• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.27 no.4
• /
• pp.238-243
• /
• 2014

This paper dealt with the measurement and analysis of partial discharge (PD) under high voltage direct current (HVDC) in SF6 gas. Electrode systems such as a protrusion on conductor (POC), a protrusion on enclosure (POE), a crack on epoxy plate and a free particle (FP) were fabricated to simulate the insulation defects. The analysis system was designed with a Time-Frequency (T-F) map algorithm programed based on LabVIEW. This can arrange the acquired PD pulses into frequency and time domain. A HVDC power source is composed of a transformer (220 V/50 kV), a diode (100 kV) and a capacitor (50 kV, 0.5 ${\mu}F$). The gap between the electrodes is 3 mm, and the $SF_6$ gas was set at 5 bar. PD pulses were detected by a 50 ${\Omega}$ non-inductive resistor. In the analysis, PD pulses were distributed below 0.5 MHz and 20 ns ~ 35 ns for the POC, 0.7 MHz ~ 1.7 MHz, below 0.6 MHz and 10 ns ~ 40 ns and 60 ns ~125 ns for the POE, below 0.1 MHz and 135 ns ~ 215 ns for the crack, and below 1.6 MHz and 250 ns for the FP.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.16 no.6
• /
• pp.484-489
• /
• 2003

In this paper, a single phase driven piezoelectric motor design was presented for linear motion Two metal/ceramic composite actuators, a piezoelectric ring which was bonded to a metal endcap from one side, were used as the active elements of this motor. The motor was composed of a piezoelectric ceramic, a metal ring which has 4 arms, and a guider. Motors with 30 [mm] and 35 [mm] diameter were studied by finite element analysis and experiments. As results, the maximum speed of motor was obtained at resonance frequency. When the applied voltage of the motor increased, the speed was increased. Also, bidirectional motion of the motor was achieved by combining two motors which have different resonance frequency. But the characteristics of bidirectional motion were not equaled, because of the problem of reproduction on the fabrication and the experiment. If present motor is used at the auto-zoom device of a camera, it will have much advantage. Because the direct linear motion can be achieved with a simple structure of motor and no gearbox of total system.

• The Korean Journal of Community Living Science
• /
• v.28 no.2
• /
• pp.191-201
• /
• 2017

This study compared and analyzed the structures of cooking recipes in order to identify the overall cooking method and develop an efficient method for analyzing cooking recipes. We present procedural texts using a flow graph, which can be referred to as a recipe tree, to represent cooking recipes and the database. A total of 110 kimchi jjigae recipes were identified and classified as 'portion', 'kinds of ingredients', and 'number of cooking deployment'. Recipes for two persons were the most common (43.6%), and 7-13 kinds of ingredients accounted for 50% of kimchi jjigae recipes. Kimchi presented the highest frequency at 78 cases, and pork showed the high frequency at 30 cases. To identify cooking deployment, step 6 was the highest, followed by step 5 (17.3%), step 7 (17.3%), step 4 (11.8%), and step 3 (9.1%). When analyzing the frequency of the relationship between ingredients and action in a recipe expression, Food (F) and Action by the chef (Ac) showed the highest rates at 11.29 and 12.30, respectively, in the cooking process. For frequencies of dependency relation expression in recipes, d-obj (direct object) was the highest at 13.56. The proposed method provides users more efficient and easier access to recipes suitable for their cooking skills.

• Structural Engineering and Mechanics
• /
• v.82 no.4
• /
• pp.477-490
• /
• 2022

This article investigates the nonlinear behavior of two-directional functionally graded materials (TDFGM) doubly curved panels with porosities for the first time. An improved and effectual approach is established based on the improved first-order shear deformation shell theory (IFSDST) and von Karman's type nonlinearity. The IFSDST considers the effects of shear deformation without the need for a shear correction factor. The composition of TDFGM constitutes four different materials, and the modified power-law function is employed to vary the material properties continuously in both thickness and longitudinal directions. A nonlinear finite element method in conjunction with Hamilton's principle is used to obtain the governing equations. Then, the direct iterative method is incorporated to accomplish the numerical results using the frequency-amplitude, nonlinear central deflection relations. Finally, the influence of volume fraction grading indices, porosity distributions, porosity volume, curvature ratio, thickness ratio, and aspect ratio provides a thorough insight into the linear and nonlinear responses of the porous curved panels. Meanwhile, this study emphasizes the influence of the volume fraction gradation profiles in conjunction with the various material and geometrical parameters on the linear frequency, nonlinear frequency, and deflection of the TDFGM porous shells. The numerical analysis reveals that the frequencies and nonlinear deformations can be significantly regulated by changing the volume fraction gradation profiles in a specified direction with an appropriate combination of materials. Hence, TDFGM panels can overcome the drawbacks of the functionally graded materials with a gradation of properties in a single direction.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.4 no.4
• /
• pp.293-299
• /
• 2004

