• Applied Microscopy
• /
• v.26 no.1
• /
• pp.1-9
• /
• 1996

This paper aims to probe the effect of SQ in the rat liver which pretreated with CP was examined by transmission electron microscope. In the A group, the difference between the normal and the treated groups were not detected at 24 hours, but the few mitochondria were expanded at the 72 hours. In the B group, the cisternae of rough-surfaced endoplasmic reticulum were partially destructed and attached ribosomes were remarkably decreased at 24 hours. A number of the mitochondria were dilated and increased in number, the filamentous materials also detected at 72 hours. These results suggest that SQ is not only concerned with construction of the membrane of the cell organelles but also decreased the cellular toxicity in the hepatic cells.

• Journal of Sensor Science and Technology
• /
• v.24 no.5
• /
• pp.348-352
• /
• 2015

Thin nickel oxide films formed on uncooled and cooled $SiO_2/Si$ substrates using a radio frequency (RF) magnetron sputter powered by 200 W in a mixed atmosphere of argon and oxygen. Grazing-incidence X-ray diffraction and field emission scanning electron microscopy are used for the structural analysis of nickel oxide films. The electrical conductivity required for better bolometric performance is estimated by means of a four-point probe system. Columnar and (200) preferred orientations are discovered in both films regardless of substrate cooling. Electric resistivity, however, is greatly influenced by the substrate cooling. Oxygen partial pressure increase during the nickel oxide deposition leads to a rapid decrease in resistivity, and the resistivity is higher in the cooled nickel oxide samples. Even when small microstructure variations are applied, lower resistivity in favor of low noise performance is acquired in the uncooled samples.

• Proceedings of the Korean Magnetic Resonance Society Conference
• /
• 2002.08a
• /
• pp.72-72
• /
• 2002

In most traditional sorption study in environmental conditions, experimental sorption data have been measured and interpreted by empirical ways such as partition coefficient and sorption isotherms. A mechanistic understanding of heavy metal interactions with various minerals (metal oxides, clay minerals) in aqueous medium is required to describe the behavior of radioactive metal ions in the environment. Various spectroscopic methods provide direct or indirect information on sorption mechanisms involved. We applied EPR (Electron Paramagnetic Resonance) spectroscopy to investigate the nature of metal ion sorption at water/mineral interfaces using Cu(II) as a spin probe. The major sorbed species and their motional state was identified by their EPR spectra. They showed distinct signals due to their strength of binding, local structure and motional state. The EPR results together with macroscopic sorption data show that sorption involved at least three different mechanisms depending on chemical environments (1).

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.385-386
• /
• 2007

We prepared the Al doped ZnO coating Ag multilayer thin films on glass without substrate heating using FTS system. The structure of multilayer thin films has Al doped ZnO/Ag/Al doped ZnO(AZO/Ag/AZO). The thickness of top and bottom AZO thin films were fixed to 50 nm, respectively and controlled the thickness of Ag thin films with deposition time. As-doped multilayer thin films were prepared at 1mTorr and input power (DC) of 100W at room temperature. To investigate the film properties, we employed four-point probe, UVNIS spectrometer, X-ray diffractometer (XRD), scanning electron microscopy (SEM), Hall Effect measurement system and Atomic Force Microscope (AFM).

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.11a
• /
• pp.492-493
• /
• 2007

Organic field-effect transistors (OFETs) are of interest for use in widely area electronic applications. We fabricated a copper phthalocyanine(CuPc) based field-effect transistor with different metal electrode. So we need the effect of the substituent group attached to the phthalocyanine on the surface potential was investigated by Kelvin probe method with varying temperature of the substrate. We were obtained the positive shift of the surface potential for CuPc thin film. We observed the electron displacement at the interface between Au electrode and CuPc layer and we were confirmed by the surface potential measurement.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.403-404
• /
• 2007

We prepared the Al doped ZnO (AZO) thin film on polyethersulfon (PES) without any substrate heating by Facing Targets Sputtering (FTS) system. ZnO doped the content of Al 2 wt% was used and the sputtering conditions were gas pressure 1mTorr and input power 100W. The electrical, structural and optical properties of AZO thin films were investigated. To investigate the as-deposited thin film properties, we employed four-point probe, UV/VIS spectrometer, X-ray diffractometer (XRD), scanning electron microscopy (SEM), Hall Effect measurement system and Atomic Force Microscope (AFM).

