• Environmental Sciences Bulletin of The Korean Environmental Sciences Society
• /
• v.10 no.S_3
• /
• pp.127-137
• /
• 2001

The sonochemical Process has been applied as a treatment method and was investigated its effect on the decomposition of humic substances(HS). The reaction kinetics and mechanisms in the Process of sonochemical treatment for humic substances(HS) in wastewater have also been discussed. It was observed that the metal ions such as Fe(II) and Mn(II) showed catalytic effects, while Al(III), Ca(II), and Mg(II) had inhibitory effects on the decomposition of humic substances in sonochemical reaction with hydrogen peroxide. Experimental results also showed factors such as hydrogen peroxide dose affected the formation of disinfection by-products. Two trihalomethanes, chloroform and dichlorobromomethane were formed as major disinfection by-products during chlorination. The mechanism of radical reaction is controlled by an oxidation process. The radicals are so reactive that most of them are consumed by HS radicals and hydroxyl radicals can be acted on organic solutes by hydroxyl addition, hydrogen abstraction, and electron transfer. The depolymerization and the radical reaction of HS radicals appear to occur simultaneously. The final steps of the reaction are the conversion of organic acids to carbon dioxide.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1998.06a
• /
• pp.259-262
• /
• 1998

The liquid crystal (LC) alignment and pretilt angle generation using photo-alignment method were investigated in this study. We obtained that the monodomain alignment of nematic(N) LC increases with increasing irradiation time in a cell with linearly polarized ultraviolet (LPUV) light irradiation on polyimide (Pl) surfaces. We consider that the monodomain alignment is able to be anisotropic dispersion force due to photo-depolymerization of polymer with LPUV light irradiation on Pl surface. Also, we observed that the uniform alignment of NLC is obtained in a cell with normally LPUV light irradiated on Pl surface at 30 min. and then oblique LPUV is secondly irradiated on Pl surfaces rotated by 90$^{\circ}$. The pretilt angle of NLC is generated about 1.5$^{\circ}$ with oblique angle 60$^{\circ}$.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1998.06a
• /
• pp.267-270
• /
• 1998

In this study, we investigated the generation of pretilt angle for nematic liquid crystal (NLC) in a cell with oblique non-polarized ultraviolet (UV) light irradiation on polyimide (PI) surfaces. It was found that the monodomain alignment of the NLC is obtained in a cell with an angle of incidence of 70∼85$^{\circ}$on PI surface. We consider that the monodomain alignment of NLC is attributed to anisotropic dispersion force effect due to Photo-depolymerization of polymer on PI surfaces. Also, pretilt angle of NLC is generated about 3$^{\circ}$ with an angle of incidence of 70∼75$^{\circ}$. It is considered that the pretilt angle generation in NLC is attributed to interaction between the LC molecules and the polymer surfaces.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.10
• /
• pp.878-884
• /
• 1998

We have investigated that the monodomain alignment of nematic liquid crystal (NLC) is obtained with polarized ultraviolet(PUV) light irradiation on polyimide (PI) surface. The LC alignment capability increases with increasing the UV light irradiation time. The polarized UV light irradiation on oblique angle of 60。 irradiated on PI surface rotated by 90。 at 10 min. after being normally irradiated on PI surface at 30 min., the generated pretilt angle of NLC is about 2.5。. The pretilt angle of NLC is attributed to the interaction between the LC molecules and the asymmetric triangular structure of polymer surface due to photo-depolymerization of polymer with the oblique UV light on PI surface. The voltage -transmittance and response time characteristics of photo-aligned twisted nematic (TN)-LCD with UV light irradiation time 60 min. were almost same in comparison with the rubbing-treated TN-LCD.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.10
• /
• pp.911-917
• /
• 1998

In this paper, we have investigated the generation of pretilt angle for nematic liquid crystal (NLC) in a cell with oblique non-polarized ultraviolet(UV) light irradiation polyimide (PI) surface. It was found that the monodomain alignment of the NLC is obtained with an angle of incidence of 70∼85。 on PI surface. It is considered that the monodomain alignment of NLC is attributed to anisotropic of NLC is about 3。 with and angle of incidence of 70∼75。. Finally, we observed that the voltage-transmittance, response time, and voltage-holding-ratio(VHR) characteristics of photo-aligned twisted nematic(TN)-LCD with and angle of incidence of 85。 on PI surface were almost same compared to rubbing -treated TN-LCD.

