• ETRI Journal
• /
• v.25 no.1
• /
• pp.19-24
• /
• 2003

This paper describes the performance of a Ku-band 5-bit monolithic phase shifter with metal semiconductor field effect transistor (MESFET) switches and the implementation of a ceramic packaged phase shifter for phase array antennas. Using compensation resistors reduced the insertion loss variation of the phase shifter. Measurement of the 5-bit phase shifter with a monolithic microwave integrated circuit demonstrated a phase error of less than $7.5{\circ}$ root-mean-square (RMS) and an insertion loss variation of less than 0.9 dB RMS for 13 to 15 GHz. For all 32 states of the developed 5-bit phase shifter, the insertion losses were $8.2{\pm}1.4$dB, the input return losses were higher than 7.7 dB, and the output return losses were higher than 6.8 dB for 13 to 15 GHz. The chip size of the 5- bit monolithic phase shifter with a digital circuit for controlling all five bits was 2.35 mm ${\times}$1.65 mm. The packaged phase shifter demonstrated a phase error of less than $11.3{\circ}$ RMS, measured insertion losses of 12.2 ${\pm}$2.2 dB, and an insertion loss variation of 1.0 dB RMS for 13 to 15 GHz. For all 32 states, the input return losses were higher than 5.0 dB and the output return losses were higher than 6.2 dB for 13 to 15 GHz. The size of the packaged phase shifter was 7.20 mm${\times}$ 6.20 mm.

• Asian-Australasian Journal of Animal Sciences
• /
• v.14 no.10
• /
• pp.1419-1424
• /
• 2001

Previous research in our laboratory has demonstrated the importance of lactose in phase I and II pig starter diets. Two experiments were conducted to evaluate the use of a carbohydrate by-product (food by-products) as a replacement for lactose. In Exp. I, 120 weaned pigs ($14{\pm}2d$ and 5.65kg) were allotted in a randomized complete block design (RCBD) to 10 replications with four pigs per pen. This experiment evaluated three carbohydrate sources (lactose, carbohydrate by-product, and 50-50 blend of the carbohydrate by-product and lactose). The carbohydrate sources were added at 26% in the phase I diets and 15% in the phase II diets. Phase I diets contained 7.5% spray dried plasma protein (SDP). The phase I diets were fed from d 0 to 14 and the phase II diets from d 15 to 28. There were no significant differences between carbohydrate sources on pig performance in phase I. However, during phase II pigs fed the diet with lactose had an improved gain/feed ratio (G/F) (p=0.06) compared to pigs fed the carbohydrate by-product. For the entire 28 d trial ADG, ADFI and G/F were similar for the 50-50 blend and those fed lactose. Total replacement of lactose with the carbohydrate byproduct resulted in a reduced G/F (p=0.09). Exp. 2 used 100 weaned pigs ($17{\pm}2d$ and 4.75kg) with five replications with five pigs per pen. This experiment evaluated four carbohydrate treatments (lactose, carbohydrate by-products, 50-50 blend, and corn). All phase I diets contained 3.5% SDP with the carbohydrate sources included at 15%, and were fed d 0 to 14. The phase II diets contained 7.5% of the carbohydrate sources and were fed d 15 to 27. A common phase III diet was fed d 28 to 42. During all phases pigs fed com tended to have a lower ADG than pigs fed the other carbohydrate sources with the 50-50 blend resulting in the highest ADG. The results of both experiments suggest that this carbohydrate by-product can replace at least 50% of the lactose in phase I and phase II pig starter diets.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.10
• /
• pp.1973-1979
• /
• 2016

As technologies evolve, diverse 3D measurement techniques using cameras and pattern projectors have been developed continuously. In 3D measurement, high accuracy, fast speed, and easy implementation are very important factors. Recently, 3D measurement using multi-frequency fringe patterns for absolute phase computation has been widely used in the fringe projection profilometry. This paper proposes an improved method to compute the object's absolute phase using the reference plane's absolute phase and phase difference between the object and the reference plane. This method finds the object's absolute phase by adding the difference between the reference plane's wrapped phase and the object's wrapped phase to the reference plane's absolute phase already obtained in the calibration stage. Through this method, there is no need to obtain multi-frequency fringe patterns about new object for the absolute phase computation. Instead, we only need the object's phase difference relative to the reference planes's phase in the measurement stage.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.4
• /
• pp.511-519
• /
• 2016

This paper proposes a CMOS 6-bit phase shifter with low RMS phase and amplitude errors for an X-band phased array antenna. The phase shifter combines a switched-path topology for coarse phase states and a switch-filter topology for fine phase states. The coarse phase shifter is composed of phase shifting elements, single-pole double-throw (SPDT), and double-pole double-throw (DPDT) switches. The fine phase shifter uses a switched LC filter. The phase coverage is $354.35^{\circ}$ with an LSB of $5.625^{\circ}$. The RMS phase error is < $6^{\circ}$ and the RMS amplitude error is < 0.45 dB at 8-12 GHz. The measured insertion loss is < 15 dB, and the return losses for input and output are > 13 dB at 8-12 GHz. The input P1dB of the phase shifter achieves > 11 dBm at 8-12 GHz. The current consumption is zero with a 1.2-V supply voltage. The chip size is $1.46{\times}0.83mm^2$, including pads.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.1 s.92
• /
• pp.49-55
• /
• 2005

In this paper, the phase locked harmonic oscillator(PLHO) using the analog PLL(Phase Locked Loop) is designed and implemented for a wireless LAN system. The harmonic oscillator is consisted of a ring resonator, a varactor diode and a PLL circuit. Because the fundamental fiequency of 8.5 GHz is used as the feedback signal for the PLL and the 2nd harmonic of 17.0 GHz is used as the output, a analog frequency divider for the phase comparison in the PLL system can be omitted. For the simple PLL circuit, the SPD(Sampling Phase Detector) as a phase comparator is used. The output power of the phase locked harmonic oscillator is 2.23 dBm at 17 GHz. The fundamental and 3rd harmonic suppressions are -31.5 dBc and -29.0 dBc, respectively. The measured phase noise characteristics are -87.6 dBc/Hz and -95.4 dBc/Hz at the of offset frequency of 1 kHz and 10 kHz from the carrier, respectively.

