• Journal of the Korean Society of Industry Convergence
• /
• v.22 no.3
• /
• pp.251-257
• /
• 2019

This paper proposes a new measurement method using virtual power concept to measure the effective value of 3-phase voltage with variable frequency. The conventional effective value measurement method uses a method of integrating data sampled during one or half cycle of the power voltage and averaging it. In this method, since the effective voltage is calculated every cycle, a time delay occurs in the measured effective voltage and it is s a problem to measure the effective value of a device whose frequency varies from time to time, such as a generator. The proposed 3-phase voltage rms measurement method has an advantage that it can measure accurate voltage RMS value regardless of measurement frequency variation. In particular, there is an advantage in that it is possible to measure a 3-phase effective voltage rather than an average value of the effective voltage of each phase in a 3-phase unbalance voltage. In addition, the validity of the proposed method is verified by using the Psim simulation tool and the experimental results are analyzed by applying the proposed measurement algorithm to the actual three phase synchronous generator voltage measurement experiment.

• Particle and aerosol research
• /
• v.15 no.3
• /
• pp.115-126
• /
• 2019

In this study, a serial methodology is presented for estimating the effective density of ambient sub-micron aerosol employing lab-made 1 stage low-pressure impactor of Hyun et al. (2015) and SMPS (Scanning Mobility Particle Sizer) together. The effective density from this methodology (Impactor+SMPS) was compared with another methodology (BAM+SMPS) for estimating the effective density employing BAM (Beta-Attenuation Monitor) and SMPS. As a result, the effective density obtained with impactor+SMPS ranged from $0.42g/cm^3$ to $2.36g/cm^3$, while the effective density obtained with BAM+SMPS ranged from $1.01g/cm^3$ to $1.72g/cm^3$. The difference between these results might be caused by the particle loss in the impactor.

• Tribology and Lubricants
• /
• v.36 no.6
• /
• pp.320-323
• /
• 2020

Thin film coatings are commonly exploited to minimize wear and optimize the frictional behavior of various precision mechanical systems. The enhancement of thin film durability is directly related to the performance maximization of the system. Therefore, a fine approach to analyze the thin film wear behavior is required. Archard's equation is a representative and well-developed law that defines the wear coefficient, which is the probability of creating wear particles. A ploughing model is a commonly used model to determine the friction force during the abrasive contact. The equations demonstrate that the friction force and wear coefficient are inversely proportional to the hardness of the material. In this study, Archard's equation and ploughing models are modified with an effective hardness to minimize the gap between the experimental and numerical results. It is noted that the effective hardness is the hardness variation with respect to the penetration depth owing to the substrate effect. The nanoindentation method is utilized to characterize the effective hardness of Cu film. The wear coefficient value considering the effective hardness is more than three times higher than that without considering the effective hardness. The friction force predicted with the effective hardness agreed better with the results obtained directly from the friction force detecting sensor. This outcome is expected to improve the accuracy of friction and wear amount predictions.

• Proceedings of the Korean Information Science Society Conference
• /
• 2002.04a
• /
• pp.280-282
• /
• 2002

기존의 네트워크에서는 혼잡상황이 감지된 이후에 네트워크 성능이 급격하게 저하된다. 이러한 문제를 해결하고자 RED(Random Early Detection)기법이 소개되어 게이트웨이에서 혼잡상황에 대하여 능동적으로 대처할 수 있는 알고리즘이 제시되었다. 하지만, RED는 매개변수 설정이라는 문제가 남아있다. 그리하여, 잘못된 변수값 설정으로 인한 네트워크 성능 저하가 현저하게 발생한다. 본 논문에서는 기존의 RED를 개선한 Effective RED를 제안한다. Effective RED는 RED 알고리즘의 문제점을 개선하여 네트워크의 상황에 맞추어 동적으로 매개 변수 값을 조정하는 알고리즘이다. 그리고, ns를 이용하여 Effective RED의 성능을 검증하였다.

• Structural Engineering and Mechanics
• /
• v.24 no.5
• /
• pp.601-620
• /
• 2006

The paper presents an effective stiffness model for deformational analysis of reinforced concrete cracked members in bending throughout the short-term loading up to the near failure. The method generally involves the analytical derivation of an effective moment of inertia based on the smeared crack technique. The method, in a simplified way, enables us to take into account the non linear properties of concrete, the effects of cracking and tension stiffening. A statistical analysis has shown that proposed technique is of adequate accuracy of calculated and experimental deflections data provided for beams with small, average and normal reinforcement ratios.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2003.11a
• /
• pp.595-599
• /
• 2003

For implementation of the strut-tie model approach to the practical analysis and design of structural concrete, the effective strengths of concrete struts in a strut-tie model, which have a crucial effect on the determination of strut and tie forces and the validity verification of strut-tie model's geometric compatibility condition, have to be determined accurately. In this study, the validity of the methods for determining the effective strengths of concrete struts was evaluated by conducting the strut-tie model analyses of the three reinforced concrete deep beams tested to failure with the effective strengths of concrete struts obtained from the suggested determination methods.