• Elastomers and Composites
• /
• v.47 no.2
• /
• pp.104-110
• /
• 2012

Depending on the states of polyurethane scraps generated in the production sites of polyurethane or recycling center of polyurethane scraps, appropriate recycling technologies can be employed for the recycling of resources. In this study, recycling technologies for the polyurethane scraps were classified into physical recycling, chemical recycling, and energy recycling and reports in the literatures were discussed.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1997.11a
• /
• pp.198-201
• /
• 1997

We investigated the generation of pretilt angle for nematic liquid crystal (NLC) in a cell with slanted non-polarized ultraviolet (UV) light irradiation on mixtured polyimide (PI) surfaces. It was found that the monodomain alignment of NLC is obtained in a cell with an angle of incidence of 75∼85 degrees on PI surface. We consider that the monodomain alignment of NLC is attributed to anisotropic dispersion force effect due to photo-depolymerization of polymer on Pl surfaces. We successfully observed that the pretilt angle of NLC is generated above 5 degree with an angle of incidence of 75∼85 degree. It is considered that the pretilt angle generation in NLC is attributed to interaction between the LC molecules and the Polymer surfaces.

• Macromolecular Research
• /
• v.17 no.11
• /
• pp.919-925
• /
• 2009

The enzymatic polymerization of 12-hydroxystearic acid (12-HSA) was carried out with Lipase $CA^{(R)}$ in benzene to produce poly(12-hydroxystearate) (PHS) with a low molecular weight. When this polymerization was continued for a long reaction time, the PHS once formed was depolymerized into a cyclic diester, 13,16-dihexyl-1,14-dioxacyclohexacosane-2,15-dione (12-HSAD). Similar polymerization and depolymerization were observed when 12-hydroxyoleic acid (12-HOA) was treated with Lipase $CA^{(R)}$, whereas only polymerization occurred when 12-hydroxydodecanoic acid (12-HDA) was treated in a similar manner. The preferential formation of cyclic diesters for 12-HSA was attributed to the structural requirements due to the bulky n-hexyl side groups stemming from the ring systems.

• Prospectives of Industrial Chemistry
• /
• v.24 no.2
• /
• pp.31-37
• /
• 2021

일반적으로 cross-link된 열경화성 에폭시수지는 유기용매에 용해되지 않고 열에 용융되지 않는 특성이 있다. 따라서 에폭시수지가 사용된 물질, 특히 탄소섬유강화플라스틱(carbon fiber reinforced plastic, CFRP)은 재활용이 어렵고, 사용 후 폐기물 처리에 막대한 비용이 소비되고 있다. 본 원고는 열경화성 에폭시수지 응용물 중 CFRP의 재활용을 중심으로 한 친환경적 재활용 기술에 관하여 정리하였다. 특히, CFRP의 구성요소인 탄소섬유(CF)와 기지재인 에폭시수지를 모두 재활용 할 수 있는 화학적 방법에 관하여 보고한다. 더 나아가 열경화성 에폭시수지의 화학적 분해물의 재이용기술에 관한 예를 소개한다.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.33 no.2
• /
• pp.427-432
• /
• 2004

Effect of gamma irradiation on porridge viscosity was studied. Vegetable, beef and pine nut dry flour porridges were irradiated at 0, 2.5, 5, 7.5 and 10 kGy, and rheological characteristics and sensory qualities of irradiated porridge were evaluated. Hunter color lightness were decreased, while redness were increased in dry flour porridge with the increase of irradiation dose. Firmness, consistency, cohesiveness and viscosity of dry flour porridge were significantly decreased with the increase of irradiation dose (p<0.05). Vegetable, beef and pine nut dry flour porridges at dose of 10 kGy reduced the viscosity with 93%, 71% and 55%, respectively Irradiation greatly reduced the viscosity of porridges, probably by starch depolymerization. Irradiation increased the total solids and thus, can improve the calorie up to 30 ㎉. Gamma irradiation was effective in enhancing calorie value of porridge due to reduction of viscosity. As a result of sensory evaluation, overall acceptability and the quality characteristics of irradiated porridges (up to S kGy) were not significantly different from those of the control (p<0.05). In the vegetable porridge, the irradiated porridge at dose of 2.5 kGy was a significantly better overall acceptability than the non-irradiated porridge (p<0.05).