• 한국환경과학회지
• /
• 제5권5호
• /
• pp.569-577
• /
• 1996

과잉수소 반응조건하에서 사염화탄소의 열적 안정성과 수첨탈염소화 과정을 고찰하기 위한 모델로써 Cl/H의 비가 다른 순수 염화메탄화합물인 메틸염소, 메틸렌염소, 클로로포름과 사염화탄소를 이용하였다. 반응시간 1초에서 99% 분해되는 온도를 기준으로한 열적 안정성은 메틸염소는 $875^{\circ}C,$ 메틸렌염소는 $780^{\circ}C,$ 클로로포름은 $675^{\circ}C,$ 사염화탄소는 $635^{\circ}C$ 이었으며, 낮은 반응온도영역에서는 클로로포름의 열적 안정성이 사염화탄소보다 낮았으나 온도가 증가함에 따라 사염화탄소의 분해가 증가하여 $570^{\circ}C$ 이상에서는 클로로포름보다 쉽게 분해되었다. 사염화탄소의 분해 반응계에서의 생성물 고찰결과, 반응온도가 증가함에 따라 염화탄화수소 화합물 계열 생성물의 농도와 염화정도가 감소하였다. 과잉수소 반응조건에서 사염화탄소 열분해 실험결과, $850^{\circ}C$ 이상에서는 탈염소화 탄화수소화합물인 메탄, 에틸렌, 에탄의 생성물의 농도가 증가하였으며 염소화 합물로는 메틸염소만이 소량 검출되었다. 이는 염화정도가 낮은 화합물일수록 열적 안정성이 크다는 것을 의미하며 CCl4/H2 반응계에서 염화탄소화합물중 메틸염소가 열적 안정성이 가장 큰 화합물이었다.

• 대한환경공학회지
• /
• 제29권3호
• /
• pp.304-310
• /
• 2007

본 연구는 초단파조사 처리된 잉여슬러지를 하수와 함께 활성슬러지공법으로 처리할 때 하수처리효율과 잉여슬러지 발생량에 미치는 영향을 파악하기 위하여 실시되었다. 온도가 $20^{\circ}C$이고 MLSS농도가 약 2,000 mg/L인 250 mL의 잉여슬러지를 발진주파수가 2,450 MHz이고 정격고주파출력이 700 W인 전자렌지(microwave oven)로 초단파조사 처리한 결과 조사시간이 1분 증가함에 따라 수온이 약 $20^{\circ}C$씩 증가하였으며, 슬러지의 SCOD, TKN 및 T-P 농도는 모두 $40\sim130$ sec의 조사시간에서 가장 많이 증가하였다. 그리고 혼합액 미생물의 산소섭취율을 측정한 결과 130 sec 이상의 조사시간($65^{\circ}C$ 이상)에서는 혼합액의 미생물이 거의 사멸하는 것으로 나타났다. 잉여슬러지를 초단파조사 처리한 다음 하수와 혼합시켜 활성슬러지공법으로 처리하였을 때 유입수 및 처리수의 pH 및 알칼리도에는 거의 영향이 없었으나, 유입수의 SS, COD, T-N 및 T-P 농도는 증가하였으며, 처리수의 SS, BOD 및 T-P 농도는 거의 영향을 받지 않았으나 COD 및 TKN 농도는 증가하였다. 그리고 초단파 조사비가 1 g SS/g SS-day 증가할수록 미생물성장계수 값은 0.91 g SS/g COD removed의 율로 감소하였다.

