• 상하수도학회지
• /
• 제30권5호
• /
• pp.553-559
• /
• 2016

There has been increasing global interest in the environmental pollution problems produced by fossil fuel consumption and greenhouse gas emissions. In order to tackle these issues, new renewable energy such as solar, wind, bio gas, fuel cell and pressure retarded osmosis(PRO) have been developed extensively. Among these energy sources, PRO is one of the salinity gradient power generation methods. In PRO, energy is obtained by the osmotic pressure generated from the concentration difference between high and low concentration solutions separated by a semipermeable membrane. The development for high power density PRO membranes is imperative with the purpose of commercialization. This study investigates development of thin film composite PRO membrane and spiral wound module for high power density. Also, the influence of membrane backing layer on power density was identified, and the characteristic factors of PRO membranes was determined. Different backing layers were used to improve power density. As expected, the PRO membrane with more porous backing layer showed higher power density.

• 전자공학회논문지A
• /
• 제33A권6호
• /
• pp.172-177
• /
• 1996

We have characterized XeCl excimer-laser-induced crystallization of thin amorphous silicon films deposited by PECVD (${\alpha}$-Si:H) and LPCVD (${\alpha}$-Si). The electrical properties, surface roughness and crystallinity of crystallized thin films have been measured. The dc conductivities, crystallinity andsurface roughness of the films increased as the laser energy density and shot density were increased. The properties of laser annealed films deposited by LPCVD were better than those of thin films deposite by PECVD. We have also found that the multiple shots with relative low energy density were more benifical to the improsvement of surface roughness than the single shot with high energy density preserving the crystallinity.

• 한국초전도ㆍ저온공학회논문지
• /
• 제1권1호
• /
• pp.22-27
• /
• 1999

Recently, small-sized superconducting magnetic storage($\mu$SMES) coils become commercially as an energy storage device for a power conditioner. In design and fabrication of the $\mu$SMES coils, to determine optimum current capacity of the superconducting(SC) conductors is one of the important things. We thus investigated the effect of conductor's current capacity, current density, and stability on the coil's maximum stored energy density in consideration of AC losses and switching device's capacities in a power converter. The results show that the smaller current capacity of the SC conductors is preferred for the $\mu$SMES coils but can increase their induced voltage excessively.

• Applied Science and Convergence Technology
• /
• 제23권2호
• /
• pp.90-96
• /
• 2014

Flexible $ZrO_2$ films as dielectric materials for high-energy-density capacitors were deposited on polyethylene terephthalate (PET) substrates by RF magnetron sputtering. The growth behavior, microstructure and electrical properties of the flexible $ZrO_2$ films were dependent on the sputtering pressure and gas ratio. Although $ZrO_2$ films were deposited at room temperature, all films showed a tetragonal crystalline structure regardless of the sputtering variables. The surface of the film became a surface with large white particles upon an increase in the $O_2/Ar$ gas ratio. The RMS roughness and crystallite size of the $ZrO_2$ films increased with an increase in the sputtering pressure. The electrical properties of the $ZrO_2$ films were affected by the microstructure and roughness. The $ZrO_2$ films exhibited a dielectric constant of 21~38 at 1 kHz and a leakage current density of $10^{-6}{\sim}10^{-5}A/cm^2$ at 300 kV/cm.

• 한국정밀공학회지
• /
• 제30권5호
• /
• pp.493-498
• /
• 2013

The present study treats the optimization process for a non-linear grinding system with dual time delay, mainly from the energetic viewpoint. To this end, the stability of the grinding system is investigated first with regard to the grinding wheel rotation speed. The concept of grinding energy density is newly proposed as the primary figure of merit and this quantity is evaluated at various stable and limit cycle conditions. The computational results show that simple monotonic trend in energy density is observed under stable conditions, whilst rather complicated behaviors can appear when the conditions are associated with limit cycle oscillations. Finally, the relations between the vibration amplitude and the energy density and their implications on the engineering decision/compromise are discussed.

