• Proceedings of the KSME Conference
• /
• 2001.11a
• /
• pp.507-514
• /
• 2001

Direct drive servovalve(DDV) is a kind of one-stage valve since the rotary motion of DC motor is directly transferred to the linear motion of valve spool through the link. Since the structure of DDV is simple, it is less expensive, more reliable and offers reduced internal leakage and reduced sensitivity to fluid contamination. However, the flow force effect on the spool motion is significant such that it induces large steady-state error in a step response. If the proportional control gain is increased to reduce the steady-state error, the system becomes unstable. In order to satisfy the system design requirements, the classical controller is designed using the analytical Bode method.

• Proceedings of the IEEK Conference
• /
• 2001.06b
• /
• pp.189-192
• /
• 2001

We have studied fabrication processes that form asymmetric $\Gamma$-gate with a 0.1${\mu}{\textrm}{m}$ gate length in MMIC's(Monolithic Microwave Integrated Circuits). Asymmetric $\Gamma$-gate was fabricated using mixture of PMMA and MCB. Thus pseudomorphic high electron mobility transistor (PHEMT's) with 0.1${\mu}{\textrm}{m}$ gate length was fabricated via several steps such as mesa isolation, metalization, recess, passivation. PHEMT's has the -1.75 V of pinch-off voltage (Vp), 63 mA of drain saturation current(Idss and 363.6 mS/mm of maximum transconductance (Gm) in DC characteristics and current gain cut-off frequency of 106 GHz and maximum frequency of oscillation of 160 GHz in RF characteristics.

• Proceedings of the KSR Conference
• /
• 2006.11a
• /
• pp.145-159
• /
• 2006

This paper describes the development of a clustering based fuzzy controller of an electromagnetic suspension vehicle using gain scheduling method and Kalman filter for a simplified single magnet system. Electromagnetic suspension vehicle systems are highly nonlinear and essentially unstable systems For achieving the levitation control of the DC electromagnetic suspension system, we considered a fuzzy system modeling method based on clustering algorithm which a set of input/output data is collected from the well defined Linear Quadratic Gaussian(LQG) controller. Simulation results show that the proposed clustering based fuzzy controller methodology robustly yields uniform performance with adequate gap response over the mass variation range.

• Journal of Sensor Science and Technology
• /
• v.20 no.3
• /
• pp.145-150
• /
• 2011

In this paper, we designed a tunable microstrip patch antenna using RF MEMS switches. The design and simulation of the antenna were performed using a high frequency structure simulator(HFSS). The antenna was designed for use in the ISM band and either operates at 2.4 GHz or 5.7 GHz achieving -10 dB return-loss bandwidths of 20 MHz and 180 MHz, respectively. In order to obtain high efficiency and improve the ease of integration, a high resistivity silicon(HRS) wafer on a glass substrate was used for the antenna. The antenna achieved high gains: 8 dB at 5.7 GHz and 1 dB at 2.4 GHz. The RF MEMS DC contact switches were simulated and analyzed using ANSYS software.

• Publications of The Korean Astronomical Society
• /
• v.8 no.1
• /
• pp.1-15
• /
• 1993

We made a pyramidal horn antenna system for 21cm cosmic radio wave. The antenna system has a rectangular waveguide with $TE_{10}$ mode and a copper probe to detect the electromagnetic wave in waveguide. The parameters of the probe are obtained by experiments using two waveguides. Pyramidal horn antenna is designed to get a gain of 20dB. The size of the aperture of this horn is $94cm{\times}74cm$. The beam width of half power is about $14.7^{\circ}$ for the frequency of 1.4GHz. The horn is made of aluminum plate with a thickness of 2mm. The signal from horn and waveguide is amplified in a receiver system and is converted into DC in the detecter. The intensity of the signal is recorded on a chart recorder. We observed the sun using this simple radio telescope and obtained the brightness temperature of $2.2{\times}10^5K$, which indicates that the sun is quiet at 21cm.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.34D no.3
• /
• pp.9-16
• /
• 1997

A 23GHz 1-stage LNA was designed by using new topology of coupled line type with EEsof softwares and modified by using MPIE numerical analysis. The parallel coupled filter-type matching sections give impedance matching and DC blocking simultaneously, and have small discontinuities. This matching scheme has simple structure in the design process and give small error. The EFT chip was directly attached to the ground metal. The designed LAN gives 6.2dB gain and 2.5dB noise figure without considering the loss of connectors. Through these results, it was verified that our design process, matching schemes and fabrication technologies was valied for developing 20GHz-band LNA.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2003.11a
• /
• pp.389-393
• /
• 2003

This paper describes the design of enhanced TSSI RF Power Detector which has wide dynamic range using switch and Log amp. This Power Detector consists of low and high gain loops, and they adaptively switched by output DC voltage which is proportioned to input power level. Because Power Detector needs to separate the channel, so architecture is heterodyne system having 70MHz intermediate frequency. This proposed RF Power Detector is settle to the satisfaction of Closed loop power control system for W-CDMA optic repeater, and the obtained dynamic range cover the higher than 50dB.

• Proceedings of the KIEE Conference
• /
• 2008.07a
• /
• pp.1779-1780
• /
• 2008

This paper presents a switching system of speed controller between PI (Proportional_Integrator) and P_LPF (Proportional_Low pass filter) to improve overshoot and slow settling time in DC motor. When the integrator is saturated in the PI controller, the error signal is integrated continuously. For preventing the state, the Anti-windup scheme is proposed. But the Anti-windup scheme dose not show stable characteristics in the whole speed command section after tuned a gain. By using P_LPF switching system these problems are improved and there is no need to tune of user hereafter, when the integrator is saturated. The proposed method is verified by the simulation results using MATLAB SIMULINK.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2001.05a
• /
• pp.465-468
• /
• 2001

An objection of this study is to develop a high stable analytic system of radioactive pulses. The proposed system consists of an amplifying circuit with 60dB gain, a programmable power supply unit which can generate DC voltage up to 1, 500V, and a digital signal processor. Pulse height distribution in accordance with pulse counts is important data in analyzing radioactive pulses. In this study, AD convertor (12bit, l00ns) and DSP (TMS 320C31-60) are used to analyze the pulse height, and the analytic system is designed to be operated in PC-networking.

• Proceedings of the KSME Conference
• /
• 2003.11a
• /
• pp.1590-1595
• /
• 2003

Direct drive servovalve(DDV) is a kind of one-stage valve since the rotary motion of DC motor is directly transferred to the linear motion of valve spool through the link. Since the structure of DDV is simple, it is less expensive, more reliable and offers reduced internal leakage and reduced sensitivity to fluid contamination. However, the flow force effect on the spool motion is significant such that it induces large steady-state error in a step response. If the proportional control gain is increased to reduce the steady-state error, the system becomes unstable. In order to satisfy the system design requirements, the lead-lag controller is designed using the complex method that is one kind of constrained direct search method.