• Journal of Biosystems Engineering
• /
• v.2 no.2
• /
• pp.37-45
• /
• 1977

Solar energy is a potential source of power that offers much promise being used for low-temperature applications like drying farm crops, space heating, and water heating for domestic uses. Already much of it are being used for those purpose in foreign countries. However, very little research has been done to determine the possibility of using the solar energy in Korea. This study was conducted to develop the general prediction equation of the total radiation on a horizontal surface in Daejeon area based on 5 years 91972, Jun.1-1976. Dec.31) meteorological data (bright sunshine hours, average total horizontal radiation), and to obtain experimentally the thermal efficiency of solar air and water collectors, which will be used as a basic data of designing flat-plate solar collector system.In addition to the thermal efficiency of the collectorsthe relationship among those factors affecting it such as weather condition, orientation factor, and tilted angle of collector was analyzed. The results of this study were as follows. 1. The general predicted equation of the total radiation on a horizontal surface in Daejeon area based on bright sunshine hours was developed as $H_{av} =(1.546\frac{n}{N}-0.582)H_o$. Predicting the total radiation on a horizontal surface by the above equation was thought to be possible because to values of 0.882 was smaller than any t values at above 0.05 level on the basis of two tailed test of the difference between the calculated and the recorded values. 2.It was observed that optimum tilt angle of the collector in the summer and the autumn drying season was 13 degrees and 51 degrees respectively, these values could be obtained by adding or substracting approximately 25 degrees from the latitude of this area $(36.3^{\circ}N)$ .The relationship between orientation factor and declination of sun at suitable tilt angle of 33 degrees $(s=0.9\O)$ was shown at Fig.4. 3.The thermal efficiency of solar wdter collector was shown 13.4-51. 6% on Aug. 15 (the minimum radiation recorded) and 43.8 ~537% Aug.20 (the maximum radiation recorded), and 13.8~ 46.6 and 44.3~ 49.7 were shown on each corresponding day. 4.The thermal efficiency of the collectors according to the weather condition was shown a big difference of about 10% between the day of the maximum radiation recorded and the minimum, but the differen of efficiency between the air and the water collector was at most 2 ~ 3%. 5. Even if the efficiency of the solar water collector was a little higher than the solar air collector, for drying farm products, the solar air collector was thought to be more effective because the air heated by collector could be directly used for drying them.

• Journal of Construction Engineering and Project Management
• /
• v.4 no.2
• /
• pp.12-22
• /
• 2014

Over the last decade, Saudi Arabia has experienced significant economic increases as evidenced by the 30% growth in its gross domestic product; furthermore, the construction industry has increased 10% in the same time period. Due to this significant growth, the construction industry is encountering issues related to construction quality resulting in significant waste and associated environmental impacts. In this research, we applied our previously developed framework that integrates three different methods-Lean, Green, and Six-sigma - to a residential construction complex in Saudi Arabia. Our aim of this case study was to explore the application of the framework in practice to glean quantitative results and further validate the framework. In the case study, we used the developed framework to identify a significant issue related to quality and delays - final completion of 53 residential units was delayed because of failed exterior buildings surfaces. We then used the framework to define the causes behind the defects via a field investigation of the 53 units. Of the defect, construction execution was responsible for 43% of the defect, 31% untrained workers, 19% unfavorable construction weather condition, with 7% accounting for other issues. A procedure was developed in concert with the construction manager and overall developer reducing the amount of rework and waste causes revealed by the field examination and the framework. Although two steps were added to the original construction process to overcome waste causes, still save a lot of resources and reduces environmental impact. In summary, we found that the Lean, Green, Six-sigma framework increased productivity, quality, and reduced waste.

• Journal of the Korean Institute of Gas
• /
• v.22 no.4
• /
• pp.13-26
• /
• 2018

Currently, local regulations, such as KS Code, do not clearly specify how to calculate the range of hazardous area, so the dispersion modeling program should be used to select dispersion. The purpose of this study is to present a methodology of determining the range of hazardous area which is simpler and more reasonable than modelling by using representative materials and process conditions. Based on domestic and overseas regulations that are currently in effect, variables affecting distance to LFL(Lower Flammable Limit) were selected. A total of 16 flammable substances were modelled for substance variables, process conditions variables, and weather conditions variables, and the statistical analysis selected the variables that affect them. Using the selected variables, a three-step classification method was prepared to select the range of locations subject to explosion hazard.

