• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.13 no.3
• /
• pp.173-183
• /
• 1993

Four wave gauges of pressure type were installed for about one month(1992. 2~3) for the analysis of wave agitations induced by the intrusion of long-period incident waves inside and outside of Donghae Harbor. Helmholtz natural period and second peak period of seiche in Donghae Harbor are found to be approximately 17.1 and 5.5 minutes from the spectral analysis of measured long-period wave data. Amplification ratio at Helmholtz natural period reaches about 10 which is five times as lagre as that of Youngil Bay, but wave amplitudes ill harbor were about 10 em during the measurement period which are relatively small.

• Journal of the Korean Applied Science and Technology
• /
• v.32 no.4
• /
• pp.649-660
• /
• 2015

Data obtained from the Calpuff inverse modeling estimate the emission amount of pollutants, and enable to establish the aim for reduction through the comparison of various cases. This study pursued to accumulate the fundamental data by the Calpuff inverse modeling for five areas in the vicinity of Donghae harbor, which focused on reduction of atmospheric fine dust. As a result of evaluation of the allowed emission amount for local sites, site-D required the most reduction, $4.95{\mu}g/m^2{\cdot}S$, based on the atmospheric guideline, $50{\mu}g/m^3$. The theoretical mitigation could decrease the average concentration of PM10 to $42.6{\mu}g/m^3$ for the study field (Donghae waste water treatment plant). Modeling only for site-A emission showed the potential concentration around the residential area of Donghae harbor, $40{\sim}50{\mu}g/m^3$. However, it will rise over $50{\mu}g/m^3$ with the addition of background level. Therefore no more emission would be allowed. Site-B including commercial area and unpaved field required the reduction of $0.11{\mu}g/m^2{\cdot}S$ due to vehicles and fugitive dust. Site-C and E did not emit additional pollutants.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.13 no.3
• /
• pp.185-192
• /
• 1993

A numerical model has been used for the prediction of wave agitations in a harbor which are induced by the intrusion and transformation of incident waves. Based on linear wave theory a mild-slope equation has been used. A partial absorbing boundary condition has been used on solid boundary. Functional has been derived following Chen and Mei(l974)'s technique based on Hybrid Element Method which uses finite discretisation in the inner region and analytical solution of Helmholtz equation in the outer region. Final simultaneous equation has been solved using the Gaussian Elimination Method. Helmholtz natural period and second peak period of seiche in Donghae Harbor coincide very well with the results from numerical calculation. Computed amplification factors show good agreement, especially when the reflection coefficient on solid boundary is 0.99, with those of measurements.

• Journal of the Korean Applied Science and Technology
• /
• v.29 no.4
• /
• pp.561-569
• /
• 2012

Study attempts to evaluate the environmental cost and benefit for management of particulate matters of Donghae harbor in Gangwondo. The level of fine dust suspended in the vicinity of the harbor was quite high, exceeding the national standard ($100{\mu}g/m^3$) depending on the places. The test field harbor deals with lots of limestone and coal, so that fine particulates could be generated while loading it and unloading. It was estimated that the direct handling of cargos might produce 12 tons of PM10(Particulate Matters of $10{\mu}m$) a year. In addition, heavy vehicles for transportation of various cargos including raw materials emit huge amount of diesel soots and cause to redispersion of road dust. The local government spends more than 2 billion won every year, and it contributes to reduce the atmospheric dust. According to the prediction of cost to benefit, it will present the effectiveness in 720 % maximum and at least 240 %.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.9 no.10
• /
• pp.1153-1159
• /
• 2014

In this paper we propose novel method for cost of harbor facility of redevelopment of Mookho harbor at Donghae city by using ICT(Information Communication Technology) and Social Network System that is able to participate most residents instead of partly participation for harbor development. In order to do this, we analyze urban marketing which was maximally reflected opinion of resident by using previous simple questionnaire as well as various SNS (Social Network System) as method of effective resident's participation in process harbor redevelopment. We perform optimal selection for ratio of resident's participation. We also propose calculation of optimal construction cost and method of urban marketing.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.14 no.3
• /
• pp.607-618
• /
• 1994

Effects of wave grouping on the harbor oscillation are studied in order to clarify the energy source of harbor resonance. The resonant periods of Donghae harbor and Imwon harbor are calculated using the boundary integral equation method. Also, the periods of the group-bounded long waves due to the irregular wave group are calculated using the theory developed in this study. Analyzing from the view point of period, it is concluded that the group-bounded long waves due to the irregular wave group can cause resonance in small harbors such as fishery harbors, and heavy ship motion in large harbors such as industrial ones.

