• Journal of Hydrogen and New Energy
• /
• v.21 no.5
• /
• pp.419-424
• /
• 2010

The 125kW external reforming (ER) type molten carbonate fuel cell (MCFC) system for developing a commercial prototype has been operated at Boryeong thermal power plant site since the end of 2009. The system consists of 125kW stack with $10,000 cm^2$ effective area, mechanical balance of plant (MBOP) with anode recycle system, and electrical balance of plant (EBOP). The 125kW MCFC stack installed in December, 2009 has been operated from January, 2010 after 20 days pre-treatment. The stack open circuit voltage (OCV) was 214V at initial load operation, which approaches the thermodynamically theoretical voltage. The stack voltage remained stable range from 160V to 180V at the maximum generating power of 120 kW DC. The stack has been operated for 3,270 hours and operated at rated power for 1,200 hours.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.34 no.5 s.118
• /
• pp.70-75
• /
• 2006

The purpose of this study is to explore the effects of difference in urban tree plantings on microclimate amelioration, and to suggest essential information for quantifying urban energy budgets and energy savings. This study was focused on measuring and analyzing air temperature and relative humidity in summer. Daytime air temperatures at places with 8%, 24%, 44%, 79%, and 100% cover of woody plants were, respectively, $0.6^{\circ}C,\;1.3^{\circ}C,\;2.4^{\circ}C,\;3.5^{\circ}C,\;and\;4.8^{\circ}C$ cooler, compared to a place with 0% cover. A 10% increase of woody plant cover was estimated to reduce the temperature by approximately $0.55^{\circ}C$. The temperature reduction effects were relatively greater between places with lower cover of woody plants than between those with higher cover. Woody plant cover and crown volume were the appropriate indicators which quantified the effects of tree plantings on air temperatures, based on the correlation analysis. Regression equations to estimate temperature change ($Y:^{\circ}C$) using woody plant cover ($X_1:%$) or crown volume ($X_2:m^3$) as independent variables are as follows: $$1nY=3.3233-0.0018X_1\;(r^2=0.99,\;p<0.0001)\;Y=27.5297-0.0019X_2\;(r^2=0.96,\;p=0.0007)$$

• Journal of Radiation Industry
• /
• v.9 no.4
• /
• pp.181-185
• /
• 2015

Today the biosafety evaluation, a common problem of vital importance, is based on internationally proved test-systems, standards and techniques. The paradigm of biosafety includes multidisciplinary approach, a combination of physical, chemical and biological tests to monitor the environmental level of pollutants and needs to be improved by modern approaches. The genetic risk of environmental pollutions has long been studied by many researchers. In this study, used was the known sensitive plant test-system, clones of plant Tradescantia (spiderwort) able to detect gene mutations (frequency of mutational events and formation of micronuclei) in combination with chemical and, in some instances, with radiological measurements. In addition, male gametophyte generation of fruit trees was applied as bioindicators of genotoxicity. The obtained results did not show any significant increase along with wind direction. As for the male gametophyte assay, the fertility of the investigated fruit-trees near to NPP did not significantly differ from that of the control point. The influence of the NPP on the male generative system of the investigated taxa of fruit trees for the investigated year was not revealed. The system described needs to be expanded by species of interest (human) as there is a difficulty to transfer the revealed dose correlations to humans. The development of this idea includes various levels: population (epidemiological studies), individual, cellular, molecular (DNA), etc.

• Journal of the Korean Society of Industry Convergence
• /
• v.23 no.6_1
• /
• pp.907-915
• /
• 2020

Specification selection, Layout, specifications and combinations of Power Drives, and Ship motions were studied for FGPP(Floating Gas-fired Power Plants), which are still needed in areas such as the Caribbean, Latin America, and Southeast Asia where electricity is not sufficiently supplied. From this study, the optimal equipment layout in ships was derived. In addition, the difference between engine and turbine was verified through LCOE(Levelized Cost of Energy) comparison according to the type and combination of Power Drives. Analysis of Hs(Significant Height of wave) and Tp(spectrum Peak Period of wave) for places where this FGPP will be tested or applied enables design according to wave characteristics in Brazil and Indonesia. Normalized Sloshing Pressures of FGPP and LNG Carrier are verified using a sloshing analysis program, which is CFD(Computational Fluid Dynamics) software developed by ABS(American Bureau of Shipping). Power Transmission System is studied with Double bus with one Circuit Breaker Topology. A nd the CFD analysis allowed us to calculate linear roll damping coefficients for more accurate full load conditions and ballast conditions. Through RAO(Response Amplitude Operator) analysis, we secured data that could minimize the movement of ships according to the direction of waves and ship placement by identifying the characteristics of large movements in the beam sea conditions. The FGPP has been granted an AIP(Approval in Principle) from a classification society, the ABS.