• Journal of Korea Port Economic Association
• /
• v.34 no.1
• /
• pp.35-49
• /
• 2018

Busan Port handles more than 75% of the domestic freight volume and is ranked at 6th for global shipping in the world. This paper aims to estimate ship emission in North Port that is the center of Busan Port and located near the residential area. The emission for each type of ship is calculated applying a emission model proposed by U.S. EPA and the atmospheric diffusion pattern of the exhaust gas according to the season, the weather condition and the time was identified using CALPUFF Model. As a result, the major pollutants of $NO_x$, $SO_x$ and PM10 were 30,853 tons, 36,281 tons and 6,856 tons, respectively, and the highest rate was 42% in oil tankers. On clear days, air pollution was stagnant around the harbor, spread widely on windy days, and tended to be thinner on rainy days. The research contributes to recognizing the seriousness of air pollution and can be used as basic data for policy making in the future.

• Journal of Fisheries and Marine Sciences Education
• /
• v.28 no.6
• /
• pp.1581-1590
• /
• 2016

In order to reduce the risk of death from hypothermia for the fishing vessel's crew at sea, this paper suggests that the criteria of equipment of fishing vessels should be revised for fishing vessels engaged in coastal and inshore fisheries to be equipped with the immersion suit. The criteria of equipment of fishing vessels for immersion suits was amended to reflect the sinking of No.501 Oryongho but it was only reflected in ocean fisheries at Bering sea and Antarctic ocean that immersion suits must be provided with the same number of the total number of crew on board. Therefore, this paper analyses the relationship between maritime accident of fishing vessels and weather condition based on sea water temperature to find out the risk of hypothermia and also compares the international conventions(SFV Protocol 1993, Cape Town Agreement 2012, STCW-F 1995 and SOLAS 1974) and domestic law concerning criteria of equipment of fishing vessels. As a result, fishing vessels engaged in coastal and inshore fisheries are exposed to the risk of hypothermia when they are in distress and the criteria of equipment of fishing vessels should be amended to provide the immersion suits in accordance with the revision trend of international conventions.

• Journal of the Architectural Institute of Korea Structure & Construction
• /
• v.34 no.1
• /
• pp.61-68
• /
• 2018

Recently, concentration of fine and ultra-fine particulate matter(PM) has been increased in KOREA. The increase of PM in KOREA is due to increase of domestic industries and yellow dust from china. PM is known to cause diseases such as dyspnoea, asthma, arrhythmia. Since PM is harmful to human, KOREA Ministry of Environment(ME) warns people to stay indoors when the outdoor PM concentration is high. However, prior studies has shown that indoor PM concentration can be relatively high when outdoor PM concentration is high due to infiltration of PM into buildings though leakage areas. In this study, airtightness, indoor and outdoor pressure difference and PM 2.5 & 10 concentration were measured in an apartment complex to observe PM infiltrating into building. Field measurement was conducted in newly-built apartment buildings to avoid the influence of indoor PM which can be generated by residents. The airtightness test was conducted to identify the leakage areas of the apartment, such as electric outlets and supply/exhaust diffusers. The airtightness test result showed that the air leakage area of the building was dominant in buildings envelop. According to indoor and outdoor pressure difference measurement result and PM concentration measurement result, it can be concluded that outdoor PM can infiltrate into indoor by leakage areas when wind is blown toward the apartment. As a result, pressure difference formed by the external weather condition and architectural characteristics such as the airtightness in building can influence PM to infiltrate into buildings. In further studies, I/O ratio, stack-effect, infiltration and penetration factor will be considered.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.14 no.6
• /
• pp.1-13
• /
• 2015

Travellers consider extra travel time to be arriving their destination because of uncertainty of travel. So it is important to make predictable highway by providing information of travel time variability to traveller so as to enhance level of service at highway. In order to make predictable highway, it is necessary to develope measures of travel time variability that travellers can easily understand. Recently advanced country including the United States, travel time variability index are actively studied. In earlier study, 95percentile of travel time is considered to be most important calculation index of travel time variability. In this study, is has focused on the propriety analysis of 95percentile of travel time in domestic transportation environment. Result of analysis, All of measures(80percentile of travel time, 90percentile of travel time, 95percentile of travel time) show the tendency to increase when case of weather factor occur compare to normal condition under LOS A~D. Especially 95percentile of travel time increased sensitively.