• The Journal of the Korea Contents Association
• /
• v.15 no.9
• /
• pp.395-402
• /
• 2015

when the radiation therapy of chest and abdomen, evaluation of the tumor motion and the data was used to minimize damage to normal tissues by separating the tumor and normal tissue and maximize tumor therapeutic effect. Lung and liver cancer each 20 patients based on the 50% top phase using 4D-CT simulation and Light speed-16 of shooting equipment 30 ~ 70 % gating phase interval and 0 ~90 % movement in the full phase interval was measured. If the full phase 0 ~ 90% with gating phase 30~70% of tumors in the liver and lung is shown the biggest difference compared to the motion and the size of the GTV was the largest difference in the I(inferior), full phase 0~90% degree of tumor motion only when a relatively large, gating phase to 30~70% of the tumor when the movement has been found that the reduced average 7.1mm. In the 4D-CT simulation comparing the motion value when the full phase 0~90 % and gating phase 30~70 % when the motion value, twice in the gating phase 30~70 % more than full phase 0~90 % showed a small movement value. The exposure to normal tissues, based on the results obtained from the 4D-CT simulation can be significantly alleviated, After treatment will reduce pain and disability in patients with radiation is expected to be able to effective treatment.

• Journal of the Korean Applied Science and Technology
• /
• v.15 no.2
• /
• pp.25-32
• /
• 1998

The emulsion stability of W/O emulsion prepared by D phase emulsification during storage and handling is studied by using phase diagrams. The process of D phase emulsification begins with the formation of isotropic surfactant solution, followed by formation of oil-in-surfactant (O/D) gel emulsion by dispersion of octamethylcyclotetrasiloxane(OMCS) in the surfactant solution. Polyols were essential components for this purpose. To understand the function of polyols, the solution behavior of nonionic surfactant/oil/water/polyol systems were investigated by the ternary phase diagrams of polyoxyethylene oleyl ether/OMCS/propylene glycol(PG) aqueous solutions. The addition of PG increased the solubility of oil in the isotropic surfactant phase. D phase emulsification method has been applied to a new type of cosmetics. By using this emulsification technique, O/W emulsion were formed without a need for adjust of HLB. Fine and stable W/O emulsions were prepared by D phase emulsion.

• 제어로봇시스템학회:학술대회논문집
• /
• 1989.10a
• /
• pp.799-804
• /
• 1989

A new method for measuring optical phase changes of reflection beam from optical mirror is proposed. The optical phase change is liable to change with varying atmosphere conditions. This optical phase changes are measured against air pressure, temperature, humidity and CO$\_$2/ concentration variations. It is clarified that the optical phase changes are most effected by humidity change.

• Current Optics and Photonics
• /
• v.2 no.4
• /
• pp.332-339
• /
• 2018

A new multi-frequency fringe projection method is proposed to reduce the nonlinear phase error in 3-D shape measurements using an adaptive compensation method. The phase error of the traditional fringe projection technique originates from various sources such as lens distortion, the nonlinear imaging system and a nonsinusoidal fringe pattern that can be very difficult to model. Inherent possibility of phase error appearing hinders one from accurate 3-D reconstruction. In this work, an adaptive compensation algorithm is introduced to reduce adaptively the phase error resulting from the fringe projection profilometry. Three different frequencies are used for generating the gratings of projector and conveyed to the four-step phase-shifting procedure to measure the objects of very discontinuous surfaces. The 3-D shape results show that this proposed technique succeeds in reconstructing the 3-D shape of any type of objects.

• Animal Bioscience
• /
• v.34 no.5
• /
• pp.886-894
• /
• 2021

Objective: An experiment was conducted to study the effect of graded concentration of digestible lysine (dLys) on performance of layers fed diets containing sub-optimal level of protein. Methods: Five diets were formulated to contain graded concentrations of dLys (0.700%, 0.665%, 0.630%, 0.593%, and 0.563%), but similar levels of crude protein (15% CP), energy (10.25 MJ ME/kg) and other nutrients. A total of 3,520 hens (26 wk of age) with mean body weight of 1,215+12.65 g were randomly divided into 40 replicate groups of 88 birds in each and housed in an open sided colony cage house. Each diet was offered ad libitum to eight replicates from 27 to 74 wk of age. The performance was compiled at every 28 d and the data for each parameter were grouped into three phases, that is early laying phase (27 to 38 wk), mid laying phase (39 to 58 wk), and late laying phase (59 to 74 wk of age) for statistical analysis. Results: Egg production, egg mass and feed efficiency (feed required to produce an egg) were significantly improved by the dLys level during the early and mid laying phases but not during the late phase. Whereas feed intake was significantly reduced by dLys concentration during mid and late laying phases but not during early laying phase. The egg weight was not affected by dLys concentration in any of the three phases. Conclusion: Based on best fitted statistical models, dietary requirements of dLys worked out to be 0.685%, 0.640%, and 0.586% during early phase, mid phase, and late egg laying phase, respectively. The calculated requirement of dLys for the respective production phases are 727 mg/b/d during the early and mid laying phases and 684 mg/b/d during the late laying phase in diets containing 15% CP.