• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2003.05a
• /
• pp.89-89
• /
• 2003

• Proceedings of the KIEE Conference
• /
• 1992.07b
• /
• pp.860-863
• /
• 1992

In this paper, we investigate $\pi$-A isotherms of biological lipid layer such as cholesterol and phosphatidyl choline to study a gas sensor characteristics which response only to specific materials. And, we also deposit it on the surface of quartz crystal by vertical dipping method and horizontal lifting method. Then, we evaluate the deposition status of cholesterol and phosphatidyl choline LB film using AT-cut quartz crystal. We obtain the following results: (1) Cholesterol's solid surface pressure is about 20$\sim$40(dyne/cm) and limiting area is about 50${\AA}^2$/molecule. And, phosphatidyl choline's surface pressure is about 25$\sim$40(dyne/cm) and limiting area is about 20 ${\AA}^2$/molecule. (2) When LB films are deposited, the deposition ratio is coincident with the frequency shift. Therefore, we can evaluate the deposition status of LB film. (3) For cholesterol, Y type LB films are deposited up to 15 layers by vertical dipping method. (4) For phosphatidyl choline, X typo LB films are deposited to 15 layers by horizontal lifting method. But, in case of vertical dipping method, the deposition status is not good.

• Tribology and Lubricants
• /
• v.24 no.2
• /
• pp.63-71
• /
• 2008

Friction and adhesion tests were conducted to investigate tribological characteristics of materials for MEMS/NEMS using atomic force microscope (AFM). AFM Si tips were chemically modified with a self-assembled monolayer (SAM) derived from trichlorosilane like octadecyltrichlorosilane (OTS) and (1H, 1H, 2H, 2H-perfluorooctyl) trichlorosilane (FOTS), and various materials, such as Si, Al, Au, Cu, Ti and PMMA films, were prepared for the tests. SAMs were coated on Si wafer by dipping method prior to AFM tip to determine a proper dipping time. The proper dipping time was determined from the measurements of contact angle, surface energy and thickness of the SAMs. AFM tips were then coated with SAMs by using the same coating condition. Friction and adhesion forces between the AFM Si tip modified with SAM and MEMS/NEMS materials were measured. These forces were compared to those when AFM tip was uncoated. According to the results, after coating OTS and FOTS, the friction and adhesion forces on all materials used in the tests decreased; however, the effect of SAM on the reduction of friction and adhesion forces could be changed according to counterpart materials. OTS was the most effective to reduce the friction and adhesion forces when counterpart material was Cu film. In case of FOTS, friction and adhesion forces decreased the most effectively on Au films.

• The Plant Pathology Journal
• /
• v.23 no.4
• /
• pp.239-244
• /
• 2007

MicroTom is a miniature tomato plants with various properties that make it as a model system for experiments in plant molecular biology. To extend its utility as a model plant to study a plant - bacterial wilt system, we investigated the potential of the MicroTom as a host plant of bacterial wilt caused by Ralstonia solanacearum. We compared the disease progress on standard tomato and MicroTom by two inoculation methods, root dipping and soil drenching, using a race 1 strain GMI1000. Both methods caused the severe wilting on MicroTom comparable to commercial tomato plant, although initial disease development was faster in root dipping. From the diseased MicroTom plants, the same bacteria were successfully reisolated using semiselective media to fulfill Koch's postulates. Race specific and isolate specific virulence were investigated by root dipping with 10 isolates of R. solanacearum isolated from tomato and potato plants. All of the tested isolates caused the typical wilt symptom on MicroTom. Disease severities by isolates of race 3 was below 50 % until 15 days after inoculation, while those by isolates of race 1 reached over 50% to death until 15 days. This result suggested that MicroTom can be a model host plant to study R. solanacearum - plant interaction.

• Applied Chemistry for Engineering
• /
• v.7 no.4
• /
• pp.691-697
• /
• 1996

The NR films were prepared with mixing of natural rubber latex(NRL) with various additives, and NR/CR films were prepared by blend ratio of chloroprene rubber latex(CRL). The swelling degree and the mechanical properties of these films were measured according to the procure time. As a result, optimum condition were showed the swelling degree : 80~85%, precure time : 48~60hrs., and tensile strength was reduced but elongation was increased as increasing the blend ratio of CRL. On the mechanical properties of films prepared by different dipping process in these optimum condition, the tensile strength and tear strength of NR/CR films by one dipping process are better than NR-d-CR films by two dipping process. The surface of these films were observed with scanning electron microscopy(SEM). It was found that phase separation was occured as increasing the blend ratio of CRL.

