Statistical Study of Failure-Modes around the Pibanryeong Region, Boeun-Gun, Chungbuk

충북 보은군 피반령 부근 절취사면의 파괴양상에 대한 통계학적 연구

  • Cheong, Sang-Won (Department of Earth Science Education, Chungbuk National University) ;
  • Choi, Byoung-Ryol (Department of Earth Science Education, Chungbuk National University)
  • 정상원 (충북대학교 사범대학 지구과학교육학과) ;
  • 최병렬 (충북대학교 사범대학 지구과학교육학과)
  • Published : 2009.12.31

Abstract

Statistical analyses of cut-slope stability were performed over approximately 5.7 km section along the National road No. 25, which cross-cuts in NW-SE direction the Cheongwon and Boeun-Gun area, Chungbuk. A measure of slope-stability was established by using direct reinforcement and indirect protection methods in whole section. Orientations(dip/dip direction) of the slopes, foliations(bedding), cleavages and joints were measured in total of 30 slope sites. The results analyzed using stereographic projection indicate that major directions of the slopes come out predominantly in three directions: 1) $58^{\circ}/095^{\circ}$, 2) $60^{\circ}/296^{\circ}$ and 3) $59^{\circ}/212^{\circ}$. In analyses of dip direction and frequency of cut-slopes established by reinforcement and protection methods, slopes with dip direction of $80-120^{\circ}$ and $280-320^{\circ}$ mostly occur. However, slopes with dip direction of $0-80^{\circ}$(N and NW) and $120-160^{\circ}$(SE) are not distributed in the study area. Failure aspects were analyzed for three major directions of the slopes, respectively. The results of failure aspects analyzed indicate that slopes in the study area could generate various failures as the results of intersection and/or intersection combination among joints, foliations(bedding) and cleavages. However, possibility of failure in a slope of major direction No. 3 is statistically very low because of low frequency in total number of slopes with the direction and of formation of small scale-slopes geographically, although the slope might generate all aspects of failure-modes.

충북 청원군과 보은군에 북서-남동 방향으로 관통하는 국도 25번 도로를 따라 약 5.7 km에 걸친 절취 사면의 안정성에 대한 통계학적 분석을 수행하였다. 이 구간은 전 사면에 걸쳐 직접적인 보강 방법과 간접적인 보호 대책을 사용하여 사면의 안정화 대책이 수립되었다. 총 30개소의 사면에서 사면의 방향성, 엽리와 층리, 벽개 및 절리구조의 방향성을 측정하였다. 스테레오 투영을 이용하여 분석한 결과 사면의 주방향성(경사/경사방향)은 1) $58^{\circ}/095^{\circ}$, 2) $60^{\circ}/296^{\circ}$ 및 3) $59^{\circ}/212^{\circ}$으로 3방향성이 우세하게 나타났다. 보강과 보호 대책이 수행된 사면의 빈도수와 사면의 경사방향의 분석에서 사면은 경사방향 $80-120^{\circ}$$280-320^{\circ}$의 방향성으로 주로 분포하며 사면의 경사방향 $0-80^{\circ}$(북쪽과 북동 방향)와 $120-160^{\circ}$(남동방향)의 사면은 연구지역에서 나타나지 않는다. 분석된 사면의 3가지 주방향성에 대하여 각각 사면의 파괴 양상을 분석하였으며 절리구조, 엽리와 층리 및 벽개구조의 교차나 교차 조합에 기인하여 여러 유형의 파괴가 발생할 수 있는 사면으로 분석되었다. 하지만 주방향성 3의 사면은 모든 파괴 양상이 발생할 수 있으나 통계상 빈도수에서 가장 적으며 지형상 소규모의 사면으로 형성되어 확률상 사면의 파괴가 발생할 가능성은 적은 것으로 분석되었다.

Keywords

References

  1. 구호본 외 17인, 2007, 사면공학, 한국암반공학회, 건설정보사, 525p
  2. 김경수, 김원영, 채병곤, 조용찬, 2000, 강우에 의한 산사태의 지질공학적 특성 - 충청북도 보은 지역, 지질공학회, 10(2), 163-174
  3. 이연희, 정영국, 박혁진, 이사로, 장범수, 전귀현, 2003, GIS를 이용한 공간자료 적용 및 무한 사면의 안정성 해석 기법 적용 검증: 보은지역을 중심으로, 대한지질공학회 정기총회 및 학술발표회, 153-158
  4. 이종혁, 이민성, 박봉순, 1980, 한국지질도, 미원도폭, 1:50,000, 자원개발연구소, 29p
  5. 이지수, 박혁진, 민경덕, 구호본, 2001, 불연속면의 특성을 고려한 보은지역 암반사면 안정성 해석, 자원환경지질, 34, 601-615
  6. 정상원, 최병렬, 2008, 지질구조에 의한 사면의 불안정성에 관한 연구: 충북 피반령 부근, 대한지질공학회, 18(4), 459-470
  7. 정상원, 최병렬, 2009, 사면 안정 분석을 위한 정면적법과 선조사법의 비교연구, 대한지질공학회, 19(2), 119-129
  8. 최병렬, 정상원, 2008, 정면적법을 이용한 불연속면의 특성화 및 사면안정해석: 충북 보은군 내북면 창리 지역, 암반공학회지 터널과 지하공간, 18(1), 20-32
  9. 최재원, 이사로, 민경덕, 우익, 2004, 지리정보시스템(GIS) 및 베이지안 확률기법을 이용한 보은지역의 산사태 취약성도 작성 및 검증, 자원환경지질, 37, 207-223
  10. Barton, N. R. and Chouby, V., 1977, The shear strength of rock joints in theory and practice, Rock Mechanics, 10, 1-54 https://doi.org/10.1007/BF01261801
  11. Hancock. P. L., 1985, Brittle microtectonics: Principles and practices, Journal of Structural Geology, 7, 437-457 https://doi.org/10.1016/0191-8141(85)90048-3
  12. Hoek, E., 2007, Practical Rock Engineering, Evert Hoek's Consulting Engineering Inc., 2007 ed., 326p
  13. Hoek, E. and Bray. J. W., 1981, Rock slope engineering, 3rd ed. The Institution of Mining and Metallurgy London, 402p
  14. Stern, D. W., 1968, Certain aspects of fracture in naturally deformed rocks, in: Riecker, R. E., ed., NSF Advanced Science Seminar in Rock Mechanics, Special Report Air Force Cambridge Research Laboratory, Bedford, Mass, 97-116
  15. Wyllie, D. C. and Mah, C. W., 2004, Rock Slope and Engineering, Civil and Mining, 4th ed., Spon Press, 431p