• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.30B no.5
• /
• pp.62-72
• /
• 1993

The phased array antenna has the ability to perform adaptive sampling by directing the radar beam without inertia in any direction. The adaptive sampling capability of the phased array antenna allows each sampling time interval to be varied for each target, depending on the acceleration of each target at any time. In this paper we design a three dimensional adaptive target tracking algorithm for the phased array radar system with a given set of measurement parameters. The tracking algorithm avoids taking unnecessarily frequent samples, while keeping the angular prediction error within a fraction of antenna beamwidth so that the probability of detection will not be degraded during a track updata illuminations. In our algorithm, the target model and the sampling rate are selected depending on the target range and the target maneuver status which is determined by a maneuver level detector. A detailed simulation is conducted to test the validity of our tracking algorithm for target trajectories under various conditions of maneuver.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.40 no.12
• /
• pp.24-30
• /
• 2003

In this paper, we proposed an adaptive ATC(Automatic Threshold Control) circuit with more decreased settling time by improving the structure of the peak detector. We showed that it could reduce a good deal of the settling time because it showed less than half the error voltage ratio that the ATC circuit with conventional structure showed in analysis. We also designed a burst-mode ATC circuit for the 1.25Gbps EPON system using a commercial foundry. It produced the reference levels in very short time, 6㎱ in 40 ㏈ input dynamic range.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.27 no.3
• /
• pp.326-333
• /
• 2003

In the measurement using DMA and CPC in series, there is some time delay for particles classified in DMA to detect in CPC. During this time, the DMA time-response changes due to the velocity profile of sampling tube and the diffusion of particles in the volume that exists between the DMA exit and the detector of ultra-fine CPC. This is called mixing effect. In the accelerated measurement methods like the TSI -SMPS, the size distribution is obtained from the correlation between the time-varying electrical potential of the DMA and the corresponding particle concentrations sampled in DMA. If the DMA time -response changes during this delay time, this can cause the error of a size distribution measured by this accelerated technique. The kernel function considering this mixing effect using the residence time distribution is proposed by Russell et al. In this study, we obtained a size distribution using this kernel to compare to the result obtained by the commercial accelerated measurement system, TSI -SMPS for verification and considered the errors that result from the mixing effect with the geometric mean diameters of originally sampled particles, using virtually calculated responses obtained with this kernel as input data.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2006.11a
• /
• pp.197-200
• /
• 2006

ATSC DTV시스템에서는 심볼타이밍 동기를 위해서 ATSC규격에 소개되어있는 $77.3{mu}s$ 마다 반복적으로 삽입되어있는 세그먼트 싱크를 이용하는 세그먼트 동기 방법 또는 QAM과 같은 다중레벨을 가지는 신호에 일반적으로 사용되는 가드너(Gardner)방법을 사용한다. 이중 가드너 방법은 매심볼마다 타이밍 에러성분을 추출하므로 다중경로 채널에서 타이밍동기를 추적하면서 유지하는데 유리한 방식이어서 일반적으로 사용한다. 가드너 방법을 이용하는 ATSC DTV시스템에서 가드너 방법에 에러를 검출하기 위해 사용되는 가드너 타이밍 에러 검출기(Timing Error Detector)는 수신단의 파워레벨이 기준 파워레벨에서 크게 벗어날 경우 에러를 검출 할 수 없는 문제점을 가지고 있다. 이를 해결 하기 위해 가드너 타이밍 에러 검출기 블록 앞에 송신파워 레벨과 수신파워 레벨의 비를 이용하여 정상적인 수신 파워 레벨로 수신학 수 있도록 보정하는 블록을 추가하여 전체적인 동기성능을 향상시키는 알고리즘을 제안한다.

• 정보저장시스템학회:학술대회논문집
• /
• 2005.10a
• /
• pp.154-159
• /
• 2005

The next generation of optical storage systems requires higher numerical aperture (NA) objective lenses and shorter wavelength laser in order to improve the unit areal density. A blu-ray technology satisfies a miniaturization and a high capacity which are the requirements of the portable device. In this paper, we analyze the optical performance of hybrid micro lens and do active alignment. The hybrid micro lens is manufactured by using a wafer based fabrication technology. Optical components of hybrid micro lens are evaluated. The measurement of the optical power, the spot size and the wavefront error awe performed to evaluate the hybrid micro lens with NA 0.85. Using the measured data, we estimate if the performance of hybrid micro lens corresponds to the designed performance. After the performance of hybrid micro lens is evaluated, the integrated optical pickup and the hybrid micro lens are assembled by active alignment using UV curing and the optical performance of SFFOP is satisfied with BD specifications.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.10C
• /
• pp.999-1006
• /
• 2005

