• Journal of information and communication convergence engineering
• /
• v.12 no.3
• /
• pp.181-185
• /
• 2014

The lifetime of a solid-state drive (SSD) is limited because of the number of program and erase cycles allowed on its NAND flash blocks. Data cannot be overwritten in an SSD, leading to an out-of-place update every time the data are modified. This result in two copies of the data: the original copy and a modified copy. This phenomenon is known as write amplification and adversely affects the endurance of the memory. In this study, we address the issue of reducing wear leveling through efficient handling of write requests. This results in even wearing of all the blocks, thereby increasing the endurance period. The focus of our work is to logically divert the write requests, which are concentrated to limited blocks, to the less-worn blocks and then measure the maximum number of write requests that the memory can handle. A memory without the proposed algorithm wears out prematurely as compared to that with the algorithm. The main feature of the proposed algorithm is to delay out-of-place updates till the threshold is reached, which results in a low overhead. Further, the algorithm increases endurance by a factor of the threshold level multiplied by the number of blocks in the memory.

• Journal of Crop Science and Biotechnology
• /
• v.10 no.4
• /
• pp.237-242
• /
• 2007

Genome duplication(i.e. polyploidy) is a common phenomenon in the evolution of plants. The objective of this study was to achieve a comprehensive understanding of genome duplication for SNP discovery by Thymine/Adenine(TA) cloning for confirmation. Primer pairs were designed from 793 EST contigs expressed in the roots of a supernodulating soybean mutant and screened between 'Pureunkong' and 'Jinpumkong 2' by direct sequencing. Almost 27% of the primer sets were failed to obtain sequence data due to multiple bands on agarose gel or poor quality sequence data from a single band. TA cloning was able to identify duplicate genes and the paralogous sequences were coincident with the nonspecific peaks in direct sequencing. Our study confirmed that heterogeneous products by the co-amplification of a gene family member were the main cause of obtaining multiple bands or poor quality sequence data in direct sequencing. Counts of amplified bands on agarose gel and peaks of sequencing trace suggested that almost 27% of nonrepetitive soybean sequences were present in as many as four copies with an average of 2.33 duplications per segment. Copy numbers would be underestimated because of the presence of long intron between primer binding sites or mutation on priming site. Also, the copy numbers were not accurately estimated due to deletion or tandem duplication in the entire soybean genome.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.14 no.5
• /
• pp.23-36
• /
• 2004

This paper presents a password based authentication and key exchange protocol which can be used for both authenticating users and exchanging session keys for a subsequent secure communication over an untrusted network. Our idea is to increase a randomness of the password verification data, i.e., we split the password, and then amplify the split passwords in the high entropy-structured password verification data. And in order to prevent the verifier-compromised attack, we construct our system such that the password verification data is encrypted with the verifier's key and the private key of verifier used to encrypt it is stored in a secure place like a smart cards. Also we propose the distributed password authentication scheme utilizing many authentication servers in order to prevent the server-compromised attack occurred when only one server is used. Furthermore, the security analysis on the proposed protocol has been presented as a conclusion.

• International Journal of Internet, Broadcasting and Communication
• /
• v.13 no.2
• /
• pp.27-35
• /
• 2021

NAND flash memory-based SSD needs an internal software, Flash Translation Layer(FTL) to provide traditional block device interface to the host because of its physical constraints, such as erase-before-write and large erase block. However, because useful host-side information cannot be delivered to FTL through the narrow block device interface, SSDs suffer from a variety of problems such as increasing garbage collection overhead, large tail-latency, and unpredictable I/O latency. Otherwise, the new type of SSD, open-channel SSD exposes the internal structure of SSD to the host so that underlying NAND flash memory can be managed directly by the host-level FTL. Especially, I/O data classification by using host-side information can achieve the reduction of garbage collection overhead. In this paper, we propose a new scheme to reduce garbage collection overhead of open-channel SSD by separating the journal from other file data for the journaling filesystem. Because journal has different lifespan with other file data, the Write Amplification Factor (WAF) caused by garbage collection can be reduced. The proposed scheme is implemented by modifying the host-level FTL of Linux and evaluated with both Fio and Filebench. According to the experiment results, the proposed scheme improves I/O performance by 46%~50% while reducing the WAF of open-channel SSDs by more than 33% compared to the previous one.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.26 no.11
• /
• pp.1608-1614
• /
• 2022

As competition between universities intensifies due to the recent decrease in the number of students, it is recognized as an essential task of universities to predict students who are underperforming at an early stage and to make various efforts to prevent dropouts. For this, a high-performance model that accurately predicts student performance is essential. This paper proposes a method to improve prediction performance by removing or amplifying abnormal data in a classification prediction model for identifying underperforming students. Existing anomaly data processing methods have mainly focused on deleting or ignoring data, but this paper presents a criterion to distinguish noise from change indicators, and contributes to improving the performance of predictive models by deleting or amplifying data. In an experiment using open learning performance data for verification of the proposed method, we found a number of cases in which the proposed method can improve classification performance compared to the existing method.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.11 no.4
• /
• pp.201-215
• /
• 1999