• 한국자동차공학회논문집
• /
• 제12권2호
• /
• pp.9-16
• /
• 2004

Close-coupled catalyst (CCC) can reduce the engine cold-start emissions by utilizing the energy in the exhaust gas. However, in case the engine is operated at high engine speed and load condition, the catalytic converter may be damaged and eventually deactivated by thermal aging. Excess fuel is sometimes supplied intentionally to lower the exhaust gas temperature avoiding the thermal aging. This sacrifices the fuel economy and exhaust emissions. This paper describes the results of an exhaust heat exchanger to lower the exhaust gas temperature mainly under high load conditions. The heat exchanger was installed between the exhaust manifold and the inlet of close-coupled catalytic converter. The exhaust heat exchanger successfully decreased the exhaust gas temperature, which eliminated the requirement of fuel enrichment under high load conditions. However, the cooling of the exhaust gas through the heat exchanger may cause the deterioration of exhaust emissions at cold start due to the increment of catalyst light-off time.

• 산업기술연구
• /
• 제20권A호
• /
• pp.279-283
• /
• 2000

Lime is one of the world's most useful chemicals and manufactured in various types of kilns, using various fuels. Quicklimes vary in reactivity with water due to variations in the time and temperature calcining process and type of kiln used. Careful attention and control of time and temperature in the calcining process is necessary to insure a highly reactive lime. Excess time and temperature will cause the lime to be over burned. The highest reactivity of quicklime is obtained by calcination of limestone in the particle size of 0.1cm~2cm, calcination temperature of $1000^{\circ}C$, calcination time 90min. It was found by the scanning electron microscopes that pores of quick lime is reducted if the soft burned quick lime is heated continually.

• 한국세라믹학회지
• /
• 제19권3호
• /
• pp.205-214
• /
• 1982

The method of lowering the sintering temperature and enlarging the range of sintering temperature in the manufacture of forsterite porcelain as a high frequency insulator was investigated. The four kinds of forsterite chamotte were calcinated at $1400^{\circ}C$. The forsterite bodies produced by adding $BaCO_3$ as a flux and 5% Kaolin as a bonding agent were heated in the range of sintering temperature. Sintering temperature tended to increase almost straightly as MgO exceded without $BaCO_3$. The range of sintering tem was at least $140^{\circ}C$. Specimens of MF-2-0, MF-2-A had superior mechanical strength and dielectric properties. The growing of the forsterite crystal was restricted and thus their grain size became fine and also the amount of crystal formation tended to decrease rapidly as $BaCO_3$ increased excessively.

• 한국세라믹학회지
• /
• 제30권8호
• /
• pp.671-677
• /
• 1993

Effects of PbTiO3 addition on dielectric properties and extent of PbO loss in Nd-doped Pb(Mg1/3Nb2/3)O3 system were investigated. As the proportion of dopping increased, the phase transition temperature shifted to low region, and the dielectric constant at room temperature decreased rapidly. But as the proportion of PbTiO3 increased, the phase transition temperature shifted to high retion, and the dielectric constant at room temperature increased. The substitution of Nd3+ for Pb2+ decreased the amount of PbO evaporation, therefore the sample sintered well in case of only 1 mole% adding excess PbO.

• 한국세라믹학회지
• /
• 제17권2호
• /
• pp.89-95
• /
• 1980

The effect of non-stoichimetry and sintering temperature on the magnetic properties of materials in the system $Ni_{0.39}Zn_{0.61}Fe_{2.0+x}O_4$ have been investigated. The value of x used in initial weighing of oxides were varied from -0.04 to -0.12. The value of x, however, appears to be from +0.04 to -0.04 after ferrite powder preparation due to iron pick up during ball mill mixing and grinding. The densities of specimens which were deficientinrion were higher than those with excess ion. Specimens with near stoichiometric composition showed maximum initial permeability an dminimum coercivity whereas high values of quality factor (Q) were observed in iron deficient specimens. The quality factor decreased monotonically with increasing sintering temperature, but the permeability showed maxima with increasing sintering temperature. Thus highest value of figure of merit $\mu$Q was obtained in composition $Ni_{0.39}Zn_{0.61}Fe_{1.98O4}$ sintered at 100$0^{\circ}C$ for 3 hrs. in an air atmosphere.

