• Corrosion Science and Technology
• /
• v.23 no.2
• /
• pp.113-120
• /
• 2024

An attempt was made to apply digital image correlation (DIC) strain analysis to in-situ scanning electron microscopy (SEM) observations of bending deformation to quantify local strain distribution inside a ZnMgAl-alloy coating in deformation. Interstitial-free steel sheets were hot-dipped in a Zn-3Mg-6Al (mass%) alloy melt at 400 ℃ for 2 s. The specimens were deformed using a miniature-sized 4-point bending test machine inside the SEM chamber. The observed in situ SEM images were used for DIC strain analysis. The hot-dip ZnMgAl-alloy coating exhibited a solidification microstructure composed of a three-phase eutectic of fine Al (fcc), Zn (hcp), and Zn2Mg phases surrounding the primary solidified Al phases. The relatively coarsened Zn₂Mg phases were locally observed inside the ZnMgAl-alloy coating. The DIC strain analysis revealed that the strain was localized in the primary solidified Al phases and fine eutectic microstructure around the Zn₂Mg phase. The results indicated high deformability of the multi-phase microstructure of the ZnMgAl-alloy coating.

• The Journal of Engineering Geology
• /
• v.19 no.4
• /
• pp.517-528
• /
• 2009

Statistical analyses of cut-slope stability were performed over approximately 5.7 km section along the National road No. 25, which cross-cuts in NW-SE direction the Cheongwon and Boeun-Gun area, Chungbuk. A measure of slope-stability was established by using direct reinforcement and indirect protection methods in whole section. Orientations(dip/dip direction) of the slopes, foliations(bedding), cleavages and joints were measured in total of 30 slope sites. The results analyzed using stereographic projection indicate that major directions of the slopes come out predominantly in three directions: 1) $58^{\circ}/095^{\circ}$, 2) $60^{\circ}/296^{\circ}$ and 3) $59^{\circ}/212^{\circ}$. In analyses of dip direction and frequency of cut-slopes established by reinforcement and protection methods, slopes with dip direction of $80-120^{\circ}$ and $280-320^{\circ}$ mostly occur. However, slopes with dip direction of $0-80^{\circ}$(N and NW) and $120-160^{\circ}$(SE) are not distributed in the study area. Failure aspects were analyzed for three major directions of the slopes, respectively. The results of failure aspects analyzed indicate that slopes in the study area could generate various failures as the results of intersection and/or intersection combination among joints, foliations(bedding) and cleavages. However, possibility of failure in a slope of major direction No. 3 is statistically very low because of low frequency in total number of slopes with the direction and of formation of small scale-slopes geographically, although the slope might generate all aspects of failure-modes.

• Archives of Plastic Surgery
• /
• v.36 no.3
• /
• pp.318-321
• /
• 2009

Purpose: The bony mallet finger injury is generally managed by conservative treatments, but operative treatments are needed especially when the fractures involve above 30% of articular surface or distal phalanx is accompanied by subluxation in the volar side. This is the reason they often result in chronic instability, articular subluxation and unsatisfactory cosmetic. In this report, We describe new method using the hook plate as an operative treatment of Mallet finger deformity. Methods: Among 13 patients with Mallet finger deformity who came from February 2006 to February 2008, six patient were included in surgical indication. Under local anesthesia, H or Y type incision was made at the DIP joint area. After the DIP joint extension, the hook plate was put on the fracture line, and one self tapping screw was used for fixation. 2 hole plate which was one of the holes in 1.5 mm diameter was cut in almost half and bended through approximately $100^{\circ}$. Results: In all six cases which applied the hook plate, complications such as loss of reduction or nail deformity were not seen. In only one patient, hook pate was removed due to inflammatory reaction after surgery. At 2 weeks after operation, active motion of DIP joint was performed. The result was satisfactory not only cosmetically but also functionally. At 6 weeks after operation, the range of motion of DIP joint was average $64^{\circ}$. Conclusion: The purpose of the operative treatment for mallet finger deformity using the hook plate is to provide anatomical reduction with rigid fixation and to prevent contracture at the DIP joint. While other operations take 6 weeks, the operation using the hook plate begins an active motion at 2 weeks after operation. Complication rate was low and the method is rather simple. Thus, the operation using the hook plate is recommended as a good alternative method of the mallet finger deformity treatment.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.11 no.2 s.23
• /
• pp.97-102
• /
• 2005