• Journal of the Korean Society of Industry Convergence
• /
• v.24 no.6_2
• /
• pp.827-839
• /
• 2021

Due to climate change and population growth, water scarcity is getting worse all over the world. Among various methods for desalination of seawater, the Multi-Effect Adsorptive Desalination method, which combines the existing Multi-Effect Desalination method and the Adsorptive Desalination method and can produce high-concentration-high-concentration freshwater, is emerging. Because the Multi-Effect Adsorptive Desalination method combines the two different methods, the system becomes complicated and the possibility of failure increases. Therefore, in this study, availability analysis was performed on the Multi-Effect Adsorptive Desalination process. A total of four types of reliability block diagrams were presented, and availability analysis was conducted based on them. The first form of a reliability block diagram is configured in series without any redundancy. The availability of the reliability block diagram composed of the serial system was found to be lower than the required availability. In order to increase availability, the redundancy to pumps and boiler are added to system. As a result of availability analysis, it was confirmed that designing desalination systems with redundancy to pump meets the 93% availability, which is typically required availability for various plants.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.25 no.3
• /
• pp.321-328
• /
• 2022

The current development tend of the gun propellants that they should have low sensitivity and high energy. We studied a nitrocellulose based propellant composition that replaced sensitive NG with RDX and DEGDN which high energy and low sensitivity. The important factors in the design of the gun propellant were impetus and flame temperature. NC-based propellant containing RDX showed similar impetus but low flame temperature compared to KM30A1, a triple-based propellant. The developed propellant composition didn't show any abnormal combustion reaction and the characteristics of ballistic resistance were also confirmed.

• Nuclear Engineering and Technology
• /
• v.55 no.4
• /
• pp.1571-1584
• /
• 2023

In this study, a numerical analysis was performed as part of an international joint research project to reproduce a real cable tray fire that occurred in the heater bay area of the turbine building of a nuclear power plant. A sensitivity analysis was performed on various input parameters to derive results consistent with the sprinkler activation time obtained from the fire event analysis. For all sensitive parameters, the normalized sprinkler activation time correlated well with the power function of the normalized sprinkler height. A correlation equation was developed to identify the sprinkler activation time at any location when determining the slope or fire growth rate under the conditions assuming a linear or t-squared heat release rate (HRR) time curve. Various cable fire growth assumptions were used to determine which assumption was better to provide the prediction coincident with the information given from the fire event analysis in terms of the sprinkler activation time and total energy generated from cables damaged by fire. In the comprehensive analysis of all the sensitive parameters, the standard deviation of the input parameters increased as the sprinkler height decreased. Within the range of the sensitivity parameter values given in this study, when considering all sprinkler heights, the standard deviation of the cable model change was the largest and that of the overhang position change was the smallest.

• Nuclear Engineering and Technology
• /
• v.55 no.3
• /
• pp.981-988
• /
• 2023

A seismic event caused an accident at the Fukushima Nuclear Power Plant, which further resulted in simultaneous accidents at several units. Consequently, this incident has aroused great interest in the safety of nuclear power plants worldwide. A reasonable safety evaluation of such an external event should appropriately consider the correlation between SSCs (structures, systems, and components) and the probability of failure. However, a probabilistic safety assessment in current nuclear industries is performed conservatively, assuming that the failure correlation between SSCs is independent or completely dependent. This is an extreme assumption; a reasonable risk can be calculated, or risk-based decision-making can be conducted only when the appropriate failure correlation between SSCs is considered. Thus, this study analyzed the effect of the failure correlation of SSCs on the safety of the system to realize rational safety assessment and decision-making. Consequently, the impact on the system differs according to the size of the failure probability of the SSCs and the AND and OR conditions.

• Plant Journal
• /
• v.16 no.1
• /
• pp.34-37
• /
• 2020

The need to improve the performance of the dust collector by increasing the fine dust pollution in Korea is eminent. In this study, electrostatic spray wet electrostatic precipitator is used to remove Particulate Matter (PM). In order to enter the Cone-jet mode, which is the most stable spray mode among the various modes of electrostatic spraying, an appropriate voltage-flow condition must be satisfied, and a voltage-flow interval enabling this can be expressed as Stability Island. The voltage at which the conduit mode starts in the Stability Island section is referred to as the electrostatic spray minimum voltage (Onset Voltage). However, the conventional electrostatic spray is uses a very low flowrate, at most few millilitres per minute. The use of much higher flowrates has introduced different patterns of electrospray modes. In this study, the different spray modes will be studied in detail.

• Journal of the Korean Institute of Gas
• /
• v.22 no.4
• /
• pp.63-73
• /
• 2018

Innovative technical process for Energy Storage System (ESS), Liquid Air Energy Storage system (LAES) is mature technologies based on the gas liquefaction process. In spite of many advantages such as high energy density, no geographical constraints, low investment costs and long useful life, the system has not yet widely commercialized due to low round trip efficiency. To improve RTE and acquire high yield of liquid air, various configurations of LAES process have been considered. In this research, dual refrigerants cycle (R-600a and methanol) for air liquefaction and thermal oil circulation for power generation via liquid air gasification have been applied to improve cycle performance significantly using Aspen HYSYS simulator.