• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2008년도 춘계학술대회논문집
• /
• pp.826-829
• /
• 2008

In a field measurement, measurement errors are produced by measuring environments and systematic errors in the measurement procedure. Measurement errors can be expressed as a measurement uncertainty. In this study, the measurement uncertainty and various measuring factors are investigated in heavy-weight impact sounds. According to KS 2810-2, the model functions, which is the estimation of the maximum SPL measurement in each octave band frequency, are determined. From this estimation model, 3.53dB is shown in 63Hz. This level is caused by the sound field of the receiving room, which does not meet the diffusing field.

• Journal of international Conference on Electrical Machines and Systems
• /
• 제3권3호
• /
• pp.289-297
• /
• 2014

This paper proposed a novel high performance sensorless control scheme for IPMSM based on an extended nonlinear state observer. The gain-matrix of the observer has been derived by using state linearization method. Steady state errors in estimated rotor position and speed due to parameter inaccuracy have been analyzed, and an equivalent flux error is defined to represent the overall effect of parameter errors contributing to the wrong convergence of the estimated rotor speed as well as rotor position. Then, an online compensation strategy was proposed to limit the estimation errors in rotor position and speed. The effectiveness of the extended nonlinear state observer is validated through simulation and experimental test.

• ETRI Journal
• /
• 제29권5호
• /
• pp.596-606
• /
• 2007

It is well known that an OFDM receiver is vulnerable to synchronization errors. Despite fine estimations used in the initial acquisition, there are still residual synchronization errors. Though these errors are very small, they severely degrade the bit error rate (BER) performance. In this paper, we propose a residual error elimination scheme for the digital OFDM baseband receiver aiming to improve the overall BER performance. Three improvements on existing schemes are made: a pilot-aided recursive algorithm for joint estimation of the residual carrier frequency and sampling time offsets; a delay-based timing error correction technique, which smoothly adjusts the incoming data stream without resampling disturbance; and a decision-directed channel gain update algorithm based on recursive least-squares criterion, which offers faster convergence and smaller error than the least-mean-squares algorithms. Simulation results show that the proposed scheme works well in the multipath channel, and its performance is close to that of an OFDM system with perfect synchronization parameters.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 하계학술대회 논문집 D
• /
• pp.2088-2090
• /
• 2003

A practical recursive weighted least square(WLS) solution is proposed to solve the passive ranging problem. Apart from the previous works based on the extended Kalman filter(EKF), to ensure the convergency at long-range, the proposed scheme makes use of line-of-sight(LOS) rate instead of bearing information. The influence of LOS rate measurement errors is investigated and it is asserted that the WLS estimates contain bias and scale factor errors. Together with simple compensation algorithm, the estimation errors of proposed filter can be reduced dramatically.

• Communications for Statistical Applications and Methods
• /
• 제6권3호
• /
• pp.849-860
• /
• 1999

This paper addresses the issue of estimating regression function with errors in variables using wavelets. We adopt a nonparametric approach in assuming that the regression function has no specific parametric form, To account for errors in covariates deconvolution is involved in the construction of a new class of linear wavelet estimators. using the wavelet characterization of Besov spaces the question of regression estimation with Besov constraint can be reduced to a problem in a space of sequences. Rates of convergence are studied over Besov function classes $B_{spq}$ using $L_2$ error measure. It is shown that the rates of convergence depend on the smoothness s of the regression function and the decay rate of characteristic function of the contaminating error.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제13권11호
• /
• pp.5370-5393
• /
• 2019

In this paper, we consider a two-way relay non-orthogonal multiple access (TWR-NOMA) system with residual hardware impairments (RHIs) and channel estimation errors (CEEs), where two group users exchange their information via the decode-and-forward (DF) relay by using NOMA protocol. To evaluate the performance of the considered system, exact analytical expressions for the outage probability of the two groups users are derived in closed-form. Moreover, the asymptotic outage behavior in the high signal-to-noise ratio (SNR) regime is examined and the diversity order is derived and discussed. Numerical simulation results verify the accuracy of theoretical analyses, and show that: i) RHIs and CEEs have a deleterious effects on the outage probabilities; ii) CEEs have significant effects on the performance of the near user; iii) Due to the RHIs, CEEs, inter-group interference and intra-group interference, there exists error floors for the outage probability.

