• Journal of Advanced Marine Engineering and Technology
• /
• 제35권4호
• /
• pp.379-387
• /
• 2011

최근 디젤엔진에서 엔진성능향상 및 배출가스저감을 위해 저압 EGR시스템에 대하여 연구개발이 활발히 진행되고 있다. 저압 EGR시스템은 EGR율에 따라 과급압력이 영향을 받지 않기 때문에 PM을 최소 화하면서 $NO_x$를 저감할 수 있는 장점을 갖고 있다. 본 연구에서는 2.0L급 고속직분사방식의 엔진에서 출력 및 연비저하로 EGR적용이 어려운 엔진회전수 2000 rpm, BMEP 1.0 MPa, 과급압력 181.3 kPa인 중부하 운전영역에서 서로 다른 EGR시스템에 따른 엔진성능 및 배출가스 특성을 실험적으로 연구하였다. 그 결과로서 기존의 고압 EGR시스템 또는 배압조절밸브를 사용하는 저압 EGR시스템에 비하여 ETC를 적용한 저압 EGR시스템이 $NO_x$ 배출특성은 큰 차이가 없는 반면에, 연비 및 열효율이 향상되고 PM 저감에 연소효과를 나타내고 있음을 확인하였다.

• 한국산학기술학회논문지
• /
• 제21권8호
• /
• pp.401-406
• /
• 2020

자동차에서 배출되는 배기가스 중 질소산화물은 요사이 문제가 되는 미세먼지의 주요 요인 중 하나이다. 질소산화물(NOx)은 고온 조건에서 연소가 진행될 때 발생하므로 연소시 온도를 낮추는 방법으로 발생을 억제하고 있다. 자동차에서는 일반적으로 배기가스 재순환(EGR)을 사용하여 연소 온도를 낮추는 방법으로 감소시킨다. 그러나 EGR 비율이 높아질수록 NOx의 양은 저감되나 연소 안정성의 하락으로 인한 불완전연소 가능성의 증가로 일산화탄소와 미연탄화수소의 양이 증가하여 오히려 오염물질이 증가하는 문제를 발생시킬 수 있다. 여기에서는 연료 입자에 음파를 조사하여 연료 입자의 운동성을 향상시켜 연소가 원활히 진행되게 하여 연소의 안정성을 향상시키는 방안에 대하여 해석적 및 실험적 방법으로 연구하였다. 해석적 방법으로는 유동해석 소프트웨어를 사용하여 연료 입자에 다양한 주파수의 음파를 조사하여 연료 입자의 움직임 변화에 대한 연구를 진행하였다. 해석 결과, 작은 연료 입자의 조건에서는 고주파의 음파에 의해 영향을 많이 받고, 연료 입자가 큰 조건에서는 저주파의 음파에 의해 영향을 많이 받아 운동성이 증가함을 알 수 있었다. 실험적 방법으로는 연소실을 구성하여 정해진 당량비 조건에서 연소시키며 다양한 주파수의 음파를 조사하며 연소실내 압력을 측정하는 연구를 진행하였다. 측정된 압력으로부터 열방출량을 계산하면 연소의 진행 상황에 대한 정보를 얻을 수 있는데, 실험 결과 초기 연소시 상대적 저주파 조사 조건에서 열방출량이 증가한 것을 확인할 수 있었다.

