• Structural Engineering and Mechanics
• /
• v.22 no.6
• /
• pp.719-739
• /
• 2006

An analytical method for the free vibration of two circular plates coupled with an inviscid and compressible fluid is developed by the Rayleigh-Ritz method. The fluid is bounded by a rigid cylindrical vessel and two circular plates with an unequal thickness and diameter. It was found that the theoretical results could predict well the fluid-coupled natural frequencies with an excellent accuracy when compared with the finite element analysis results. As the fluid thickness increases or the plate thickness difference increases, an abrupt curve veering in the natural frequency loci of the neighboring modes and drastic changes in the corresponding mode shapes are observed. The mode localization frequently appears in the higher modes and in the wide gap between the plates because of a decrease in the fluid coupling owing to the fluid dispersion effect.

• Journal of the Korean Ceramic Society
• /
• v.35 no.2
• /
• pp.180-184
• /
• 1998

It was examined that the rheological behaviors of fly ash 70wt%-clay 30wt% slip in which nonplastic fly ash was a major component. We have systematically investigated the effects of deflocculant(Tetrasodium pyrophosphate ; Na4P2O7 nH2O Sodium silicate; Na2SiO3) and coagulant(CaSO4) on the rheological behavior of ash-clay slip. Ash-clay slip have been characterized on the basis of the time dependent rheology which was done out by the gel-curve test. Dispersion mechanism of ash-clay slip is the steric stabilization by the Na2SiO3 coating of cenospheres surface. Coagulated slip seems to have the new network structure and shows the gellation behaviors which makes it possible to direct coagulated casting(DCC).

• Journal of the Korean Society of Safety
• /
• v.10 no.1
• /
• pp.56-63
• /
• 1995

Two methods of the numerical method of CPQRA(Chemical Process Quantitative Risk Analysis) and the manual method of IAEA(International Atomic Energy Agency) were used to estimate the individual risk and societal risk around the chemical plant. Where, the CPQRA is introduced to verify the theoritical background of the manual of international atomic energy agency. The Gaussian plume model which has a weather stability class D with velocity of 5m/s was applied to calculate dispersion of hazard material. Also, 8-point method was employed to the effects of accidents for wind distribution. Furthermore, historical record, FTA(Fault Tree Analysis) and ETA(Event Tree Analysis) were used to estimate the probability or frequency of accidents. Eventually, the individual risk shows isorisk contour and the societal risk shows F-N curve around hazard facility, especially in chemical plants. Caulculated results, which both individual and societal risk, by using IAEA manual show simillar results to those of calculation by numerical method of CPQRA.

• Journal of Astronomy and Space Sciences
• /
• v.20 no.1
• /
• pp.63-82
• /
• 2003

Using the Schwarzschild's linear programming technique, we obtained the general solutions of the collisionless Bolzmann equation describing the spherical galaxy in dynamical equilibrium. From this calculation we have confirmed the existence of isotropic spherical galaxies obeying a de Vaucouleurs'law which includes a dark halo. The flattening profile of the velocity dispersion curve seen in the elliptical galaxies can be explained as the increase of mass to light ratio in this dark matter. The space density distribution of this dark matter shows that the core radius of the dark matter is smaller than the effective radius of the galaxy.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2005.04a
• /
• pp.151-154
• /
• 2005

Laboratory column experiments for simultaneous removal of Cd and Cr(VI) are conducted using newly developed material, referred to as Fe-loaded zeolite, which has both reduction ability of iron and ion exchange ability of zeolite. Breakthrough curves were obtained from each column experiment, and described with advection-dispersion equation. Apparent parameters including $K_{app}\;and\;D_{app}$ were newly introduced for effectively describing the Cr(VI) breakthrough curve. $K_{app}$ decreased with increasing initial contaminant concentration and with decreasing flow rates. Whereas, $D_{app}$ were not significantly affected by initial contaminant concentration or flow rate.

