• Journal of Power Electronics
• /
• v.12 no.3
• /
• pp.410-417
• /
• 2012

In this paper, a direct current control method based on a one-cycle controller (DCOCC) for double frequency buck converters (DF buck) is proposed. This control method can make the average current through the high frequency and low frequency inductors of a DF buck converter equal. This is similar to the average current control method. However, the design of the loop compensator is much easier when compared with the average current control. Since the average current though the high frequency and low frequency inductors is equivalent, the current stress of the high frequency switches and the switch losses are minimized. Therefore, the efficiency of the DF buck converter is improved. Firstly, the operation principle of DCOCC is described, then the small signal models of a one cycle controller and a DF buck converter are presented based on the state space average method. Eventually, a system block diagram of the DCOCC controlled DF buck is established and the compensator is designed. Finally, simulation and experiment results are given to verify the correction of the theory analysis.

• Proceedings of the KIEE Conference
• /
• 2007.07a
• /
• pp.553-554
• /
• 2007

This paper proposes the method to increase the current direct load control program by inspecting the problems of the DLC program. In order to increase the number of the customers participating DLC program, a raise of the base incentive and the direct load control incentive is suggested based on the interruption cost of electric power considering the characteristics of kinds of load.

• Journal of Power Electronics
• /
• v.18 no.5
• /
• pp.1448-1457
• /
• 2018

Many researchers devote themselves to develop model-predictive direct power control (MPDPC) so as to accelerate the response speed of the grid-connected systems, but they are troubled its large computing amount. On the basis of MPDPC, dual MPDPC (DMPDPC) is presented in this paper. The proposed algorithm divides the conventional MPDPC into two steps. In the first step, the optimal sector is obtained, which contains the optimal switching state in three-level converters. In the second step, the optimal switching state in the selected sector is searched to trace reference active and reactive power and balance neutral point voltage. Simulation and experiment results show that the proposed algorithm not only decreases the computational amount remarkably but also improves the steady-state performance. The dynamic response of the DMPDPC is as fast as that of the MPDPC.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.19 no.6
• /
• pp.494-502
• /
• 2014

This paper presents a control method of the modular multilevel converter - high-voltage direct current (MMC-HVDC) system to regulate grid voltage on the basis of the Jeju Island power system. In this case, the MMC-HVDC system is controlled as a static synchronous compensator (Statcom) to exchange the reactive power with the power grid. The operation of the MMC-HVDC system is verified by using the PSCAD/EMTDC simulation program. The Jeju Island power system is first established on the basis of the parameters and measured data from the real Jeju Island power system. This power system consists of two line-commutated converter - high-voltage direct current (LCC-HVDC) systems, two Statcom systems, wind farms, thermal power plants, transformers, and transmission and distribution lines. The proposed control method is then applied by replacing one LCC-HVDC system with a MMC-HVDC system. Simulation results with and without using the MMC-HVDC system are compared to evaluate the effectiveness of the control method.

• Proceedings of the IEEK Conference
• /
• 2000.06a
• /
• pp.209-212
• /
• 2000

In this paper, effect of imperfect power control on performance of a pseudonoise (PN) code tracking loop is analyzed and simulated for a direct-sequence/code-division multiple access (DS/CDMA) system. The multipath fading channel is modeled as a two-ray Rayleigh fading model. Power control error is modeled as a log-normally distributed random variable. The tracking performance of DLL (delay-locked-loop) is evaluated in terms of tracking jitter and mean-time-to-lose-lock (MTLL). From the simulation results, it is shown that the PN tracking performance is very sensitive to the power control error.

• ETRI Journal
• /
• v.27 no.6
• /
• pp.810-813
• /
• 2005

This letter presents an analytical framework for a performance analysis of the imperfect direct-sequence code division multiple access (DS-CDMA) closed-loop power control (CLPC) loop with loop delay, channel estimation error, and power control command bit error as the parameters under a Rayleigh flat fading environment. The proposed model is verified through a comparison between analytical results and simulation ones.

