• 대한전자공학회논문지SD
• /
• 제42권8호
• /
• pp.7-14
• /
• 2005

본 논문은 새로운 저전력 BIST 패턴 생성기에 대해 제안하고 있다. 이는 천이 감시 윈도우 블록과 MUX로 구성된 천이 감시 윈도우를 사용하는데, LFSR(linear feedback shift register)에서 생성되는 무작위 테스트 패턴의 패턴 천이 수 분포가 유사 무작위 가우시안(pseudo-random gaussian) 분포를 보이는 성질을 이용한다. 제안된 방식에서 천이 감시 윈도우는 스캔 체인에서 높은 전력 소모의 원인이 되는 초과 천이를 감지하고, k-value라는 억제 천이 수를 통해 초과 천이를 억제하는 역할을 한다 ISCAS'89 벤치마크 회로 중 많은 수의 스캔 입력을 갖는 회로를 사용하여 실험한 결과, 성능 손실 없이 약 $60\%$정도의 스캔 천이 수 감소를 나타내었다.

• 센서학회지
• /
• 제28권5호
• /
• pp.311-317
• /
• 2019

Rotating devices are commonly installed in power plants and factories. This study proposes a self-powered sensor node that is powered by converting the vibration energy of a rotating device into electrical energy. The self-powered sensor consists of a piezoelectric harvester for self-power generation, a rectifier circuit to rectify the AC signal, a sensor unit for measuring the vibration frequency, and a circuit to control the light emitting diode (LED) lighting. The frequency of the vibration source was measured using a piezoelectric-cantilever-type vibration frequency sensor. A green LED was illuminated when the measured frequency was within the normal range. The power generated by the piezoelectric harvester was determined, and the LED operation was assessed in terms of the vibration frequency. The piezoelectric harvester was found to generate a power of 3.061 mW or greater at a vibration acceleration of 1.2 g ($1g=9.8m/s^2$) and vibration frequencies between 117 and 123 Hz. Notably, the power generated was 4.099 mW at 122 Hz. As such, our self-powered sensor node can be used as a module for monitoring rotating devices, because it can convert vibration energy into electrical energy when installed on rotating devices such as air compressors.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2006년도 하계종합학술대회
• /
• pp.881-882
• /
• 2006

According as society looks graying trend gradually, more shaped system that can achieve measuring health-state of old people more harmoniously construction required in field of old people's welfare and medical treatment. Health-state is measured by two methods of contact and non-contact. The first, for example measurement of blood pressure or electrocardiogram, requires that measuring equipments are attached on human body but the second, for example X-Ray or MRI, is not. But both of methods are have some of defect, for example attaching equipments, needing of the special equipments or the necessary time, etc. Therefore desirable method of monitoring system must have minimum interrupt about daily life. This study suggest the system that can monitor the user, especially old people's outward aging and health-state by use the PAN TILTER and CCD camera.

• 대한의용생체공학회:학술대회논문집
• /
• 대한의용생체공학회 1996년도 춘계학술대회
• /
• pp.320-324
• /
• 1996

Digital fetal monitoring system based on the personal computer combined with the digital signal processing board was implemented. The DSP board acquires and digitally processes ultrasound fetal Doppler signal for digital rectification, FIR filtering, autocorrelation function calculation, its peak detection and MEDIAN filtering. The personal computer interfaced with the DSP board is in charge of graphic display, hardcopy, data transmission and on-line analysis of fetal heart rate change including and variability. I used a recursive technique for autocorrelation function computation method and MEDIAN filter which can greatly reduce the amount of calculation and accuracy. I also implemented analysis algorithm of fetal heart rate change based on normal fetal sample data in order to exact diagnosis.

• 한국정보전자통신기술학회논문지
• /
• 제2권3호
• /
• pp.9-15
• /
• 2009

분만시 국내에서 영아 사망률은 약 1%에 이르고, 태아의 질병 발생과 사망은 계속적으로 일어나고 있으므로 저가의 태아 모니터링기술의 개발이 절실하다. 이를 위하여 본 연구에서는 임산부의 복부로부터 태아의 움직임과 심음을 검출할 수 있는 증폭기를 설계하여 고성능 태아 포노그램용 전자청진장치를 개발하고자 한다. 장치로부터 검출된 태아의 청진 신호는 듣거나 녹음할 수 있으며, PC에서 태아의 심음을 분석할 수도 있다. 개발된 증폭기를 이용하여 잡음에 노출된 일반 대학병원 환경에서 30명의 임산부를 대상으로 임상실험을 수행한 결과, 개발된 증폭기는 저잡음, 고이득의 특성을 나타내고, 임산부 중에서 빠른 경우 22주에서도 태아의 심음을 검출할 수 있었고, 심음의 주기검출이 가능하였다.

• 전력전자학회논문지
• /
• 제20권3호
• /
• pp.209-213
• /
• 2015

With the increasing popularity of renewable generation systems and the advancement of power electronics, DC distribution systems have recently received considerable research attention. DC distribution has numerous advantages, including reliability, power quality, and efficiency. Owing to these advantages, DC distribution has been applied to data centers and power quality-sensitive electronic load conditions. Because grounding electrodes in DC are much more susceptible to corrosion than in AC, the IT system defined in IEC Standard 60364 may be a good candidate for an earthing method for DC distribution systems. In addition, IEC Standard 61557 specifies the requirements for insulation monitoring devices (IMD) for protection of the IT system, which continuously monitors the insulation resistances between the power lines and the earth. This paper discusses the development and evaluation of IMD to promote the reliability of distribution systems and increase safety of humans and facilities.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2008년도 하계종합학술대회
• /
• pp.207-208
• /
• 2008

In this paper, we propose an efficient algorithm for reducing the complexity of LDPC code decoding by using node monitoring (NM). This NM algorithm is based on a new node-threshold method, and the message passing algorithm. This algorithm was simulated in order to verify its efficiency. Simulation results show that the complexity of our NM algorithm is improved to about 10%, compared with well-known methods.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 하계학술대회 논문집 D
• /
• pp.2811-2813
• /
• 2000

Nowadays PLC is used for controlling various industrial processes. For its better performance operating status of PLC should be continuously checked. However. it is difficult to monitor the status of PLC owing to the spatial limitation. This paper presents an internet based remote monitoring and control system for PLC and a practical implementation for Tiny PLC is executed for verifying its feasibility.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 하계학술대회 논문집 D
• /
• pp.2808-2810
• /
• 2000

Most measuring devices are equipped with RS232 interface or GPIB interface for communicating with computers. If the measuring devices can be accessed by a server computer, the valuable information from the devices can be effectively shared with other computer via internet. VRML is a web based technology for specifying and delivering three-dimensional interactive visualizations over the internet through a web browser. This paper proposes a remote 3-dimensional monitoring system for digital multimeter equipped with RS232 interface by utilizing VRML.

• 전기학회논문지
• /
• 제58권5호
• /
• pp.1047-1049
• /
• 2009

This paper presents an intelligent electronic device(IED) platform which is based on a new frequency estimation algorithm. The IED platform features not only the accurate estimation of frequency but also the fast network-based transmisstion of fault data and waveforms. The simulation results show that the proposed frequency estimation algorithm improves convergence speed, and has lower frequency estimation error compared with those of conventional algorithms. The network-based IED is designed to ensure transmission latency being less than 1.0% of sampling interval.