• Polymer(Korea)
• /
• v.28 no.1
• /
• pp.35-40
• /
• 2004

The formation mechanism of void defect which deteriorate composite's property is various according to each composite process. In this paper, void formation and growth mechanism is analyzed by thermal analysis and GC/MS. We made a vacuum chamber for observing pressure effect. Thermal analysis has been done in various condition. Elements of volatiles during resin curing were turned out by GC/MS. The most of volatiles of polyester were composed of styrene (over 80%) and a small quantity of toluene. In case epoxy resin, butyl glycidyl ether was the main element of volatiles (over 90%). We concluded that the original sites of void growth existed in resin and they were eliminated by vacuum and heating process. And the growth of void was influenced by water, diluents, solvent, and reactants in resin.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.41 no.4
• /
• pp.267-271
• /
• 2008

We experimentally determined the physico-chemical properties of seminal plasma as well as the sperm cryopreservation techniques of masou salmon, Oncorhynchus masou masou. Seminal plasma contained $18{\pm}1mmol/L$ potassium, $144{\pm}4mmol/L$ sodium, $116{\pm}3mmol/L$ chloride, $83.2{\pm}3.1mg/L$ calcium, $14.8{\pm}0.7mg/L$ magnesium, $45{\pm}9mg/L$ glucose, and $1.0{\pm}0.0g/L$ total protein. The osmolality and pH of seminal plasma were $287{\pm}7\;and\;7.7{\pm}0.1mmol/kg$, respectively, and the spermatocrit was $28{\pm}2$. The rate of embryonic survival at the eyed-stage and the hatching rate were highest in 10% methanol with 300 mM glucose. Compared to DMSO or glycerol, methanol served as a better cryoprotectant of masou salmon sperm.

• Journal of the Korean Ceramic Society
• /
• v.49 no.4
• /
• pp.363-368
• /
• 2012

Nitriding and post-sintering behavior of powder mixture compacts were investigated. As mixture compacts are different from simple Si compacts, the fabrication of a sintered body with a mixture composition has engineering implications. In this research, in specimens without a pore former, the extent of nitridation increased with $Si_3N_4$ content, while the highest extent of nitridation was measured in $Si_3N_4$-free composition when a pore former was added. Large pores made from the thermal decomposition of the pore former collapsed, and they were filled with a reaction product, reaction-bonded silicon nitride (RBSN) in the $Si_3N_4$-free specimen. On the other hand, pores from the decomposed pore former were retained in the $Si_3N_4$-added specimen. Introduction of small $Si_3N_4$ particles ($d_{50}=0.3{\mu}m$) into a powder compact consisting of large silicon particles ($d_{50}=7{\mu}m$) promoted close packing in the green body compact, and resulted in a stable strut structure after decomposition of the pore former. The local packing density of the strut structure depends on silicon to $Si_3N_4$ size ratio and affected both nitriding reaction kinetics and microstructure in the post-sintered body.

• Korean Journal of Veterinary Research
• /
• v.29 no.2
• /
• pp.41-49
• /
• 1989

The study was undertaken to obtain indirect values of volume of packed red cell (VPRC) without centrifugation, using the erythrocyte sedimentation rate (ESR) of diluted blood in dogs. ESRs of diluted blood using the diluent of autologous plasma in which formed numerous RBC-rouleau clumps, autologous serum in which formed a few RBC-rouleau clumps, and 5% dextrose or 6% sucrose solutions in which formed numerous RBC-aggregation clumps, were accelerated. But, ESR of diluted blood using the 0.9% saline, D-S, ACD-B, CDP or D-PBS solutions were sluggish, because erythrocytes were dispersed in these diluents. Reliable values of VPRC on the basis of the correlating regressive equation to the ESR could be derived from values of$60^{\circ}$-angled-micro-ESR/40 min in the mixture, four parts of 5% dextrose solution and one part of whole blood. In the ESR values of diluted blood with low ratio, 1:1~3:1, $60^{\circ}$-micro-ESR was higher than $60^{\circ}$-Wintrobe-ESR. But, in the diluted blood with high ratio, 4:1~5:1, there was no different ESR values. For an aid of practical use, authers suggested a list of the $60^{\circ}$-micro-ESR/40 min in the diluted blood with equivalent VPRC of whole blood.