• Transactions on Electrical and Electronic Materials
• /
• 제8권4호
• /
• pp.153-156
• /
• 2007

Structural and electrical properties of the fully crystallized-bismuth magnesium niobate ($Bi_2Mg_{2/3}Nb_{4/3}O_7$, BMN) films with 15 mol% excess bismuth deposited on Pt bottom electrode by pulsed laser deposition are characterized for various deposition temperatures. The BMN films were crystallized with a monoclinic structure from $300^{\circ}C$ and the surface roughness slightly decreases with increasing deposition temperature. The capacitance density of the films increases with increasing deposition temperature and especially, films deposited at $400^{\circ}C$ exhibit a capacitance density of approximately $620nF/cm^2$. The crystallized BMN films with approximately 170 nm thickness exhibit breakdown strength above 600 kV/cm (${\leq}10V$) irrespective of deposition temperature and a leakage current density of approximately $2{\times}10^{-8}A/cm^2$ at 590kV/cm (at 10 V).

• Nuclear Engineering and Technology
• /
• 제54권8호
• /
• pp.3106-3116
• /
• 2022

The present work presents analysis results of the core design optimizations for an annular, prismatic High Temperature Gas-cooled Reactor (HTGR) with passive decay-heat removal features. Its thermal power is 100 MW_t and the operating temperature is 850 ℃ (1123 K). The neutronic calculations are done for the core with heterogeneous distribution of fuel and burnable poison particles (BPPs) to flatten the reactivity swing and power peaking factor (PPF) during the reactor operation as well as for control rod (CR) insertion into the core to restrain a small excess reactivity less than 1$. The next step of the study is done for evaluation of core reactivity coefficient of temperature.

• The Korean Journal of Physiology
• /
• 제21권1호
• /
• pp.1-12
• /
• 1987

There is evidence that the effect of extracellular $Ca^{2+}$ on heart rate is temperature-dependent: at $38^{\circ}C$ excess $Ca^{2+}$ induces positive chronotropic response, whereas at $30^{\circ}C$ there is no significant chronotropic effect of $Ca^{2+}$. The cause of this temperature-dependency, however, remains still unclear. Therefore, this study was undertaken to investigate the chronotropic effect of external $Ca^{2+}$ at different temperature in the isolated rabbit atria and in the small strips of SA node cut perpendicularly to crista terminalis. In the isolated atria, the $Ca^{2+}$ effect was temperature-dependent: at $35^{\circ}C$ excess $Ca^{2+}$ evoked positive chronotropic response, while at $30^{\circ}C$ there was no significant changes in sinus rate. On the contrary, in the small SA strips external $Ca^{2+}$ induced negative chronotropic effect. At $35^{\circ}C$ changes in $Ca^{2+}$ concentration from 2 to 4, 6, and 10 mM decreased the sinus rate by $2.7{\pm}1.6%$, $11.2{\pm}3.7%$ and $23.2{\pm}8.1%$ respectively. Lowering the temperature to $30^{\circ}C$, the negative chronotropic effect of $Ca^{2+}$ became greater. With intracellular microelectrodes transmembrane potential was recorded in the small SA strips at $30^{\circ}C$, $35^{\circ}C$ and $38^{\circ}C$. As temperature increased from 30 to $38^{\circ}C$, sinus rate was accelerated by $13/min/^{\circ}C$, $APD_{50}$(action ptential duration from peak to 50% repolarization) decreased by $5\;msec/^{\circ}C$, and amplitude of action potential was slightly decreased. With an increase in $Ca^{2+}$ concentrations from 0.5 to 6 mM, overshoot increased and MDP decreased. These $Ca^{2+}$ effects on the overshoot and MDP of action potentials were not altered by temperature. But the $Ca^{2+}$ effects on the rates of diastolic depolarization, systolic depolarization and repolarization were modified by temperature. Discrpancy of the chronotropic effects of $Ca^{2+}$ between isolated atria and small SA strips was discussed.