• JSTS:Journal of Semiconductor Technology and Science
• /
• v.13 no.2
• /
• pp.98-107
• /
• 2013

This work describes a 13b 100 MS/s 0.13 um CMOS four-stage pipeline ADC for 3G communication systems. The proposed SHA-free ADC employs a range-scaling technique based on switched-capacitor circuits to properly handle a wide input range of $2V_{P-P}$ using a single on-chip reference of $1V_{P-P}$. The proposed range scaling makes the reference buffers keep a sufficient voltage headroom and doubles the offset tolerance of a latched comparator in the flash ADC1 with a doubled input range. A two-step reference selection technique in the back-end 5b flash ADC reduces both power dissipation and chip area by 50%. The prototype ADC in a 0.13 um CMOS demonstrates the measured differential and integral nonlinearities within 0.57 LSB and 0.99 LSB, respectively. The ADC shows a maximum signal-to-noise-and-distortion ratio of 64.6 dB and a maximum spurious-free dynamic range of 74.0 dB at 100 MS/s, respectively. The ADC with an active die area of 1.2 $mm^2$ consumes 145.6 mW including high-speed reference buffers and 91 mW excluding buffers at 100 MS/s and a 1.3 V supply voltage.

• The Journal of the Acoustical Society of Korea
• /
• v.20 no.1
• /
• pp.56-61
• /
• 2001

This paper presents the real-time implementation of an AMR (Adaptive Multi Rate) vocoder which is included in the asynchronous International Mobile Telecommunication (IMT)-2000 mobile ASIC. The implemented AMR vocoder is a multi-rate coder with 8 modes operating at bit rates from 12.2kbps down to 4.75kbps. Not only the encoder and the decoder as basic functions of the vocoder are implemented, but VAD (Voice Activity Detection), SCR (Source Controlled Rate) operation and frame structuring blocks for the system interface are also implemented in this vocoder. The DSP for AMR vocoder implementation is a 16bit fixed-point DSP which is based on the TeakLite core and consists of memory block, serial interface block, register files for the parallel interface with CPU, and interrupt control logic. Through the implementation, we reduce the maximum operating complexity to 24MIPS by efficiently managing the memory structure. The AMR vocoder is verified throughout all the test vectors provided by 3GPP, and stable operation in the real-time testing board is also proved.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.10
• /
• pp.885-892
• /
• 2013

The main advantage of ESPAR antenna is that ESPAR antenna requires only a single RF chain for reduction of transceiver's hardware complexity, as compared to conventional MIMO system. In conventional MIMO system, each data symbol is mapped to each antenna. But, each data symbol is mapped to each orthogonal basis pattern in ESPAR antenna system. In this paper, we design beamspace MIMO system using ESPAR antenna with single RF chain for MIMO system of low-complexity and low power consumption. And then, we analyze performance of beamspace MIMO according to each PSK modulation. Performance of beamspace MIMO system is similar to performance of conventional MIMO system. As a result of analyzing the performance of beamspace MIMO system using higher-order PSK modulation. we can confirm that performance characteristic of beamspace MIMO system with low complexity and low power consumption is similar to digital communication of signal domain.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.10 s.89
• /
• pp.1011-1017
• /
• 2004

Ultra Wideband(UWB) technologies have been developed to exploit a new spectrum resource in substances and to realize ultra-high-speed communication, high precision geolocation, and other applications. The energy of UWB signal is extremely spread from near DC to a few GHz. This means that the interference between conventional narrowband systems and UWB systems is inevitable. However, the interference effects had not previously been studied from UWB wireless systems to conventional mobile wireless systems sharing the frequency bands such as Korean Cellular CDMA and WCDMA. This paper experimentally evaluates the interference from two kinds of UWB sources, namely a direct-sequence spread-spectrum CDMA(DS-CDMA) UWB source and an impulse radio UWB source, to a Cellular CDMA and WCDMA digital transmission system. The average frame error rate degradation of each system are presented. From these experimental results, the interference effects of DS-CDMA UWB source is not severe compared to the Impulse UWB.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.7
• /
• pp.797-804
• /
• 2012

