• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2016년도 제50회 동계 정기학술대회 초록집
• /
• pp.422.1-422.1
• /
• 2016

Graphene quantum dots (GQDs), a new kind of carbon-based photo luminescent nanomaterial from chemically modified graphene oxide (CMGO) or chemically modified graphene (CMG), has attracted extensive research attention in the last few years due to its outstanding chemical, optical and electrical properties. To further extended its potential applications as optoelectronic devices, solar cells, bio and bio-sensors and so on, intensive research efforts have been devoted to the CMG. However, the CMG, a suspension of aqueous, have problematic since they are prone to agglomeration after drying a solvent. In this study, we synthesized the GQDs from graphite and deposited on silicon substrate by kinetic spray. The photo luminescent properties of deposited GQD films were analyzed and compared with initial GQDs suspension. In addition, its carbon properties were investigated with GQDs solution properties. The properties of deposited GQD films by kinetic spray were similar to that of the GQDs suspension in water. We could provide a pathway for silicon-based silicon based device applications. Finally, the well-adjusted GQD films with photo luminescence effects will show Energy-Down-Shift layer effects on silicon solar cells. The GQD layers deposited at nozzle scan speeds of 40, 30, 20, and 10 mm/s were evaluated after they were used to fabricate crystalline-silicon solar cells; the results indicate that GQDs play an important role in increasing the optical absorptivity of the cells. The short-circuit current density (Jsc) was enhanced by about 2.94 % (0.9 mA/cm2) at 30 mm/s. Compared to a reference device without a GQD energy-down-shift layer, the PCE of p-type silicon solar cells was improved by 2.7% (0.4 percentage points).

• International Journal of Naval Architecture and Ocean Engineering
• /
• 제9권3호
• /
• pp.239-245
• /
• 2017

As a new technical approach, wave energy converter by using vertical motion of water in the multiple water chambers were developed to realize actual wave power generation as eco-environmental renewable energy. And practical use of wave energy converter was actually to require the following conditions: (1) setting up of the relevant device and its application to wave power generation in case that severe wave loading is avoided; (2) workability in installation and maintenance operations; (3) high energy conversion potential; and (4) low cost. In this system, neither the wall(s) of the chambers nor the energy conversion device(s) are exposed to the impulsive load due to water wave. Also since this system is profitable when set along the jetty or along a long floating body, installation and maintenance are done without difficulty and the cost is reduced. In this paper, we describe the system which consists of a float, a shaft connected with another shaft, a rack and pinion arrangement, a ratchet mechanism, and rotary type generator(s). Then, we present the dynamics model for evaluating the output electric power, and the results of numerical calculation including the effect of the phase shift of up/down motion of the water in the array of water chambers aligned along the direction of wave propagation.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2008년도 춘계학술대회 논문집
• /
• pp.256-259
• /
• 2008

The gasification of biomass, sawdust, was carried out in order to investigate gasification characteristics. The experiment was performed using a down-draft fixed bed gasifier to surpass tar components generation in the gasification process. In the experiments, we investigated synthetic gas composition by varying reaction temperature, steam/carbon ratio, and excess ratio (ER), respectively. Higher reaction temperature, $700^{\circ}C$ to $900^{\circ}C$, could obtain higher $H_2$ yield. However, we could not obtain any meaning data by varying S/C ratio. Using $O_2$-LNG burner in the top of the gasifier may surpass water-gas shift reaction by increasing $CO_2$ concentration from the LNG-$O_2$ combustion reaction.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2014년도 제46회 동계 정기학술대회 초록집
• /
• pp.135.2-135.2
• /
• 2014

Photon conversion technology for thin film solar cells is reviewed. The high-energy photons which are hardly absorbed in solar cells can be transformed the low energy photon by the photon conversion process such as down conversion or down shift, which can improve the solar cell efficiency over the material limit. CdSe-based quantum dot materials commonly used in LED can be used as the photon conversion layer for Si thin film solar cells. The photon conversion structure of CdSe-based quantum dot for Si thin film solar cells will be presented and the pros and cons for the Si thin film solar cells integrated with the photon conversion layers will be discussed.

• Nuclear Engineering and Technology
• /
• 제54권6호
• /
• pp.2213-2220
• /
• 2022

The maximum dose delivery at the end of the beam range provides the main advantage of using proton therapy. The range of the proton beam, however, is subject to uncertainties, which limit the clinical benefits of proton therapy and, therefore, accurate in vivo verification of the beam range is desirable. For the beam range verification in spot scanning proton therapy, a prompt gamma detection system, called as gamma electron vertex imaging (GEVI) system, is under development and, in the present study, the performance of the GEVI system in spot scanning proton therapy was predicted with Geant4 Monte Carlo simulations in terms of shift detection sensitivity, accuracy and precision. The simulation results indicated that the GEVI system can detect the interfractional range shifts down to 1 mm shift for the cases considered in the present study. The results also showed that both the evaluated accuracy and precision were less than 1-2 mm, except for the scenarios where we consider all spots in the energy layer for a local shifting. It was very encouraging results that the accuracy and precision satisfied the smallest distal safety margin of the investigated beam energy (i.e., 4.88 mm for 134.9 MeV).

