• Journal of Energy Engineering
• /
• v.24 no.2
• /
• pp.129-143
• /
• 2015

Increasing concerns on climate change and energy security accelerated policies to reduce green-house gas emission, especially from the transportation sector. Electric vehicle (EV) has been on the spotlight to deal with such environmental issue and V2G (Vehicle-to-Grid) technology began to draw attentions as an alternative to reduce ownership costs while contributing to an efficient and decentralized power grid. This study conducts a scenario analysis on total cost of ownership of EV under V2G scheme and compare with non-V2G EV and Internal Combustion Engine (ICE) vehicle. As result, V2G service is expected to provide an annual average profit of $210 to EV users willing to reverse flow its residual power in the battery. The profit from V2G service leaves a margin of $4,530 over operational lifetime, compared with $2,420 cost of charge for non-V2G EV. In summary, total cost of ownership of V2G-capable EV was 6.2% less than non-V2G EV and 10.2% higher than ICE vehicle. The results confirm a comparative economic advantage of operating EV under V2G scheme. Increased number of EVs with V2G service has shown to provide positive effects to power industry for valley filling in load distribution, thus, favorably increasing the overall economic feasibility.

• Applied Chemistry for Engineering
• /
• v.21 no.5
• /
• pp.509-513
• /
• 2010

Recently, an amount of waste electronic devices such as LED and trichromatic fluorescent lamp has increased with the development of electronic industry. Reportedly, rare earth metals such as yttrium and europium have been discovered in the waste electronic devices. In order to improve the selectivity of yttrium and europium, the effects of the following factors on recovery experiment have been considered : i) fatty acids with various alkyl chain lengths, ii) the concentration of extractant, and iii) pH. The results show that the extraction efficiencies decrease at the same pH with decreasing the concentration of extractant and so $pH_{0.5}$ (That value of pH in an aqueous phase at which the distribution ratio is unity at equilibrium: 50% of the solute is extracted (E = 0.5) only when the phase ratio is unity.) moves into higher pH. The highest selectivity of yttrium and europium was obtained with tetradecanoic acid as extractant. The extraction mechanism of yttrium and europium was varied with the change of concentration of the tetradecanoic acid. $MR_3$single-species was formed from the yttrium and europium ion in the extractant concentration less than 0.1 M. On the other hand, the yttrium or europium ion is solvated with three molecules of tetradecanoic acid monomer like $MR_3{\cdot}$ 3RH in the extractant concentration more than 0.1 M.

• Journal of radiological science and technology
• /
• v.39 no.3
• /
• pp.361-368
• /
• 2016

As the tertiary industry is being developed, many problems are introduced in an industrial area in Korea. This study aims to investigate the residents' health conditions, such as the prevalence of metabolic syndrome and fatty liver diagnosed by ultrasonography, comparing the urban with the industrial areas. The subjects were 378 adults in the urban area and 376 adults in the industrial area. Subject variables accounted for were gender, age, drinking habits, smoking habits, physical activities, waist circumferences and BMI. In blood tests, fasting blood glucose, triglyceride, HDL, blood pressures, total cholesterol, AST, ALT and GGT were examined. Also, the presence and absence of fatty liver, diagnosed using ultrasonography, was investigated. As a result, the prevalence of metabolic syndrome were 43.7% in the urban area and 51.6% in the industrial area, hence it was significantly higher in the industrial area than in the urban area. Fasting blood glucose, triglyceride and waist circumference in the distribution of the individual components were 47.4, 53.7, and 16.1% in the urban area and 54.5, 61.5, and 22.9% in the industrial area respectively, so it was substantially higher in the industrial area than in the urban area. On the other hand, HDL, diastolic blood pressure, and fatty liver were 25.7, 43.4, and 44.7% in the urban area and 21.3, 19.9, and 36.7% in the industrial area respectively and thus it was much higher in the urban area than in the industrial area. In conclusion, this study shows that there were significant differences between the residents' health condition, comparing the urban area to the industrial area. Therefore, the precaution and aggressive management of metabolic syndrome may be necessary, in accordance with the characteristics of the industrial zone.

