• The Journal of the Acoustical Society of Korea
• /
• v.37 no.1
• /
• pp.31-38
• /
• 2018

Based on the measured data in the south western sea of Jeju Island during the SAVEX15(Shallow Water Acoustic Variability EXperiment 2015), the effect of internal waves on the PPD (Predictive Probability of Detection) of a sonar system was analyzed. The southern west sea of Jeju Island has complex flows due to internal waves and USC (Underwater Sound Channel). In this paper, sonar performance is predicted by probabilistic approach. The LFM (Linear Frequency Modulation) and MLS (Maximum Length Sequence) signals of 11 kHz - 31 kHz band of SAVEX15 data were processed to calculate the TL (Transmission Loss) and NL (Noise Level) at a distance of approximately 2.8 km from the source and the receiver. The PDF (Probability Density Function) of TL and NL is convoluted to obtain the PDF of the SE (Signal Excess) and the PPD according to the depth of the source and receiver is calculated. Analysis of the changes in the PPD over time when there are internal waves such as soliton packet and internal tide has confirmed that the PPD value is affected by different aspects.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.5
• /
• pp.555-564
• /
• 2016

This paper proposes a time slot allocation scheme for military patrol environments. This proposal comes from analysis of traffic properties in a military patrol environment. In the near future, robots are expected to explore enemy grounds and measure threat, taking the place of human patrol. In order to control such robots, control messages must be extremely accurate. One mistake from the control center could cause a tragedy. Thus, high reliability must be guaranteed. Another goal is to maintain a continual flow of multimedia data sent from patrol robots. That is, QoS (Quality of Service) must be guaranteed. In order to transmit data while fulfilling both attributes, the per-path based centralized TDMA slot allocation scheme is recommended. The control center allocates slots to robots allowing synchronization among robots. Slot allocation collisions can also be avoided. The proposed scheme was verified through the ns-3 simulator. The scheme showed a higher packet delivery ratio than the algorithm in comparison. It also performed with shorter delay time in the downlink traffic transmission scenario than the algorithm in comparison.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37C no.11
• /
• pp.1170-1181
• /
• 2012

Wireless Sensor Networks(WSNs) are used in diverse applications. In general, sensor nodes that are easily deployed on specific areas have many resource constrains such as battery power, memory sizes, MCUs, RFs and so on. Hence, first of all, the efficient energy consumption is strongly required in WSNs. In terms of event states, event-driven deliverly model (i.e. surveillance and reconnaissance applications) has several characteristics. On the basis of such a model, clustering algorithms can be mostly used to manage sensor nodes' energy efficiently owing to the advantages of data aggregations. Since a specific node collects packets from its child nodes in a network topology and aggregates them into one packet to relay them once, amount of transmitted packets to a sink node can be reduced. However, most clustering algorithms have been designed without considering can be reduced. However, most clustering algorithms have been designed without considering characteristics of event-driven deliverly model, which results in some problems. In this paper, we propose enhanced clustering algorithms regarding with both targets' movement and energy efficiency in order for applications of surveillance and reconnaissance. These algorithms form some clusters to contend locally between nodes, which have already detected certain targets, by using a method which called CHEW (Cluster Head Election Window). Therefore, our proposed algorithms enable to reduce not only the cost of cluster maintenance, but also energy consumption. In conclusion, we analyze traces of the clusters' movements according to targets' locations, evaluate the traces' results and we compare our algorithms with others through simulations. Finally, we verify our algorithms use power energy efficiently.

• Research in Community and Public Health Nursing
• /
• v.14 no.1
• /
• pp.144-156
• /
• 2003

