• KIEE International Transaction on Electrical Machinery and Energy Conversion Systems
• /
• v.5B no.4
• /
• pp.337-342
• /
• 2005

Direct torque control (DTC) was originally developed for induction machine drives, and, more recently has been applied to permanent magnet brushless AC (BLAC) drives. In this paper, the performance of DTC controlled brushless DC (BLDC) drives is compared with that of PWM current controlled BLDC drives, both with and without current shaping. Both simulation and experimental results are presented, as well as the analysis of the resulting torque waveforms. It is shown that, in addition to exhibiting a fast torque response, a DTC controlled BLDC drive has a significantly lower low-frequency torque ripple than the PWM current controlled BLDC drive without current shaping, and that it is easier to implement than PWM current control with current shaping.

• Journal of Power Electronics
• /
• v.11 no.5
• /
• pp.704-712
• /
• 2011

This paper describes a hybrid induction motor drive system incorporating DTC-hysteresis and Direct Self Control (DSC) schemes to achieve excellent dynamic performance. The control scheme is switched from a circular to a hexagonal flux locus whenever a dynamic condition is encountered. On the other hand, when the motor operates under steady state conditions, a circular flux locus is used. Without major modifications to the simple structure of a basic DTC, hexagonal flux locus operation is established by modifying the flux error status, before it is fed to the look-up table. The feasibility of the proposed hybrid scheme to achieve excellent control performance is verified by experimental results.

• Journal of Ceramic Processing Research
• /
• v.19 no.6
• /
• pp.514-518
• /
• 2018

The direct carbon fuel cell (DCFC) has attracted researcher's attention recently, due to its high conversion efficiency and its abundant fuel, carbon. A DCFC mathematical model has developed in two-dimensional, lab-scale, and considers Boudouard reaction and carbon monoxide (CO) oxidation. The model simulates the CO production by Boudouard reaction and additional electron production by CO oxidation. The Boudouard equilibrium strongly depends on operating temperature and affects the amount of produced CO and consequentially affects the overall fuel cell performance. Two different operating temperatures (973 K, 1023 K) has been calculated to discover the CO production by Boudouard reaction and overall fuel cell performance. Moreover, anode thickness of the cell has been considered to find out the influence of the Boudouard reaction zone in fuel cell performance. It was found that in high temperature operating DCFC modeling, the Boudouard reaction cannot be neglected and has a vital role in the overall fuel cell performance.

• Korean Circulation Journal
• /
• v.52 no.9
• /
• pp.643-658
• /
• 2022

Cell-based therapy has emerged as a promising option for treating advanced ischemic cardiovascular disease by inducing vascular regeneration. However, clinical trials with adult cells turned out disappointing in general. As a newer approach, direct reprogramming has emerged to efficiently generate endothelial cells (ECs), which can promote neovascularization and vascular regeneration. This review provides recent updates on the direct endothelial reprogramming. In general, directly reprogrammed ECs can be generated by two approaches: one by transitioning through a plastic intermediate state and the other in a one-step transition without any intermediate states toward pluripotency. Moreover, the methods to deliver reprogramming factors and chemicals for the fate conversion are highlighted. Next, the therapeutic effects of the directly reprogrammed ECs on animal models are reviewed in detail. Other applications using directly reprogrammed ECs, such as tissue engineering and disease modeling, are also discussed. Lastly, the remaining questions and foremost challenges are addressed.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.11a
• /
• pp.440-443
• /
• 2002

Present1y the X-Ray diagnosis system is a real condition that is changing by digital ways in it's existent analog ways. This digital radiation detector is divided by the direct method and the indirect method. The indirect method of applied voltage has special qualities that the resolution is low than direct method by diffusion effect that happens. The conversion process ( radiation${\rightarrow}$visible ray${\rightarrow}$electrical signal of two times, has shortcomings that the energy conversion efficiency of electrical signal is low. The direct method has shortcomings that need strong electric fie1d to detect electrical signal efficiently. This research achieved to develop digital detector of the Hybrid method that have form that mixes two ways to supplement shortcoming of direct. indirect method. A studied electrical characteristic by Iodine's Mixture ratio change is added to selenium in the detector which has a multi-layer structure (Oxybromide + a-Se). There are 8 kinds of Manufactured compositions to amorphous selenium Iodine each 30ppm, 100ppm, 200 ppm, 300ppm, 400ppm, 500ppm, 600ppm, 700ppm by a doped photoconductor through a vacuum thermal evaporation method. The phosphor layer is consisted of Oxybromide ($BrO_2$) which uses optical adhesives multi-layer structure. The manufactured compositions calculates and compares Net Charge and signal to noise ratio measuring Photocurrent about Darkcurrent and X-ray. When doped Iodine Mixture ratio is 500ppm to the multi-layer structure (Oxybromide + a-Se), applied voltage of $3V/{\mu}m$, leakage current of compositions $2.61nA/cm^2$ and net charge value by 764pC/$cm^2$/mR then the best result appeared.

