• 전력전자학회논문지
• /
• 제18권4호
• /
• pp.349-358
• /
• 2013

In this paper, the sensorless MPPT algorithm is proposed where the performance of varied duty ratio change has been improved using multi-layer neuro-fuzzy that aligns with neuro-fuzzy based optimized membership function. Since the change of duty ratio of sensorless MPPT is varied by using the neuro-fuzzy, the MPPT response speed is faster than the convectional method and is able to reduce the steady-state ripple. The neuro fuzzy controller has the response characteristics which is superior to the existing fuzzy controller, because of the usage of the optimal width of the fuzzy membership function. The effectiveness of the proposed method has been verified by simulations and experimental results.

• Journal of Magnetics
• /
• 제17권1호
• /
• pp.42-45
• /
• 2012

We have developed an alternating magnetic field stimulation system consisting of a switched-mode power supply and a digital control circuit which modulates a duty ratio to maintain a magnetic field intensity of a few mT even while the frequency increases up to 4 kHz with a controllable coil temperature below $30^{\circ}C$ in air. This duty ratio modulation and water circulation are advantageous for cell culture under ac-magnetic field stimulation by preventing the incubator from exceeding a cell-viable temperature of $37^{\circ}C$. Although the temperature of the coil when subjected to a sinusoidal voltage rapidly increased, that of our system modulated by the duty factor did not change. This is a potentially valuable method to investigate the effects of intermediate frequency magnetic field stimulation on biological entities such as cells, tissues and organs.

• 전기학회논문지
• /
• 제61권10호
• /
• pp.1432-1441
• /
• 2012

In this study, an improved LCCT(Inductor-Capacitor-Capacitor-Trans) Z-source inverter(Improved LCCT ZSI) with characteristics of Quasi Z-source inverter(QZSI) and LCCT Z-source inverter(LCCT ZSI) is proposed. The proposed inverter can also reduce the voltage stress and input current/capacitor voltage ripples compared with conventional LCCT ZSI and Quasi ZSI. A two winding trans in Z-impedance network of the conventional LCCT ZSI is replaced by a three winding trans in the proposed inverter. To verify the validity of the proposed inverter, a DSP controlled hardware was made and PSIM simulation was executed for each method. Comparing the current and voltage ripples of each method under the condition of input DC voltage 70[V] and output AC voltage 76[Vrms], the input current and capacitor voltage ripple factors of the proposed inverter were low as 11[%] and 1.4[%] respectively. And, for generation of the same output AC voltage of each method, voltage stress of the proposed inverter was low as 175[V] under the condition of duty ratio D=0.15. As mentioned above, we could know that the proposed inverter have the characteristics of low voltage stress, low ripple factor and low operation duty ratio compared with the conventional methods. Finally, the efficiency according to load change/duty ratio and the transient state characteristics were discussed.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2007년도 추계학술대회 논문집
• /
• pp.165-168
• /
• 2007

Electrooptic characteristics of Xe-type flat fluorescent lamps (FFL) have been investigated by using a Q-V Lissajous method. It was found that the luminance of the Mgo-coated FFL became more than doubled compared to normal FFLs operated at the same driving voltage, indicating the possibility of the efficacy improvement in the MgO-coated FFLs. Change in the driving condition, in particular, the duty ratio had effects on the electrooptic properties, and it was found that the duty ratio of 50% was the optimum condition from the viewpoints of the efficacy and the lamp voltage.

• Journal of the Optical Society of Korea
• /
• 제11권3호
• /
• pp.130-132
• /
• 2007

The characteristics of $S\breve{o}lc$ filters in $X^{(2)}$ nonlinear photonic crystals, periodically poled lithium niobate ($LiNbO_3$), were investigated by the Jones matrix method. The transmittance increases and the full width half maximum of the filter becomes narrow as the duty ratio increases. However, the filtering wavelength does not change. The transmittance at the filtering wavelength is over 95% when the duty ratio is larger than 0.35.

• International Journal of Automotive Technology
• /
• 제8권2호
• /
• pp.249-258
• /
• 2007

This paper proposes a method that can be used for the resistance estimation of a PWM (Pulse Width Modulation)-driven solenoid. By using estimated solenoid resistance, the PWM duty ratio was compensated to be proportional to the solenoid current. The proposed method was developed for use with EHB (Electro-Hydraulic Braking) systems, which are essential features of the regenerative braking system of many electric vehicles. Because the HU (Hydraulic Unit) of most EHB systems performs not only ABS/TCS/ESP (Electronic Stability Program) functions but also service braking function, the possible duration of continuous solenoid driving is so long that the generated heat can drastically change the level of solenoid resistance. The current model of the PWM-driven solenoid is further developed in this paper; from this a new resistance equation is derived. This resistance equation is solved by using an iterative method known as the FPT (fixed point theorem). Furthermore, by taking the average of the resistance estimates, it was possible to successfully eliminate the effect of measurement noise factors. Simulation results showed that the proposed method contained a sufficient pass-band in the frequency response. Experimental results also showed that adaptive solenoid driving which incorporates resistance estimations is able to maintain a linear relationship between the PWM duty ratio and the solenoid current in spite of a wide variety of ambient temperatures and continuous driving.