• Journal of Korea Water Resources Association
• /
• v.48 no.12
• /
• pp.1023-1035
• /
• 2015

This study applies 3-D N-S solver based on PBM (Porous Body Model), LED-WASS-3D ver 2.0 to directly analyze non-linear interaction of seawater-freshwater-coastal aquifer in order to simulate the seawater infiltration into coastal aquifer. This numerical simulation is the first trial in Korea, as well as unusual and new numerical analysis abroad. Firstly, to validate the applied numerical model, the validity and effectiveness was verified for the numerical model by comparing and considering it with the result of laboratory experiment for seawater-freshwater interface in coastal aquifer. And then it simulated the seawater infiltration into coastal aquifer considering the changed levels of seawater and groundwater in order to analyze the distribution characteristics of flow field and seawater-freshwater interface of coastal aquifer as the level difference between seawater and groundwater and rate of seawater level (${\Delta}h/h$) increased. In addition, the characteristics of seawater infiltration were analyzed from the vertical salinity in the coastal aquifer by ${\Delta}h/h$, which cannot be obtained from existing non-diffusion numerical models. Finally, it analyzed the effect of ${\Delta}h/h$ on the seawater infiltration distance in coastal aquifer, which was indexed.

• Journal of Internet Computing and Services
• /
• v.15 no.4
• /
• pp.21-31
• /
• 2014

As the protein drug industry is growing, protein informations are indispensable for the protein drug development. NCBI and PDB in the U.S., the EMBL in Europe and the DDBJ in Japan are the representative centers for bio information and each center provides specific data for protein information. To obtain specific protein information, users are to be collect them from the service sites of each center and then combine or analyze for their purpose. To facilitate the accessibility to bio data, various R&D activities are running for development of diverse web services relevant to bio data in major data centers or small-scale projects. With the recognition of protein information as pivotal for the protein drug development, DrugBank in Canada, GDSC in the U.S. start to provide integrated informations between drugs and proteins. However, those service does not meet users' demands due to lack of diversity. In Korea, infra structures for bioinformatics are limited and the current services for protein drug information are providing only basic information of the drug including distribution data. This is a pilot study to construct a specialized service for protein drug information in Korean style breaking through the limitations of current services. This study proposed new fields for protein characterization information which had not been provided by current services and evaluated their effectiveness and usability by comparing them to the existing fields with expert survey. As a result, the newly proposed fields for protein characterization have been proven to be useful data fields for the service of protein drug information.

• Korean Chemical Engineering Research
• /
• v.55 no.1
• /
• pp.40-47
• /
• 2017

Dust explosion hazards are always present when combustible dusts are manufactured or handled in the process. However, industries is experiencing difficulty in establishing chemical accident prevention measures because of insufficiency of information on dust explosion characteristics of combustible dust handled in industry. In this study, we investigated experimentally dust explosion characteristics of two kinds of multi-walled carbon nano tubes (MWCNT) different in particle size distribution and examined classification of dust explosion hazardous area for MWCNT manufacturing or handling process by applying the NFPA 499 code. As a result, $P_{max}$, $K_{st}$, LEL, MIE and MIT of MWCNT 1 having $124.2{\mu}m$ median diameter are obtained 6.3 bar, $56bar{\cdot}m/s$, $125g/m^3$, over 1000 mJ, and over $650^{\circ}C$. $P_{max}$, $K_{st}$, LEL, MIE and MIT of MWCNT 2 having $293.5{\mu}m$ median diameter are 6.2 bar, $42bar{\cdot}m/s$, $100g/m^3$, over 1000 mJ, and over $650^{\circ}C$, respectively. MWCNT 1, 2 are not categorized as combustible dust listed in the NFPA 499 Code for classification of dust explosion hazardous area because explosion severity and ignition sensitivity of MWCNT 1, 2 are below 0.35 and 0.01, respectively.

• Elastomers and Composites
• /
• v.48 no.2
• /
• pp.172-179
• /
• 2013

Impact modifier reinforced polymers are frequently used. In this study, Izod impact test has been simulated to analyze the mechanism of impact reinforcement of Nylon6 which contains impact modifier. The modeling of rubber particles added to Nylon6 as an impact modifier has been attempted. Based on the modeling, simulation of Izod impact test has been performed to observe the distribution and direction of stress at the cross-section of impact specimen. Three computer simulation models for Nylon6 were investigated. Those were without impact modifier, containing impact modifier without surface treatment, and containing impact modifier with surface treatment in the Nylon6. Simulation results showed that the stress which originated at the notch surface propergated to the inside of specimen round a impact modifier. In addition to that, impact modifier reinforced Nylon6 specimen showed low stress ditribution in the cross-section specially at notch surface. Principal stress in perpendicular direction to crack was also lowered in impact modifier reinforced Nylon6. These enhanced impact resistance reduced and crack propergations. Through this study it was realized that the computer simulation can be utilized to investigate the property enhacement of composite materials.