This study was conducted to investigate the relationship between the self-esteem, social support and health promoting lifestyle of the elderly in a community. The sample consisted of 147 elderly, and data were collected from September 1 to October 15, 2001. The instrument of this study was a structured questionnaire including Health Promoting Lifestyle (47 items), Social Support(18 items), Self-Esteem(10 items), Socio-demographic Characteristics. Analysis of the data was done by use of descriptive statistics, ANOVA, Pearson Correlation Coefficient. The results of this study are as follows: 1. The degrees of self-esteem of the elderly were mean score $25{\pm}2.98$ points, socio-demographic characteristics containing meaningful difference with self-esteem was not significant. 2. The degrees of social support by elderly were mean score $55.03{\pm}9.60$ points and social support according to the socio-demographic characteristics showed meaning difference in family structure $\ulcorner$with off spring$\lrcorner$ (F=8.50, p=.000), health status $\ulcorner$good$\lrcorner$ (t=2.19, p=.030), smoking $\ulcorner$below 1 packet daily$\lrcorner$ (F=4.88 p=.009). 3. The degrees of health enhancing lifestyle by elderly were mean score $113.61{\pm}20.12$ points and health enhancing lifestyle according to the socio-demographic characteristics showed meaning difference in education level $\ulcorner$middle school and above$\lrcorner$ (F=6.37 p=.002), occupation before retirement $\ulcorner$profession, technician, employee of company, education$\lrcorner$ (F=5.00, p=.003), health status $\ulcorner$good$\lrcorner$ (t=3.14, p=0.002), exercise $\ulcorner$weekly 2-3$\lrcorner$ (F=4.31, p=.006), drinking $\ulcorner$weekly 1$\lrcorner$ (F=2.74, p= .046). 4. The item mean score of personal relationship support field in health enhancing lifestyle were $2.90{\pm}.60$ points. item mean scores of exercise and nutrition were $2.26{\pm}.39$ points, item mean scores of stress managing field were $2.25{\pm}.49$ points, item mean scores of health responsible field were $2.14{\pm}.61$ points. 5. The relationship between self-esteem and health enhancing lifestyle revealed a significant correlation(r=.169. p=.041), but self-esteem and social support, showed no significant correlation, and health enhancing lifestyle and social support, revealed a significant correlation(r=.654, p=.001).

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.7 s.361
• /
• pp.71-80
• /
• 2007

This paper describes an efficient hardware design of WiBro security processor (WBSec) supporting for the security sub-layer of WiBro wireless internet system. The WBSec processor, which is based on AES (Advanced Encryption Standard) block cipher algorithm, performs data oncryption/decryption, authentication/integrity, and key encryption/decryption for packet data protection of wireless network. It carries out the modes of ECB, CTR, CBC, CCM and key wrap/unwrap with two AES cores working in parallel. In order to achieve an area-efficient implementation, two design techniques are considered; First, round transformation block within AES core is designed using a shared structure for encryption/decryption. Secondly, SubByte/InvSubByte blocks that require the largest hardware in AES core are implemented using field transformation technique. It results that the gate count of WBSec is reduced by about 25% compared with conventional LUT (Look-Up Table)-based design. The WBSec processor designed in Verilog-HDL has about 22,350 gates, and the estimated throughput is about 16-Mbps at key wrap mode and maximum 213-Mbps at CCM mode, thus it can be used for hardware design of WiBro security system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.42 no.3
• /
• pp.554-561
• /
• 2017

IoT (Internet of Things) devices are often located in environments where indoor or underground, signals are difficult to reach. In addition, the transmission power is low, the base station should be designed to be able to receive signals even at low reception sensitivity. For this reason, a device having a poor channel condition can be transmitted at a low data rate using a low coding rate or repetition. When the coverage class is divided according to the channel condition and the data rate, the packet length may vary from one coverage class to another, and the performance of the slotted aloha random access may be degraded. We will focus on two methods of using shared-resource and seperate resources among multiple slotted aloha methods. In particular, when devices with different coverage classes use shared resources, performance of a device with a bad channel condition may deteriorate. Conversely, when using separate resources for each coverage class, there is a problem that congestion may occur which increases the number of devices that perform random access to one resource area. In this paper, we propose some methods to overcome this problem. This study is mainly focused on MTC devices, and is considered to be a high possibility of future development.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.31 no.5
• /
• pp.901-909
• /
• 2021

Since mobile devices have limited computational resources, it tends to use the cloud to compute or store data. As real-time becomes more important due to 5G, many studies have been conducted on edge clouds that computes at locations closer to users than central clouds. The farther the user's physical distance from the edge cloud connected to base station is, the slower the network transmits. So applications should be migrated and re-run to nearby edge cloud for smooth service use. We run applications in docker containers, which is independent of the host operating system and has a relatively light images size compared to the virtual machine. Existing migration studies have been experimented by using network simulators. It uses fixed values, so it is different from the results in the real-world environment. In addition, the method of migrating images through shared storage was used, which poses a risk of packet content exposure. In this paper, Containers are migrated with Secure CoPy(SCP) method, a data encryption transmission, by establishing an edge computing environment in a real-world environment. It compares migration time with Network File System, one of the shared storage methods, and analyzes network packets to verify safety.