• Korean journal of applied entomology
• /
• v.36 no.1
• /
• pp.105-110
• /
• 1997

Mixture study of bifenthrin and prothiofos was conducted to control insecticide resistant diamondback moth (DBM), Plutella xylostella, which had shown 581, 18, 19, 11 fold resistance to fenvalerate, cypermethrin, furathiocarb, and prothiofos in Chinju strain, respectively and 38 and 9 fold resistance to fenvalerate and furathiocarb in Seosang strain, respectively. Optimal mixture ratios of bifenthrin and prothiofos was selected against Seosang strain of DBM by leaf dipping method in laboratory and by field test. Maximum co-toxicity coefficient by dipping method was shown at a ratio of 1:50 mixture of bifenthrin 1EC and prothiofos 50EC in active ingredient(a.i.) by 243.2 and then suddenly decreased. The mixed formulation from the dipping test was examined at the cabbage field of Seosang, Hamyang. Although insecticides were reduced to half, control efficacy was similar to farmer's conventional method. In addition, the mixture combination was also more effective against Chinju DBM population which had very high level of resistance to several representative insecticides. Mixture methods of insecticides will be effective countermeasures to the resistance problem of pests.

• Korean Journal of Plant Resources
• /
• v.15 no.1
• /
• pp.43-49
• /
• 2002

Effects of BA treatment and cut planting methods on shooting and seedling characteristics were investigated to increase seedling products by cuttings of lacquer tree. Dipping on 1,000mg/L BA solution was better than dripping with same solution at 5 weeks after cut planting. As shooting rate was increased suddenly, it was 85％ at 10 weeks after cut planting. Among 3 dripping treatments, interval was not effective on shooting rate. Dripping per 2 days with 100 ㎕ of 1,000 mg/L BA solution was most effective on seedling height and leaf number and than dipping was more effective than dripping per 5 and 7 days. Branch developed on near part from dripped scion. Shooting of horizontal planting was earlier about a week and rate was increased suddenly from 3 to 6 weeks, it was highest with 96％ than others at 10 weeks after planting. Seedling of horizontal cut planting was tallest about 40cm and branch developed lower than vertical and oblique cut planting. In case of horizontal cut planting, 2-3 shoots were formed on different part of scion and than those were could divided to seedling, so horizontal cut planting was most effective to propagation of seedling than any others.

• Journal of the Korea Society for Simulation
• /
• v.20 no.2
• /
• pp.59-66
• /
• 2011

In this paper, a method to allocate a submarine search mission to an ASW(Anti-Submarine Warfare) helicopter is proposed. The aim of the proposed method is to increase the submarine detection capability. For this purpose, we modeled the behaviors that the ASW helicopter conduct during the search mission, and the relations between the behaviors are also modeled. To measure quantitatively the effectiveness of ASW search mission, the measure of effectiveness(MOP) is defined. Scenarios are designed to analyze the effectiveness utilizing the ASW mission model. We conducted simulations applying the designed scenarios and some parameters concerned with the friendly ship and the enemy submarine interacting each other in the ASW missions. We analyzed the result of simulation depending on the dipping interval and the pattern of dipping positions in the situation that the helicopter operates for a long time and should resupply several times on the friendly ship. From the analyzed data, we suggested the practical value of ratio between the detectable range of the sonar and the dipping interval to improve the effectiveness of ASW mission.

• Korean journal of applied entomology
• /
• v.31 no.2
• /
• pp.182-189
• /
• 1992

The influnces of 9 kinds of solvents on the toxicities against several insect species, phytotoxicity and solubility of compounds were evaluated by means of leaf dipping and spray methods. In case of the spray application, density and vapor pressure seemed to be a contributing factor to lethal toxicity against brown planthopper and diamond-back moth, respectively; the bigger the property of density and the smaller the vapor pressure gave the stronger toxicity. It appeared that the toxicity of solvents was not correlated with anyone of physical properties such as boiling point, dipole moment, dielectric constant, surface tension and viscosity. Spray treatment gave more toxicity to insects than leaf dipping treatment. Although dielectric constant and dipole moment seemed to be contributing factors to phytotoxic damage to rice seedling and bean plants, respectively, no general correlation between phytoxicity and the other physical properties was found. Leaf dipping application caused stronger phytotoxicity than spray application. It is concluded that 5% acetone solution may be most suitable to test chemicals because of its favorable solubility of compounds, lower toxicity to insects, and lower phytotoxicity.

• Food Science and Preservation
• /
• v.13 no.1
• /
• pp.13-17
• /
• 2006

The strawberry was dipped into $1\%\;CaCl_2$ solution at $20^{\circ}C\;and\;45^{\circ}C$ for 15min. respectively, and then packaged with or without PE film (thickness: 0.011mm) before putting into the cold storage at $5^{\circ}C$. The results showed the lowest rate of rot incidence and the highest firmness with higher Vitamin C content and the best superficial appearance in the treatment of $CaCl_2$ dipping at $45^{\circ}C$ with packaging. It also showed lower pH and higher titratable acidity in the treatment However, no significant difference of SSC was found among various treatments. The results suggested that the combination of postharvest calcium dipping and packaging could result in more effective preservation for strawberry compared with the individual treatment.