• Mass Spectrometry Letters
• /
• 제7권4호
• /
• pp.102-105
• /
• 2016

This study explored the feasibility of using a carburization technique to enhance the ion intensity of isotopic analysis of ultra-trace levels of uranium using thermal ionization mass spectrometry (TIMS). Prior to fixing uranium samples on TIMS filaments, graphite powder suspended in nitric acid was deposited on rhenium filaments. We observed an enhancement of $^{238}U^+$ intensity by a factor of two when carburization was used, and were able to roughly optimize the amount of graphite powder necessary for carburization. The positive shift in heating current when evaporating filaments upon carburization implies that uranium was chemically altered by carburization, when compared to normal fixation processes. The good agreement between our method and known standards down to an ultra-trace level shows that the proposed technique can be applied to isotopic uranium analysis down to abundances of ~10 pg.

• 비파괴검사학회지
• /
• 제32권4호
• /
• pp.369-375
• /
• 2012

기존 비파괴평가 기술의 결함 탐지 한계를 극복하기 위하여 비선형 초음파공명 특성을 이용한 미세 균열 진단 기술을 개발하였다. 가진 전압에 따른 초음파공명 주파수의 천이현상과 정규화 공명 진폭 감소 현상을 비선형 초음파공명 특성 파라미터로 제안하였으며 이를 실험적으로 확인하였다. CT 시편에 피로시험을 통하여 미세한 자연 균열을 생성하였으며 피로 사이클 단계마다 초음파공명주파수와 정규화 공명진폭의 변화를 측정하였다. 무결함 또는 10 ${\mu}m$ 정도의 매우 미세한 균열이 존재하는 시편에서는 초음파공명 주파수 천이현상이나 정규화 공명 진폭의 변화가 나타나지 않는 반면에 30 ${\mu}m$급 이상의 미세 균열 시편에서는 균열 크기가 증가함에 따라 초음파공명주파수의 천이 현상이나 정규화 공명 진폭의 감소량이 증가함을 확인하였다.

• 한국세라믹학회지
• /
• 제31권6호
• /
• pp.587-594
• /
• 1994

(Ba, Sr)TiO3-based PTCR ceramics were sintered and cooled down with various cooling conditions in the air. AES was applied to investigate the composition change in the grain boundary and bulk area of oxidatively cooled samples. Ba component was deficit in grain boundary region, while oxygen was abundant than bulk region. The discrete changes of oxygen binding energies were confirmed in the grain boundary region of the heavily oxidized samples. It was supposed that the large binding energy shift resulted from the oxidation of the segregated Mn in grain boundary region and this idea was supported by the DV-X$\alpha$ molecular energy simulation.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제52권4호
• /
• pp.169-172
• /
• 2003

Silicon nanocrystalline thin films on p-type (100) silicon substrate have been fabricated by pulsed laser deposition technique using a Nd:YAG laser with the wavelength of 355, 532, and 1064 nm. The base vacuum in the chamber was down to $10^-6$ Torr and the laser energy densities were 1.0~3.0 J/$\textrm{cm}^2$ After deposition, silicon nanocrystalline thin films have been annealed at nitrogen gas. Strong Blue and green luminescence from silicon nanocrystalline thin films have been observed at room temperature by photoluminescence and its peak energies shift to green when the wavelength is increased from 355 to 1064 nm.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2016년도 전력전자학술대회 논문집
• /
• pp.333-334
• /
• 2016

This paper proposes a new cascoded configuration for hybrid energy storage system (HESS) which consists of batteries and supercapacitor (SC) for Electric Vehicle applications. In this configuration,a resonant LLC converter is interfacedin series with a battery module and it converts a part of the energy from the batteries and transfer it to the dc-link bus. The LLC converter is controlled by a phase-shift angle between the primary and secondary switches to maintain a constant dc-link voltage and obtain soft-switching conditions for all the primary switches. By placing the SC moduleina cascoded concept, the rated voltage of SC can be reduced significantly compared with the conventional topologies. It helps save the cost and reduce the number of SC cells. The proposed configuration can operate with four different modes: feeding load, acceleration, regenerative braking andSC charging. A scaled-down prototype converter (2 kW, 600V output) is designed and tested to verify the advantages of the proposed topology. The maximum efficiency obtained with the proposed topology is 99%.