• 한국지반공학회논문집
• /
• 제16권1호
• /
• pp.191-201
• /
• 2000

본 연구에서는 굴착부지가 넓고 지하수위가 높은 점성토지반에 얕은 굴착시 종래에 널리 적용되었던 강널말뚝 흙막이공 대신 줄말뚝을 이용한 흙막이공을 제안하였다. 줄말뚝을 이용한 흙막이 구조물의 거동을 관찰하기 위하여 지하굴착기간 동안 경사계 및 지하수위계를 설치하여 말뚝과 지반의 수평변위와 지하수위 변화를 조사하였다. 현장계측결과 말뚝과 지반의 변형거동은 굴착면 기울기, 말뚝두부구속조건, 말뚝설치간격, 굴착지반의 안정수 등의 요소에 영향을 받는 것으로 나타났다. 그리고 줄말뚝을 이용한 흙막이공의 시공성과 안정성뿐만 아니라 근접시공의 문제점이 없는 연약지반에서는 강널말뚝 흙막이공보다 경제적인 공법임을 확인하였다.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2001년도 봄 학술발표회 논문집
• /
• pp.105-112
• /
• 2001

The purpose of this study is to assess the stability of tunnel for a high speed railway crossing the fault zone. The area where the tunnel crossed the fault zone can be unstable during construction and operation. Geotechnical investigations have been conducted to determine an optimum excavation method by obtaining the material properties around the fault zone and to check the stability of the tunnel. For the numerical analysis, the FLAC, numerical analysis code based on finite difference method, was utilized to analyze the behavior of the fault at three points having typical ground conditions. Based on the results of numerical analysis, the combinations of compaction grouting and LW grouting were determined as suitable methods for pre-excavation Improvement of the ground surrounding the tunnel opening. In conclusion, the stability of the tunnel construction for the high speed railway within the fault zone may be obtained by adopting the optimum excavation method and the reinforcement method. The numerical analysis based on FLAC program contains errors caused by assumptions used in numerical analysis, therefore constant monitoring with respect to the change of ground condition and groundwater is highly recommended to minimize the numerical error and the possibility of damage to tunnel.

• 터널과지하공간
• /
• 제6권4호
• /
• pp.326-334
• /
• 1996

In underground construction the multi-step excavation sequence is commonly adopted for the convenience of the underground work. A numerical simulation method which is capable of analyzing the effects of excavation sequence on the stability of the opening is greatly needed. In this study a two dimensional finite element code was developed based on the effective numerical algorithm for the multistep excavation. The practical applicability of the model was verified for the simplified excavation sequences.

• 한국지반환경공학회 논문집
• /
• 제12권9호
• /
• pp.5-11
• /
• 2011

최근 들어 대규모 및 대심도 지반굴착공사가 증가하고 있으며, 굴착으로 인한 인접구조물들의 붕괴사례는 건설수요와 더불어 꾸준히 증가하고 있고, 특히 도심지 개발 및 불량한 조건에서의 지하철 구조물과 인접하여 진행되는 굴착으로 인해 발생될 수 있는 문제점이 많아지고 있는 실정이다. 이에 본 논문에서는 서울시 내에서 수행된 16개 현장에 대한 사례연구를 통해 적용된 지하굴착공법과 보강공법의 현황을 고찰하였다. 또한 대표 현장을 선택하여 안정성 분석을 실시하였고, 적용된 굴착공법 및 보강방안에 대해 검토하고 이에 따른 공법의 적정성에 대해 검토하였다. 그 결과 16개 현장의 지층 분포상태는 모두 상부로부터 매립층, 그 하부는 퇴적층, 풍화토, 풍화암, 연암층의 순으로 분포하고 있었다. 또한 중요 구조물에 인접하여 굴착공사를 진행할 경우 구조물의 위치 및 지층조건에 매우 큰 영향이 있는 것으로 나타났다. 또한 도심지 특성상 일반 가시설 공법을 적용하여 지하철구조물과 인접하여 굴착이 진행될 경우는 별도의 보강공법의 적용이 필요할 것으로 판단된다.

• 터널과지하공간
• /
• 제33권4호
• /
• pp.255-264
• /
• 2023

근래 들어 도심지 지하공간 개발에 대한 수요가 증가함에 따라 도심지 터널계획이 활발히 진행되고 있다. 도심지 구간에는 주민 생활환경을 고려하여 지하정거장이 계획되며, 기존 구조물의 안정성 및 환경훼손 저감 등을 위해 2-Arch터널 정거장을 적용하고 있다. 그러나 도심지 구간은 심한 풍화작용에 따라 불량지반의 심도가 깊게 발달되어 터널 안정성 확보를 고려한 신중한 계획이 요구된다. 이뿐만 아니라 도심지의 복합적인 지반상태를 고려하여 본선터널에 TBM 기계굴착 공법을 적용하는 경우, 기존 NATM형 2-Arch터널과는 시공연계성을 확보할 수 없게 된다. 본 연구에서는 쉴드TBM과 2-Arch터널을 조합한 형태인 TBM선굴진 2-Arch터널을 국내 최초로 적용한 설계사례를 중점으로 기술하고자 하였다. 중앙터널 굴착후 좌우터널 시공을 고려하여 쉴드TBM 세그먼트 설치 및 해체를 위해 고려한 설계사항을 설명하고, 수치해석을 활용한 안정성 검토를 통해 TBM선굴진 2-Arch터널의 설치효과를 검증하였다.

