• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.6
• /
• pp.900-909
• /
• 1999

The receiving part of the RF system for the digital TRS base stations is developed in this paper. Based on the system specifications, the structure of the RF system is accomplished and its block diagram is drawn. The RF system is implemented according to these block diagrams. Subsequently the RF band-pass filter, the low noise amplifier, the automatic level controlled attenuator, the frequency synthesizer and other components for the system are designed and implemented, and a main board to integrate these modules is also manufactured. To lower the noise floor of the system and suppress the RF spurious noise, a PCB layout is performed carefully. For each module consisting of the RF system and the entire system, the performance tests are accomplished to check the specifications.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.11C
• /
• pp.1085-1097
• /
• 2009

We present a structure and design method of the D8PSK modem compatible with the VDL mode-2 standard and performance test results of the developed modem. In VDL mode-2, the raised cosine filter is used only in the transmitter and a general low pass filter is used in the receiver. Consequently, we can not achieve ISI reduction but can have better spectrum characteristics. Although there is 1~2 dB performance degradation with an un-matched filter compared to that with a matched filter, it is more important to minimize adjacent channel interference in narrow band communications. The transmit signal is generated digitally to avoid the problems(I/Q imbalance and DC offset etc.) of analog modulators. In addition the digital down converter using digital IF sampling technique is adopted for the receiver. This paper contains the overall configuration, design method and simulation results based in part on the previously proposed structures and algorithms. It is confirmed that the modem transmits and receives messages successfully at a speed of max. 870 km/h over ranges of up to 310 km through the ground and in-flight communication tests.

• The Journal of the Acoustical Society of Korea
• /
• v.16 no.3
• /
• pp.106-113
• /
• 1997

A 3V CMOS continuous-time fully-balanced integrator for low-voltage analog-digital mixed-mode signal processing is designed in this paper. The basic architecture of the designed fully-balanced integrator is complementary circuit which is composed of NMOS and PMOS transistor. And this complementary circuit can extend transconductance of an integrator. So. the unity gain frequency, pole and zero of integrator are increased by the extended transconductance. The SPICE simulation and small signal analysis results show that the UGF, pole and zero of the integrator is increased larger than those of the compared integrtors. The three-pole active low-pass filter is designed as a application circuit of the fully-balanced integrator, using 0.83V CMOS processing parameter.

• Special Issue of the Society of Naval Architects of Korea
• /
• 2008.09a
• /
• pp.68-75
• /
• 2008

This paper describes the design and implementation of a low cost inertial navigation system(INS) using an inertial measurement unit(IMU), a digital compass, GPS, and an embedded system. The system has been developed for a transporter that load and unload ship blocks in a shipbuilding yard. When the transporter would move from place to place, they would periodically pass under obstructions that would obscure the GPS signal. This increases the error when estimating the position. Thus the INS has been used to improve position accuracy. INS is also capable of providing continuous estimates of the transporter's position and orientation. Even though IMU is typically very expensive, this INS is made of "low cost" components and the indirect Kalman filtering algorithm.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.7
• /
• pp.636-645
• /
• 2015

In this paper, unusual harmonics noise problem of digital electronic products in mass production was introduced and a practical solution was proposed. Generally, 5th or higher harmonics noise level has been ignored in circuit designs because over 5th harmonics noise decreases by 40 (dB/decade). Through some measurements, it is confirmed that over 10th harmonics noise can propagate and radiate in case of a certain PCB or housing conditions. We propose a capacitively loaded micro-strip low pass filter for commercial products having spatial design constraints and measured the effectiveness. The proposed structure can solve both of the continual increment of harmonics noise level and the spatial design constraint of commercial products. We expect the proposed method be effectively used for various digital electronic products.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.4 no.3
• /
• pp.527-536
• /
• 2000

This paper discusses the design of self-oscillating mixer type low noise down converter using the microwave field effect transistor. The mixer is consists of local oscillator in which high stability dielectric resonator and band pass filter to get rid of spurious oscillation at intermediate frequency stage. The microstrip antenna was integrated in the same substrate which generate 12.3GHz and low noise amplifier was also added after antenna using 3 stage of high electron mobility transistors. The output frequency from the local oscillator was chosen as 11.3GHz for the Ku-band application. The measured phase noise was -804dBc/Hz at 100kHz offset frequency, and the gain was 7～12dB in frequency range from 12.0GHz to 12.7GHz. The noise figure at intermediate frequency stage was 64H. The designed model shows less conversion loss than previous diode type mixer. The proposed mixer can be used in digital satellite broadcasting and communication system and expected to use in next generation low noise block design.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.7
• /
• pp.774-783
• /
• 2007

