• 한국연소학회:학술대회논문집
• /
• 2006.10a
• /
• pp.117-121
• /
• 2006

Non-thermal plasma technology has many applications in various areas. One of the applications is regenerating diesel particulate filter (DPF). DPF is a widely applied device to control the particulate emission of diesel engines. But it needs periodic removal of clogged soot for the smooth running of engine. Conventional high-temperature removal processes easily leads to the breakage of DPF. Herein, low-temperature plasma formed in a dielectric barrier discharge (DBD) reactor was used to form active oxidants such as ozone and nitrogen dioxide. Experimentally, the effects of discharge power and frequency on the performance of DBD reactor were studied. Two oxidants, $O_3$ and $NO_2$, were synthesized and used for incinerating soot in the used DPF. Performances of the two oxidants on the reduction of soot were compared, and it was found that $NO_2$ is more effective than $O_3$ for getting rid of soot

• Journal of Environmental Impact Assessment
• /
• v.10 no.1
• /
• pp.9-19
• /
• 2001

An intensive watershed survey including water quality measurement of 6 times was carried out in order to find out the relationship between pollutant load and water quality in a small stream watershed where livestock wastewater is the main source of water pollution. The findings from the survey are as follows. 1) The number of livestock showed large disagreement among county office, myon, and insite survey. It is vital to check the data at the beginning of watershed survey. 2) The fluctuation of streamflow and water quality was so large depending on the day of measurement that it is essential to set up continuous telemetering system to get reliable data about delivery ratio of pollutants. 3) It was helpful for setting the priority of investigation to check water quality and quantity at several points along the stream after dividing the watershed into 5 drainage areas. 4) To control the livestock wastewater, especially in case of cows, it is necessary to have roof system and prevent overland flow from the ground. In case of pig farms, it is recommended to have public treatment system instead of private treatment system. The exact emission load of livestock wastewater was difficult to estimate, and requires more study.

• Journal of Korean Society on Water Environment
• /
• v.21 no.4
• /
• pp.385-392
• /
• 2005

The control of nonpoint source pollution is essentially needed to successfully perform the Total Maximum Daily Load program. Of the various land uses in the nonpoint source, the paved areas such as a parking lot and a bridge are stormwater intensive land uses because of high imperviousness and high pollutant mass emissions. This research was performed to understand the magnitude and nature of the stormwater emissions with the purposes of quantifying stormwater pollutant concentrations and mass emission rates from a parking lot and a bridge. Two monitoring sites in Kongju city were equipped with an automatic rainfall gages and an automatic flow meter for accumulating the data such as rainfall, water quality and runoff flow rates. This paper will summarize the metal concentration changes during the storm duration and metal EMCs to characterize the concentration profiles in a parking lot and a bridge. Also a new concept, dynamic EMC, will be proposed to find the relationship between EMC and first flush effect. It can be used to determine the economical treatment criteria in best management practices.

• Proceedings of the Korean Environmental Sciences Society Conference
• /
• 2003.11a
• /
• pp.5-10
• /
• 2003

This paper explores not only emerging scientific problems but also the difficulties communicating air quality issues into an increasingly sensitive the public and policy arena. The public understanding and trust in air pollution information and indices may be very different to the notions of validity or accuracy that are important for a scientist. We operate in a world where openness requires us to reveal both the difficulties and disagreements in our understanding of the polluted atmosphere. Yet this can be confusing and increase complexity in situations where clear political and social decisions are required. I am going to examine these issues, starting with questions of what substances we regard as pollutants and the difficulties of getting the correct balance of concern given the broadening the base of chemicals emitted to the environment. There are also questions of exposure particularly in terms of vulnerable populations, who may spend large amounts of time indoors, where air is rarely monitored. In contemporary society there are pollution problems that extend far beyond urban areas and we have to consider regional issues such as windblown dusts, smoke from forest fires along with issues of the emission of green house gases and ozone depleting substances. Finally I will discuss the issues of communicating with a concerned public and sceptical politicians and the troubling interface between technological and sociological control. Such complexity is often missed in a maze of seemingly stronger political and social needs.