The difference threshold test (DTT) declares erasures whenever the difference between the largest and second largest energy detector outputs does not exceed a given threshold. we show that the DTT outperforms the ratio threshold test (RTT) for finite modulation size and diversity order in the detection of M-FSK signals. The asymptotic performance for infinite modulation size and diversity order is then investigated. It is shown that the minimum signal-to-noise ratio required to achieve error-free communication for the DTT is the same as that for the RTT.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.3
• /
• pp.737-746
• /
• 1996

In this paper, we present simulation result of quantization effects about a new Angular From Carrier Recovery Loop(AF CR loop) for PSK modulation technique. AF CR loop includes detected angle symbol and Multi Level hardimiter. In general, detected angle is used in dtermining symbol. Because detected angle is used to make an error signal of phase detector output, hardware implementation of AF CR loop is simpler than that of other loops. Before hardware implementation of AF CR loop, the result due to quantization effect should be investigated. In order to confirm quntization effect of AF CR loop, we evaluate performance of this loop by Monte-Carlosimulation method. Under both in the AWGN and Jake's fading noise channel environments, we confirmed the characteristics of AF CR loop in terms of RMS jitter due to quntization effect. Differential APSK modulation schemeis used in this paper. Especially, Jake's fading channel is used as a channel model and also AGC(Automatic Gain Control) is used in the overall process of performance evaluation. We obtained the resonable result of quantization effect about AF CR loop. With the result of performanceevaluation based on quantization effects, we can expect to operate AF CRloop under the fading channel environments reasonably well.

• The Transactions of the Korean Institute of Electrical Engineers D
• /
• v.55 no.10
• /
• pp.452-457
• /
• 2006

In this paper, an algorithm to detect steps in hemiplegic patients using a 3-axis accelerometer a紅ached on the trunk was proposed. The proposed algorithm consisted of the signal pre-processing, the step detector, the classification of steps and the calculation of stride time. Two FIR band-pass filters were designed and steps were measured by the combination of filtered signals in the vertical and the anteroposterior directions. In addition, the classification of steps and the calculation of stride time were computed by using the detected steps and lateral signals. For the experiment, fourteen hemiplegic patients were participated and the linear accelerations of the trunk and foot switch signals were measured synchronously. To evaluate the system performance, the detected steps and initial contacts by the foot switch were compared. The average error between the steps and initial contacts was 0.024ms and the difference of the average stride time was 0.01s. Finally, all gait events were detected exactly. Results showed that the accelerometry could use for the gait evaluation in clinical rehabilitation therapies.

• Nuclear Engineering and Technology
• /
• v.30 no.5
• /
• pp.452-461
• /
• 1998

The pin power distribution is determined by analyzing the rotational gamma scanning data for 36 element fuel bundle of HANARO. A fission monitor of Nb$^{95}$ is chosen by considering the criteria of the half-life, fission yield, emitting ${\gamma}$-ray energy and probability. The ${\gamma}$-ray spectra were measured in Korea Atomic Energy Research Institute(KAERI) by using a HPGe detector and by rotating the fuel bundle at steps of 10$^{\circ}$. The counting rates of Nb$^{95}$ 766 keV ${\gamma}$-rays are determined by analyzing the full absorption peak in the spectra. A 36$\times$36 response matrix is obtained from calculating the contribution of each rod at every scanning angle by assuming 2-dimensional and parallel beam approximations for the measuring geometry. In terms of the measured counting rates and the calculated response matrix, an inverse problem is set up for the unknown distribution of activity concentrations of pins. To select a suitable solving method, the performances of three direct methods and the iterative least-square method are tested by solving simulation examples. The final solution is obtained by using the iterative least-square method that shows a good stability. The influences of detection error, step size of rotation and the collimator width are discussed on the accuracy of the numerical solution. Hence an improvement in the accuracy of the solution is proposed by reducing the collimator width of the scanning arrangement.

• YAKHAK HOEJI
• /
• v.47 no.3
• /
• pp.148-153
• /
• 2003

Skin moisture is an important factor in skin health. Measurement of moisture content can provide diagnostic information on the condition of skin. In this study, a portable near-infrared (NIR) system was newly integrated with a photo diode array detector that has no moving parts, and this system has been successfully applied for the evaluation of human skin moisture. Diffuse reflectance spectra were collected and transformed to absorbance using 1 nm step size over the wavelength range of 1100 nm to 2200 nm. Partial least squares regression (PLSR) was applied to develop a calibration model. For practical use for the evaluation of human skin moisture, the PLS model for human skin moisture was developed in vivo using the portable NIR system on the basis of the relative water content values of stratum corneum from the conventional capacitance method. The PLS model showed a good correlation. The calibration with the use of PLS model predicted human moisture with a standard error of prediction (SEP) of 3.5 at 1120∼1730 nm range. This study showed the possibility of skin moisture measurement using portable NIR system.