• Journal of Environmental Impact Assessment
• /
• v.28 no.3
• /
• pp.183-200
• /
• 2019

In this study, the characteristics of seasonal $PM_{2.5}$ behavior in South Korea and other Northeast Asian regions were analyzed by using the $PM_{2.5}$ ground measurement data, weather data, WRF and CMAQ models. Analysis of seasonal $PM_{2.5}$ behavior in Northeast Asia showed that $PM_{2.5}$ concentration at 6 IMS sites in South Korea was increased by long-distance transport and atmospheric congestion, or decreased by clean air inflow due to seasonal weather characteristics. As a result of analysis by applying BFM to air quality model, the contribution from foreign countries dominantly influenced the $PM_{2.5}$ concentrations of Baengnyeongdo due to the low self-emission and geographical location. In the case of urban areas with high self-emissions such as Seoul and Ulsan, the $PM_{2.5}$ contribution from overseas was relatively low compared to other regions, but the standard deviation of the season was relatively high. This study is expected to improve the understanding of the air pollutant phenomenon by analyzing the characteristics of $PM_{2.5}$ behavior in Northeast Asia according to the seasonal weather condition change. At the same time, this study can be used to establish the air quality policy in the future, knowing that the contribution of $PM_{2.5}$ concentration to the domestic and overseas can be different depending on the regional emission characteristics.

• International Journal of Highway Engineering
• /
• v.17 no.2
• /
• pp.79-87
• /
• 2015

PURPOSES: According to accident statistics for road built in 2004, the ratio of accidents on frozen roads to normal roads is 0.9%, whereas the fatality ratio is 2.7%. The risk of accidents on frozen roads is very high. Measures taken every year to prevent traffic accidents of frozen roads in the winter season are still insufficient. Additionally, measures have been established mainly on rural roads. Therefore, for urban roads, analyses and measures to prevent accidents are lacking. In this study, data on accidents on frozen roads was used to search for the causes behind these accidents and measures to reduce accidents have been recommended. METHODS: In this study, collected data from the TAMS (Traffic Accident Management System), which were collected by the Seoul National Police Agency was used. The data were divided into vehicle, people, and condition of road. The analytical model used here was the Logistic Regression Model, which is frequently used for traffic safety and accident analysis. This study uses the odds ratio analysis to search for variables related to frozen road traffic accidents in each category. A total of 18 out of 47 variables were found to be the causes of accidents. RESULTS: From the results of the comparative analysis of 18 variables, the category of the condition of the road was found to be the most critical. Contrary to expectations, more accidents occurred in clear weather than in other conditions. Accidents on bridges occurred frequently, and its odds ratio was the highest compared with other road types. When BPT is operated, the probability of accidents on frozen roads is lower than in general conditions, and accidents occurred frequently on roads with less than four lanes. CONCLUSIONS : Based on the results of this study, suggestions for reducing the risk of future domestic road accidents in freezing conditions are indicated as follows. First, it is necessary to perform a technical review of the urban road traffic accidents caused by frozen roads. Second, it is necessary to establish criteria for the study of the road environment based on the major causes of road accidents on frozen roads. Third, improvements in urban road environmental factors should be made.

• Journal of Navigation and Port Research
• /
• v.34 no.10
• /
• pp.781-786
• /
• 2010

In this study, a new concept of ocean transport system, called the mobile harbor serving for a short distance transport of containers with cargo handling cranes between mother containerships and coastal ports, is introduced. Instead of direct berthing a very large containership at the coastal port, Mobile Harbor is moving to the offshore mooring basin with enough water depth condition. Therefore, investigation of the coastal environment, technical condition and limitation of the domestic trade ports for the application of Mobile Harbor, is essential process. To figure out the accessibility of mobile harbor, the environmental conditions, the cargo handling capacity and marine traffic volume and flow pattern has been analyzed with the tools for marine traffic simulation and virtual navigation aids system. The most proper Mobile Harbor mooring areas among trade ports of the south and east coast are selected by analyzing the obtained information and evaluating its application: (1) Under natural environmental conditions such as air and sea weather, three candidate areas are selected such as Masan port, Ulsan port, and Busan(New port) port. (2) Under marine traffic and appropriateness of water facilities, three candidate areas are selected as Mokpo port, Busan(New port) port, and Donghae & Mookho port (3) For a region-based analysis considering handling capacity and the local managed trade ports in vicinity, three candidate areas are selected as Busan region, Yosu & KwangYang region, and Mokpo region. Through this study, the basic guideline for selection of optimum trade port and offshore mooring basin for mothership and Mobile Harbor is recommended. In order to apply the Mobile Harbor to the real water, navigaton aids as the virtual route identification with AIS must be introduced for maritime safety in the vicinity of Mobile Harbor area which berthing and cargo handling is being conducted.