• Geomechanics and Engineering
• /
• 제32권2호
• /
• pp.145-157
• /
• 2023

This paper aims at investigating the face stability of large-diameter underwater shield tunnels considering seepage in soft-hard uneven strata. Using the kinematic approach of limit upper-bound analysis, the analytical solution of limit supporting pressure on the tunnel face considering seepage was obtained based on a logarithmic spiral collapsed body in uneven strata. The stability analysis method of the excavation face with different soft- and hard-stratum ratios was explored and validated. Moreover, the effects of water level and burial depth on tunnel face stability were discussed. The results show the effect of seepage on the excavation face stability can be accounted as the seepage force on the excavation face and the seepage force of pore water in instability body. When the thickness ratio of hard soil layer within the excavation face exceeds 1/6D, the interface of the soft and hard soil layer can be placed at tunnel axis during stability analysis. The reliability of the analytical solution of the limit supporting pressure is validated by numerical method and literature methods. The increase of water level causes the instability of upper soft soil layer firstly due to the higher seepage force. With the rise of burial depth, the horizontal displacement of the upper soft soil decreases and the limit supporting pressure changes little because of soil arching effect.

• 농업과학연구
• /
• 제24권2호
• /
• pp.226-236
• /
• 1997

The results obtained by elasto-plastic analysis method about the displacement, deformation and stability on the soft ground excavation using sheet pile were summarized as follows ; 1. In the case of strut 1 step, the maximum wall displacement value in the first and the second excavation was small, but it increase remarkably after the third excavation and when the excavation depth was 8m, the point of maximum wall displacement was shown 0.75H~0.8H. 2. The value of safety factor(Fs) was increased with increasing of the penetration depth of sheet pile, cohesion and internal friction angle of ground. Safety factor was mostly effected by penetration depth of sheet pile and more effected by cohesion than internal friction angle of ground. 3. Since the deformation of sheet pile of this ground from the results of analysis and measurement increased remarkabaly after 6m excavation depth, it was desirable that the point of strut installation was GL-6m. 4. Safe excavation depth on ground by analysis considered penetration depth, cohesion and internal friction was shown at the table 3.

• 한국터널지하공간학회 논문집
• /
• 제17권4호
• /
• pp.499-511
• /
• 2015

주방식 지하구조물은 여러 개의 갱도 굴착에 의해 형성되는 격자 형태의 구조물이므로, 갱도들의 굴착순서에 따라 주방식 지하구조물의 시공성과 경제성이 좌우될 수 있다. 따라서 본 연구에서는 주방식 지하구조물의 지반조건, 굴착순서 등의 다양한 설계조건들을 고려하여 주방식 공법의 굴착공정을 검토하였다. 굴착공법으로는 발파공법을 가정하였으며, 가로 세로 병행 시공방식과 가로 세로 순차시공방식으로 구분하여 굴착공정을 검토하였다. 굴착순서에 따른 주방식 지하구조물의 안정성과 더불어 굴진면의 개수, 점보드릴의 이동거리 등에 따른 시공성을 분석한 결과, 구조적 안정성에는 큰 차이가 없으나 굴진면 운영 개소와 점보드릴의 이동거리 측면에서 가로 세로 병행 시공방법의 시공성이 상대적으로 유리한 것으로 나타났다.

• 한국농공학회논문집
• /
• 제46권2호
• /
• pp.93-103
• /
• 2004

In trench excavation, essential factor of earth-retaining temporary work structure should be easy taking to pieces and movement, and dead weight must be less. This paper studies about the light weight material and application as earth-retaining structure to prevent the slope failure of sand soil ground caused by the variation of groundwater level in trench excavation. That is, light weight earth-retaining structural is proposed and a simulation with FEM on application of proposed structural in sandy soil is presented. The results are summarized as follows; (1) The study proposed FRP H-shaped pannel for the light weight member, and also presented estimation method about stability. (2) Mechanical property (bending moment, shear force, axial force, displacement) were changed according to groundwater level, but these values had been within enough safety rate and allowable stress. Therefore, proposed light weight pannel with FRP is available for bracing structure in trench excavation.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 1994년도 가을 학술발표회 논문집
• /
• pp.139-148
• /
• 1994

Rapid industrialization and urbanization caused by the high economic growth of the country requires optimization of land usage as well as the expansion of underground space. Therefore the construction of large and deep basements is inevitable in built up areas where the braced excavation for earth retaining structures may create many problems such as settlement and damages of nearby buildings and underground utilities. In this work, some of major influential factors concerning the stability of braced excavation are investigated and the results are compared with the field observation results. The ground water table, applied strut forces, horezontal wall displacement, infilling materials in the rock joints were found to be the most critical factors influencing the stability of braced walls constructed in the layered ground. Magnituide and type of the wall deformation was closely related to the pattern of the surface settlement. The stability of braced walls are described in terms of strut forces.