Seasonal and year-to-year variations of water quality were observed at six stations in Mokpo Harbor area between 1997 and 2004. Water quality(salinity, pH, DIN and DIP) was variable between years. Salinity was significantly low in 1998, while nutrient concentrations were significantly higher in 1998 than other years. Water temperature, salinity, DO, COD and DIP concentrations exhibited clear seasonal variations, and these seasonal trends reflected seasonal changes in fresh water discharge from Youngsan river mouth. Water temperature, COD and DIP were significantly higher in August, while salinity and DO reached minimum values in August. In the station 1(Youngsan river mouth), waters with low salinity are subject to high nutrient inputs from Youngsan river, while in the station 6 (outside from Mokpo harbor) waters are primarily oceanic Relationship between water quality parameters indicates that salinity is the primary factor influencing the COD, DO, pH, Chlorophyll a and nutrient concentrations in Mokpo harbor area.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.22 no.1
• /
• pp.42-51
• /
• 2016

We investigated the distribution of dissolved nutrients, phytoplankton community structure and utilization of nitrogen compounds by dominant species in the southwestern part of East Sea in September, 2014. Dissolved inorganic nitrogen (DIN) and dissolved inorganic phosphorus (DIP) were lower in the surface layer, and concentrations were increased with depth. Dissolved organic nitrogen (DON) and dissolved organic phosphorus were the opposite of dissolved inorganic nutrients. Although DIN DIP ratio in all of the water masses was higher than Redfield ratio (16), DIN : DIP ratio in mixed layer was about 2, indicating that inorganic nitrogen is the limiting factor for the growth of phytoplankton. In particular, DON proportion in dissolved total nitrogen was about 88 % in the mixed layer where inorganic nitrogen is limiting factor. The dominant species Chaeotceros debilis and Prorocentrum minimum were able to grow using DIN as well as DON such as urea and amino acids. Therefore, DON utilization of phytoplankton may play a role as a survival strategy in the DIN-limited conditions of East Sea.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.22 no.1
• /
• pp.1-10
• /
• 2016

In this paper, an analysis of the inflowing pollution load of the rivers in Hampyeong bay showed the average organic matter pollution loads of BOD, COD, and TOC to be 79.7 kg-BOD/day, 144.06 kg-COD/day, and 93.0 kg-TOC/day, respectively. The inflowing organic matter pollution load was the heaviest in Sonbul dike, followed by Jupo bridge and Yangman complex. With regard to season, the load characteristics were outstanding in July, the rainy period in the summer. The average inflowing pollution loads of nutrients were 20.9 kg-DIN/day, 17.1 kg-DIP/day, 148 kg-TN/day, and 37.4 kg-TP/day A comparison of the inflowing nutrients loads for each river showed the load to be the heaviest in Yangman complex, followed by Baegok bridge and Jupo bridge. In the experiment on the material budgets of Hampyeong bridge conducted using a box model, the detention time of fresh water was found to be 52.4 days, with the bay displaying the characteristics of a so dissolved inorganic nitrogen (DIN) in the nutrients material budgets, ${\Delta}DIN$ values were found to be negative, indicating the tendency of consumption and open sea leak by photosynthesis to be higher than the nitrogen that flowed in. As for dissolved inorganic phosphorus (DIP), ${\Delta}DIP$ showed positive values, indicating a tendency for accumulation as the supply through organic matter decomposition, elution load of sediments, and inflowing load of the river turned out to be higher than the consumption by phytoplankton and outflow to open sea.

• The Journal of Engineering Geology
• /
• v.26 no.3
• /
• pp.393-401
• /
• 2016

In the present study, fault attitudes and the locations of appearance of faults in tunnel faces were predicted by analyzing the trajectory of the maximum longitudinal displacement immediately before the appearance of faults through three-dimensional finite element analysis. A total of 28 fault attitude models were used in the analysis. Those faults that have drives with dip appear first in the upper part of tunnel faces as tunnel excavation progresses and their maximum longitudinal displacement shows a tendency to move from the middle part to the upper part of tunnel faces. Those faults that have drives against dip appear first in the lower part of tunnel faces as tunnel excavation progresses and their maximum longitudinal displacement shows a tendency to move from the middle part or middle upper part to the lower part of tunnel faces. In addition, when the dip of faults is larger the maximum longitudinal displacement moves from the left upper part toward the wall part in the case of drive with dip models and from the left lower part toward the wall part in the case of drives against dip models. Therefore, it was indicated that the attitudes of faults distributed ahead of tunnel faces and the locations where faults appear in tunnel faces can be predicted by analyzing the longitudinal displacement trajectory of tunnel faces following excavation.