• Journal of Power Electronics
• /
• v.17 no.4
• /
• pp.860-873
• /
• 2017

The present article reports an analysis and investigation of a direct AC-AC quasi-resonant converter. A bidirectional power device, whose switching frequency is lower than the frequency of the current passing through the load, is used for its realization. The zero voltage switching mode is described when zero voltage on the power device is available by measuring it with the control system. The continuous current in the resonant inductance by switching the power device at zero voltage is considered, and it is characterized by two sub-modes. A mathematical analysis of the processes has been made and comparative results from the computer simulation and experimental study have been brought. The converter can be used in a wide areas of power electronics: induction heating, wireless power transfer, AC-DC converters, etc.

• Proceedings of the KIEE Conference
• /
• summer
• /
• pp.875-877
• /
• 2004

Research related to renewable energy is urgently required to cope with the depletion of fossil fuel and the environmental pollution. This paper deals with maximum power control of 1kW rating wind power generator. To implement direct-drive generator, axial flux permanent magnet generator is adopted to test the converter. The blade is attached to the surface of outer rotor disk. Generally wind power generator is operated under the rated wind speed. To capture maximum power at my given wind speed, the coordination of generator and converter is essential. Buck/Boost converter is designed to charge 24V battery and under the low wind speed it operates as boost converter.

• Journal of the Korean Society for Precision Engineering
• /
• v.26 no.1
• /
• pp.112-119
• /
• 2009

An automatic transmission of construction equipment is controlled by hydraulic and electronic system for doing in various functions like as shifting and operation. The shifting is operated by the engaged and disengaged clutch motion from hydraulic power. On the shifting process, suitable pressure control to the clutch is required for smooth shifting. Hydraulic control system in the automatic transmission is divided by the pilot control type and the direct control type greatly. The direct control type has an advantage than the pilot control type. Because the structure is simple, the design and the manufacture are having less troubles and the system can be maximized precision pressure control. However, the excellent performance proportional control valve should be used to achieve proper control-ability. In this study, the dynamic analysis model composing the automatic transmission and hydraulic system for forklift truck is presented to simulate the characteristics of hydraulic system about the direct control type. That model is verified the validity compared the results of the testing examination. Parameters of input signal are analyzed to reduce the output torque according to input control signal is affected in shifting characteristic.

• Journal of Families and Better Life
• /
• v.25 no.3 s.87
• /
• pp.77-87
• /
• 2007

This study purports to understand the direct and indirect effects between eating disorder behavior of female adolescents and their body-related variables(concerning the degree of diet regime, weight control, body satisfaction, and obesity), self-esteem and internal control, by checking three sub-categorized behavior of eating disorders of diet behavior, bulimia behavior, and eating control behavior. The sample group used for the study consisted of 190 female high school students and 292 female university students; measurement devices used for the study were those of body-related variables, self esteem and internal control, and eating disorder behavior; and data analysis was performed using ${\chi}2$, t-test, Pearson's correlation, regression analysis and path analysis. The results are as follows. First, there is a significant difference between university students and high school students regarding their body satisfaction, weight control experience, and self esteem. University students are more satisfied with their body, have higher self esteem, and control their weight better than high school students. Second, diet behavior shows a correlation with the degree of diet interest, weight control experience, and body satisfaction. Body satisfaction and internal control proved to be correlated with bulimia behavior, while weight control experience, obesity, and self esteem were correlated with eating control behavior. Third, the variables that showed a direct influence on diet behavior as an eating disorder are diet interest, weight control experience, body satisfaction and obesity, in that the explanatory power of the variables is 60.7% with the highest mark on obesity. The variables that showed effects on bulimia are body satisfaction and internal control with an explanatory power of 2.8%. Indirect variables effecting bulimia include objects, diet interest, body satisfaction, and self esteem. The variable with a direct influence on eating control behavior was self esteem with and explanatory power of 4%, whereas the variables of objects, diet interest, body satisfaction, weight control experience, and internal control were all indirectly correlated with eating control behavior.