• Proceedings of the IEEK Conference
• /
• 2008.06a
• /
• pp.191-192
• /
• 2008

We give new definition of the effective-leakage and the signal to effective-leakage plus noise ratio (SELNR) to consider receiver combining motivated by the leakage. We propose a method to find jointly beamforming vector and combining vector for the two linear receivers (maximal ratio combining (MRC) receiver and minimum mean square error (MMSE) receiver) based on the SELNR.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.25 no.3
• /
• pp.287-293
• /
• 1988

This paper calculates the band structure of the GaAs/(Al,Ga) As semiconductor superlttice with the interface3 grading, in consideration of different effective masses in each region. Including the effective masses, superlattice period, well and barrier widths, and the interface, the dispersion relation is derived, and the effects that the above parameters affect the subband (or miniband) structure of the superlattice and effective energy gap are investigated. It is particularly found that this case(ma<>mb<>mc) is significantly different from the same effective mass case(ma<>mb<>mc).

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.18 no.1
• /
• pp.232-239
• /
• 1994

This paper presents an effective way of improving fuel consumption for a variable displacement engine. The improvement of fuel consumption can be accomplished by means of deactivating inlet and exhaust valves, reducing the number of effective cylinders of a four-cylinder gasoline engine that is mounted on a domestic compact automobile.

• The Journal of Korean Medicine Ophthalmology and Otolaryngology and Dermatology
• /
• v.20 no.1 s.32
• /
• pp.80-98
• /
• 2007

Objectives : This study was carried out to evaluate anti-oxydative, anti-tumor effect for clinical application of Whakijogyungtang (WJT) Results : 1. DPPH radical scavenging activities of WJT water extracts(Exts) were in proportion as concentration of WJT.(3 ${\mu}g/ml:12.6{\pm}2.3$ %) 2. ABTS+ scavenging activities of WJT water Exts were more effective in high density.(3 ${\mu}g/ml:4.3{\pm}1.6$ %, 10 ${\mu}g/ml$: $11.8{\pm}2.5$ %, 30 ${\mu}g/ml:45.3{\pm}3.2%$ 100 ${\mu}g/ml$: $62.7{\pm}4.8%$) 3. Hydrogen peroxide$(H_2O_2)$ scavenging activities of WJT water Exts were effective.(3 ${\mu}g/ml:4.7{\pm}0.8$ %, 10 ${\mu}g/ml: $8.2{\pm}1.6$ %, 30 ${\mu}g/ml:19.5{\pm}3.2$ % 100 ${\mu}g/ml$: $24.6{\pm}3.8$ %) 4. Anti oxidative effects against linoleic acid were not effective. 5. The generation of $O_2\;^-$ in S-180 cells were according to the concentration of WJT water Exts, specially effective over 100 ${\mu}g/ml$ concentration. 6. The SOD activities in S-180 cells were in proportion as cytotoxicity against S-180 cells of WJT water Exts. 7. The GPx activities in S-180 cells were in proportion as cytotoxicity against S-180 cells of WJT water Exts(more effective on 300 ${\mu}g/ml$ and 1000 ${\mu}g/ml$ concentration), but the catalase activities in S-180 cells were not effective. 8. The results of activites against multi-drug-resistance(MDR) of WJT were as follows. 1) In water Exts from WJT, cytotoxicity against AML-2/D100 with vincristine($IC_{50:}39.78$ ${\mu}g/ml$) was more effective than without vincristine($IC_{50:}$ 183.58 ${\mu}g/ml$), Cross resistance(CR:3.85) was not effective, and anti-MDR activites(RF) was effective.(RF:3.85) 2) In hexane fraction, cytotoxicity against AML-2/D100 with vincristine ($IC_{50:}130.88$ ${\mu}g/ml$) was more effective than without vincristine ($IC_{50:}293.10$ ${\mu}g/ml$) and anti-MDR activites(RF) was effective.(RF:4.61) 3) In chloroform fraction, the cytotoxicity against AML-2/WT and AML-2/D100 was not effective. 4) In ethyl acetate fraction, cytotoxicity against AML-2/D100 with vincristine($IC_{50:}36.43$ ${\mu}g/ml$) was more effective than without vincristine ($IC_{50:}73.07$ ${\mu}g/ml$), Cross resistance(CR:0.53) was not effective, and anti-MDR activites(RF) was effective.(RF:2) 5) In butanol fraction, the cytotoxicity against AML-2/WT and AML-2/D100 was not effective. 6) In $H_2O$ fraction, the cytotoxicity against AML-2/WT and AML-2/D100 was not effective. Conclusion : These result suggest that WJT has antioxidative effects, anti-tumor effects by apoptosis of free radical$(O_2\;^-)$ activity, and anti-MDR activites(especially hexane and ethyl acetate fraction).