• Transactions of the Korean Society of Automotive Engineers
• /
• v.22 no.7
• /
• pp.70-75
• /
• 2014

The experiment was done on traveling at the speed of 20km/h, 60km/h and 100km/h using the performance testing mode for chassis dynamometer. The experimental method were employed to measure the waveform of secondary ignition coil and exhaust emission. In this experiment, the correlation between the secondary waveform coming from ignition coil and exhaust emission were measured in decrepit vehicle. The secondary waveform characterized by the value of effective discharge energy. The following results are obtained by analyzing the data relativity between the effective discharge energy and exhaust emission. The variation rate of effective discharge energy was largest 60km/h, 20km/h, 100km/h velocity in the ordered named. As the vehicle velocity increases, the average variation rate of CO and $NO_X$ decreases and that of HC and $CO_2$ decrease. The value of effective discharge energy, CO, $NO_X$ and fuel consumption is measured badly in case of car with failures in MAP, spark plug and good in case of car with before and after maintenance regardless of vehicle velocities. The value of effective discharge energy is to be nearly parabolic shape as vehicle velocity increases. As the value of effective discharge energy increases, the value of $NO_X$, HC and $CO_2$ decrease, the value of CO increase. The most sensible factors of exhaust emission were CO, $NO_X$, and the small variation factors were HC, $CO_2$.

• Journal of Hydrogen and New Energy
• /
• v.13 no.1
• /
• pp.65-73
• /
• 2002

Because of low flame ion density in hydrogen-air mixture, many residual electric energy could be existed in the ignition system of hydrogen engine, If these residual energy discharged abnormally during intake stroke, it may be the cause of backfire occurrence which is serious problem in development of hydrogen fueled engine but unsolved in spite of many concerned research on it. In this study, the possibility of backfire occurrence by abnormal electric discharge and countermeasure of that were investigated by using the experimental single cylinder hydrogen fueled engine with two types of ignition system. The results show that abnormal electric discharge appeared in low load with low ion density and then results in back fire occurrence, It is also seen that countermeasure method installing larger earth resistance in high tension code is effective to control abnormal electric discharge.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.20 no.7
• /
• pp.58-64
• /
• 2006

Recently deep interests have been paid on the effective generation of ozone, which has been widely used for water treatment, deodorization, color removal, and chemical processing of exhausted smoke. The silent discharge reaction has been proposed as the most effective one in the many ozone generation methods, because the silent discharge can be generated under the conditions of lower applied voltage and power consumption, compared other ones. In this paper, in order to improve the ozone generation and ozone generation efficiency, the conventional silent discharge chamber with $Al_2O_3$ dielectric layer and tubular ferroelectric bed discharge reactor packed with $Al_2O_3$ pellets were made, and the silent discharge of the reactors were studied experimentally. The ozone generation characteristics are also discussed based on the discharge characteristics, especially on the wall charge accumulation properties and power consumption. The results show that the electric charges of discharge tube with bead are around 2.5 times as large as those without bead. In the discharge chamber packed with dielectric beads, the ozone concentration and the energy yield characteristics were also improved, compared with those in the conventional silent discharge reactor.

• Journal of the Korean Society of Safety
• /
• v.15 no.3
• /
• pp.66-70
• /
• 2000

In order to cope with environmental problems caused by harmful gases emitted from various industrial sources, a new technology which employs discharge plasma formed in ordinary atmospheric pressure has been intensively investigated in many industrialized nations. Although a plenty of useful outcomes and suggestions have been made public by scientists in this field, few commercial products which effectively decompose pollutant gases have appeared as yet. This is partly because that the energy efficiency of a most effective plasma reactor has not reached a satisfactory level in comparison with those of devices using conventional technologies. In an attempt to solve the problem mentioned above, we noticed to combine heterogeneous electrical discharges. This concepts is based on that each plasma reactor has its specific spatial region in which chemical reaction are active and by electrically affected with another reactor of different type, the activated region would increase - which may lead to cutting down the energy consumption. To prove this concept experimentally, two different discharge equipments, a plane ceramic-based surface discharge electrode and a corona electrode with tungsten needle may, are selected and combined to fabricate a hybrid plasma reactor. The results are summarized as follows; (1) Ozone concentration generated in the plasma region drastically increases when the positive corona discharge is added to the surface discharge. The rate of increase of ozone depends on the frequency of the surface discharge. The negative corona, however, does not contribute to the improvement of the ozone generation. (2) NO(nitrogen monoxide) decomposition rate also improves by simultaneously applying the surface and the positive corona discharges. The effect of the corona superposition is more evident when the level of the surface discharge is moderate. (3) By adjusting the corona level, the net energy efficiency during NO decomposition improves in comparison with the simple surface discharge reactor.

