• Korean Journal of Environmental Agriculture
• /
• v.38 no.2
• /
• pp.69-75
• /
• 2019

BACKGROUND: Measurement of electrical conductivity of saturated soil paste ($EC_e$) for assessment of soil salinity is time-consuming, and thus conversion of EC of 1:5 soil-water extract ($EC_{1:5}$) to $EC_e$ using a dilution factor may be of help to monitor salinity of huge number of soil samples. This study was conducted to evaluate the dilution factor for reclaimed tideland (RTL) soils of South Korea. METHODS AND RESULTS: Soil samples (n=40) were collected from four RTLs, and analyzed for $EC_{1:5}$, $EC_e$, and cation compositions of 1:5 soil-water extract. The dilution factor (8.70) was estimated by regression analysis between $EC_{1:5}$ and $EC_e$, and the obtained dilution factor was validated by applying to an independent data set (n=96) of $EC_{1:5}$ and $EC_e$. The $EC_e$ measured and predicted was strongly correlated ($r^2=0.74$, P<0.001), but $EC_e$ was overestimated by 16% particularly for the soils with high clay content and low sodium adsorption ratio (SAR). CONCLUSION: This study suggests that using the dilution factor to convert $EC_{1:5}$ to $EC_e$ is feasible method to monitor changes in the soil salinity of the study RTL. However, overestimation of $EC_e$ should be cautioned for the soils with high clay content and low SAR.

• KSBB Journal
• /
• v.8 no.3
• /
• pp.243-255
• /
• 1993

In this study, it was observed that hydrogen Productivity varied with stirrer speed, bead radius, input glucose concentration and dilution rate in a continuous stirred tank reactor in which immobilized R. rubrum KS-301 was used as a hydrogen-producing bacterium The mass transfer resistance due to cell immobilization was also studied. In order to estimate an effectiveness factor, Des of glucose was first obtained, which was subsequently represented by the correlation equation between Dos and Xb, As a result external mass transfer resistance could be neglected for stirrer speeds greater than 400rpn With bead radius increasing, the hydrogen productivity and internal effectiveness factor decreased. With input 91ucose concentration increasing, the hydrogen productivity and interval and external effectiveness factor increased. Although an Internal effectiveness factor was not affected, hydrogen productivity Increased with dilution rate increasing. An overall effectiveness factor remained nearly constant for the dilution rates investigate4 but increased with input 91ucose concentration increasing.

• Korean Journal of Soil Science and Fertilizer
• /
• v.34 no.1
• /
• pp.71-75
• /
• 2001

Linear regression analyses between the electrical conductivity of the saturation-paste extract. ECe, and the electrical conductivity of the 1:5 soil extract, EC1:5, for different soils yielded different dilution factors, or slopes with significant $r^2$ values from 0.842 to 0.905. The dilution factor was inversely proportional to the cation exchange capacity of soil which reflected textural difference. The dilution factors recommended for different textural classes ranged from 6.44 for clay soil to 12.29 for sandy soil based on the CEC's of the textural classes among 350 surface soils recorded in the Taxonomical Classification of Korean Soils except volcanic ash derived soils. Though saturation percentage of the saturation-paste of the soils in this study, CEC should be taken into account for dilution factor between ECe and EC1:5, and the suggested dilution factors might be reasonable estimate for the soil textural classes.

• Journal of Mechanical Science and Technology
• /
• v.14 no.2
• /
• pp.177-187
• /
• 2000

Dilution is an important factor which influences the properties of clad layer. In this paper the change of dilution during laser cladding and the control of dilution are simulated by a finite element method. The adaptive mesh method is adopted for the time-dependent finite element method computation so that the shape of melt pool can be well represented. The situation of the width control of melt pool is also simulated, which indicates that the dilution can be controlled if the width of melt pool is controlled. Computational results indicate that if a line energy (input energy per unit distance) remains constant the dilution will increase with time, especially at the beginning. Simulation results show that it is possible to control dilution in a certain range if the line energy decreases with time. Experiment of Nd: YAG laser cladding with wire feeding is performed. Experiment results coincide well with the FEM results.

• Journal of Advanced Navigation Technology
• /
• v.16 no.6
• /
• pp.944-951
• /
• 2012

The conventional indexes for describing the GNSS positioning performance such as satellite visibility, dilution of precision (DOP) and signal to noise ratio is very useful in open sky, however, they are not useful in the land road environment. In this paper new index is suggested for describing the GNSS positioning performance for the road environment. The new index is called Sky View based DOP (SVDOP). SVDOP is derived referring the Sky-View-Factor (SVF). The usefulness is analyzed by comparing the SVDOP and SVF in land road environment after the singularity points are selected and SVDOP is calculated.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.11 no.5
• /
• pp.92-98
• /
• 2008

Chaff is one of important devices for heliborne protection from radars and missiles. When we use a chaff for heliborne protection, J/S(jamming signal of chaff vs reflected signal from heliborne) is important factor to analyze a heliborne survive. When the radial angle between missile and heliborne is changed, J/S of missile receiver is changed and jamming effectiveness of chaff is also changed. We calculate the RCS of chaff and heliborne, and compare the returned signals in a half power beam width of receiver antenna. We analyze chaff dispense modes and specially simulate the effectiveness of a dilution mode chaff between missile and heliborne.

