• 대한전자공학회논문지SP
• /
• 제41권3호
• /
• pp.231-238
• /
• 2004

주파수 영역에서의 적응 신호처리는 입력의 자기 상관 행렬에 이산 퓨리에 변환(DFT Discrete Fourier Transform)을 이용할 때 거의 대각선화 되는 특성으로 인해 시간영역 적응필터보다 주파수 영역 적응 필터가 빠르게 적응한다. 본 논문에서는 변형된 이산 퓨리에 변환(MDFT: modified DFT)을 이용하여 주파수 영역 적응 필터를 설계함으로써 안정한 수렴 속도를 갖는 잡음 제거 시스템을 제안한다. 제안한 구조는 MDFT를 이용하여 연산수를 최소화하며, 안정한 수렴을 유지하면서 블록 없는 처리를 할 수 있고, 최적의 수렴 속도를 위해 입력 자기 상관 행렬에 MDFT를 사용해 근사적으로 대각화 시키고 시간적으로 변하는 스텝 크기를 정규화 하는 고속 적응 잡음 제거(HANR: high speed adaptive noise reduction) 알고리즘이다. HANR 알고리즘을 적용한 필터는 DFT변환법을 사용한 LMS방법(non-proposed)보다 30%정도의 속도 개선이 있다.

• 전력전자학회논문지
• /
• 제17권2호
• /
• pp.93-98
• /
• 2012

A precise measurement of the grid voltage is one of the essential techniques, which is required to connect a renewable energy to the grid. In general, when a filter is used to eliminate unnecessary harmonics and noises, a signal is distorted by phase delay, amplitude attenuation, and other distortions. And the response characteristic of a controller is directly affected by bandwidth of cut-off frequency of the filter. To alleviate this problems, we propose an effective algorithm based on DFT(Discrete Fourier Transform) instead of approaching the filter application. The proposed algorithm ensures high precise measurement of the grid voltage because it can extract the fundamental and harmonics from the raw signal without any distortions. The high performance of the proposed algorithm is verified by PSIM simulation and experiments of Grid-Connected VSI.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2011년도 전력전자학술대회
• /
• pp.477-478
• /
• 2011

본 논문에서는 신재생 에너지를 전력 계통에 효율적으로 연계시키기 위한 요소 기술로 Filter 대신 DFT 기법을 사용한 고정밀 계측에 대해 제안한다. 일반적으로 Filter를 사용할 경우 원신호의 위상 지연, 크기 감소 같은 신호 왜곡으로 정확한 제어가 어려우나, 제안된 DFT 기법을 사용하면 기존 문제점을 해결 가능하다. 따라서 본 논문에서 제안된 DFT 기법은 PSIM을 이용한 시뮬레이션과 실험을 통해 제안된 알고리즘의 타당성과 우수성을 검증하였다.

• Journal of Electrical Engineering and Technology
• /
• 제6권4호
• /
• pp.439-446
• /
• 2011

Frequency is an important operating parameter for the protection, control, and stability of a power system. Thus, it must be maintained very close to its nominal frequency. Due to the sudden change in generation and loads or faults in a power system, however, frequency deviates from its nominal value. An accurate monitoring of the power frequency is essential for optimum operation and prevention of wide area blackout. Most conventional frequency estimation schemes are based on the DFT filter. In these schemes, the gain error could cause defects when the frequency deviates from the nominal value. We present an advanced frequency estimation technique using gain compensation to enhance the DFT filter-based technique. The proposed technique can reduce the gain error caused when the frequency deviates from the nominal value. Simulation studies are performed using both the data from EMTP-RV software and the user-defined arbitrary signals to demonstrate the effectiveness of the proposed algorithm. Results show that the proposed algorithm achieves good performance under both steady state tests and dynamic conditions.

• 전기학회논문지P
• /
• 제59권3호
• /
• pp.253-257
• /
• 2010

The frequency is an important operation parameter for the control, protection, and stability of a power system. The frequency as a key index of power quality can be indicative of system abnormal conditions and disturbances. Due to the sudden change in generation and loads or faults in power system, the frequency is supposed to deviate from its nominal value. It is essential that the frequency must be maintained very close to its nominal frequency. An accurate monitoring of the power frequency is essential to optimal operation and prevention for wide area blackout. As most conventional frequency estimation schemes are based on DFT filter, it has been pointed out that the gain error could cause defects when the frequency is deviated from nominal value. This paper presents an advanced frequency estimation technique using gain compensation to improve the performance of DFT filter based techniques. To evaluate performance of the proposed algorithm, the 765kV T/L system in Korea is simulated by EMTP-RV software. The proposed technique can reduce the gain error caused when the power system frequency deviates from nominal value.

