• The Transactions of The Korean Institute of Electrical Engineers
• /
• 제58권12호
• /
• pp.2303-2310
• /
• 2009

Defense systems are needed to prevent catastrophic failures of a power grid due to cascaded events. Cascaded events can be attributed to improper operations of protective relays. Especially, it is the most dangerous problem that trips of backup relays by overload. In this paper, a new algorithm of predicting Zone 3 acting time of distance relay is proposed using the real time synchronized data from PMUs on the transmission system when the power system is danger. In the proposed, some part of the power system are outage when some unexpected fault in the power system, the algorithm will monitor the impedance locus of distance relay. At this time, if there is a big change of Impedance locus, the algorithm will calculate the Zone 3 acting time of the distance relay by the over load. In the case studies, the estimation and simulation network have been testified and analysed in Matlab Simulink.

• Journal of the Korean Society of Safety
• /
• 제38권6호
• /
• pp.60-71
• /
• 2023

The purpose of this study is to propose a quantitative toxicity endpoint distance suitable for the initial response of firefighters by comparing and analyzing the commonly applied toxic level of concern (T-LOC), specifically emergency response planning guidelines (ERPG), acute exposure guideline levels (AEGL), and immediately dangerous to life or health (IDLH). This is to protect the fire brigade, which responds to toxic chemical accidents first during the golden time. Using areal locations of hazardous atmospheres, a damage prediction program, the amount of leakage for both acidic and basic substances, along with the endpoint distance, were analyzed for alternative accident and worst-case accident scenarios. The results showed that the toxicity endpoint distance, serving as a compromise between Level-3 and Level-2 of T-LOC, was longer than ERPG-3 and shorter than ERPG-2 with IDLH, while its values were analyzed in the order of ERPG-2, AEGL-2, IDLH, AEGL-3, and ERPG-3. It is suggested that the application of IDLH in an emergency (red card) and ERPG-2 endpoint distance in a non-emergency (non-red card) can be utilized for the initial response of the fire brigade.

• Journal of the Korean Society for Nondestructive Testing
• /
• 제25권6호
• /
• pp.421-430
• /
• 2005

Brillouin time-domain analysis in optical fibres is a novel technique making possible a distributed measurement of temperature and strain over long distance and will deeply modify our view about monitoring large structures, such as dams, bridges, tunnels and pipelines, Optical fibre sensing will certainly be a decisive tool for securing dangerous installations and detecting environmental and industrial threats.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 한국소음진동공학회 2006년도 춘계학술대회논문집
• /
• pp.1044-1048
• /
• 2006

Nuclear power generation is very dangerous in occasion that skirt of structure by earthquake although it is high effective generation that can make a lot of energies with few raw material. when design, it must consider a lot of problems caused by an earthquake. The seismic analysis of the structure has been great concern in the engineering society with an effort to reduce the severe damages from an earthquake. So the earthquake resistant design is one of the crucial design procedures of a gate valve used in nuclear power generation. The gate valve which has the contact area between stem and bellows. Because of the contact area. The gate valve should be given high stress and frictional wear. In this thesis, Considering the gate valve which has some contact distance between stem and bellows. The gate valve which has some contact distance is analyzed by a commercial FEM code of Ansys and Then compared to the gate valve behavior which doesn't have contact distance.

• IEMEK Journal of Embedded Systems and Applications
• /
• 제15권2호
• /
• pp.71-78
• /
• 2020

This paper proposes vision sensors and deep learning-based around view monitoring system for ship berthing. Ship berthing to the port requires precise relative position and relative speed information between the mooring facility and the ship. For ships of Handysize or higher, the vesselships must be docked with the help of pilots and tugboats. In the case of ships handling dangerous cargo, tug boats push the ship and dock it in the port, using the distance and velocity information receiving from the berthing aid system (BAS). However, the existing BAS is very expensive and there is a limit on the size of the vessel that can be measured. Also, there is a limitation that it is difficult to measure distance and speed when there are obstacles near the port. This paper proposes a relative distance and speed estimation system that can be used as a ship berthing assist system. The proposed system is verified by comparing the performance with the existing laser-based distance and speed measurement system through the field tests at the actual port.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• 제41권5호
• /
• pp.422-428
• /
• 2013

