• Journal of the Korea Computer Industry Society
• /
• v.3 no.12
• /
• pp.1651-1658
• /
• 2002

Recently power cable used generally in Korea, because installation is very simple and it has high stability. It confirms to the requirements of IEEE std. 404-1993 by factory testing, but many problems of insulated cable systems are caused by internal defects of the joint part which have to be mounted ensile. Especially, fault rates are arise from impurities or voids. A suitable solution for a monitoring of power cable during the after-laying test and service is partial discharge detection. The artificial defects between cable joint(EPR) and insulator(XLPE) interface are considered in this research to investigating the partial discharge characteristics. ${\varphi}$-q-n properties were detected using data acquisition system and Maximum charge($q_{max}$), repetition rate(${\={n}$), average charge(${\={q}$), Unbalance rate of ${\={n}$ and ${\={q}$ are calculated in order to analysis partial discharge properties quantitatively from this statistic value.

• Asian-Australasian Journal of Animal Sciences
• /
• v.33 no.3
• /
• pp.436-445
• /
• 2020

Objective: Ensiling is a simple and effective method for long-term preservation; however, less information exists about the ensilability characteristics of garlic stalk (GS). Therefore, the objectives were to examine the ensiling feasibility of GS. Methods: The GS was ensiled alone or inoculated with Lactobacillus plantarum KU5 in the presence or absence of 5% molasses and ensiled for 7, 14, and 28 d. As an alternative storage method, GS was co-ensiled with wet citrus pulp (CP) at different proportions (GS:CP: 70:30, 60:40, 50:50, and 40:60). Analysis was made on physicochemical, fermentative, and nutritional parameters. Results: The GS was found to be a biomass which is difficult to ensile. A combination of microbial inoculant and molasses was successful in the improvement of the silage fermentation quality of GS. Co-ensiling of GS with wet CP at the mixing ratio of 50:50 provided the most desirable silage fermentation parameters, including the substantial lactic acid formation, low final pH, minor effluent loss, and the more favorable organoleptic properties. Conclusion: Co-ensiling GS with CP appears to be a simple and viable method of conservation, enabling the more efficient utilization of these by-product resources over a prolonged period.

• Resources Recycling
• /
• v.8 no.4
• /
• pp.57-63
• /
• 1999

Wood-Polymer Composites (WPC) m s prepared irom recycled films of agricullural use and wood wastes, and LLDPE and neal PE resin mlxlurr war also utilized in order to cornpiue the praperlies. Molc~ca nhydride (MA) and dicumyl peroxide were used as an adheslon pmmoler and an il~lliatotor~, .espcmivelyT. ensile prapenies of W Cw zrc measured via lenslle test as a funclieu of woad lille~m d MA contmt, and rractu1.e surface was also mvestigaled wilh SEM. As the content of wwd tiller mcreased, clongauon deneased bul modulus increased However, tensile slrength OI WPC increased only when MA war used, and 1 wt.% of MA may be hgh enough to increase the tensile properties. The tensilc ptopcrlies af WPC prepwed from recycled PE films were &nost same as thosc of neal PE resin mixture.

• Journal of the Korean Home Economics Association
• /
• v.39 no.6
• /
• pp.25-40
• /
• 2001

The purpose of this study was to find out the amount of the household work time related to food and examine the factors affecting the time accomplished by married female home-based workers and on-site workers. The data were collected from 165 married female home-based workers, and 292 married female on-site workers in Pusan and Kyungnam province, by the self-administered questionnaire. frequency distributions, Cronbach's alpha, t-tests, Pearson's correlations, and multiple regression analyses were conducted by SPSS/PC+. The major findings of this study were as follows: (1) both married female home-based and on-site workers spent more time on household work related to food in a weekend than in a weekday, (2) in a weekday, occupation was significantly related to the amount of time that married female home-based workers spent on food household work, whereas age and occupation were significant for married female on-site workers, (3) on Saturday, the significant factors of the time spent on food household work were the number of family and occupation for married female home-based workers, and educational level, occupation, sex role attitude, existence of children of 6 years or under, and existence of elders/disability within the family for married female on-site workers, and (4) on Sunday, for married female home-based workers, the number of family, occupation, and the level of market good substitution had significant effects on the amount of time spent on food household work, and for married female on-site workers, age, the number of family, occupation, sex role attitude, work hours on Sunday, and the level of market good substitution were significant.