• Journal of the Korea Concrete Institute
• /
• v.24 no.5
• /
• pp.613-621
• /
• 2012

Steel corrosion is one of the most critical deteriorations in concrete structures due to the problems associated with both durability and structural safety issues. For protection of steel against corrosion problems, researches to improve concrete durability and steel corrosion protection such as rebar coating by hot-dip galvanizing steel have been carried out. This study was performed to quantitatively evaluate anti-corrosion and structural performance of concrete structures reinforced with hot-dip galvanizing steel rebar. Preliminary tests for several metal coatings such as zinc, aluminum, and their alloy (Zn 45% + AL 55%) were performed. After evaluation of corrosive characteristics, Zn was selected for the coating material and the corrosion behaviors in Zn-coated steel were evaluated in various conditions. Furthermore, tensile and adhesive strengths were evaluated for the normal and the hot-dip galvanized steel. The crack patterns and structural behaviors of RC specimens with the normal and coated steel were investigated. Also, corrosion characteristics including corrosion in various coating metal and potential change in metal with notch were evaluated. Structural performances of tensile and adhesive strengths as well as RC beam behavior under flexural/shear loading were evaluated. The test and evaluation results showed that the applicability of hot-dip galvanized steel rebar can be used as corrosion resistant reinforcements for RC structures.

• Journal of radiological science and technology
• /
• v.34 no.1
• /
• pp.59-64
• /
• 2011

We investigated the radiation exposure caused by DIPS, which is used to identify accurate repositioning and tumor location in pediatric cancer patients proton therapy. To compare and analyze DIPS condition, 50 pediatric cancer patients who underwent proton therapy were selected in Ilsan K cancer-specialized hospital from March 2007 to October 2009. For DIP exposure, 0.09~1.57 mGy is measured in AP and lateral directions and 23.55 mGy is measured in CSI patients. In whole brain patient, the amount of a day DIP exposure dose was 1.13 mGy. During treatment period, who exposed the biggest DIP dose are whole brain patients, 632.71 mGy is exposed. It is 1.13% of prescribed dose, represented dose is adequate because it is not exceeded 2% of recommended dose. Even though the exposed dose is not exceeded more than 2% of prescribed in DIP exposure, we should recognize the radiation damage and genetic influences to pediatric cancer patients, who is much sensitive to radiation and has longer mean residual life time. Therefore, DIPS guideline for pediatric cancer patients should be indicated to minimize the radiation exposure.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.17 no.2
• /
• pp.90-103
• /
• 2014

Distribution characteristics of water masses, dissolved inorganic and organic nutrients were investigated in the southern part of the East Sea of Korea in September, 2011. On the basis of the vertical profiles of temperature, salinity and dissolved oxygen, water masses in the study area were divided into 4 major groups, such as WM (water mass)-I, WM-II, WM-III, WM-IV. Their characteristics were similar to Tsushima Surface Water (TSW), Tsushima Middle Water (TMW), North Korea Cold Water (NKCW) and East Sea Proper Water (ESPW), respectively. In the vertical profiles of dissolved nutrients, dissolved inorganic nitrogen (DIN) and dissolved inorganic phosphorus (DIP) concentrations were highest in the WM-IV, followed by WM-III, WM-II, WM-I. On the contrary, distribution of dissolved organic nitrogen (DON) and dissolved organic phosphorus (DOP) were highest in the WM-I, followed by WM-II, WM-III, WM-IV. Although the DIN : DIP ratio in all of the water masses was similar to Redfield ratio(16), the DIN : DIP ratio in mixed layer was about 5.3, indicating that inorganic nitrogen is the limiting factor for the growth of phytoplankton. However, the DON proportion in dissolved total nitrogen (DTN) was about 70% in the mixed layer where inorganic nitrogen is limiting factor. Thus, enriched DON may play an important source of the nutrient for the growth of phytoplankon in the East Sea.