• Journal of Power Electronics
• /
• v.13 no.2
• /
• pp.250-255
• /
• 2013

This paper proposes an optimal current distribution method of dual-rotor brushless DC machines (DR-BLDCMs) which have inner and outer surface-mounted permanent-magnet rotors. The DR-BLDCM has high power density and high torque density compare to the conventional single rotor BLDCM. To drive the DR-BLDCM, dual 3-phase PWM inverters are required to excite the currents of a dual stator of the DR-BLDCM and an optimal current distribution algorithm is also needed to enhance the system efficiency. In this paper, the copper loss and the switching loss of a DR-BLDCM drive system are analyzed according to the motor parameters and the switching frequency. Moreover, the optimal current distribution method is proposed to minimize the total electrical loss. The validity of the proposed method was verified through several experiments.

• Journal of electromagnetic engineering and science
• /
• v.10 no.3
• /
• pp.183-185
• /
• 2010

A 2.4 GHz dual-polarized antenna for a Doppler radar is studied. The proposed dual-polarized antenna using a stacked annular ring patch with two co-centric gap-coupled feed lines and a $90^{\circ}$ hybrid exhibits fairly good performance of 22 dB isolation at a center frequency of 2.4 GHz. Using a $90^{\circ}$ hybrid, a right-handed circular polarization for the transmitter and a left-handed circular polarization for the receiver are implemented. The gain of the designed antenna is about 0 dBi over operating frequencies. The antenna size including a ground plane is only $40{\times}40\;mm^2$.

• Journal of Power Electronics
• /
• v.14 no.6
• /
• pp.1217-1223
• /
• 2014

A novel half load-cycle worked dual input single output (DISO) DC/AC inverter is presented. The basic circuit consists of a dual buck regulator, which works in continuous current mode. The working principle of DISO DC/AC inverter has been used. The control method applied for half load-cycle worked DISO DC/AC inverter has been studied. The control effects of the open-loop proportional control and closed-loop proportional-integral control are compared by using PSIM software. The parameters are adopted in the realistic simulation and experiment test. Moreover, the waveforms, such as voltage of modulation reference signal and output voltage, were given. The simulation and experiment results proved that the half load-cycle worked DISO DC/AC inverter could achieve good performance, gain a line frequency of 50 Hz, and verify the correctness of theoretical analysis.

• Proceedings of the KIEE Conference
• /
• 2006.10c
• /
• pp.476-478
• /
• 2006

A prescaler is an essential building block for PLL-based frequency synthesizers and must satisfy high-speed and low-power characteristics. The design of D-flip flips used in the prescaler implementation is thus critical. In this paper a 64/65, 128/129 dual-modulus prescaler is designed using a $0.25{\mu}m$ CMOS process. In the design a new dynamic D-flip flop is employed, where glitches are minimized using discharge suppression scheme, speed is improved by making balanced propagation delay, and low power consumption is achieved by removing unnecessary discharge. The designed prescaler operates up to 2.5GHz and consumes 3.1mA at 2.5GHz operation.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2010.06a
• /
• pp.342-342
• /
• 2010

This paper mainly focuses and describes four-armed dual-band rectangular type patch antenna using teflon of 0.54 mm thickness substrate for the application in personal wireless communications at about 2 GHz and 2.5 GHz frequency ranges. The dual-band patch antenna is obtained by embedding one centered and two pairs of rectangular patches on single body above the substrate. Details of the proposed antenna design are presented and discussed as a novel design with remarkable value of return loss (S11) of -28.68 dB and it is the most suitable for WiMAX applications as well.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2003.06a
• /
• pp.664-669
• /
• 2003

This paper proposes a swing-arm type dual-stage actuator, which consists of a PZT actuator for fine motion and a VCM(Voice Coil Motor) for coarse motion, for SFF ODD(Small Form Factor Optical Disk Drive), in order to achieve fast access speed and precise track following control. We focus our attention on the design and control of the PZT actuator, because there have been a lot of previous researches related to the VCM and dual-stage actuators. Due to the dual cantilever structure, the PZT actuator can generate precise translational tracking motion at its tip where optical pickup is attached at, and the effect of hysteric behavior of the PZT element is reduced. The dynamic model of the PZT actuator is derived by using the Hamilton's principle, and verified by comparing with the experimental frequency response. The sliding mode control is designed in order to be robust against modeling uncertainties. Simulations and experimental results confirm the effectiveness of the suggested control scheme.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.5
• /
• pp.213-217
• /
• 2012

In this paper, we design dual-band microstrip antenna for IEEE 802.16e mobile WiMAX standard IEEE 802.11 WLAN band at the same time. To solve interference at the desired operating frequency band, impedance matching is improved and simple production method showed the characteristics of the omni-directional and compact size. The proposed structure is considered to bring the effect of the installation costs, and show the antenna for dual-band communication.

• Proceedings of the KIPE Conference
• /
• 2002.07a
• /
• pp.480-484
• /
• 2002

A new active lossless snubber for half-bridge dual converter(that is called 'dual converter') is proposed in this paper. It features soft switching(ZVS) as well as turn-off snubbing in both main and auxiliary switches. As it uses parasitic components, such as leakage inductances and switch output capacitances etc, it helps the dual converter to operate at the higher frequency with a higher efficiency and smaller size reactive components. The operational principle, theoretical analysis, and design consideration are presented. To confirm the operation, features and validity of the proposed circuit, simulated results from an 1kW, 24V/DC-250V/DC are presented.

• Journal of electromagnetic engineering and science
• /
• v.15 no.2
• /
• pp.111-114
• /
• 2015

In this paper, we have proposed dual-band Phi-shaped slot gap filler antenna for satellite internet service applications. Some properties of the antenna such as return loss, radiation pattern, and gain have been simulated and measured. The proposed antenna has a Phi-shaped slot on the circular patch and is fabricated on the TLX-9 substrate. The radius of the circular patch is 25 mm, and it has a coaxial feeding structure. The dual-band Phi-shaped slot gap filler antenna has high-gain, small-size, simple-structure, and good radiation patterns at each band. The operating frequency band can be tuned by adjusting the length AL and FL of the Phi-shaped slot.

• Journal of Electrical Engineering and Technology
• /
• v.12 no.3
• /
• pp.1250-1256
• /
• 2017

This paper proposes the design of microstrip patch antennas for dual-band polarization adjustment. The antenna has a multi-layer structure for dual-band operation, and each layer contains a resonating patch with surrounding strips separated into two parts. The antenna polarization is adjusted by varying the separated positions of the strips, while fixing other design parameters. To demonstrate the feasibility, an antenna sample with right-hand circular polarization is fabricated, and its antenna characteristics are measured in a full anechoic chamber. The operating principle of polarization adjustment in the dual frequency bands is also verified by observing near electromagnetic fields and the magnetic surface current density around the antenna.