• Asian-Australasian Journal of Animal Sciences
• /
• v.14 no.7
• /
• pp.1024-1050
• /
• 2001

Avian spermatozoa are characterised by high concentrations of polyunsaturated fatty acids (PUFAs), in particular docosatetraenoic (DTA, 22:4n-6) and arachidonic (AA, 20:4n-6) acids. As a result they are vulnerable to lipid peroxidation, which is considered to be an important factor of male infertility. Antioxidant systems are expressed in spermatozoa and seminal plasma and build three major levels of antioxidant defense. The first level is based on the activity of superoxide dismutase (SOD) which is, in conjunction with glutathione peroxidase (GSH-Px), catalase and metal-binding proteins, responsible for prevention of free radical formation. The second level of defence is responsible for prevention and restriction of chain reaction propagation and includes chain-breaking antioxidants such as vitamin E, ascorbic acid, glutathione and some others. The third level of antioxidant defence deals with damaged molecules, repairing or removing them from the cell and includes specific enzymes such as lipases, proteases, DNA repair enzymes etc. In the review, profiles of PUFAs and the two first lines of antioxidant defence in avian spermatozoa are characterised. Dietary manipulation of the breeder's diet (PUFA, vitamin E and selenium) as an effective means of modulating fatty acid composition and antioxidant system is also considered. Antioxidant properties of seminal plasma and efficiencies of inclusion of antioxidants into semen diluents are also characterised.

• Membrane and Water Treatment
• /
• v.9 no.6
• /
• pp.463-471
• /
• 2018

The present paper deals with the liquid-liquid extraction and flat sheet supported liquid membrane studies of Pd(II) separation from nitric acid medium using a novel synthesized ligand, namely, N,N,N',N'-tetraethyl-2,2-thiodiethanthiodiglycolamide (TETEDGA). The effect of various diluents and stripping reagents on the extraction of Pd(II) was studied. The liquid-liquid extraction studies showed complete extraction of Pd(II) in ~ 5 min. The influence of nitric acid and TETEDGA concentration on the distribution of Pd(II) has been investigated. The increase in nitric acid concentration resulted in increase in extraction of Pd(II). Stoichiometry of the extracted species was found to be $Pd(NO_3)_2{\cdot}TETEDGA$ by slope analysis method. Extraction studies with SSCD solution showed negligible uptake of Pt, Cr, Ni, and Fe, thus showing very high selectivity and extractability of TETEDGA for Pd(II). The flat sheet supported liquid membrane studies showed quantitative transport of Pd(II), ~99%, from the feed ($3M\;HNO_3$) to the strippant (0.02 M thiourea diluted in $0.4M\;HNO_3$) using 0.01 M TETEDGA as a carrier diluted in n-dodecane. Extraction time was ~160 min. Parameters such as feed acidity, TETEDGA concentration in membrane phase, membrane porosity etc. were optimized to achieve maximum transport rate. Permeability coefficient value of $2.66{\times}10^{-3}cm/s$ was observed using TETEDGA (0.01 M) as carrier, at 3 M, $HNO_3$ feed acidity across $0.2{\mu}m$ PTFE as membrane. The membrane was found to be stable over five runs of the operation.

• Preventive Nutrition and Food Science
• /
• v.17 no.4
• /
• pp.274-279
• /
• 2012

For the quantitative analysis of genetically modified (GM) maize in processed foods, primer sets and probes based on the 35S promoter (p35S), nopaline synthase terminator (tNOS), p35S-hsp70 intron, and zSSIIb gene encoding starch synthase II for intrinsic control were designed. Polymerase chain reaction (PCR) products (80~101 bp) were specifically amplified and the primer sets targeting the smaller regions (80 or 81 bp) were more sensitive than those targeting the larger regions (94 or 101 bp). Particularly, the primer set 35F1-R1 for p35S targeting 81 bp of sequence was even more sensitive than that targeting 101 bp of sequence by a 3-log scale. The target DNA fragments were also specifically amplified from all GM labeled food samples except for one item we tested when 35F1-R1 primer set was applied. A reference plasmid pGMmaize (3 kb) including the smaller PCR products for p35S, tNOS, p35S-hsp70 intron, and the zSSIIb gene was constructed for real-time PCR (RT-PCR). The linearity of standard curves was confirmed by using diluents ranging from $2{\times}10^1{\sim}10^5$ copies of pGMmaize and the $R^2$ values ranged from 0.999~1.000. In the RT-PCR, the detection limit using the novel primer/probe sets was 5 pg of genomic DNA from MON810 line indicating that the primer sets targeting the smaller regions (80 or 81 bp) could be used for highly sensitive detection of foreign DNA fragments from GM maize in processed foods.