• Elastomers and Composites
• /
• v.29 no.2
• /
• pp.113-120
• /
• 1994

The vulcanization characteristics, physical and electrical properties have been measured for magnetite-loaded CM compounds containing various concentration of magnetite. Samples of the various concentration of magnetite are characterized by oscillating disk rheometer, mooney viscometer, tensometer and resistance meter. The morphology and dispersion of magnetite are analyzed by scanning electron microscope(SEM). The results obtained are as follows : 1. The CM compound without magnetite shows plain curve, while the CM compounds containing magnetite show short curves. 2. The maximum volume of magnetite is 600 phr in the CM compounds. The magnetite of 30 to 150 phr of magnetite act as reinforcement agents and the 50 phr magnetite shows maximum tensile strength. 3. The electric conductivity is mostly influenced by the conditions of temperature, compacting pressure, and magnetite orientation. Further efforts should be made to develop a new design in various electric conductivity fillers for the most efficient and applicable rubber products.

• Journal of Power System Engineering
• /
• v.12 no.1
• /
• pp.58-65
• /
• 2008

A method to test thin-walled tubes by guided ultrasonic wave is reported. The principle is that applicate two types of axially symmetric ultrasonic tube modes and "longitudinal" modes with particle displacement, which is coupled in axial and radial directions for transverse failures and torsional modes, oscillating in the circumferential direction only, for longitudinal failures. Both types of modes propagate along the tube in the axial direction. Therefore, a pulse-echo technique is possible. The pulses are excited and received at one end of the tube without contact electro-dynamic transducers. As soon as the tubes is put into a transducer coil at one end, the test of the whole tube can be accomplished in a few milliseconds. It is not necessary to rotate and transport the tubes during the test.

• Proceedings of the Acoustical Society of Korea Conference
• /
• spring
• /
• pp.529-534
• /
• 2002

유도초음파는 얇은 판재와 다층재료를 평가하는데 널리 사용되는데, 이를 정량적으로 이용하기 위해서는 위상 및 군속도의 분산선도는 필수적이다. 본 연구에서는 후방복사 리키 램파를 이용하여 위상속도 분산곡선과 군속도를 측정하였다. 물에 잠긴 판재에 입사각을 변화 시키면서 판재에서 발생하는 후방복사 초음파 신호를 측정하였고, 후방복사된 초음파 신호는 유도초음파의 분산특성을 지님을 보였다. 입사각도와 수신된 파형의 주파수 분석을 통하여 램파의 위상속도 분산선도를 구하였다. 또한, 특정한 입사각에서 입사점을 변화시키면 서 론 파형의 시간대역 이동으로부터 군속도를 측정하였다.

• Proceedings of the Earthquake Engineering Society of Korea Conference
• /
• 1999.10a
• /
• pp.91-98
• /
• 1999

In this study a modified ground strain model is developed for an equivalent earthquake load and is applied to the seismic analysis of buried pipelines, The ground strain can be obtained using the ratio of a maximum ground velocity to a wave propagation velocity. To reflect soil conditions and seismic characteristics the wave propagation velocity is evaluated by a proposed dispersion curve based on wave energy distribution. In order to verify the procedures the observed earthquake data and the results of this study are compared. For the application of an equivalent earthquake load to the seismic analysis the buried pipelines are modeled using the beam theory. the results of the analyses are compared with those of a dynamic analysis code and those obtained from the response displacement method. Finally various parametric studies considering different soil conditions and seismic loads are examined.

• Journal of the Optical Society of Korea
• /
• v.16 no.4
• /
• pp.336-342
• /
• 2012

A low-cost optimal double-prism method is proposed by using the developed MATLAB program to correct chromatic aberration. We present an efficient approach to choose a couple of low-cost glasses to obtain a low aberration double prism. The doublet prisms were made of two lead-free glasses. The relative partial dispersion of the two lead-free glasses is identical and their Abbe numbers are different greatly. The proposed design aims to minimize chromatic aberration, such as in apochromats, for paraxial ray tracing. Finally, an optimization design for real ray tracing can be evaluated by the chromatic aberration curve with a minimal area.