• 한국산학기술학회논문지
• /
• 제20권12호
• /
• pp.608-613
• /
• 2019

자동차 배기가스에 포함된 질소산화물은 심각한 대기 오염을 일으키는 주요한 요인 중의 하나이다. 질소산화물은 연소가 고온 조건에서 진행되는 경우에 생성되므로 일반적으로 배기가스 재순환 방법을 사용하여 연소 온도를 낮추어 저감시킨다. 배기가스 재순환 비율이 높아질수록 질소산화물의 양은 감소하나 연소가 불안정하게 되어 일산화탄소와 연소실 내의 연료가 연소 되지 않고 나오는 미연탄화수소의 양이 증가하여 오히려 오염물질을 증가시킨다. 본 논문에서는 연소 안정성 향상을 위해 연료 입자에 음파를 조사하여 연료 입자의 움직임을 증가시는 방안 및 배기가스재순환 비율의 증가에 따른 엔진 성능 향상에 대하여 연구하였다. 이에 대한 기본 연구로, 유동해석 소프트웨어를 사용하여 여러 주파수의 음파를 연료 입자에 조사하여 연료 입자의 속도 변화에 대한 연구를 진행하였다. 해석 결과, 연료 입자의 크기가 크면 저주파의 음파에 의해, 연료 입자의 크기가 작으면 고주파의 음파에 의해 영향을 많이 받음을 알 수 있었다. 또한 연소 안정성 향상이 엔진 성능에 미치는 영향에 대해 엔진 해석 모델을 사용하여 연구하였다. 해석 결과, 배기가스 재순환 비율을 15% 증가시킨 경우, 질소산화물의 농도가 45% 저감되고, 열효율이 10% 향상됨을 확인하였다.

• 대한기계학회논문집B
• /
• 제32권10호
• /
• pp.769-775
• /
• 2008

In this study, the investigations on the dimpled type Exhaust Gas Recirculation (EGR) cooler have been focused on the high heat exchanger efficiency. To overcome low heat exchanger efficiency of general EGR cooler, the dimpled type EGR cooler was developed. It was ensured the improvement of the performance of the dimpled type EGR cooler related to the heat exchange based on a series of the experiment. These results were caused by the increase of thermal surface area in accordance with the dimple's one. The estimation model of the heat exchanger efficiency using the Effectiveness-NTU method was also developed in order to verify the validity of experimental result. Also, the program for the estimation of the heat exchanger efficiency on the EGR cooler with regard to the dimpled tube shape was developed. Resultantly, it was confirmed that the dimpled type EGR cooler could be served better performance than the conventional one in view of the heat exchanger efficiency.

• 한국자동차공학회논문집
• /
• 제15권4호
• /
• pp.178-185
• /
• 2007

A study is improvement of power and emission in a inline-pump Dr diesel engine by using Dimethyl ether Fuel. Dimethyl ether (DME) is an oxygenated fuel with a cetane number higher than that of diesel oil. It meets the ULEV emission regulation and reduces the smoke to almost zero when used in a diesel engine. But NOx emission is almost same and CO, THC emissions are lower than that of diesel engine. The emissions aren't satisfied the stronger emission regulation in the further. Generally DOC (Diesel Oxidation Catalyst) is used to reduce CO & THC emissions and EGR (Exhaust Gas Recirculation) system is used to reduce NOx emission. Test results showed that the torque and the power with DME were almost same as those of pure diesel oil, but the brake thermal efficiency increased a little. also the BSEC (Brake Specific Energy Consumption) with DME was similar that of diesel. The test results showed that the DOC was the vary effective method to reduce the CO emission in case of Dimethyl Ether Fuel in diesel engine. But, THC emission is showed a little reduction rates. Also EGR system was the very effective method to reduce the NOx emission in case of Dimethyl Ether Fuel in diesel engine.

• 한국자동차공학회논문집
• /
• 제20권3호
• /
• pp.141-147
• /
• 2012

A direct injection diesel engine with large amount of exhaust gas recirculation was used to investigate low temperature diesel combustion. Pilot injection strategy was adopted in low temperature diesel combustion to reduce high carbon monoxide and hydrocarbon emissions. Combustion characteristics and exhaust emissions of low temperature diesel combustion under different pilot injection timings, pilot injection quantities and injection pressures were analyzed. Retarding pilot injection timing, increasing pilot injection quantity and higher injection pressure advanced main combustion timing and increased peak heat release rate of main combustion. As a result of these strategies, carbon monoxide and hydrocarbon emissions were reduced. Soot emission was slightly increased with retarded pilot injection timing while the effect of pilot injection on nitrogen oxides emission was negligible under low combustion temperature condition. Spatial distribution of fuel from the spray targeting visualization was also investigated to provide more insight into the reason for the reduction in carbon monoxide and hydrocarbon emissions.