• Environmental Engineering Research
• /
• v.24 no.3
• /
• pp.427-433
• /
• 2019

Sakarya is famous for cucurbit productions in Turkey and cucurbits can grow as big as 560 kg of weight per fruit in its agricultural areas. There is no or limited information about contaminant levels and profiles of the agricultural fields in Sakarya. The purpose of this study is to investigate the levels of polycyclic aromatic hydrocarbons (PAHs) (naphthalene, phenanthrene, pyrene, and fluoranthene) and heavy metal (As, Cd, Cu, Cr, Ni, Pb, Zn) concentrations of the selected fields. Total 33 soil samples were collected from 12 counties of Sakarya where both cucurbits have been produced and organochlorine pesticides have been applied to the fields for more than 30 y during the historical plantation periods. Heavy metal and PAH contents in the soil samples were measured by an Inductively Coupled Plasma Emission Spectroscopy and a Gas Chromatography-Mass Spectrometry. The highest phenanthrene, pyrene, and fluoranthene concentrations were measured as 63.50 ng/g, 134.34 ng/g, 140.0 ng/g, respectively in the soil samples from Geyve County. Cu, Ni, and Cr concentrations were measured as 108.2 mg/kg, 219.9 mg/kg, and 173.1 mg/kg, respectively in Geyve's samples which were also the highest and 2-7 times more than the limit values given in the Turkish Soil Pollution Control Regulation. Precautions need to be taken for Sakarya's agricultural fields which are an important milestone of Turkey's cucurbit and fruit productions since the contaminants can be accumulated in the fruits and edible parts of the plants.

• Journal of IKEEE
• /
• v.13 no.1
• /
• pp.49-56
• /
• 2009

In this paper, a simulation for the stability of the catenary voltage through charging and discharging by introducing an energy storage system in the railway system and the efficient usage of restoration energy has been performed. In order for the simulation, a simple railway model with an appropriate control technique has been introduced. The catenary voltage area is divided into two areas with voltage control and an area with normal operation and current control is performed to satisfy current limit of the supercapacitor. We confirmed the energy absorption and emission through the simulation and observed energy efficiency through charging and discharging according to the operation state of the railway.

• Journal of Korean Society for Atmospheric Environment
• /
• v.13 no.1
• /
• pp.19-29
• /
• 1997

It is more likely that the degree of air quality degradation that we have faced would be much lessen, if integrated management of air pollution control and assessment had been fully enforced by the local administrations, not by the centralized environmental agency in the first place. As the selfgoverning local administrations have been established since 1995, the need for air quality control by the local administration or local agency is getting the ground. However, in practice, air quality control by the local administration rarely put into effect due to lack of basic data which cover the present trends of air quality in each local city or county and are necessary for decision making. The emissions of SO$_2$ in each city and county of Korea in 1993 were calculated in this study, based on energy consumptions and emission factors. The ambient concentrations of SO$_2$ also were estimated by applying modified Miller-Holtzworth model. Observed and estimated concentrations of SO$_2$ showed that about 17.5 percents of cities and counties in the country were more polluted than the target value, 20ppb/year. The emissions and ambient concentrations of SO$_2$ in each city and county in 2000, 2005, and 2010 were also forecasted, assumed business as usual senario. It was shown that, in 2010, the emissions of SO$_2$ will be 2.8 times more than those of 1993 and much of them are from industrial sector. Also shown that 38.3 percents of cities and counties will be more polluted than the target value and most of them are polluted areas in 1993. The methods and results of this study could be used in developing the efficient reduction strategies in each city and county.

• Journal of odor and indoor environment
• /
• v.16 no.3
• /
• pp.277-286
• /
• 2017

The objectives of this study were to investigate the effects of $PM_{10}$ and $O_3$ concentration on the symptoms of allergic diseases. The questionnaire was used to determine whether or not symptoms of allergic diseases were present from September to October 2012. The air pollution concentration data used was the corresponding point CEM (continuous emission monitoring) data. The average concentration of $PM_{10}$ was $56.09{\mu}g/m^3$ in the control area, and the concentration in the exposed area was $40.44{\mu}g/m^3$. In the two areas, concentration of $O_3$ was 28.73 ppb and 28.74 ppb, respectively. The total average concentrations of $PM_{10}$ and $O_3$ were $45.66{\mu}g/m^3$ and 28.73 ppb in the Gwangyang area. The rate of asthma diagnosis was higher in the control area (9.6%) than in the exposed area (4.1%), but the rate of allergy eye disease was higher in the exposed area (23.9%) than in the control area (16.5%). There was a significant difference in the symptoms of some allergic diseases when the relative concentration of $PM_{10}$ and $O_3$ were high and low.