• Journal of Software Engineering Society
• /
• v.29 no.2
• /
• pp.7-12
• /
• 2020

A project to establish an information system with a project cost of more than 500 million won at a local public firm is subject to the Information System Audit (hereinafter referred to as IS Audit), and the IS Auditor shall conduct audit according to the audit criteria. Recently, as blockchain technology has been applied to various fields such as manufacturing, healthcare, distribution, and public sectors beyond the financial industry, the development of systems that apply blockchain technology is increasing. The use of Hyperledger Fabric, a private blockchain, is on the rise to utilize blockchain technology in public firms and private firms. However, the newly emerging blockchain-based system is not sufficient to carry out auditing with existing audit check items, so it has no choice but to make and use audit items individually. Therefore, a need for verified audit items for systems that base on blockchain technology has emerged. In this study, we customized the Delphi process to derive audit items suitable for the system development project using the blockchain technology, and verified the completeness and accuracy of the audit items derived through a survey by the IS Auditor. This research will be of direct help to the IS Auditor, and it is expected that operators and organizers who provide services through the blockchain-based system will also contribute to improving the quality of the system.

• Hwankyungkyoyuk
• /
• v.4 no.1
• /
• pp.89-211
• /
• 1993

The Korean government embarked upon ambitious economic development plans in the 1960's the goals of development policy at that time were the elimination of absolute poverty and the alleviation of unemployment. With scant natural resources, the government had to push for industrialization based upon borrowed foreign raw materials with surplus local labor. Preoccupation with the economic goals of industrialization and export expansion left little room for considering environmental protection. It is evident that Korea's exported industrialization strategy of the past three decades has been a success in terms of income, production, and other macroeconomic indicators, but it cannot be denied that a host of undesirable side-effects have been created. These include environmental problems. congestion in several large cities, poor wealth distribution, and regional disparities. The environmental problems were recognized even in the early stage of development, but preoccupation with the pending economic goals of industrialization and export expansion left little room for considering environment protection. The perceived and actual seriousness of the problems, however, has reached such a level that further negligence may imperil political stability and developmental problems facing the world arise from a world economic order characterized by ever expanding consumption and production, which exhausts and contaminates natural resources and creates and perpetuates gross inequalities between and within nations. It will be necessary to develop new culture and ethical values, transform economic structures, and reorient, our lifestyles. Changing lifestyles can not be promoted by government policy initiative alone but through self=generated educational efforts and mutual training by people themselves. The citizens group for environment (NGOs) should assume these educational and training responsibilities starting from grass-root level of people. It must be reawakened to the reality that the environmental preservation for better quality of life is based on the development of human relationships, creativity, spirituality, reverance for the natural world and celebration of life, and is not dependent upon increased consumption of non-basic material goods. To carry on such environment education social movements and NGOs should (1) provides educational methodologies, which focus on values clarification and moving beyond clarification and moving beyond blame to constructive action. (2) provide training for leaders of business and industry, government, union and others on consumption and production. (3) initiate and support the training and work of environmental counselor who encourage responsible consumption. (4) cooperative with media to initiate and strengthen educational programs on the social environmental programs on the social environmental impacts of consumption and production and to build awareness of consumer responsibility and potential. Economic and social development can be compatible with environment protection : both can be achieved simultaneously. Effective environmental management depends on the various factors : political will, institutional arrangements, appropriate legislation, and availability of the requistite financial and technological resources, which is possible with a strong public awareness of the importance of environmental preservation.

• Proceedings of the Korea Society for Industrial Systems Conference
• /
• 2006.05a
• /
• pp.95-108
• /
• 2006

Because of rapid expansion of third party logistics, fierce competition in the transportation industry, and the diversification and globalization of transportation channels, an effective transportation planning by means of multimodal transport is badly needed. Accordingly, this study aims to suggest an optimal transport algorithm for the multimodal transport in the international logistics. Cargoes and stopovers can be changed numerously according to the change of transportation modes, thus being a NP-hard problem. As a solution for this problem, first of all, we have applied a pruning algorithm to simplify it, suggesting a heuristic algorithm for constrained shortest path problem to find out a feasible area with an effective time range and effective cost range, which has been applied to the Label Setting Algorithm, consequently leading to multiple Pareto optimal solutions. Also, in order to test the efficiency of the algorithm for constrained shortest path problem, this paper has applied it to the actual transportation path from Busan port of Korea to Rotterdam port of Netherlands.