• Journal of IKEEE
• /
• v.3 no.1 s.4
• /
• pp.69-78
• /
• 1999

In this paper, direct conversion receiver was designed to even harmonic anti-paralled diode pair ring mixer. Using a second harmonic component of LO instead of LO signal and RF signal are mixed by SHP(Sub Harmonic Pumped) mixer with anti-parallel diode pair. Canceling the harmonics of LO signal in ring mixer, SHP mixer using anti-parallel diode pair could mostly reduce the radiation of LO signal through a input port the most, good isolation characteristic, and low spurious characteristic by LO signal was shown over broad band. The produced SHP mixer showed LO/IF, RF/IF and LO/RF isolation was 24.6dB,36.2dB and 22.5dB respectively. And conversion loss was measured 15.6dB, IF output -35.6dBm with -20dBm RF input and 5.5dBm LO signal. 1dB compression point of If signal, in respect to RF signal, was found at the 0dbm RF signal.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.7 s.98
• /
• pp.681-689
• /
• 2005

This paper presents an ultra wide band(UWB) mixer using anti-parallel diode pair(APDP) with simulation and measurement results. The proposed mixer adopts the even-harmonic direct conversion mixing, which consists of a couple of filter, in-phase wilkinson power divider, wideband $45^{\circ}$ power divider, and APDP. The m mixer is operating over 3.1 to 4.8 GHz and producing quadrature(I/Q) outputs with a conversion loss of 18 dB and input third order intercept point($IIP_3$) of 15 dBm. I/Q outputs also have difference of about 0.5 dB and phase difference of ${\times}3^{\circ}$ and $P_{1dB}$ of 2 dBm.

• The Korean Journal of Food And Nutrition
• /
• v.27 no.4
• /
• pp.725-731
• /
• 2014

This study aims to find the correlation the low-molecule fucoidan for cancer prevention with an accelerated formation of cotinine. In the presence of fucoidan, a nicotine to cotinine coversion was studied in established assay, direct mixture method and Hep-G2 cell line method. Fucoidan of $1{\mu}g/mL$ showed the potential effect for converting nicotine to cotinine in the direct mixture method compared to control. Increase of conversion rate at the treatment of fucoidan is exhibited as 15 times compared to control. In Hep-G2 cell treatment, fucoidan showed the potential activity for converting nicotine to cotinine as 6 times compared to control. Therefore, fucoidan was shown to be effective in the conversion of nicotine into cotinine even though it is not higher content of polyphenol and flavonoid than its of green tea extract.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.4
• /
• pp.542-551
• /
• 1998

In this study, a method of error compensation for channel gain imbalance, phase imbalance and local oscillator leakage in the modulator of frequency direct conversion is suggested. The compensation of channel imbalance can be carried out by using the received power after transmitting test signal. By applying this method, the phase imbalance conversion with frequency can be easily compensated since this method is rarely affected by the transmission channel. It is confirmed that the algorithm proposed in this study(iteration coefficient=11) converges faster than conventional algorithm(iteration coefficient=43). From the numerical results, the DC-offset, channel gain, phase imbalance compensation coefficient and iteration number converges into($f_1$=0.0199999, $f_2$=-0.050001, $C_{22}$=0.9133, $C_{12}$=-0.0524, N=13) when the local oscillator leakage is not considered. However, it converges into($f_1$=-0.02, $f_2$=-2.2476, $C_{22}$=0.9133, $C_{12}$=-0.0524, N=16) when the local oscillator leakage is considered.

• Korean Journal of Soil Science and Fertilizer
• /
• v.48 no.6
• /
• pp.697-704
• /
• 2015

This study was carried out to assess bioenergy conversion efficiency by biogas and solid fuel production in the cattle feedlot manure discharged from beef cattle barn. Feedlot manure was sampled from the cattle farmhouse located in Yong-in, Gyeonggi during the mid-fattening stage, periodically. The chemical characteristics, BMP (Biochemical methane potential) and HV (Heating values) of feedlot cattle manures were analyzed. Total solid contents of cattle feedlot manure were in the range of 29.98~44.28%, and volatile solid contents were in the range of 23.53~24.47%. In the anaerobic digestion of cattle feedlot manure, the methane production potential has increased from 0.141 to $0.187Nm^3kg^{-1}-VS_{added}$. The methane production of fresh cattle feedlot manure showed the range $0.141{\sim}0.187Nm^3kg^{-1}$-Manure (average $0.047Nm^3kg^{-1}$-Manure), the LHVs (lower heating values) of the produced methane were in the range of $316{\sim}560kcalkg^{-1}$-Manure (average $400kcalkg^{-1}$-Manure). In the direct combustion of fresh cattle feedlot manure, the LHVs were measured in the range of $747{\sim}1,271kcalkg^{-1}$-Manure (average $916kcalkg^{-1}$-Manure), and LHVs of solid fuel which have the water content of 20% were in the range of $2,694{\sim}2,876kcalkg^{-1}$-Manure (average $2,791kcalkg^{-1}$-Manure). Then, the drying energy of average $443kcalkg^{-1}$-Manure was consumed in the production of solid fuel which has a water content of 20%. Therefore, the direct combustion of cattle feedlot manure showed about 2.3 times higher LHV than the LHV of methane produced by anaerobic digestion. And LHV of solid fuel was about 6.0 times higher than the LHV of methane produced by anaerobic digestion. Then, the production of solid fuel presented more bioenergy conversion efficiency than the biogas production in the bioenergy use of cattle feedlot manure.