• Journal of Electrical Engineering and information Science
• /
• v.3 no.2
• /
• pp.239-244
• /
• 1998

Piezoelectric pressure sensors and pyroelectric infrared detectors based on ZnO thin film have been integrated with GaAs metal-semiconductor field effect transistor (MESFET) amplifiers. Surface micromachining techniques have been applied in a GaAs MESFET process to form both microsensors and electronic circuits. The on-chip integration of microsensors such as pressure sensors and infrared detectors with GaAs integrated circuits is attractive because of the higher operating temperature up to 200 oC for GaAs devices compared to 125 oC for silicon devices and radiation hardness for infrared imaging applications. The microsensors incorporate a 1${\mu}$m-thick sputtered ZnO capacitor supported by a 2${\mu}$m-thick aluminum membrane formed on a semi-insulating GaAs substrate. The piezoelectric pressure sensor of an area 80${\times}$80 ${\mu}$m2 designed for use as a miniature microphone exhibits 2.99${\mu}$V/${\mu}$ bar sensitivity at 400Hz. The voltage responsivity and the detectivity of a single infrared detector of an area 80${\times}$80 $\mu\textrm{m}$2 is 700 V/W and 6${\times}$108cm$.$ Hz/W at 10Hz respectively, and the time constant of the sensor with the amplifying circuit is 53 ms. Circuits using 4${\mu}$m-gate GaAs MESFETs are fabricated in planar, direct ion-implanted process. The measured transconductance of a 4${\mu}$m-gate GaAs MESFET is 25.6 mS/mm and 12.4 mS/mm at 27 oC and 200oC, respectively. A differential amplifier whose voltage gain in 33.7 dB using 4${\mu}$m gate GaAs MESFETs is fabricated for high selectivity to the physical variable being sensed.

• The Journal of the Acoustical Society of Korea
• /
• v.25 no.3E
• /
• pp.115-122
• /
• 2006

The bistatic scattering of an incident wave by a hemi-spherically capped cylinder is of particular interest because it has rarely been studied until the present day. The configuration of a hemi-spherically capped cylinder is similar to naval underwater weapons (submarines, mines, torpedos, etc.), but which is not exactly the same. This paper describes a novel laboratory experiment aimed at direct measurement of bistatic scattering by a hemi-spherically capped cylinder. Bistatic scattering by a hemi-spherically capped cylinder was measured in an acoustic water tank (5m long, 5m wide, 5m deep) using a high frequency projector (120kHz) and hydrophone. Measurements of monostatic scattering were also made under the same conditions. The bistatic scattering pattern by a hemi-spherically capped cylinder was measured against the incident angles $(0^{\circ},\;15^{\circ},\;20^{\circ},\;30^{\circ},\;45^{\circ},\;60^{\circ},\;90^{\circ})$ in order to verify various scattering pattern characteristics by the change of incident angle. The results indicate that the bistatic scattering TS at a wide scattering angle is much stronger than the mono static scattering TS. In bistatic scattering, the forward scattering TS is significantly stronger than the backward scattering TS, and the forward scattering pattern is also broader. In case of seven incident angles, the maximum value of forward scattering TS is about 14dB stronger than that of backward scattering TS. It is also found that forward scattering varies with the incident angle of sound to a much less extent than backscattering, and it is not seriously affected by the incident angle. These features could be the advantages of using forward scattering for detecting underwater targets at long range and increasing detection area and probability.

• Convergence Security Journal
• /
• v.12 no.4
• /
• pp.3-8
• /
• 2012

Smartphones have all the recent technology integration and NFC (Near Field Communication) Technology is one of them and become an essential these days. Despite using smartphones with NFC technology widely, not many security vulnerabilities have been discovered. This paper attempts to identify characteristics and various services in NFC technology, and to present a wide range of security vulnerabilities, prevention, and policies especially in NFC Contactless technology. We describe a security vulnerability and an possible threat based on human vulnerability and traditional malware distribution technic using Peer-to-Peer network on NFC-Enabled smartphones. The vulnerability is as follows: An attacker creates a NFC tag for distributing his or her malicious code to unspecified individuals and apply to hidden spot near by NFC reader in public transport like subway system. The tag will direct smartphone users to a certain website and automatically downloads malicious codes into their smartphones. The infected devices actually help to spread malicious code using P2P mode and finally as traditional DDoS attack, a certain target will be attacked by them at scheduled time.