This paper presents an integrated packaging antenna-diplexer module for wireless communication systems in the Cellular and SDMB band. The design and the realization of the proposed one are experimentally analyzed and discussed. It consists of a dual-resonance antenna and a diplexer with a multi-layer LTCC(${\varepsilon}_r=7.8,\;tan\;{\delta}=0.0043$) technology with integration capability and low loss. The dual-resonance antenna of the proposed module has the meander line structure for size reduction and has the shorting structure of an inverted F antenna to achieve good impedance matching. The diplexer of the proposed module was designed with the combination of low pass filter(LPF) and high pass filter(HPF). Decreasing the mutual interference between them provides a high isolation characteristic. The proposed antenna-diplexer module with dimensions of $27.5{\times}12.0{\times}2.2mm$ operates within a range from 813 MHz to 902 MHz for the cellular band and from 2,586 MHz to 2,655 MHz for the SDMB band. And the measured gain of the fabricated module is -1.96 dBi for Cellular band and -5.43 dBi for SDMB band. The parameters for the antenna-diplexer module are investigated and the several performances are discussed.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.9 no.2
• /
• pp.97-104
• /
• 2004

As a device that returns surplus energy, regenerated from trains to d.c. source, to a.c. system and reuses it, the thyristor Inverter has been widely used. Because the conventional thyristor inverter is a unidirectional phase-controlled device, it Is Impossible to control the power factor of its output. Moreover, harmonics emission is high and it needs to take a additional filter. In this paper, to solve the problems stated above, the inverter, which can control real and reactive power by adopting IGBT modules as switching elements and being controlled by means of space vector PWM, is developed. Considering high economical efficiency and reliability in order to apply to the system for commercial use, the developed inverter is equipped with fully digital control system and low pass filter, and reduces harmonics and has compact size. The detail description about the developed inverter is stated in various respects: design criteria, technical description, power circuits, control techniques, the developed system, test results, etc.

• Aerospace Engineering and Technology
• /
• v.6 no.1
• /
• pp.83-91
• /
• 2007

An experimental verification of multipactor(MP) discharge for S-band diplexer as a sample DUT for space application by an in-house MP test facility is proposed. The designed diplexer having two BPFs for Rx and Tx is applied to a design of five pole inter-digital cavity type band pass filter with chebyshev response, it has 2.7 % bandwidth centered at 2.232 and 2.055 GHz for Rx, Tx, respectively. To avoid the MP discharge, the accurate design and analysis methods based on 3D EM field analysis are considered. The proposed in-house MP test facility consists of a phase detecting system using a doubly balanced mixer as a simple, low cost and real time MP test method compared with results of previously well-known MP detection systems as cross reference methods. The calculated MP threshold RF input power is 43.13 dBm. The measured one is 43 dBm and 44 dBm for CW, pulsed mode test, respectively.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.14 no.2
• /
• pp.222-231
• /
• 2011

In this paper, we have proposed a method which can make it possible to stably transmit and receive data like the ARC-164 radio frequency hopping environment as a S/W packet modem with PSK modulation. This is a method that the S/W packet modem with PSK digital modulation and the use of PC sound cards change over from data to voice signals and then transmit/receive data. We confirmed not only that it is possible to solve the slow speed communication with the use of sending data through multi-channels and PSK modulation that has the ability to methodically improve transmission rates, but also that it is possible to send the state of frequency hopping stably. In conclusion, we've confirmed both tactical values that though the transmission rate may be a tad slow, a state of frequency hopping of more than 94% confidence plus voice and data can be sent via radio at the same time. In this paper, the proposed S/W packet modem is only an implemented S/W component, so when we apply it to aircraft that we don't consider EMC problems with, then we have the advantage of a wider use of conventional UHF/VHF/HF radio that is possible to voice communication. If we recognize these operational requirements, we can apply for a lot of field equipment efficiently.