• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.6
• /
• pp.906-911
• /
• 2001

In this paper, LPI(low probability of intercept) and AJ(anti jamming) performance of the chirped BPSK system are analyzed. In the chirp method the cyclostationary of the signal is eliminated, since the instantaneous frequency is varied randomly within the whole spread bandwidth. Therefore, chirp method is considered for good LPI system against DAM(delay-and-multiplier) or SC (squaring circuit) interceptor which detects the chip rate or carrier frequency. Longer chirp duration makes the LPI performance better. From the simulation results, the chirp method has better AJ performance than DS(direct sequence) system in the PBNJ(partial band noise jammer) channel. At the same JSR(jammer to signal power ratio) level, chirped BPSK system has more robust AJ performance against MTJ(multi-tone jammer) than PBNJ.

• The Journal of the Acoustical Society of Korea
• /
• v.35 no.5
• /
• pp.368-374
• /
• 2016

This paper presents constructing transmitter and receiver by using a direct sequence spread spectrum techniques to DPSK (Differential Phase-Shift Keying) scheme in underwater acoustic communication. Since DPSK signal can be demodulated if the receiver knows only the phase difference between the adjacent bits, DPSK receiver structure has the advantage of being simplified. In the conventional receiver, two adjacent symbols of transmitted signal before despread are passed to the transition correlator that detects data by comparing maximum correlation outputs. At this time, the error for maximum value of the correlator output may increase because of low SNR (Signal to Noise Ratio) or high Doppler shift frequency according to the underwater channel. In this paper, we propose a method for accurate detection result using the width as well as the magnitude among outputs produced by the correlator. The performances of the proposed method was evaluated by simulation and lake trial data.

• Proceedings of the IEEK Conference
• /
• 2009.05a
• /
• pp.296-298
• /
• 2009

In this paper, we are performance analysis of IEEE 802.15.4b LR-WAPN(Low-Rate Wireless Personal Area Network; Zigbee) system noncoherent receivers at 915MHz under Jamming. IEEE 802.15.4b concerns itself with devices at 915MHz, which employ a higher data rate of up to 250 kbps, and which use O-QPSK(Offset Quradrature Phase Shift Keying modulation with DSSS(Direct Sequence Spread Spectrum). Communication between devices can still be hampered by the presence of interferers outside the network, whether the interference be intentional or not. Hence the receivers can not have stable receiving condition due to worse BER. To solve this problem, we present a mere stabilized receiver system of using noncoherent detection. In this paper, we look instead at the effect of jamming, i.e. intentional interference, on the BER performance of IEEE 802.15.4 devices.

• Proceedings of the KIEE Conference
• /
• 2002.07d
• /
• pp.2637-2639
• /
• 2002

This paper presents the design and implementation of a baseband Modem using DSP that supports a wireless LAN. It is implemented with DSP and D/A and A/D Converters in baseband and tested without using IF and RF modules. In this paper, we have used the matched filler and DLL(delay lock loop) for synchronization. And the matched filter and the carrier recovery are directly connected. Therefore, the proposed architecture is very simple and the operation of DSP becomes fast.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.10C
• /
• pp.995-1006
• /
• 2003

It is well know that in the wireless communication systems the transmitted signals can suffer from multipath fading due to the wave propagation characteristics and the obstacles over the paths, resulting in serious reduction in the power of the received signals. However, it is possible to take advantage of the inherent diversity imposed in the multipath reception if the underlying channel can be properly estimated. One of the diversity reception methods in this case is Rake processing. In this paper we study the Rake receivers for the direct-sequence spread-spectrum communication systems utilizing PN (pseudo noise) sequences to achieve spread spectrum. A conventional Rake receiver can use the finite-duration impulse (FIR) filter followed by the PN sequence demodulator, where the FIR filter coefficients are the reverse-ordered complex conjugate values of the fading channel impulse response estimates. Here, we propose a new Rake processing method by replacing the aforementioned PN code sequence with a new set of optimum demodulator coefficients. More specifically, the concept of the new optimum Rake processing is first introduced and then the optimum demodulator coefficients are theoretically derived. The performance obtained using the new optimum Rake processing is also calculated. The analytical results are verified by computer simulation. As a result, it is shown that the new optimum Rake processing method improves the MSE performance more than 10 dB over the conventional one using the fixed PN sequence demodulator. It is also shown that the new optimum Rake processing method improves the MSE performance about 10 dB over the Adaptive Correlator that performs the combining of the multipath components and PN demodulation concurrently. And finally, the MSE performance of the optimum Rake demodulator is very close to the MSE performance of OPSK demodulator under the AWGN channel.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.36C no.6
• /
• pp.18-26
• /
• 1999