• 한국HCI학회:학술대회논문집
• /
• 2008.02b
• /
• pp.552-557
• /
• 2008

'Digilog Book' dealing with the combination of each advantage of analog sensibility on texts and digital sensation on virtual reality is one of the noble applications of U-book. Based on contents from books, enhancing 3D immersive display enable readers to enjoy various experiences with multisensory feedback provided. Also, 'Digilog Book' provides digitally created stories that would project different experiences and environments interacting users' choices on the interface of the book. This study focuses on developing users friendly implementation tools providing more interaction between digitally generated stories and digitally generated interface so that interaction between virtual reality and actual realty is expanded through simulating contexts and extents. From the application scenario 'Digilog Book' would perform as a storytelling tool with developing subordinated elements such as context structure, screen structure, definition of writing function, writing interface, writing system structure, etc. Therefore, this study would become a significance to direct and indicate the development of writing techniques on virtual reality back to life through digitally augmented reality.

• The Journal of Information Technology
• /
• v.4 no.3
• /
• pp.101-123
• /
• 2001

The competitive environments of the 2001s appears to demand not only information technology(IT), but also practical use of internet network in all business areas. Accordingly, Chief Information Officers(CIO) are recognizing that these objectives can only be achieved through conscious mind and business mind in digital management. Thus, the main concern of CIO in an organization is development and management of human resource in digital management innovation. To make a successful organizational innovation CIO needs to have the conscious mind for change of human resource management. To study the determinants of the level of management in Korean venture firms, Top management characteristics, resource dependence and organizational power perspective, rational expectations, There is direct successful factors of Venture firm, it is they got th notion that for venture an appropriate manager which is as important as the technical leadership itself. also they employed the people who are very good at skilled management.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.39 no.7
• /
• pp.7-15
• /
• 2002

The digital DBS tuner is designed and implemented in a CMOS process using a direct-conversion architecture that offers a high degree of integration. To generate mathched LO I/Q quadrature signals covering the total input frequency range, a fully integrated ring oscillator is employed. And, to decrease a high level of phase noise of the ring oscillator, a frequency synthesizer is designed using a double loop strucure. This paper proposes and verifies a band selective loop for fast frequency switching time of the double loop frequency synthesizer. The down-conversion mixer with source follower input stages is used for low voltage operation. An experiment implementation of the frequency synthesizer and mixer with integrated a 0.25um CMOS process achieves a switching time of 600us when frequency changes from 950 to 2150MHz. And, the experiment results show a quadrature amplitude mismatch of max. 0.06dB and a quadrature phase mismathc of max. >$3.4^{\circ}$.

• Fashion & Textile Research Journal
• /
• v.20 no.4
• /
• pp.464-473
• /
• 2018

The objective of this study is to develop a sizing system of fitness clothing that can properly accommodate various body sizes of Korean senior women. The sizing system of upper and lower fitness clothing was developed in the present study by selection of key variables, identification of size category candidates, and determination of an optimal sizing system. First, key anthropometric dimensions (stature and bust circumference for upper clothing and stature; waist circumference for lower clothing) were identified by factor analysis on the direct body measurements (n = 272) and 3D whole-body scan data (n = 271) of Korean senior women in Size Korea. Second, sizing system candidates based on the key dimensions of upper and lower clothing were explored using a grid method and an optimization method. Lastly, among the sizing system candidates, optimal sizing systems of upper and lower clothing were selected in terms of accommodation rate. Five size categories (short/small, short/medium, tall/small, tall/medium, and tall/large) were selected as the optimal sizing systems of upper and lower clothing with 89% and 78% of accommodation rate, respectively, for the Korean senior women. The anthropometric characteristics of the representative humans of the optimal size categories would be of use in the design of fitness compressive wear for the better fit and effectiveness of exercise and health of Korean senior women.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.26 no.5
• /
• pp.724-732
• /
• 2002