Field measurements were made for long- and short-period waves and current velocities at the harbor mouth using pressure-type wave gauges and a current meter, respectively, at the Gamcheon Harbor which has a rectangular shape with a narrow entrance. The measured pressure data were subjected to spectral analyses after removing tidal effects by applying trend removal and high-pass filtering. For the band averaging of the raw spectra, in order to obtain good resolution over the entire frequency, instead of a constant band width, variable band widths were used, which gradually increase as marching from the lowest frequency towards higher frequencies. The Helmholtz resonance mode at the Gamcheon Harbor shows the relative amplification ratio of 9.2 at the wave period of 31.7 minutes, which is quite large compared with those at the harbors located on the east coast of Korea. The second and the third resonance period was 10.3 and 5.4 minute, respectively. On the other hand, the analysis of every 24 hours data shows that during storms the spectral densities are very large compared to those during calm seas and also the second and third resonances are predominant.

• Journal of the Korean Geotechnical Society
• /
• v.25 no.1
• /
• pp.5-19
• /
• 2009

Most of earthquake-induced geotechnical hazards have been caused by the site effects relating to the amplification of ground motion, which is strongly influenced by the local geologic conditions such as soil thickness or bedrock depth and soil stiffness. In this study, an integrated GIS-based information system for geotechnical data, called geotechnical information system (GTIS), was constructed to establish a regional counterplan against earthquake-induced hazards at an urban area of Daejeon, which is represented as a hub of research and development in Korea. To build the GTIS for the area concerned, pre-existing geotechnical data collections were performed across the extended area including the study area and site visits were additionally carried out to acquire surface geo-knowledge data. For practical application of the GTIS used to estimate the site effects at the area concerned, seismic zoning map of the site period was created and presented as regional synthetic strategy for earthquake-induced hazards prediction. In addition, seismic zonation for site classification according to the spatial distribution of the site period was also performed to determine the site amplification coefficients for seismic design and seismic performance evaluation at any site in the study area. Based on this case study on seismic zonations in Daejeon, it was verified that the GIS-based GTIS was very useful for the regional prediction of seismic hazards and also the decision support for seismic hazard mitigation.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.30 no.1C
• /
• pp.65-76
• /
• 2010

Recent earthquake events revealed that severe seismic damages were concentrated mostly at sites composed of soil sediments rather than firm rock. This indicates that the site effects inducing the amplification of earthquake ground motion are associated mainly with the spatial distribution and dynamic properties of the soils overlying bedrock. In this study, an integrated GIS-based information system for geotechnical data was constructed to establish a regional counterplan against ground motions at a representative metropolitan area, Seoul, in Korea. To implement the GIS-based geotechnical information system for the Seoul area, existing geotechnical investigation data were collected in and around the study area and additionally a walkover site survey was carried out to acquire surface geo-knowledge data. For practical application of the geotechnical information system used to estimate the site effects at the area of interest, seismic zoning maps of geotechnical earthquake engineering parameters, such as the depth to bedrock and the site period, were created and presented as regional synthetic strategy for earthquake-induced hazards prediction. In addition, seismic zonation of site classification was also performed to determine the site amplification coefficients for seismic design at any site and administrative sub-unit in the Seoul area. Based on the case study on seismic zonations for Seoul, it was verified that the GIS-based geotechnical information system was very useful for the regional prediction of seismic hazards and also the decision support for seismic hazard mitigation particularly at the metropolitan area.

• Proceedings of the Earthquake Engineering Society of Korea Conference
• /
• 2000.04a
• /
• pp.130-140
• /
• 2000

The earthquake hazard has been evaluated for 10km by 10km area around Kyeongju which is located near Yangsan fault and has abundant historical earthquake records. The ground motion potentials were determined based on equivalent linear analysis by using the data obtained from in situ and laboratory tests and the El centro eartqhuake record scaled to CLE and OLE of the region. The in situ tests include 9 boring investigations 2 crosshole 7 downhole 13 SASW tests and in the laboratory X-ray diffraction analyses and resonant column tests were performed. The peak ground accelerations range between 0.140g and 0.286g on CLE and between 0.051g and 0.116g on OLE respectively showing the good potential of amplification in the deep alluvial layer which is common in Kyeongju area. the response spectrum based on the Korea design guide was sometimes underestimate the motion. particularly near the natural period of the site and the importance of site-specific analysis and need for the improved site categorization method were introduced.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.22 no.3
• /
• pp.211-217
• /
• 2018

The Pohang earthquake with a magnitude of 5.4 occurred on November 15, 2018. The epicenter of this earthquake located in south-east region of the Korean peninsula. Since instrumental recording for earthquake ground motions started in Korea, this earthquake caused the largest economic and life losses among past earthquakes. Korea is located in low-to moderate seismic region, so that strong motion records are very limited. Therefore, ground motions recorded during the Pohang earthquake could have valuable geological and seismological information, which are important inputs for seismic design. In this study, ground motions associated by the 2018 Pohang earthquake are generated using the point source model considering domestic geological parameters (magnitude, hypocentral distance, distance-frequency dependent decay parameter, stress drop) and site amplification calculated from ground motion data at each stations. A contour map for peak ground acceleration is constructed for ground motions generated by the Pohang earthquake using the proposed model.