• The Journal of Korean Institute of Next Generation Computing
• /
• v.13 no.6
• /
• pp.7-20
• /
• 2017

The advancement of cloud and big data and the considerable growth of traffic have increased the complexity and problems in the management inefficiency of existing networks. The software-defined networking (SDN) environment has been developed to solve this problem. SDN enables us to control network equipment through programming by separating the transmission and control functions of the equipment. Accordingly, several studies have been conducted to improve the performance of SDN controllers, such as the method of connecting existing legacy equipment with SDN, the packet management method for efficient data communication, and the method of distributing controller load in a centralized architecture. However, there is insufficient research on the control of SDN in terms of the quality of network-using applications. To support the establishment and change of the routing paths that meet the required network service quality, we require a mechanism to identify network requirements based on a contract for application network service quality and to collect information about the current network status and identify the violations of network service quality. This study proposes a method of identifying the quality violations of network paths through ontology to ensure the network service quality of applications and provide efficient services in an SDN environment.

• Journal of KIISE:Information Networking
• /
• v.30 no.3
• /
• pp.329-342
• /
• 2003

Most of the existing multicast routing protocols for ad-hoc networks do not take into account the efficiency of the protocol for the cases when there are large number of sources in the multicast group, resulting in either large overhead or poor data delivery ratio when the number of sources is large. In this paper, we propose a multicast routing protocol for ad-hoc networks, which particularly considers the scalability of the protocol in terms of the number of sources in the multicast groups. The proposed protocol designates a set of sources as the core sources. Each core source is a root of each tree that reaches all the destinations of the multicast group. The union of these trees constitutes the data delivery mesh, and each of the non-core sources finds the nearest core source in order to delegate its data delivery. For the efficient operation of the proposed protocol, it is important to have an appropriate number of core sources. Having too many of the core sources incurs excessive control and data packet overhead, whereas having too little of them results in a vulnerable and overloaded data delivery mesh. The data delivery mesh is optimally reconfigured through the periodic control message flooding from the core sources, whereas the connectivity of the mesh is maintained by a persistent local mesh recovery mechanism. The simulation results show that the proposed protocol achieves an efficient multicast communication with high data delivery ratio and low communication overhead compared with the other existing multicast routing protocols when there are multiple sources in the multicast group.

• Progress in Medical Physics
• /
• v.14 no.2
• /
• pp.124-130
• /
• 2003

Currently, as a consequence of PACS (Picture Archiving Communication System) implementation many hospitals are replacing conventional film-type interpretations of diagnostic medical images with new digital-format interpretations that can also be saved, and retrieve However, the big limitation in PACS is considered to be the lack of mobility. The purpose of this study is to determine the optimal communication packet size. This was done by considering the terms occurred in the wireless communication. After encoding medical image using JPGE2000 image compression method, This method embodied auto-error correction technique preventing the loss of packets occurred during wireless communication. A PC class server, with capabilities to load, collect data, save images, and connect with other network, was installed. Image data were compressed using JPEG2000 algorithm which supports the capability of high energy density and compression ratio, to communicate through a wireless network. Image data were also transmitted in block units coeded by JPEG2000 to prevent the loss of the packets in a wireless network. When JPGE2000 image data were decoded in a PUA (Personal Digital Assistant), it was instantaneous for a MR (Magnetic Resonance) head image of 256${\times}$256 pixels, while it took approximately 5 seconds to decode a CR (Computed Radiography) chest image of 800${\times}$790 pixels. In the transmission of the image data using a CDMA 1X module (Code-Division Multiple Access 1st Generation), 256 byte/sec was considered a stable transmission rate, but packets were lost in the intervals at the transmission rate of 1Kbyte/sec. However, even with a transmission rate above 1 Kbyte/sec, packets were not lost in wireless LAN. Current PACS are not compatible with wireless networks. because it does not have an interface between wired and wireless. Thus, the mobile JPEG2000 image viewing system was developed in order to complement mobility-a limitation in PACS. Moreover, the weak-connections of the wireless network was enhanced by re-transmitting image data within a limitations The results of this study are expected to play an interface role between the current wired-networks PACS and the mobile devices.