Although the demands for diesel engine is increased, our world is faced with very serious problems related to the air pollution due to the exhaust emissions of the diesel engine. In this study, the potential possibility of oxygenated fuel such as Methyl tertiary butyl ether (MTBE) was investigated for the sake of exhausted smoke reduction from diesel engine. MTBE has been used as a fuel additive blended into unleaded gasoline to improve octane number, but the study of application for diesel engine was incomplete. Because MTBE includes oxygen content approximately 18%, it is a kind of oxygenated fuel that the smoke emission of MTBE is reduced remarkably compared with commercial diesel fuel, that is, it can supply oxygen component sufficiently at high load and speed in diesel engine. But, the NOx emission of MTBE blended fuel is increased compared with commercial diesel fuel. And. it was tried to analyze not only total hydrocarbon but individual hydrocarbon components from $C_1$to $C_{6}$ in exhaust gas using gas chromatography to seek the reason for remarkable reduction of smoke emission. The results of this study show three conclusions. 1. The smoke omission of the MTBE blended fuel is lower than that of the diesel fuel at all experimental region in direct injection diesel engine. 2. Individual hydrocarbons(C$_1$~ $C_{6}$) as well as total hydrocarbon of oxygenated fuel are reduced remarkably compared with diesel fuel. 3. Smoke emission from diesel engines was strongly depended on oxygen content in fuel regardless of operating condition.

• Journal of The Korean Society of Inherited Metabolic disease
• /
• v.4 no.1
• /
• pp.5-12
• /
• 2004

Purpose Phenylketonuria is an inborn error of metabolism, which is inherited as an autosomal recessive trait. PKU is resulting from deficiency of phenylalanine hydroxylase. PAH gene spans about 90 kb on chromosome 12q and comprises 13 exons. In order to define the genetic basis of PKU and the frequencies and distribution of PAH mutations in the Korean population, we analyzed PAH gene in independent 80 patients with PKU. Methods All 13 exons including exon-intron boundaries and 2 kb of 5' upstream region of the PAH gene were analyzed by PCR-direct sequencing methods. Results PAH gene analysis revealed 39 different mutations including 10 novel mutations. The novel mutations consisted of 9 missense mutations (P69S, G103S, N207D, T278S, P281A, L293M, G332V, S391I and A447P) and a novel splice site variant (IVS10-3C>G). R243Q, IVS4-1G>A, and E6-96A>G were the most relevant mutations and they accounted in the whole for 38% of the mutant alleles identified in this study. We also observed that. $BH_4$ responsibility was. associated with genotype of R241C, R53H and R408Q. Conc1ustion Our present study with 80 participants extends the previous results to more comprehensive understanding of PAH allele distribution and frequency in Koreans. Although Korean mutation profile of PAH is similar to those of the nearest oriental populations (Japanese, Chinese, and Taiwanese), several different characteristic features are revealed. The characterization of the genotype-phenotype relationship was also performed. Our data would be very useful information for diagnosis, genetic counseling and planning of dietary and therapeutic strategies in Korean PAH patients.

• Laser Solutions
• /
• v.7 no.3
• /
• pp.37-46
• /
• 2004

The shape and size variations of the nanopatterns produced on a polymer film using a near-field scanning optical microscope(NSOM) are investigated with respect to the process variables. A cantilever type nanoprobe having a 100nm aperture at the apex of the pyramidal tip is used with the NSOM and a He-Cd laser at a wavelength of 442nm as the illumination source. Patterning characteristics are examined for different laser beam power at the entrance side of the aperture($P_{in}$), scan speed of the piezo stage(V), repeated scanning over the same pattern, and operation modes of the NSOM(DC and AC modes). The pattern size remained almost the same for equal linear energy density. Pattern size decreased for lower laser beam power and greater scan speed, leading to a minimum pattern width of around 50nm at $P_{in}=1.2{\mu}W\;and\;V=12{\mu}m/s$. Direct writing of an arbitrary pattern with a line width of about 150nm was demonstrated to verify the feasibility of this technique for nanomask fabrication. Application on high-density data storage is discussed.