• Proceedings of the Korean Society of Coastal and Ocean Engineers Conference
• /
• 1992.08a
• /
• pp.23-27
• /
• 1992

대형선박이 접안하여 하역작업을 수행하는 동해안의 산업항중 포항신항에서는 과거의 연구나 한국해양연구소의 현장관측(건설부, 1987; 강 등, 1989)을 통하여 다양한 주기의 부진동이 존재함이 밝혀졌으며, 검조소가 없는 동해항의 인근에 위치한 묵호항의 검조기록을 검토한 결과 10분대의 장주기 부진동이 존재하는 것으로 나타났다.(중략)

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.18 no.2
• /
• pp.137-146
• /
• 2006

This is the second of a two-part paper which describes comparison of reliability design methods by application to Donghae Harbor Breakwaters. In this paper, Part 2, we deal with sliding of caissons. The failure modes of a vertical breakwater, which consists of a caisson mounted on a rubble mound, include the sliding and overturning of the caisson and the failure of the rubble mound or subsoil, among which most frequently occurs the sliding of the caisson. The traditional deterministic design method for sliding failure of a caisson uses the concept of a safety factor that the resistance should be greater than the load by a certain factor (e.g. 1.2). However, the safety of a structure cannot be quantitatively evaluated by the concept of a safety factor. On the other hand, the reliability design method, for which active research is being performed recently, enables one to quantitatively evaluate the safety of a structure by calculating the probability of failure of the structure. The reliability design method is classified into three categories depending on the level of probabilistic concepts being employed, i.e., Level 1, 2, and 3. In this study, we apply the reliability design methods to the sliding of the caisson of the breakwaters of Donghae Harbor, which was constructed by traditional deterministic design methods to be damaged in 1987. Analyses are made for the breakwaters before the damage and after reinforcement. The probability of failure before the damage is much higher than the allowable value, indicating that the breakwater was under-designed. The probability of failure after reinforcement, however, is close to the allowable value, indicating that the breakwater is no longer in danger. On the other hand, the results of the different reliability design methods are in fairly good agreement, confirming that there is not much difference among different methods.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.17 no.3
• /
• pp.188-201
• /
• 2005

This is the first part of a two-part paper which describes comparison of reliability design methods by application to Donghae Harbor Breakwaters. This paper, Part 1, is restricted to stability of armor blocks, while Part 2 deals with sliding of caissons. Reliability design methods have been developed fur breakwater designs since the mid-1980s. The reliability design method is classified into three categories depending on the level of probabilistic concepts being employed. In the Level 1 method, partial safety factors are used, which are predetermined depending on the allowable probability of failure. In the Level 2 method, the probability of failure is evaluated with the reliability index, which is calculated using the means and standard deviations of the load and resistance. The load and resistance are assumed to distribute normally. In the Level 3 method, the cumulative quantity of failure (e.g. cumulative damage of armor blocks) during the lifetime of the breakwater is calculated without assumptions of normal distribution of load and resistance. Each method calculates different design parameters, but they can be expressed in terms of probability of failure so that tile difference can be compared among the different methods. In this study, we applied the reliability design methods to the stability of armor blocks of the breakwaters of Donghae Harbor, which was constructed by traditional deterministic design methods to be damaged in 1987. Analyses are made for the breakwaters before the damage and after reinforcement. The probability of failure before the damage is much higher than the target probability of failure while that for the reinforced breakwater is much lower than the target value, indicating that the breakwaters before damage and after reinforcement were under- and over-designed, respectively. On the other hand, the results of the different reliability design methods were in fairly good agreement, confirming that there is not much difference among different methods.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.27 no.4
• /
• pp.258-265
• /
• 2015

Over the last 20 years, freak waves have attracted many researchers because of their unexpected behaviors and damages on offshore structures and vessels in the ocean and coastal waters. Despite many researches on the causes, mechanisms and occurrence of freak waves, we have not reached consensus on the results of the researches. This paper presents the occurrence probability of freak waves based on the analysis of wave records measured at coastal waters of Donghae harbor in the East Sea. Three freak waves were found which satisfied conditions of m and $H_S{\geq}2.5m$ and $H_m/H_S{\geq}2$. The occurrence probabilities of freak waves were estimated from extreme distributions by Mori, Rayleigh and Ahn, and found to be on the orders of O($10^{-1}$), O($10^{-2}$), and O($10^{-3}$), respectively. The occurrence probabilities of freak waves measured from waves records were estimated between O($10^{-2}$) and O($10^{-3}$), which were located between predictions by Rayleigh and Ahn's extreme probability distributions. However, we need more analysis of wave records obtained from diverse field conditions in order to verify the accuracy of the estimation of occurrence probability of freak waves.