• Journal of Korean Society for Atmospheric Environment
• /
• v.34 no.2
• /
• pp.269-280
• /
• 2018

This paper reports the results of field evaluation to determine the levels of heavy metals in major industrial complexes in Korea over a seven year period (2007~2013). The measurement of heavy metal was conducted using quartz fiber filter sampling and ICP-AES analysis. In order to validate the analytical performance of these methods, studies were also carried out to investigate data quality control(QC) parameters, such as the method detection limit (MDL), repeatability, and recovery efficiencies. The average concentrations of total suspended particulates (TSP) for the nine industrial complexes in Korea were $104{\sim}169{\mu}g/m^3$, which was higher than other industrial complexes and urban areas. The Sihwa and Banwol industrial complexes were shown to be the biggest contributing sources to high TSP emission ($159{\mu}g/m^3$ and $169{\mu}g/m^3$, respectively). The concentrations of heavy metals in TSP were higher in the order of Fe>Cu>Zn, Pb, Mn>Cr, Ni, As and Cd. It was observed that Fe was the highest in the Gwangyang and Pohang steel industrial complexes. The concentrations of Zn and Pb were high in Onsan, Sihwa and Banwol industrial complexes, and this was attributed to the emission from the nonferrous industry. Additionally, Cr and Ni concentrations were high in the Sihwa and Banwol industrial complexes due to plating industry. On the other hand, Ulsan and Onsan industrial complexes showed high Cr and Ni concentrations as a response to the emission of metal industry related to automobile. The correlation analysis revealed the high correlation between Cr and Ni in plating industry from Sihwa and Banwol industrial complexes. Adding to this, components related to coal combustion and road dust showed high correlation in Pohang and Gwangyang industrial complexes. Then Onsan and Ulsan industrial complexes showed high correlation among components related to the nonferrous metals.

• Journal of Periodontal and Implant Science
• /
• v.44 no.5
• /
• pp.227-234
• /
• 2014

Purpose: Dentin hypersensitivity is a potential threat to oral health. Laser irradiation may provide reliable and reproducible treatment but remains controversial. The present study aimed to evaluate the effects of $CO_2$ or erbium-doped yttrium aluminium garnet (Er:YAG) laser therapy, and to assess mineral content. Methods: Eighteen human single-rooted teeth affected with advanced periodontitis were obtained. Buccal and lingual surfaces were planed to form 36 specimens. Ethylenediaminetetraacetic acid gel (24%) was applied to remove the smear layer and simulate hypersensitive teeth. The experimental groups were: group 1, control (no irradiation); group 2, $CO_2$ laser (repetitive pulsed mode, 2 W, $2.7J/cm^2$); and group 3, Er:YAG laser (slight contact mode, 40 mJ/pulse and 10 Hz). To evaluate dentinal tubule occlusion, six specimens per group (2-mm thickness) were prepared and observed using scanning electron microscopy (SEM) for calculation of the occlusion percentage. To evaluate the mineral content, six specimens per group (0.6-mm thickness) were used, and then the levels of Ca, K, Mg, Na, and P were measured by inductively coupled plasma-atomic emission spectrometry. In addition, the surface temperature of the specimens during laser irradiation was analyzed by a thermograph. Results: The SEM photomicrographs indicated melted areas around exposed dentinal tubules and a significantly greater percentage of tubular occlusion in the $CO_2$ and Er:YAG laser groups than the control, and in the Er:YAG group than the $CO_2$ laser group. In addition, no significant differences were noted among the experimental groups for the mineral elements analyzed. The $CO_2$ laser group showed an evident thermal effect compared to the Er:YAG group. Conclusions: $CO_2$ and Er:YAG laser are effective in treating dentin hypersensitivity and reducing its symptoms. However, the Er:YAG laser has a more significant effect; thus, it may constitute a useful conditioning item. Furthermore, neither $CO_2$ nor Er:YAG lasers affected the compositional structure of the mineral content.