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.02a
• /
• pp.223-223
• /
• 2010

본 연구에서는 Al-doped ZnO (AZO) 박막을 linear facing target sputter (LFTS) 시스템을 이용하여 성막 하였고 박막의 특성을 분석하였다. LFTS 시스템은 마주보는 두 AZO 타겟 사이에 고밀도의 플라즈마를 구속시켜 플라즈마 데미지 없이 산화물 박막을 성막 시킬 수 있는 장치이다. LFTS로 성막된 AZO 박막의 인가된 DC 파워에 따른 전기적 특성을 분석하기 위해 four-point probe와 Hall measurement 장비를 이용하여 분석을 진행 하였으며, 광학적 특성 분석을 위해 UV/Vis spectrometer 장비를 이용하여 분석하였다. AZO 박막의 구조적, 표면적 특성을 분석하기 위해 X-ray diffraction(XRD) 및 scanning electron microscope(SEM)을 사용하여 상온에서 성막된 AZO 박막의 특성을 관찰 하였다. 또한 AZO 박막의 PET 기판과의 접합성 및 구부림 시의 안정성을 평가하기 위해 bending test를 진행 하였다. 최적화된 AZO 박막으로부터 기판에 성막 중 열처리공정이나 후 열처리 공정의 진행 없이 35 ohm/square의 낮은 면저항과 약 80 % 이상의 투과율을 얻을 수 있었다. LFTS 시스템을 이용하여 낮은 공정온도에서 AZO 박막을 성막 하였음에도 불구하고 낮은 저항과 높은 투과도 특성을 나타내고 있어 기존의 투명 박막을 대체 할 수 있는 가능성을 제시하였다

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.08a
• /
• pp.286.2-286.2
• /
• 2013

기존의 이온성 고분자-금속 복합체(IPMC)는 백금(Pt)전극을 이온성 전기활성 고분자(Ionic electroactive polymer)인 나피온에 무전해 도금으로 만들어졌다. 본 연구는 백금전극을 그래핀으로 대체하여 투명 이온성 고분자-그래핀 복합체(IPGC)를 제작하였다. 그래핀은 근적외선 화학기상증착법(NIR-CVD)으로 전이금속 (Cu, Ni) 위에 탄화수소 가스(CH4)를 이용하여 성장하였다. 전이 금속위에 성장된 그래핀을 나피온 양쪽면에 van der Waals 결합력을 이용하는 습식 전이공정으로 전극을 형성하였다. IPGC는 면 저항(4-point probe), 투과도(UV/Vis spectrometer) 및 라만 분광법(Micro Raman spectroscopy)의 측정으로 그래핀 전극의 특성평가를 하였고, 전계방사 주사전자현미경(Field Emisson Scanning Electron Microscope; FE-SEM)을 사용하여 IPGC의 구조적 특성을 확인하였다. 제작된 IPGC의 성능은 백금전극을 이용한 IPMC의 변위(displacement), 힘(force), 작동 주파수(Operating frequency) 분석을 통해 비교 평가하였다.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.08a
• /
• pp.98.2-98.2
• /
• 2013

Electrochemical phenomena underpin a broad spectrum of energy, chemical, and information technologies such as resistive memories and secondary batteries. The optimization of functionalities in these devices requires understanding electrochemical mechanisms on the nanoscale. Even though the nanoscale electrochemical phenomena have been studied by electron microscopies, these methods are limited for analyzing dynamic electrochemical behavior and there is still lack of information on the nanoscale electrochemical mechanisms. The alternative way can be an atomic force microscopy (AFM) because AFM allows nanoscale measurements and, furthermore, electrochemical reaction can be controlled by an application of electric field through AFM tip. Here, I will summarize recent studies to probe nanoscale electrochemical reaction in battery applications by AFM. In particular, we have recently developed electromechanical based AFM techniques for exploring reversible and irreversible electrochemical phenomena on the nanoscale. The present work suggests new strategies to explore fundamental electrochemical mechanisms using the AFM approach and eventually will provide a powerful paradigm for probing spatially resolved electrochemical information for energy applications.

• 한국가시화정보학회:학술대회논문집
• /
• 2002.11a
• /
• pp.31-34
• /
• 2002

Imaging techniques using x-ray beam at high energies (>6KeV) such as contact radiography, projection microscopy, and tomography have been used to nondestructively discern internal structure of objects in material science, biology, and medicine. This paper introduces the x-ray micro-imaging method using 1B2 micro-probe line of PAL (Pohang Accelerator Laboratory). Cross-sectional information on low electron density materials can be obtained by probing a sample with coherent synchrotron x-ray beam in an in-line holography setup. Living organism such as plants, insects are practically transparent to high energy x-rays and create phase shift images of x-ray wave front. X-ray micro-images of micro-bubbles of $20\~120\;{\mu}m$ diameter in an opaque tube were recorded. Clear phase contrast images were obtained at Interfaces between bubbles and surrounding liquid due to different decrements of refractive index.