• 대한의용생체공학회:의공학회지
• /
• 제15권1호
• /
• pp.71-76
• /
• 1994

단일 쌍극자 모델을 이용한 source localization 문제에서 전극의 갯수, 쌍극자의 위치 및 방향 등이 S/N(signal to noise ratio)과 추정 오차사이의 관계에 미치는 영향을 Monte Carlo 시뮬레이션으로 조사했다. forward problem은 3중 구각 모델로 계산했고, simplex 방법으로 쌍극자 파라미터를 최적화시켰다. 전극의 갯수가 많을때, 쌍극자가 뇌 중심(midbrain)보다 대뇌 피질(cortex)부근에 있을 때, 쌍극자가 tangential 방향일 때 추정 오차의 평균과 표준편차가 작아졌다.

• 제어로봇시스템학회논문지
• /
• 제10권1호
• /
• pp.15-21
• /
• 2004

This paper deals with asymptotic stabilization problems for linear systems with time-varying input disturbances. In order to eliminate the influence of a disturbance on the system, a disturbance observer is designed and the time-varying disturbance can be rejected using its estimated value. Since the disturbance observer is kind of low-pass filter, it has inevitably estimation errors. To eliminate the inflences on the performance due to these errors, the additional control is designed based on these estimation errors using a well-known min-max control method. It is shown that the asymptotic stability of the closed-loop system is guaranteed. In general, the min-max control method requires the switching of control inputs and the switching magnitude of the control input is determined by the disturbance estimation error bounds. As the error bounds can be made arbitrarily small by choosing the high gain for the disturbance observer, the control method suggested in this paper can reduce the chattering phenomena as small as possible. Therefore, it has superior performance to the existing ones.

• 한국정밀공학회지
• /
• 제32권2호
• /
• pp.127-133
• /
• 2015

The error motion of a machine tool spindle directly affects the surface errors of machined parts. Those are usually due to the imperfectness of bearings, stiffness of spindle, assembly errors, external force or unbalance of rotors. The error motions of the spindle have been needed to be decreased to desired goal of spindle's performance. The level of error motion is needed to be estimated during the design and assembly process of the spindle. In this paper, the estimation method for the five degree of freedom (5 D.O.F) error motions for rotary units such as a spindle and rotary table are suggested. To estimate the error motions of the rotary unit, waviness of bearings and external force model were used as input data. The estimation model considers geometric relationship and force equilibrium of the five degree of the freedom motions.

• 한국농림기상학회지
• /
• 제7권2호
• /
• pp.171-183
• /
• 2005

In order to monitor the global terrestrial carbon cycle, NASA (National Aeronautics and Space Administration) provides 8-day GPP images by use of satellite remote-sensing reflectance data from MODIS (Moderate Resolution Imaging Spectroradiometer) at l-km nadir spatial resolution since December, 1999. MODIS GPP algorithm adopts DAO (Data Assimilation Office) meteorological data to calculate daily GPP. By evaluating reliability of DAO data with respect to surface weather station data, we examined the effect of errors from DAO data on MODIS GPP estimation in the Korean Peninsula from 2001 to 2003. Our analyses showed that DAO data underestimated daily average temperature, daily minimum temperature, and daily vapor pressure deficity (VPD), but overestimated daily shortwave radiation during the study period. Each meteorological variable resulted in different spatial patterns of error distribution across the Korean Peninsula. In MODIS GPP estimation, DAO data resulted in overestimation of GPP by $25\%$ for all biome types but up to $40\%$ for forest biomes, the major biome type in the Korean Peninsula. MODIS GPP was more sensitive to errors in solar radiation and VPD than in temperatures. Our results indicate that more reliable gridded meteorological data than DAO data are necessary for satisfactory estimation of MODIS GPP in the Korean Peninsula.