
• pp.1007-1013
• /
• 2004

A three-arch NATM tunnel with a total length of 53.5m has been constructed for a metropolitan subway station in Daejon, Korea. The tunnel, whose crown is located 22m below the ground, crosses the old Daejon station underneath. Since the tunnel comprises a very large section (10${\times}$28 m; largest in Korea), it shows complicated mechanical behaviors, especially near portal, due to its short length relative to width. As far as its construction step is concerned, the center tunnel is excavated with pre-excavated pilot tunnel, which is a unique feature of this tunnel (first in Korea) to secure safety during construction and prevent excessive settlements. The both side tunnels are then excavated along with the center tunnel. Since significant amount of settlement was predictable from the design stage, extensive monitoring was performed during construction. During excavation of the side tunnels, unexpected large settlements up to ${\~}$140mm (estimated 41.8 mm at design stage) was measured at the center tunnel. In this paper, we study the causes of this unusually large ground settlement. We believe that the extra-wide tunnel excavation increases the stress influence zone of portal in longitudinal direction and consequently add more settlements to the existing due to excavation and consolidation.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2000년도 추계학술대회 논문집
• /
• pp.628-635
• /
• 2000

The catenary system supported by the tunnel bracket which has been used uniquely in KNR was selected as the catenary inside narrow existing tunnel in the electrification of Kyeung-Bu Line for operation of Korea High Speed Train(KTX). It was demanded to judge the maximal operable speed of KTX in this catenary system to implement the planning. To do this, the tunnel bracket was firstly tested to obtain the characteristic data. The stiffness of this bracket are computed depending on the location which catenary installed on. Moreover, the catenary using tunnel bracket is modelled numerically respecting the bracket stiffness. Based on these, the dynamics between this catenary and KTX pantograph are simulated with the program developed by ourselves independently. The simulation result are evaluated according to the generally acceptable criteria. Consequently, the maximal operable speed of KTX in the catenary using KNR(Korean National Railroad) tunnel bracket is predicted and some items which are needed to be kept in the processing of implementation are drawn.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2007년도 춘계학술대회 논문집
• /
• pp.1080-1084
• /
• 2007

Recently, as demands of new railway and the relocation of existing line, a number of tunnel structures have been constructed. Tunnel structures contribute to minimize the cost and time of transport, but in case of railway fire accident bring serious damages of human life caused by narrowness of shelter, smoke and high temperature, difficulty in rescue. For that reason, at the beginning of plan of tunnel, the optimum design of safety facility in tunnel for minimizing the risks and satisfying the safety standard is needed. In this study, QRA(Quantitative Risk Analysis) technique is applied to design of railway tunnel for assuring the safety function and estimating the risk of safety. The case study is carried out to verify the QRA technique for railway tunnels in Iksan-Sili.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2011년 춘계학술대회논문집
• /
• pp.523-528
• /
• 2011

Subway becomes more and more main transportation in major cities. Air pollution in the subway platforms is decreased; however, dust flow inside subway tunnel and train is increased by installing Platform Screen Door. Airflow inside subway tunnel is observed using computational method in this study The airflow characteristics around ventilation shafts and inside the tunnel is studied following the train movement, while the train moves from existing Miasamgeori station to Gireum station ANSYS CFX V12.0.l and ICEM CFD V12.0.l are used to compute the airflow inside the subway tunnel.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2006년도 추계 학술발표회
• /
• pp.179-190
• /
• 2006

The water supply tunnel has different characteristics which play a important role in stable water supply to the public from mechanical behavior and maintenance in comparison with road md railway tunnel. In this study, the present state and characteristics of water supply tunnels controlled by K-water have been investigated. The distribution of effective stresses that takes into account the effect of seepage forces induced by internal water pressure are estimated from closed-form and numerical method. The analysis of stress-strain behavior, seepage problem and hydrojacking for ensuring safety of existing water supply tunnel against neighboring new construction has been conducted.