• Economic and Environmental Geology
• /
• v.48 no.3
• /
• pp.221-229
• /
• 2015

Clay minerals have been used in pharmaceutical industries as active ingredients and excipients without pharmacological activity such as diluents, emulsifying agents, viscosity-increasing agents, and lubricants. For example, bentonite, kaolin, magnesium aluminum silicate, and talc are generally and extensively used pharmaceutical ingredients, which are restrictedly regulated by Pharmacopoeias. We discuss the physicochemical and biopharmaceutical properties of clay minerals. In addition, we introduce the cases of pharmaceutical applications of clay minerals. From this review, pharmaceutical applications of clay minerals can be one of strategies for the development of high value-added products from clay minerals.

• Polymer(Korea)
• /
• v.34 no.6
• /
• pp.574-578
• /
• 2010

In this study, the caprolactone modified hydroxy acrylates (CHAs) were synthesized by ring-opening reaction of caprolactone and 2-hydroxyethyl acrylate (2-HEA) as initiator. Also, the caprolactone modified urethane acrylate (UA) oligomers were synthesized by condensation reaction of previously synthesized CHAs, 2-hydroxyethyl acrylate (2-HEA) and hexamethylene diisocyanate trimer (HDT). Using the hydroxy number of CHAs, the molecular weights of the CHAs were calculated easily and their molecular weight was similar to the theoretical molecular weight of them. The viscosity of UA oligomers decreased as increasing a content of CHA in the UA oligomer. Cure films were prepared from UA oligomer, reactive diluents, and UV initiator to investigate their physical properties. The thermal stability and color difference on high temperature for the cured film were improved as increasing the crosslinking density. Their surface hardness was also increased as increasing crosslinking density of the cured films, but their elongation at break was decreased.

• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2004.02a
• /
• pp.245-256
• /
• 2004

The extraction of three kinds of amido podands, N,N,N'N'-tetrabutyl-3-oxa-pentanedi- amide (TBDGA), N,N,N'N'-tetra-isobutyl-3-oxa-pentanediamide(TiBDGA) and N,N,N'N'-tetra- butyl-3,6-dioxa-oct-anediam- ide(TBDOODA) on U(VI),Pu(IV), Am(III), Eu(III) and other metal ions is studied in nitric acid solutions. 40%octanol-kerosene is chosen as diluents to eliminate third phase and emulsion. TBDGA and TiBDGA show extraction selectivity to An(III) and Ln(III) much higher than to U(VI) and Pu(IV). Fe, Ru and Mo is poorly extracted by the three kinds of amid podands in 2~3mol/L $HNO_3$ solutions. Aiming to eliminate interface crude when using simulated HLLW solution in the system of 0.2mol/L TBDGA/Octanol＋kerosene, acetohydroxyamic acid was adapted. Distribution ratio of zirconium was decreased when adding acetohydroxyamic acid in aqueous solution, and interface crude disappeared as mixing extractant with HLLW. The counter-current extraction test is carried out in a set of miniature mixer-settler, with 0.2mol/L TBDGA/ 40% octanol-kerosene as extractant to separate U(VI), Pu(IV), Am(III) and Eu(III) from simulated high level liquid waste(HLLW) solution. In battery A, lanthanides and actinides are coextracted into organic phase with the recovery of 99.98% for U(Ⅵ), >99.99% for Pu(IV), and >99.99% for Am(III) and Eu(III) respectively. In battery R1, 99.99% U, 86.2% Pu and a part of Am or Eu are stripped into aqueous phase by 0.2mol/L acetohydroxyamic acid (AHA) in 0.01mol/L $HNO_3$ solution. In battery $R_2$, Am, Eu and remained Pu are completely back-extracted by 0.2mol/L AHA. This separation process contains no salt reagent, and it is not necessary to dilute HLLW feed.