• 한국수소및신에너지학회논문집
• /
• 제23권2호
• /
• pp.117-124
• /
• 2012

Alkaline electrolysis needs the electrode having a low overvoltage and good corrosion resistance in alkaline solution such as KOH and NaOH, for the oxygen and hydrogen production. The commercial materials such as SUS(stainless steel)-316, Ni and NiFe were evaluated for the electrode in alkaline electrolysis. The test solution for the alkaline electrolysis used 1~9M NaOH and 1~9M KOH. The voltage increased with an increase of current density in each solution. As for the 15wt.% (about 5M) NaOH, the voltage of the tested electrode under the current density of 1.8A/$cm^2$ showed the almost same value. The voltage over the current density of 1.8A/$cm^2$ deceased in the order: Ni${\fallingdotseq}$NiFe$cm^2$ showed the almost same value. The voltage over the current density of 1.8A/$cm^2$ deceased in the order: NiFe${\fallingdotseq}$SUS-316. From the results, it was estimated that NiFe and Ni was suitable as the electrode for the alkaline water electrolysis using NaOH and KOH electrolyte.

• 한국가금학회지
• /
• 제48권4호
• /
• pp.319-325
• /
• 2021

In this study, we investigated the effects of feeding diets with different levels of energy and nutrient density on the egg quality of laying hens during the pre-peak and peak periods. A total of 192 (Hy-line brown) laying hens were used in a 15-week trial. The hens were randomly allotted to one of four treatments, each with four replicates (12 hens per replication). We assessed the effects of four level of dietary energy (2,710, 2,850, 2,870 and 2,890 kcal/kg) and three levels of nutrient density (Methionine + Cysteine: 0.56%, 0.85%, 0.80% and Crude Protein: 14.5%, 19%, 18%). Differences in the energy and nutrient density contents of diets showed no significant effect (P>0.05) on the average daily gain, average daily feed intake, feed conversion ratio, egg weight, or egg production of hens during the pre-peak and peak periods. However, hens subjected to 2,890 kcal/kg during the pre-peak period were found to lay eggs with significantly thicker shells, and yolk color was found to be significant enhanced in hens fed this diet during the pre-and peak periods. In contrast, we detected no significant effects of dietary energy or nutrient density on the Haugh unit or eggshell strength. In summary, increasing the energy level of diets from 2,710 to 2,890 kcal/kg was found to have positive effects on the shell thickness and yolk color of eggs produced by laying hens.

• 한국태양에너지학회 논문집
• /
• 제26권4호
• /
• pp.39-45
• /
• 2006

The decrease in the summer peak electric load in our country is very important. The government has arranged and implemented a lot of support policies and statutes to decrease the peak electric load. And the ice thermal energy storage system is known as one of the alternatives. The purpose of this paper is to evaluate the efficiency and thermal characteristics of the closed ice thermal energy storage system using screw capsules. The measured thermal energy storage density is about 18.4 USRT-h/m3 (=232.9 MJ/m3), which is higher than 13.0 USRT-h/m3 (=164.6 MJ/m3), a low criterion of normal performance. And The efficiency of the discharging process and the total energy utilization is 96.2% and 2028.4 kcal/kWh respectively.

• 한국수소및신에너지학회논문집
• /
• 제25권3호
• /
• pp.234-239
• /
• 2014

To study catalytic activity and hydrogen embrittlement of Pd, Pt, Ni, and Cr in fuel cell electrode, we used density-functional theory. The calculation tools based electron density give much shorter calculation time and cheap costs. Maximum of bond overlap populations of each metal are 0.6539eV for Pd-H, 0.6711eV for Pt-H, 0.6323eV for Ni-H, 0.6152eV for Cr-H. Electron density of Cr has strongest in related metals, which shows strong localization of electron, implying anti hydrogen embrittlement behaviors.

• Imaging Science in Dentistry
• /
• 제30권4호
• /
• pp.235-242
• /
• 2000

Purpose: To evaluate the effect of the systemic osteoporosis on radiographic density of alveolar bone and cortical thickness of mandible. Materials and Methods: The bone mineral density values of lumbar and femur were measured by dual-energy X-ray absorptiometry and T scores of lumbar, femur were obtained respectively. Radiographic densities of alveolar bones and panorama mandibular index (PMI, represents as cortical thickness) were analysed statistically according to age and T score variables. Results: The radiographic density of alveolar bone of maxillary molar showed significant difference by age and femur T group. That of mandibular molar showed significant difference between femur T group. Panorama mandibular index showed significant difference between age groups. Conclusion: The radiographic density of alvealar bones was more dependent on age and femur T than lumbar T. Cortical thickness of mandible was correlated with increasing age.