• Asian-Australasian Journal of Animal Sciences
• /
• v.16 no.11
• /
• pp.1583-1591
• /
• 2003

The influence of varying levels of urea and additives on nitrogen (N) retention and chemical composition of wheat straw was studied. The wheat straw was treated with 4, 6 and 8% urea and ensiled with 1.5, 2 and 2.5% of acetic or formic acid and 2, 4 and 6% of corn steep liquor (CSL) or acidified molasses for 15 days. The N content of wheat straw was significantly different across all treatments. The N content of urea treated wheat straw was increased with the increasing level of urea. The N content was higher in urea treated wheat straw ensiled with acetic or formic acid as compared to urea treated wheat straw ensiled without these organic acids. The N content of urea treated wheat straw was further enhanced when it was ensiled with CSL or acidified molasses. This effect was significant across all levels of urea used to treat the wheat straw. Nitrogen retention in urea treated wheat straw was decreased linearly as the urea level was increased to treat the wheat straw. The N content was increased linearly when higher levels of CSL or acidified molasses were used to ensile the urea treated wheat straw. Most of the N in urea treated wheat straw was held as neutral detergent insoluble N (NDIN). The NDIN content was increased linearly with the increasing levels of urea and additives. The neutral detergent fiber (NDF) contents were higher in urea treated wheat straw ensiled with acetic or formic acid as compared to urea treated wheat straw ensiled without additive. The NDF content further increased in urea treated wheat straw ensiled with CSL and acidified molasses. The entire increase in NDF content was because of fiber bound N. The hemicellulose content of urea treated wheat straw ensiled with CSL or acidified molasses was higher as compared to urea treated wheat straw ensiled with acetic or formic acid. The acid detergent fiber content of urea treated wheat straw ensiled with or without additives remained statistically non-significant. The cellulose contents of wheat straw was linearly reduced when urea level was increased from 4 to 6 and 8% to treat the wheat straw. This effect was further enhanced when urea treated wheat straw was ensiled with different additives. The results of the present study indicated that fermentable carbohydrates might improve the Nitrogen retention and bring the favorable changes in physiochemical nature of wheat straw. However, biological evaluation of urea treated wheat straw ensiled with fermentable carbohydrates is required.

• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2005.11a
• /
• pp.126-133
• /
• 2005

Securing of radioactive waste disposal site and the related operations for disposal of low and intermediate level radioactive waste is being actively carried out in Korea. For disposal of radioactive wastes, physicochemical and radiological status and integrity of radioactive wastes must be secured first. Also, waste generators must provide this information to disposers. In addition, to secure the safety of waste disposal, waste acceptance criteria (WAC) and site specific waste acceptance criteria (SWAC) to consider characteristics of the disposal site are required. Radioactive wastes must be processed, generated, managed and transferred in accordance with these criteria. [1] For this, evaluation of properties on each of the radioactive wastes must be performed. However, in reality, atomic power plants are experiencing difficulties in relation to this due to the large quantity of radioactive waste generation. In order to solve this problem, IAEA and major overseas countries have developed, thus are using waste certification program (WCP) and quality assurance program (QAP) [2,3]. On the basis of these programs, radioactive waste certification program has been developed for safe disposal of radioactive wastes in Korea to satisfy the provisions specified in 'low and intermediate level radioactive waste transfer guidelines' of announcement No. 2005-18 from the Ministry of Science and Technology and specific site waste acceptance criteria (tentative plan). In addition, it is being planned to administer amendment on commercial atomic power plant related procedures and ensile staff training in order for early introduction and operation of radioactive waste certification system.

• Journal of Korean Society of Environmental Engineers
• /
• v.34 no.11
• /
• pp.765-771
• /
• 2012

In this study, the biochemical methane potentials of different agricultural residues produced from agricultural plastic greenhouse were determined. Additionally, ensiling storage practice was applied on agricultural residues for its effect on biogas production. Agricultural residues of cabbage, strawberry, tomato, cucumber, and oriental melon were selected as sample. The methane potential and biodegradability of agricultural residues ranged from 149~286 mL-$CH_4/g$-VS, 27~48% (by vol.), respectively and methane production was in order of cabbage > oriental melon > strawberry ${\approx}$ cucumber > tomato. Ensiling caused difference in methane production in a range of -11~36% (by vol.) per VS compared with raw material. An increase in methane potential was presumably linked to the organic acid accumulation, cellulose degradation and decrease in methane potential was due to chemical composition change, ammonia accumulation during the storage process.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.34 no.3
• /
• pp.420-429
• /
• 2007

The purpose of this study was to compare the micro ensile bond strength to bovine dentin of several adhesives (SM, Scotch $Bond^{TM}$ Multipurpose; SB, $Adper^{TM}$ Single Bond 2; SE, $Clearfil^{(R)}$ SE Bond; AQ, AQ $Bond^{TM}$; TS, $Clearfil^{(R)}$ tri-S Bond). Except SM and SB, they have a simplified one- or two-step application protocols in compare with the dentin adhesives conventional three-step protocols. For the microtensile bond strength test, the labial surfaces of bovine incisors were used. Following exposure of dentin layer, according to their manufacturer's directions, each dentin adhesives were applied and composite resin blocks were constructed. The teeth were sectioned for specimen and tested microtensile bond strength. Also observed the fracture mode of interface. The obtained results were as follows : 1. The microtensile bond strength values ranged from 51.34 to 24.04 MPa on dentin(in decreasing order, SE, SM, SB, AQ and TS). 2. The highest microtensile bond strength was by SE and SM on bovine dentin, and the lowest by AQ and TS. 3. SM, SB and SE showed cohesive failures and adhesive failure but AQ, TS presented almost adhesive failures. In summary, microtensile bond strengths of single-step adhesives (AQ and TS) on bovine dentin were significantly lower than those of multi-step adhesives (SM, SB and SE) (p<0.05).