• 한국자동차공학회논문집
• /
• 제23권6호
• /
• pp.608-614
• /
• 2015

Nitrogen oxide(NOx) emission reductions are required to meet the strict emission regulations for environmental protection. Most of the Exhaust Gas Recirculation(EGR) system applied to a diesel engine can relatively decrease the NOx at a low cost, but it has a disadvantage in that the PM generation is promoted due to the hot intake air temperature. Thus, high heat exchange efficiency of the EGR cooler is required for an effective removal of NOx. In this study, heat exchange efficiency for various types of heat exchangers used in EGR cooler was measured under same conditions, and determined best heat exchange performance shape depending on type of heat exchanger.

• 한국자동차공학회논문집
• /
• 제18권6호
• /
• pp.105-113
• /
• 2010

In this study, a feasibility test of liquid petroleum gas (LPG) compression ignition (CI) engine has been carried out to study the effectiveness of cetane enhancing additive: Di-tertiary-butyl peroxide (DTBP). Performance and emissions characteristics of a CI engine fuelled with DTBP blended LPG fuel were examined. Also, the effect of EGR (exhaust gas recirculation) on the combustion and emissions characteristics has been investigated. Results showed that stable engine operation over a wide range of the engine loads was possible. Exhaust emissions measurements showed that hydrocarbon were decreased with the blended fuel at enhancing cetane number. Furthermore, the combustion stability of LPG with a cetane number improver was equivalent to that of commercial Diesel fuel. Increasing the EGR rate leads to deteriorate the IMEP (indicated mean effective pressure) and increase the ignition delay. It was found that the exhaust emissions with the EGR resulted in a very large reduction in nitrogen oxides at the expense of higher THC and CO emissions. Considering the results of engine performance and exhaust emissions, LPG blended fuel of enhancing cetane number could be used as an alternative fuel for diesel in a CI engine.

• 유체기계공업학회:학술대회논문집
• /
• 유체기계공업학회 2004년도 유체기계 연구개발 발표회 논문집
• /
• pp.680-686
• /
• 2004

Recently, the application of variable geometry turbocharger (VGT) to the high speed direct injection (HSDI) diesel engine has gained more and more interest in automotive industry. A steady state experimental investigation has been undertaken on a 1.5L HSDI diesel engine to verify the benefits of VGT comparing to the standard engine having a waste gate turbocharger (WGT). Specifically, part load performances (e.g., fuel economy and emission) have been investigated under various vane angles of the VGT. The results show that the real exhaust gas recirculation (EGR) rate as well as the pumping loss is very important to improve break specific fuel consumption (BSFC). It was previously known that the pumping loss only is a main parameter. In addition, the trade-off relationship between BSFC and NOx according to boost pressure, and the decreasing tendency of NOx with increasing real EGR rate have been verified. 1-D numerical analysis also has been performed, and the numerical results are in good agreement with experimental results.

• 대한기계학회논문집B
• /
• 제21권5호
• /
• pp.659-669
• /
• 1997

The effects of exhaust gas recirculation on diesel engine combustion and soot/NOx emissions are numerically studied. The primary and secondary atomization is modelled using the wave instability breakup model. Autoignition of a diesel spray is modelled using the Shell ignition model. Soot formation is kinetically controlled and soot oxidation is represented by a model which account for surface chemistry. The NOx formation is based on the extended Zeldovich NOx model. Effects of injection timing and concentration of $O_{2}$ and CO$_{2}$ on the pollutant formation and the combustion process are discussed in detail.