An active RC 2nd order Butterworth filter suitable for a baseband channel-selection filter of a direct conversion receiver is presented. The linearity of the 2nd order Butterworth filter is analyzed. In order to improve the linearity of the filter, the operational amplifiers should have a high linear gain and low 3rd harmonic, and the filter should be designed to have large feedback factor. This second order Butterworth filter achieves-14dBV in-channel (400kHz, 500kHz) IIP3, +29dBV out-channel (10MHz, 20.2MHz) IIP3 and 15.6 $nV/\sqrt{Hz}$ input-referred noise and dissipates 10.8mW from a 2.7-V supply. The analysis and experimental results are in good agreement

• The Korean Journal of Community Living Science
• /
• v.25 no.4
• /
• pp.435-448
• /
• 2014

This study analyzes the differences in school life satisfaction according to middle school students' general characteristics, including their gender, grade, monthly household income, and parents' education level, and examines the effects of intimacy with parents, optimism, and learning motivation on school life satisfaction. Data were collected from 380 middle school students by using a socio-demographic questionnaire. A measurement tool for intimacy with parents, optimism, learning motivation, and school life satisfaction was used, and a frequency analysis, a t-test, a one-way ANOVA, a correlation analysis, and a path analysis were conducted. School life satisfaction showed differences in terms of middle school students grade and, parental education but there were no meaningful differences in terms of their gender and monthly household income. Intimacy with parents and optimism had direct effects on motivation; intimacy with the father and optimism had direct and indirect effects, respectively; and intimacy with the mother had an indirect effect. An increase in the level of intimacy between parents and students and an increase in the positive perception of oneself facilitated learning motivation as well as school life satisfaction.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2000.05a
• /
• pp.205-209
• /
• 2000

Modem wireless communication equipments provides various multimedia and aims at the development of low-power, minimum size and weight, and low-cost implimentations. Because of the heterodyne architecture which was invented many decades ago in the wireless communication system using too many components, it was difficult to make it small, compact and On-Chip so it does not proper for future communication. That gives rise a new developing architecture, so called, Direct Conversion. Because The Direct Conversion down-converts the wireless frequency band to baseband directly, it does not need using additive components and has a merit of reduction in power dissipation. We describes the Direct Conversion architecture and DC-Offset, which must be solved, theorectically and predicts system performance enhancement when adopt the AC-Coupling method.

• Development and Reproduction
• /
• v.18 no.1
• /
• pp.1-11
• /
• 2014

Early growth response 1 (Egr1) is a zinc-finger transcription factor to direct second-wave gene expression leading to cell growth, differentiation and/or apoptosis. While it is well-known that Egr1 controls transcription of an array of targets in various cell types, downstream target gene(s) whose transcription is regulated by Egr1 in the uterus has not been identified yet. Thus, we have tried to identify a list of potential target genes of Egr1 in the uterus by performing multi-step in silico promoter analyses. Analyses of mRNA microarray data provided a cohort of genes (102 genes) which were differentially expressed (DEGs) in the uterus between Egr1(+/+) and Egr1(-/-) mice. In mice, the frequency of putative EGR1 binding sites (EBS) in the promoter of DEGs is significantly higher than that of randomly selected non-DEGs, although it is not correlated with expression levels of DEGs. Furthermore, EBS are considerably enriched within -500 bp of DEG's promoters. Comparative analyses for EBS of DEGs with the promoters of other species provided power to distinguish DEGs with higher probability as EGR1 direct target genes. Eleven EBS in the promoters of 9 genes among analyzed DEGs are conserved between various species including human. In conclusion, this study provides evidence that analyses of mRNA expression profiles followed by two-step in silico analyses could provide a list of putative Egr1 direct target genes in the uterus where any known direct target genes are yet reported for further functional studies.

• Journal of Satellite, Information and Communications
• /
• v.12 no.1
• /
• pp.120-124
• /
• 2017

In this paper, effect of antenna diversity on pseudorandom noise (PN) code acquisition performance is analyzed and simulated for a direct sequence/code division multiple access (DS/CDMA) overlay system where a CDMA user and a narrowband user coexist in the same frequency band. From the simulation results, it is shown that the antenna diversity is very effective in improving the PN acquisition performance. The results of this paper can be applied to design of synchronization scheme for a DS/CDMA overlay environment.

• 한국정보통신설비학회:학술대회논문집
• /
• 2009.08a
• /
• pp.305-308
• /
• 2009

This paper presents the design and analysis of RF Front End for Wireless Heartbeat measurement System. In this work LNA, an inductor connected at the gate of the cascode transistor and capacitive cross-coupling are strategically combined to reduce the noise and the nonlinearity influences of the cascode transistors in a differential LNA. The Mixer is implemented by using the Gilbert-type configuration, cross pmos injection technique and the resonating technique for the tail capacitance. The resulting LNA achieves 1.26 dB NF, better than 1.88dB NF Typical Also Mixer resulting achieves 9.8dB at 100KHz.