• 전기학회논문지
• /
• 제66권1호
• /
• pp.165-170
• /
• 2017

This paper presents an event-triggered model predictive controller for adaptive cruise control system with sampled and quantized-data. Unlike existing works, a longitudinal continuous-time model is used for the predictive control of the system. To efficiently utilize network resources, event-trigger scheme is employed, which allows limited sensor and actuator signal satisfying the condition that the measurement of errors is over the ratio of a trigger level. The proposed control gain is obtained by solving a convex problem satisfying several linear matrix inequalities at every sampling times. Simulation results are given to show the effectiveness of the proposed design method.

• 전기학회논문지
• /
• 제66권9호
• /
• pp.1364-1372
• /
• 2017

In this paper, a problem of event-triggered model predictive control is investigated for continuous-time Takagi-Sugeno (T-S) fuzzy systems with input quantization. To efficiently utilize network resources, event-trigger is employed, which transmits limited signals satisfying the condition that the measurement of errors is over the ratio of a certain level. Considering sampling and quantization, continuous Takagi-Sugeno (T-S) fuzzy systems are regarded as a sector bounded continuous-time T-S fuzzy systems with input delay. Then, a model predictive controller (MPC) based on parallel distributed compensation (PDC) is designed to optimally stabilize the closed loop systems. The proposed MPC optimize the objective function over infinite horizon, which can be easily calculated and implemented solving linear matrix inequalities (LMIs) for every event-triggered time. The validity and effectiveness are shown that the event triggered MPC can stabilize well the systems with even smaller average sampling rate and limited actuator signal guaranteeing optimal performances through the numerical example.

• 제어로봇시스템학회논문지
• /
• 제16권6호
• /
• pp.546-552
• /
• 2010

As the demands for the safety and convenience applications of the vehicles increase, the data load for the In-vehicle Network has increased significantly. As a result, a deterministic and fault-tolerant communication system is required to implement the safety critical applications such as X-by-wire systems. FlexRay communication system is a new standard of network communication system which provides the high speed serial communication, time triggered bus and fault tolerant communication between electronic devices. In addition to time-triggered communication, as providing of the event-triggered communication such as CAN, FlexRay protocol is able to manage the restricted communication resource more effectively. This paper presents the development of FlexRay driver which will be applied to the future ECU's communication system. To develop the FlexRay driver, the FlexRay requirement specification and FlexRay specification is analyzed. The developed FlexRay driver is implemented by using MPC5567 microprocessor of the Freescale semiconductor. To verify the developed FlexRay driver, the waveform of the FlexRay driver was measured and compared with the CAN communication system. As a result, the bus load is reduced about 13% compared with the CAN communication system.