In this paper, we propose a QAPM(Quadrature Amplitude Position Modulation) modulation using compressive sensing for the purpose of power efficiency improvement. QAPM modulation is a combination technique of QAM (quadrature amplitude modulation) and PPM(Pulse Position Modulation). Therefore it can decrease the transmission power and improve BER performance. Moreover, even if the band width is widened when the number of positions is increased, high sparsity characteristic caused by position number can be applied to compressive sensing technique. Compressive sensing has recently studied as a method that can be successfully reconstructed from the small number of measurements for sparse signal. Therefore, the proposed system can lower price of receiver by reducing sampling rate and has performance improved by using QAPM modulation. And the results are confirmed through simulations.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.7 no.1
• /
• pp.1-7
• /
• 2012

In this paper, An X-band solid state power amplifier(SSPA) for pulse compressed microwave signal with 60Watt power and power added efficiency(PAE) above 30% is described. Designed 60Watt high power amplifier(HPA) was implemented by cascade coupled amplifiers, and it is consisted on three stage drive amplifiers with internally matched GaAs FET and one stage main power amplifier with an internally matched GaN HEMT. The designed SSPA has performance with more than total power gain 37dB and output power 48dBm(60-W) in condition of frequency range $9.41{\pm}0.03GHz$, pulse period width under 1ms and duty cycle under 10%. The implemented SSPA can apply to high quality digital marine radar applications with pulse compression technique.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.6 no.3
• /
• pp.343-348
• /
• 2011

With the rapid and wide-spread use of mobile communications much attention has been focussed on propagation in the urban area crowed with buildings. It is often surrounded by hills, forests, and mountains. The importance of surface scattering interference between transmitters and receivers on the rough surfaces has been interested and investigated. Therefore, a prediction method is necessary to estimate the influence of rough surfaces on microwave radio propagation. Moreover, most of the mobile communications are performed based on the digital communication system rather than the analog one. In this case, we must pay more careful attention to the signal delay caused by the phase delay due to the multi-path propagation. In this paper we have analyzed numerically scattering of electromagnetic waves from Composite structures by using FVTD (Finite Volume Time Domain) method. We consider two different types of rough surfaces such as periodic and composite structures.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.9 no.1
• /
• pp.67-74
• /
• 2016

In this paper, we propose a watermarking technology for a mixed music. The mixed music means recreated music that contained a number of musics in one audio clip. Royalty associated with the audio content is typically imposed by the full audio content. However, the calculation of royalties gives rise to conflict between copyright holders and users in the mixed music because it uses not full audio content but a fraction of that. To solve the conflict related with the mixed music, we propose a audio watermarking technique that inserts different watermarks for each audio in the audio that make up the mixed music. The proposed watermarking scheme might have poor SNR (signal to noise ratio) to embed to each audio clip. To overcome poor SNR problem, we used inaudible pseudo random sequence which modifies typical pseudo random sequence to canonical signed digit (CSD) form. The proposed method verifies the performance by each watermark extraction and the time internal estimation valies from the mixed music.

• The Proceedings of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.11 no.6
• /
• pp.64-73
• /
• 1997

RPWM(Random Pulse Width Modulation) techniques have been attracting an interest as an excellent reduction method of acoustic noise on the inverter drive system. Using randomly changed switching fre-quency of the inverter, the power spectrum of the electromagnetic acoustic noise can be spread out into the wide-band area. The wide band noise is much more comfortable and less annoying than the narrow-band one. This paper describes an implementationof the triangular carrier frequency modultde RPWM inverter drive system The poweer soedtrum of the noise emittde from the induction motro was measured in the anechoic chamber. The analysis of the sources for the acoustic noise and the effects of the noise reduction are confirmed by the ceasured dpectra of the noise. Real-time RPWM along with the speed control was achieved by high speed DSP(Digital Signal Processor ) TmS320C31, By changing the center frequency and the bandwidth of the carrier, theis real-time RPWM scheme can be used as an efficient switching frequency band acoustic noise reduction method for the inverter system with variant load conditions.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.1
• /
• pp.735-738
• /
• 2005

The phase error in the digital transmission system are generated by random phase noise and tracking phase error due to doppler phenomenon. In the mobile satellite communication system that generates the doppler frequency, which is a system with a movement, the proper system phase noise spectrum should be designed based on analyses for phase noise and static phase error effects. Based on the analyses of the doppler frequency and the phase error for bilateral satellite communication system providing an asynchronous service, the phase noise spectrums for the mobile satellite communication are designed in this paper. Also, the available transmission services under the less doppler effect are proposed and the proper signal source units for a required transmission system can be designed under the proposed system phase noise spectrum.