This paper presents the architecture and design of a DSSS MODEM ASIC chip for wireless local area networks (WLAN). The implemented MODEM chip supports the DSSS physical layer specifications of the IEEE 802.11. The chip consits of a transmitter and a receiver which contain a CRC encoder/decoder, a differential encoder/decoder, a frequency offset compensator and a timing recovery circuit. The chip supports various data rates, i.e., 4,2 and 1Mbps and provides both DBPSK and DQPSK for data modulation. We have performed logic synthesis using the $SAMSUNG^{TM}$ $0.6{\mu}m$ gate array library and the implemented chip consists of 53,355 gates. The MODEM chip operates at 44MHz, the package type is 100-pin QFP and the power consumption is 1.2watt at 44MHz. The implemented MODEM architecture shows lower BER compared with the Harris HSP3824.

• Journal of Satellite, Information and Communications
• /
• v.8 no.1
• /
• pp.8-13
• /
• 2013

It is necessary to develop the next generation FTS which is suitable for our environment and effectively operates many launch vehicles. Standard tone, Secure tone, MHA, EFTS and DSSS are studied for the next generation FTS. FTS requires a high quality of performance and reliability because of their specific mission. And few FTSs are needed but the price is very expensive. Therefore we must investigate a part of the FTS whether the part can be reused for a part of the next FTS. In this paper, we use CCDF of the transmitted signal from FTS as the method to study a possibility of reusing HPA used in the present system. The simulation results show that PEP of Standard tone is 0.21dB and Secure tone and MHA has the same PEP. CPFSK's PEP is 1.81dB and PEP of DSSS using BPSK modulation is 2.6dB.

• International Journal of Fuzzy Logic and Intelligent Systems
• /
• v.15 no.1
• /
• pp.53-59
• /
• 2015

This paper proposes a novel method for acoustically and wirelessly transmitting data underwater with a high transmission rate. The method uses the most promising physical layer and multiple access technique (i.e., the code division multiple channel access technique) to divide the channel into subchannels. Data is transmitted through these subchannels. The codes are pseudo-random noise (PN) sequences. In the spread-spectrum technique, a signal such as electrical, electromagnetic, acoustic signal generated in a particular bandwidth is deliberately spread in the frequency domain, which results in a signal with a wider bandwidth. This paper reviews the possibility of application of the direct-sequence code division multiple access (DS-CDMA) technique in an underwater system using MATLAB. As the result of our review, we recognize that the DS-CDMA technique can be applied to underwater environments.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.46 no.2
• /
• pp.182-188
• /
• 2018

In order to increase the robustness of the uplink for UAS(Unmanned Aerial System), we propose a jamming signal rejection algorithm. In the UAS datalink system, DSSS (direct sequence spread spectrum) is used to reduce the radio noise or jamming signal. In general, jamming signals below the spreading gain are recoverable but the signals beyond the spreading gain can not be recovered. In this paper, these jamming signals beyond spreading gain are detected using the threshold detector in the spectrum area then, generate the estimated signals from the sine wave generator. Finally, we obtain the desired signal to remove jamming signals from the received signals. The proposed scheme can eliminate jamming signals while minimizing the hardware complexity and the original signal loss.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.2C
• /
• pp.175-183
• /
• 2006

This letter proposes a Direct Sequence Spread Spectrum (DS-SS)-based Flight Termination System(FTS) and show the simulation results and implements the system using FRGAs. The DS-SS FTS has immunity interference signals and the influence of jamming signal. Moreover, a DS-SS FTS can provides effects on an authentication and encryption with spread codes. And the system uses more less power than an analog FM system. We used Reed-Solomon (32, 28) code and triple Data Encryption Standard(3DES) for error correction and data encryption. Also we used counter algorithm for unauthenticated device's attack The spread codes of In-phase channel and Quadrature channel were generated by Gold sequence generators. The system was implemented in Altera APEX20K100E FPGA for the ground system and EPF10K100ARC240-3 for the airborne system.