• 한국통신학회논문지
• /
• 제39B권10호
• /
• pp.691-699
• /
• 2014

네트워크 수명을 연장시키기 위해 무선 센서 네트워크에서는 idle listening에 소비되는 에너지를 줄일 수 있는 듀티-사이클 MAC 프로토콜들이 제안되었다. 일반적인 듀티-사이클 MAC 프로토콜에서 각 센서 노드는 잔여 에너지양을 기반으로 듀티-사이클 주기를 계산한다. 그러나 에너지 수집이 가능한 센서 네트워크에서 기존 듀티-사이클 주기는 에너지 수집률이 높은 센서 노드에 불필요한 sleep 지연을 발생시킨다. 따라서 우리는 이전 연구에서 잔여 에너지양과 에너지 수집률을 함께 고려하여 듀티 사이클-주기를 조절하는 듀티-사이클 스케줄링 기법을 제안하였다. 그러나 이러한 듀티-사이클 MAC 프로토콜들은 듀티 사이클-주기 변화에 따른 성능 차이를 고려하지 않고 듀티-사이클 주기를 항상 선형적으로 조절하므로, 응용의 요구사항에 맞는 최적의 듀티 사이클 주기를 얻지 못한다. 본 논문에서는 듀티-사이클 주기를 계산하는 세 가지 기법들을 제안하고 그 결과에 대해 분석한다. 실험을 통해 제안된 기법들이 기존 듀티-사이클 스케줄링 기법에 비해 네트워크 수명, 단대단 패킷 전송 시간과 패킷 전송률을 각각 최대 23%, 44%, 31% 증가시킴을 확인하였다.

• 한국자동차공학회논문집
• /
• 제9권5호
• /
• pp.140-147
• /
• 2001

The solenoid valve in ABS hydraulics, modulator is a two directional on-off valve and is controlled by around 100Hz high speed pulse width modulation. When the inlet valve is switched from open state to closed state, there are braking force degration, noise and vibration due to pressure surge phenomena in the hydraulic line and wheel cylinder. In this study, identifies pressure surge phenomenon in the braking process of a ABS, and investigates the way to reduce the phenomenon. For the purpose theoretical analysis on the pressure surge in the closed state hydraulic line, characteristic curve method based on wave equation was utilized. During this analysis, we could find pressure surge characteristics change due to hydraulic line change and PWM control conditions. In conclusion, by using the results of this study for the pressure surge prediction and reduction method, we could expect braking performance enhancement in Anti-Lock Braking System.

• 전력전자학회논문지
• /
• 제17권3호
• /
• pp.205-212
• /
• 2012

This paper proposes the fuzzy logic based variable step-size MPPT (Maximum Power Point Tracking) method for the stability at the steady state and the improvement of the transient response in the wind power system. If the change value of duty ratio is set on stability of the steady state, MPPT control traces to maximum power point slowly. And if the change value is set on improvement of the transient response, the system output oscillates at the maximum power point. By adjusting the step size with fuzzy logic, it can be improved the MPPT response speed and stability at steady state when MPPT control is performed to track the maximum power point. The effectiveness of the proposed method has been verified by simulations and experimental results.

• 한국기후변화학회지
• /
• 제4권4호
• /
• pp.359-369
• /
• 2013

본 논문에서는 소형자동차에 이동식 배출가스 측정장비(PEMS)를 탑재하여 서울 도심의 실제 도로를 주행하고, 주행인자와 $CO_2$ 배출량 간의 상관관계를 분석하였다. 주요 주행인자로는 평균차속, 상대가속도(RPA-Relative Positive Acceleration), 정지비율을 선정하였고, 도로유형을 단속류와 연속류로 구분하여 분석하였다. 주행거리 기반의 이동평균구간 계산 방법을 적용하여 다양한 주행조건에서의 평균값을 구하고, 다중 선형 회귀분석 방법을 통해 주행인자와 $CO_2$ 배출량 간의 상관관계를 조사하였다. 이러한 분석을 통해 자동차의 $CO_2$ 배출량은 평균차속이 증가함에 따라 감소하고, RPA와 정지비율의 증가에 따라 증가하는 경향이 있음을 통계적인 방법으로 확인하였다. 단속류는 연속류와 비교하였을 때 평균차속이 상당히 낮고, RPA와 정지비율은 높게 나타나는데, 이러한 주행인자분포의 차이로 인해 단속류의 단위주행거리 당 $CO_2$ 배출량이 높은 것으로 판단된다.