• 전기학회논문지P
• /
• 제64권4호
• /
• pp.291-296
• /
• 2015

Transmission line is exposed to a large area, and then faults are likely to occur than the other component of power system. When a fault occurs on a transmission line, fault locator helps fast recovery of power supply on power system. This paper deals with the design of a digital fault locator for improvement accuracy of the fault distance estimation and a fault occurrence position for transmission line. The algorithm of a fault locator uses a DC offset removal filter and DFT filter. The algorithm utilizes a fault data of GPS time synchronized. The computed fault information is transmitted to the other side substation through communication. The digital fault locator includes MPU module, ADPU module, SIU module, and a power module. The MMI firmware and software of the fault locator was implemented.

• 전기학회논문지P
• /
• 제58권2호
• /
• pp.122-129
• /
• 2009

Frequency is an important operating parameter of a power system. It is essential that the frequency of a power system be maintained very close to its nominal frequency. And frequency measurement devices have need to measure a fast and accurate of frequency using voltage signals. This paper proposes a comparative study of frequency estimation techniques using the high speed FIR filter based algorithm, the DFT filter based algorithm using phasor angle between two phasors, and positive sequence component based algorithm using the half angle between two successive positions of phasor. The discussed three techniques have been formed through numerical manipulation of a discrete system. The proposed techniques have been tested using signals obtained from selected power system model using ATP simulation package. Some test results are shown in this paper.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2008년도 하계학술대회 논문집
• /
• pp.91-93
• /
• 2008

In this paper, novel phase angle following algorithm for the single phase grid-connected inverter is proposed. Gird-connected inverter needs phase angle detection for synchronization grid voltage with the inverter output. In case of single phase grid-connected inverter, zero crossing detection and virtual 2-phase PLL using digital all pass filter or digital low pass filter are used conventionally. But these methods have a weakness for harmonics, noises and ripples. The proposed method of PLL achieve DFT(Discrete Fourier Transform) using Goertzel algorithm. It can extract fundamental voltage of grid. As a results, it can obtain phase angle using digital all pass filter without effect of harmonics, noises and ripples. Simulation results are presented to demonstrate the effectiveness of the proposed algorithm.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년 학술대회 논문집 정보 및 제어부문
• /
• pp.388-390
• /
• 2006

This paper presents a hybrid SoC design for phase detection of single tone signal. The designed hybrid SoC is composed of three functional blocks, i.e., an analog to digital converter module, a phase detection module and a controller module. A design of the controller module is based on a 16-bit RISC architecture. An I/O interface and an LCD control interface for transmission and display of phase measurement values are included in the design of the controller module. A design of the phase detector is based on a recursive sliding-DFT. The recursive architecture effectively reduces the gate numbers required in the implementation of the module. The ADC module includes a single-bit second-order sigma-delta modulator and a digital decimation filter. The decimation filter is designed to give 98dB of SNR for the ADC. The effective resolution of the ADC is enhanced to 98dB of SNR by the incorporation of a pre FIR filter, a 2-stage cascaded integrator- comb(CIC) filter and a 30-tab FIR filter in the decimation. The hybrid SoC is verified in FPGA and implemented in 0.35 CMOS Technology.

• 한국통신학회논문지
• /
• 제25권9B호
• /
• pp.1570-1578
• /
• 2000

본 논문은 채널간의 간섭을 줄이는 관점에서 코사인 변조 필터 뱅크와 사인 변조 필터 뱅크로 이루어진 필터뱅크의 쌍을 다중 반송파 부호 분할 다원 접속(multi-carrier code division multiple access: MC-CDMA) 시스템의 다중화 전송에 적용하였다. 웨이브렛 특성을 필터 뱅크의 구현에 활용하는 제안된 기법은 이산 퓨리에 변환(discrete Fourier transform: DFT)에 기반을 둔 기존의 MC-CDMA 시스템과 비교하였을 때, 전송 채널의 부채널화의 우수성으로 인해 채널간의 간섭을 감소시킬 수 있다. 제안된 직교 쌍 필터 뱅크를 기반으로 하는 MC-CDMA 시스템의 성능을 평가하기 위하여, 레이라이 페이딩 채널과 가우시안 잡음 채널에서 역 방향 링크의 신호 대 잡음비에 대한 비트 오율을 계산한다. 성능평가 결과는 제안한 시스템이 간섭의 영향을 최소화하는 측면에서 기존의 MC-CDMA 시스템 보다 우수한 성능을 보이고 있다.