• Proceedings of the KIEE Conference
• /
• 2000.07c
• /
• pp.2147-2149
• /
• 2000

The silent discharge is known to be one of the most effective methods for ozone generation. In this paper. in order to improve ozone concentration and energy yield, some kind of silent discharge-type reactors with different dielectric materials were prepared. Some silent discharge characteristics of these reactors were studied and discussed.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.22 no.4
• /
• pp.235-240
• /
• 2010

The foam produced by the effluent cooling water which is released to the discharge channel provokes civil complaints due to the visual pollution to the neighboring residents. In this study, a physical model test was conducted by placing tetrapods on the bottom slope of the discharge channel in order to suggest an effective method of reducing the amount of generated foam. Field application of the main results of the model test showed qualitatively apparent reduction of the foam generation at the discharge channel.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2015.08a
• /
• pp.153-153
• /
• 2015

Application of the plasma is already highlighted as a new technology in the last few years. In these days, there are lots of attempt in various application with plasma in that it is known as an effective treatment to animal, plants, material and so on. Plasma in liquid, one of new plasma applications, has advantages in ability to treat bio-cell or solutions. For example, electro-surgery, water purification, radical generation and so on. Especially, plasma discharge in solutions is very useful technique and difficult to generate due to electrolysis, vaporization and something else. In this study, we have performed plasma discharge and checked sustainability of plasma in solution(saline 0.9%). And we have measured basic characteristics of plasma in liquid. Such as electrical energy and plasma density are calculated from discharging current and voltage. Also, its thermal energy is measured with IR camera.

• Korean Journal of Organic Agriculture
• /
• v.9 no.3
• /
• pp.23-44
• /
• 2001

To address complex solutions to tack1e the cost rise with the increasing of the prices of crude oil, and to lower warming gas discharge in agricultural sector in line with the framework Convention on Climate Change, we need to net only develop the methods of simply reducing energy use ratio, but also effectively energize resources discharged in the course of agricultural production aimed at enabling repealed farming, and develop systems to reinvest such energy into agricultural production and apply them to actual farming. To that end, specifically, we need to reduce the energy cost in agricultural production, and produce and harness bio gas that makes it possible to stabilize the continued supply of energy. Thus, in this research, we seek to discuss energy use volume and warming gas discharge, and the characteristics of bio gas and its use methods alike, in agricultural sector, and thus present methods for environment-friendly and continual development in agriculture.

• Fisheries and Aquatic Sciences
• /
• v.4 no.4
• /
• pp.257-260
• /
• 2001

The effects of light, desiccation and salinity on the discharge of spores in Korean agarophyte, Gracilaria verrucosa were studied. Among the examined factors, light after darkness was the most effective for spore discharge. The maximum release of tetraspores was induced at 24 h after the treatment. Desiccation also seems to be conductive to the release of tetraspores. However, its effect, as in treatment of distilled water for salinity, was hardly found in induction of carpospore discharge. This may suggest that spore discharge in this alga is primarily related with photoperiodic rhythm. Also it appears that the amount of light energy received by fertile thalli also significantly affects to the spore release, considering relationship between the amount of the discharged spores and the elapsed time after treatment.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2006.05a
• /
• pp.391-394
• /
• 2006

This paper presents soft switching zero voltage switching high frequency inverter for rare gas fluorescent lamp using dielectric-barrier discharge phenomenon. The simple high-frequency inverter can completely achieve stable zero voltage soft switching (ZVS) commutation for wide its output power regulation ranges and load variations under its constant high frequency pulse density modulation (PDM) scheme. Its transient and steady state operating principle is originally described and discussed for a constant high-frequency PDM control strategy under a stable ZVS operation commutation, together with its output effective power regulation characteristics-based on the high frequency PDM strategy. The experimental operating performances of this high frequency Inverter are illustrated as compared with computer simulation results and experimental ones. Its light dimming characteristics due to power regulation scheme are evaluated and discussed on the basis of simulation and experimental results. The feasible effectiveness of this high frequency inverter appliance implemented here is proven from the practical point of view.