• Journal of the Korean Society of Combustion
• /
• v.18 no.2
• /
• pp.8-16
• /
• 2013

The flameless combustion has been considered as one of the promising combustion technology for high thermal efficiency, reducing NOx and CO emissions. In this paper, the effect of air and fuel injection condition on formation of flameless combustion was analyzed using three dimensional numerical simulation. The results show that the high temperature region and the average temperature was decreased due to increase of recirculation ratio when air velocity is increased. The average temperature was also affected by entrainment length. Generally mixing effect was enhanced at low entrainment length and dilution was dominated at high entrainment length. This entrainment length was greatly affected by air and fuel injection velocity and distance between air and fuel. It is also found that the recirculation ratio and dilution effect were generally increased by entrainment length and the recirculation ratio, mixing and dilution effect are the significant factor for design of flameless combustion system.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.11 no.2
• /
• pp.116-126
• /
• 1999

In this paper, we have studied the seasonal vanatIons of near-field dilutions of wastewater discharged from the submerged mutiport-diffuser in Masan Bay. Seasonal changes of temperature and salinity, and tidal currents were measured at 16 stations in Masan Bay. Based on the observed ambient field data, the seasonal changes of near-field dilutions due to ambient current and density fields were calculated by CORMIX model. Because of the shallow ambient water depth of 15 m, the density profiles are isopycnal in autumn and winter seasons, in which the dilution factors were the highest, 168 with the strong spring-tidal current and 110-120 with the weak neap-tidal current. As the season changes from spring to summer, the dilution factors are considerably reduced by the factor of 2 as the thermocline is getting deepened up to Sm in depth in summer. In the case of a weak ambient current, the dilution factor in summer was reduced to 1/4 of the dilution in winter. However, with strong ambient current the difference between summer and winter dilutions becomes relatively small by 30%. The results indicate that the seasonal variation of near-field dilution is very large up to 4 times with a weak neap-tidal current, but its variations become small under a strong ambient current of spring tide in MasanBay.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.17 no.5
• /
• pp.67-73
• /
• 2009

Recently, Europe decided to start the regulation of diesel engine nanoparticles because of its well known adverse health effects. The diesel nanoparticles can be classified as solid carbon particles and volatile particles. The volatile particles generates during dilution process by condensation of gas phase volatile compounds such as hydrocarbon. The new nanoparticle regulation considers only solid particles because of difficulty of measurement of volatile particles. The aim of this study is to suggest a proper dilution method that prevent the volatile particle generation. As a result, it is found that the $1^{st}$ dilution air temperature should be above $120^{\circ}C$ in order to prevent volatile particle generation effectively. It is also found that the volatile particles can be removed effectively in the evaporation tube by the increase of evaporation tube temperature. But when exhaust gas is hot enough (>$190^{\circ}C$, in this study) and it is diluted in the first diluter with high temperature air (>$120^{\circ}C$), removal phenomenon of volatile particles by increasing of evaporation tube temperature can not be seen. It means that there are no volatile particles in the diluted exhaust gas. Additionally, dilution ratio is not an important factor for volatile particle generation compared with dilution air temperature or evaporation tube temperature.

• The Korean Journal of Nuclear Medicine Technology
• /
• v.16 no.2
• /
• pp.3-6
• /
• 2012

Purpose : Samsung medical ceter shall find a cause of the interference factor and suggest a solution for it. Materials and Methods : A sample of $^{18}F$-FDG, radioactive pharmaceuticals produced by TRACERlab MX and FASTlab synthesizer. Gel-clot method uses Positive control tube and single test tube. Kinetic chromogenic method uses ENDOSAFE-PTS produced by Charles River. Results : According to Gel clot method of Endotoxin Tests at FASTlab, both turbidity and viscosity increased at 40-fold dilution and Gel clot was detected. In case of TRACERlab MX, Gel clot was detected in most of samples but intermittently not in a few of them. When using ENDOSAFE-PTS, sample CV (Coefficient of Variation) of FASTlab is 0% at all dilution rates whereas spike CV is 0% at 1-fold dilution, 0~35% at 10-fold, 3.6~12.9% at 20-fold, 5.2~7.1% at 30-fold, 1.1~17.4% at 40-fold, spike recovery; 0% at one-fold, 25 ~ 58% at 10-fold, 50 ~ 86% at 20-fold, 70~92% at 30-fold, and 75~120% at 40-fold. Sample CV of TRACERlab MX, is 0% at all dilution rates whereas spike CV is 1.4~4.8% at one-fold dilution, 0.6~19.9% at 10-fold, spike recovery; 35~72% at one-fold dilution and 77~107% at 10-fold. Conclusion : Gel clot does not seem to occur probably to H3PO4 which engages in bonding with Mg2+ion contributing gelation inside PCT. Dilution which is identical to reducing the amount of H3PO4, could remove interfering effects accordingly. Spike recovery was obtained within 70~150% - recommended values of supplier - at 40-fold dilution even in kinetic chromogenic method.