Recently, many unmanned aerial vehicle (UAV) studies have focused on small UAVs, because they are cost effective and suitable in dangerous indoor environments where human entry is limited. Map building through distance measurement is a key technology for the autonomous flight of small UAVs. In many researches for unmanned systems, distance could be measured by using laser range finders or stereo vision sensors. Even though a laser range finder provides accurate distance measurements, it has a disadvantage of high cost. Calculating the distance using a stereo vision sensor is straightforward. However, the sensor is large and heavy, which is not suitable for small UAVs with limited payload. This paper suggests a low-cost distance measurement system using a laser pointer and a monocular vision sensor. A method to measure distance using the suggested system is explained and some experiments on map building are conducted with these distance measurements. The experimental results are compared to the actual data and the reliability of the suggested system is verified.

• Journal of the Institute of Convergence Signal Processing
• /
• 제8권2호
• /
• pp.98-105
• /
• 2007

In this paper, we propose the method and system which determines the condition for safe and unsafe lane changing. To determine the condition, first, the system sets up the Region of Interest(ROI) on the neighboring lane. Second, a dangerous vehicle is extracted during the line changing. Third, the condition is determined to wm or not by calculating the moving direction, relative distance md relative velocity. To set up the ROI, the only one side lane is detected and the interested region is expanded. Using the coordinate transformation method, the accuracy of the ROI raised. To correctly extract the vehicle on the neighboring lane, the Adaptive Background Update method and Image Segmentation method which uses the feature of the travelling road are used. The object which is extracted by the dangerous vehicle is calculated the relative distance, the relative velocity and the moving average. And then in order to ring, the direction of the vehicle and the condition for safe and unsafe is determined. As minimizes the interested region and uses the feature of the travelling road, the computational quantity is reduced and the accuracy is raised and a stable result on a travelling road images which demands a high speed calculation is showed.

• Journal of the Korea Society of Computer and Information
• /
• 제12권1호
• /
• pp.189-197
• /
• 2007

Developed safety system which transfers danger information to rear cars for accident prevention when drivers detect a accident, a dropping or a freezing during driving on the high way. To prevent an accident, each vehicles mount OBU which is made up of a GPS unit and a transmitter-receiver and the trace of road is always renewed and saved in OBU per a regular past distance. When the driver see dangerous situation, transfer a danger pattern and a trace information by pressing button. All cars which receive information compare the received data with the original data. And then, only cars which are located at the rear in a regular distance respond and occur a warning. Performed a road test at the rate of $30{\sim}50$ kilometer a hour using two test cars which saved about 120meter's space between them were mounted OBU which had 447Mhz transceiver. As a result of the experiment, communication between test cars had no problem. Accordingly, it can use a safety driving device because driver can notice a danger situation and set themselves ready for it using this system in advance.

• Journal of Korea Multimedia Society
• /
• 제23권2호
• /
• pp.282-292
• /
• 2020

In order to minimize casualties from marine vessel accidents that occur frequently at home and abroad, it is important to ensure the safety of the passengers aboard the vessel in the event of an accident. There is an EPIRB system as a system for disaster preparedness in the marine situation currently on the market, but there is a problem that the price is very expensive. In order to overcome the cost problem, which is a disadvantage of previous system, LoRaWAN-based communication is used. LoRaWAN communication-based vessel positioning and risk detection system based on LoRaWAN communication transmits measurement data of each module using two Beacon and GPS modules to stably perform position measurement for both indoor and outdoor situations. The rider danger situation detection system can detect the safety status of the rider using the 3-axis acceleration sensor, collect data from the rider positioning system and the rider safety status detection system, and send to server using LoRa communication. When conducting communication experiments in the long-distance maritime situation and actual communication experiments using the implemented system, it was found that the two experiments showed over 90% communication success rate on average.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• 제16권11호
• /
• pp.2424-2430
• /
• 2012

The current Navigation System for the Visually Impaired Person has a short and limited communication distance and can't receive enough information from Visually Impaired Person to assist directly. In addition, because the path is dangerous and incomplete for the Visually Impaired Person, moving with White Stick is still inconvenient and dangerous. To solve this problem we implement communication that can send and receive video, voice, location information between the Visually Impaired Person's Smart Portable Navigation System Development and assistant's PC.